Using ALSM to map sinkholes in the urbanized covered karst of Pinellas County,Florida—1, methodological considerations

Comparison of a database of interpreted sinkholes made using airborne laser swath mapping (ALSM) with databases of sinkholes made from interpretation of aerial photographs reveals substantial disagreement. The discrepancies involve the location, number, areas, and circularity of interpreted sinkholes. Methodological factors that contribute to the discrepancies include blockage of ALSM laser returns in thick vegetation, multi-path reflections, and misrepresentation of the true extent of sinkholes. Comparison of two ALSM-derived databases made (1) independently from versus (2) in combination with earlier air photo analysis in undeveloped regions had the following result: one-fourth of the sinkholes interpreted by using the composite method were missed by the independent analysis, and one-third of the sinkholes that were interpreted from the independent analysis were not interpreted as sinkholes using the composite method. Subjective interpretation leads to a high level of uncertainty such that the results of the remote sensing studies are suspect, if not invalid.     

Modeling on adsorption–desorption of trace metals to suspended particle matter in the Changjiang Estuary

The uptake and release of trace metals (Cu, Ni, Zn, Cd, and Co) in estuaries are studied using river and sea end-member waters and suspended particulate matter (SPM) collected from the Changjiang Estuary, China. The kinetics of adsorption and desorption were studied in terms of environmental factors (pH, SPM loading, and salinity) and metal concentrations. The uptake of the metals studied onto SPM occurred mostly within 10 h and reached an asymptotic value within 40 h in the Changjiang Estuary. As low pH river water flows into the high pH seawater and the water become more alkaline as it approaches to the seaside of estuary, metals adsorb more on SPM in higher pH water, thus, particulate phase transport of metal become increasingly important in the seaward side of the estuary. The percentage of adsorption recovery and the distribution coefficients for trace metals remained to be relatively invariable and a significant reduction only occurred in very high concentrations of metals (>0.1 mg L⁻¹). The general effect of salinity on metal behavior was to decrease the degree of adsorption of Cu, Zn, Cd, Co, and Ni onto SPM but to increase their adsorption equilibrium pH. The adsorption–desorption kinetics of trace metals were further investigated using Kurbatov adsorption model. The model appears to be most useful for the metals showing the conservative behavior during mixing of river and seawater in the estuary. Our work demonstrates that dissolved concentration of trace metals in estuary can be modeled based on the metal concentration in SPM, pH and salinity using a Kurbatov adsorption model assuming the natural SPM as a simple surfaced molecule.     

Use of sinkhole and specific capacity distributions to assess vertical gradients in a karst aquifer

The carbonate-rock aquifer in the Great Valley, West Virginia, USA, was evaluated using a database of 687 sinkholes and 350 specific capacity tests to assess structural, lithologic, and topographic influences on the groundwater flow system. The enhanced permeability of the aquifer is characterized in part by the many sinkholes, springs, and solutionally enlarged fractures throughout the valley. Yet, vertical components of subsurface flow in this highly heterogeneous aquifer are currently not well understood. To address this problem, this study examines the apparent relation between geologic features of the aquifer and two spatial indices of enhanced permeability attributed to aquifer karstification: (1) the distribution of sinkholes and (2) the occurrence of wells with relatively high specific capacity. Statistical results indicate that sinkholes (funnel and collapse) occur primarily along cleavage and bedding planes parallel to subparallel to strike where lateral or downward vertical gradients are highest. Conversely, high specific capacity values are common along prominent joints perpendicular or oblique to strike. The similarity of the latter distribution to that of springs suggests these fractures are areas of upward-convergent flow. These differences between sinkhole and high specific capacity distributions suggest vertical flow components are primarily controlled by the orientation of geologic structure and associated subsurface fracturing.     

GIS-based colour composites and overlays to delineate heavy metal contamination zones in the shallow alluvial aquifers, Ankaleshwar industrial estate, south Gujarat, India

In an attempt to delineate heavy metal contamination precincts and to evaluate the extent and degree of toxic levels, besides their possible sources, 38 water samples from Ankaleshwar Industrial Estate, south Gujarat, India were analyzed. By clutching geochemical analyses and GIS-based colour composites areas depicting anomalously high concentration of heavy metals (Mo, Zn, Pb, Ni, Co, Cd, etc.) in the groundwater were revealed. The multicomponent overlays in grey-scale facilitated in identifying situates of heavy metal ‘hot spots’, and lateral protuberances of the contamination plume around defile stretch of the main stream Amla Khadi flowing through the area. The multiple pollution plumes emerging from other parts of the area further coincide with effluent laden streams and small channels indicating industrial establishments as major sources of groundwater contamination. Influent nature of the streams, accelerated infiltration process, high mass influx and shallow groundwater table are the factors conducive for easy access of heavy metals to the phreatic aquifers affecting over 20 km² area. On the basis of P/U ratios (concentration of metals in polluted water to unpolluted water), geogenic and anthropogenic sources have been identified. Very high levels of technogenic elements present in the ground water raise concerns about possible migration into food crops, as the area is an important horticultural locale and is highly cultivated.     

Soil contamination from urban and industrial activity: example of the mining district of Linares (southern Spain)

The Linares region (southern Spain) has been subjected to two important sources of pollution: the intensive mining works and the urban-industrial activity. To obtain a geochemical characterisation of the soil, 31 trace elements were analysed and 669 soil samples were collected. By means of clustering analysis, we identified groups of elements and grid squares in which relations could be established concerning soil lithology, urban and industrial activities and the degree of pollution impact; in addition, we were able to characterise the geochemical background of the study area. The multivariate study led us to identify four factors. Particularly important was factor 2, which represented the elements associated with mineral paragenesis (Cu, Pb, As, Co, Mn, Zn, Sn, Ba). This factor also contains elements related with an urban-industrial activity, such as Pb, Cu, Zn, As and Ba. Furthermore, we identified factor 4, associating Ni, V and Cr, and which is related to the use of fuels.     

Impact evaluation on groundwater of the infiltration of an urban wastewater geopurification system placed over a detrital aquifer in a semiarid region (Spain)

Over a period of 4 years and 4 months, the geopurification installations at Dehesas de Guadix (Granada, Spain) were monitored to determine the impact on soil and groundwater of the controlled discharge of urban wastewater, and also to identify the best indicators of the entry of the recharged water into the aquifer. The installations are located in an area where the climate is Mediterranean sub-arid, with an average precipitation of less than 287 mm/year, and a rate of evapotranspiration that is almost three times greater. The system was controlled by determining the balance of majority nutrients and boron in the soil and in the groundwater, both at the points affected directly by the wastewater discharge and at others. The quantity of mass discharged was relatively large (COD 14,656 g/m², NO₃ 85 g/m², NO₂ 4 g/m², NH₄ 2,425 g/m², PO₄ 1,143 g/m², K 1,531 g/m², B 63 g/m²). It was observed that the elimination of nutrients within the soil (COD 97.5%, PO₄ 94.4%, K 59.17%, N _total 18.8%, B 12.69%) was very efficient except for the nitrogen, which nevertheless did not reach the groundwater, as it was eliminated at deep levels of the unsaturated zone. Only 12.69% of the boron was removed, and appreciable, increasing amounts of this element did reach the groundwater. Unexpectedly, none of the majority nutrients behaved as a reliable indicator of the impact on groundwater; despite this, the boron and the bicarbonate did clearly reflect the arrival of the recharged water, and are proposed as the best indicators.     

A comparative study of four vulnerability mapping methods in a detritic aquifer under mediterranean climatic conditions

This paper presents the results of a comparative study relating to the application of four vulnerability mapping methods, GOD, AVI, DRASTIC and SINTACS, in a pilot detritic aquifer situated in NW Morocco, known as the Martil–Alila aquifer. The principal objective of this work is to determine the most suitable such methods for this aquifer type within a Mediterranean context, and to show the effect of the rainfall variations that are characteristic of the Mediterranean climate on the degree of vulnerability. The methods applied distinguish five classes of vulnerability, these being irregularly divided up in space, with the division varying according to the method in question. The vulnerability maps obtained by the different methods strongly suggest that the eastern half of the aquifer is more vulnerable to contamination than the western half, for all hydrological situations. The effect of climatic conditions on the degree of vulnerability is well represented by the DRASTIC, according to which the aquifer is moderately to strongly vulnerable during humid hydrological years and weakly to moderately vulnerable during dry ones. For the other methods, this climatic effect is limited to the area occupied by the two predominant classes (“High” and “Low” for GOD and “High” and “Moderate” for SINTACS) while it is null for AVI. In conclusion, DRASTIC appears the most suitable for mapping the vulnerability to contamination of Mediterranean coastal detritic aquifers such as the Martil–Alila aquifer.     

Doline probability map using logistic regression and GIS technology in the central Ebro Basin (Spain)

In the surroundings of Zaragoza, karstification processes are especially intense in covered karst areas where fluvial terraces lie directly on Tertiary evaporites. Since the beginning of Quaternary, these processes have lead to the development of collapse and subsidence dolines with a wide range of sizes, which have significant economic impacts. To reduce economic impact and increase safety, a regional analysis of this phenomenon is needed for spatial management. Therefore, a probability map of dolines was developed using logistic regression and geographic information system (GIS) techniques. This paper covers the selection of input data, manipulation of data using the GIS technology, and the use of logistic regression to generate a doline probability map. The primary variable in the doline development in this area is geomorphology, represented by the location of endorheic areas and different terrace levels. Secondary variables are the presence of irrigation and the water table gradient.     

Space–time distribution of ancient and active alluvial karst subsidence: examples from the central Ebro Basin,Spain

Space and time variations of alluvial karst subsidence in the central Ebro Basin are analysed in trenches (paleodolines), aerial photographs (historical dolines) and field surveys (present-day active dolines). The measured subsidence rates, as well as a comparison between densities of paleodolines computed in randomly selected scan-lines and density of active dolines computed in maps, suggest that present-day subsidence in favourable areas is more intense than that of Pleistocene times. According to diachronic maps drawn from (a) different aerial photographs taken after 1946 and (b) field surveys on deformations in urbanized areas, subsidence behaved as a nearly steady process while the whole area was used for agriculture. In contrast, rapid changes (through periods of several tens of years) have occurred in urbanized areas, in which dolines expand their boundaries through small marginal collapses, shifting sharply their sinking centres to neighbouring sites. These rapid changes do not have an equivalent in observed paleodolines.     

Suitability analysis for sand and gravel extraction site location in the context of a sustainable development in the surroundings of Zaragoza (Spain)

Zaragoza city is located in the central Ebro Basin, in the Iberian Peninsula. The fluvial terraces formed by the Ebro River present a valuable resource of sand and gravel deposits. However, taking advantage of these available resources implies conflicts with other land use interests like urban and industrial development as well as agricultural use, which has also traditionally occupied the alluvial terraces. These deposits represent a substantial groundwater resource that should be preserved for future generations. The development of spatial decision support systems (SDSS) has greatly assisted efforts for solving land-use conflicts. These systems combine the benefits of geographic information systems (GIS) and decision support methodologies and are therefore suitable to manage sustainable development of urban areas. In this contribution, an extraction suitability map taking into consideration a variety of environmental criteria is created with the help of a SDSS. The method used is the analytical hierarchy process which is integrated in ArcGIS. Areas most suitable to sand and gravel extraction are located in the high terraces, and in those terraces covered by pediments where the thickness of resource is relatively high. These areas are far from valuable natural areas, outside areas most vulnerable to groundwater contamination, and beneath soils with poor irrigation characteristics.