Thermal Conductivity of Argillaceous Rocks: Determination Methodology Using In Situ Heating Tests

This study focuses on the characterisation of thermal conductivity for three potential host rocks for radioactive waste disposal. First, the heat conduction process is reviewed on the basis of an analytical solution and key aspects related to anisotropic conduction are discussed. Then the existing information on the three rocks is summarised and a broad uncertainty range of thermal conductivity is estimated based on the mineralogical composition. Procedures to backanalyse the thermal conductivity on the basis of in situ heating tests are assessed and a methodology is put forward. Finally, this methodology is used to estimate the impact of experimental uncertainties and applied to the four in situ heating tests. In the three potential host rocks, a clear influence of the bedding planes was identified and anisotropic heat conduction was shown to be necessary to interpret the observed temperature field. Experimental uncertainties were also shown to induce a larger uncertainty on the anisotropy ratio than on the equivalent thermal conductivity defined as the geometric mean of the thermal conductivity in the three principal directions.     

A double structure generalized plasticity model for expansive materials

The constitutive model presented in this work is built on a conceptual approach for unsaturated expansive soils in which the fundamental characteristic is the explicit consideration of two pore levels. The distinction between the macro‐ and microstructure provides the opportunity to take into account the dominant phenomena that affect the behaviour of each structural level and the main interactions between them. The microstructure is associated with the active clay minerals, while the macrostructure accounts for the larger‐scale structure of the material. The model has been formulated considering concepts of classical and generalized plasticity theories. The generalized stress–strain rate equations are derived within a framework of multidissipative materials, which provides a consistent and formal approach when there are several sources of energy dissipation. The model is formulated in the space of stresses, suction and temperature; and has been implemented in a finite element code. The approach has been applied to explaining and reproducing the behaviour of expansive soils in a variety of problems for which experimental data are available. Three application cases are presented in this paper. Of particular interest is the modelling of an accidental overheating, that took place in a large‐scale heating test. This test allows the capabilities of the model to be checked when a complex thermo‐hydro‐mechanical (THM) path is followed. Copyright © 2005 John Wiley & Sons, Ltd.     

The end of the Messinian Salinity Crisis in the western Mediterranean: Insights from the carbonate platforms of south-eastern Spain

How the Messinian Salinity Crisis (MSC) ended is still a matter of intense debate. The Terminal Carbonate Complex (TCC) is a late Messinian carbonate platform system that recorded western Mediterranean hydrological changes from the final stages of evaporite deposition till the advent of Lago-Mare fresh- to brackish water conditions at the very end of Messinian times. A multidisciplinary study has been carried out in three localities in south-eastern Spain to reconstruct the history of TCC platforms and elucidate their significance in the MSC. Overall, this study provides evidence that the TCC formed following a regional 4th order water level rise and fall concomitant with an opening-restriction trend. It can be subdivided into four 5th order depositional sequences (DS1 to DS4) recording two phases: (1) from DS1 to DS3, a tide-dominated ooidic to oobioclastic system with stenohaline faunas developed as a result of a 70 m water level rise. During this period, the TCC developed in a shallow sea with close to normal marine salinity; (2) in depositional sequence 4, a microbialite-dominated platform system developed. This is indicative of a significant environmental change and is attributed to a 30 to 40 m water level fall in the basins under study. These restricted conditions were coeval with intense evaporite deformation and brine recycling. The syn-sedimentary deformation of evaporites had a major impact on platform architecture and carbonate production, affecting the Messinian series throughout south-eastern Spain at the end of the TCC history. At that time, the TCC developed in a lake with fluctuating, brackish- to hypersaline water. These findings suggest a temporary restoration of marine conditions in the western Mediterranean marginal basins due to Atlantic water influxes prompted by a global sea level rise around 5.6 Ma. Whether marine conditions extended to the entire western Mediterranean still needs to be investigated.     

Experimentally determined biomediated Sr partition coefficient for dolomite: Significance and implication for natural dolomite

Two strains of moderately halophilic bacteria were grown in aerobic culture experiments containing gel medium to determine the Sr partition coefficient between dolomite and the medium from which it precipitates at 15 to 45 °C. The results demonstrate that Sr incorporation in dolomite does occur not by the substitution of Ca, but rather by Mg. They also suggest that Sr partitioning between the culture medium and the minerals is better described by the Nernst equation (D_Sr^dol = Sr_dol/Sr_bmi), instead of the Henderson and Kracek equation (D_Sr^dol = (Sr/Ca)_dol/(Sr/Ca)_solution. The maximum value for D_Sr^dol occurs at 15 °C in cultures with and without sulfate, while the minimum values occur at 35 °C, where the bacteria exhibit optimal growth. For experiments at 25, 35 and 45 °C, we observed that D_Sr^dol values are greater in cultures with sulfate than in cultures without sulfate, whereas D_Sr^dol values are smaller in cultures with sulfate than in cultures without sulfate at 15 °C.Together, our observations suggest that D_Sr^dol is apparently related to microbial activity, temperature and sulfate concentration, regardless of the convention used to assess the D_Sr^dol. These results have implications for the interpretation of depositional environments of ancient dolomite. The results of our culture experiments show that higher Sr concentrations in ancient dolomite could reflect microbial mediated primary precipitation. In contrast, previous interpretations concluded that high Sr concentrations in ancient dolomites are an indication of secondary replacement of aragonite, which incorporates high Sr concentrations in its crystal lattice, reflecting a diagenetic process.     

Geothermometry, geochronology, and mass transfer associated with hydrothermal alteration of a rhyolitic hyaloclastite from Ponza Island, Italy

A rhyolitic hyaloclastite from Ponza Island, Italy, was hydrothermally altered, producing four distinct alteration zones based on X-ray diffraction mineralogy and field textures: (1) nonpervasive argillic zone; (2) propylitic zone; (3) silicic zone; and (4) sericitic zone. The unaltered hyaloclastite is volcanic breccia with clasts of vesiculated obsidian in a matrix of predominantly pumice lapilli. Incomplete alteration of the hyaloclastite resulted in the nonpervasive argillic zone, characterized by smectite and disordered opal-CT. The other three zones exhibit more complete alteration of the hyaloclastite. The propylitic zone is characterized by mixed-layer illite-smectite (I-S) with 10 to 85% I, mordenite, opal-C, and authigenic K-feldspar (akspar). The silicic zone is characterized by I-S with ≥90% I, pure illite, quartz, akspar, and occasional albite. The sericitic zone consists primarily of I-S with ≥66% I, pure illite, quartz, and minor akspar and pyrite. K/Ar dates of I-S indicate hydrothermal alteration occurred at 3.38 ± 0.08 Ma.Oxygen isotope compositions of I-S systematically decrease from zones 1 to 4. In the argillic zone, smectite has δ¹⁸O values of 21.7 to 22.0‰ and I-S from the propylitic, silicic, and sericitic zones ranges from 14.5 to 16.3‰, 12.5 to 14.0‰, and 8.6 to 11.9‰, respectively. δ¹⁸O values for quartz from the silicic and sericitic zones range from 12.6 to 15.9‰. By use of isotope fractionation equations and data from authigenic quartz-hosted primary fluid inclusions, alteration temperatures ranged from 50 to 65°C for the argillic zone, 85 to 125°C for the propylitic zone, 110 to 210°C for the silicic zone, and 145 to 225°C for the sericitic zone. Fluid inclusion data and calculated δ¹⁸O_water values indicate that hydrothermal fluids were seawater dominated.Mass-transfer calculations indicate that hydrothermal alteration proceeded in a relatively open chemical system and alteration in the sericitic zone involved the most extensive loss of chemical species, especially Si. Systematic gains in Mg occur in all alteration zones as a result of I-S clay mineral formation, and systematic losses of Na, Ca, and K occur in most zones. With the exception of Ca, calculations of mass transfer associated with hydrothermal alteration on Ponza agree with chemical fluxes observed in laboratory experiments involving hydrothermal reactions of rhyolite and seawater. The anomalous Ca loss at Ponza may be due to hydrothermal formation of anhydrite and later low-temperature dissolution. On the basis of Mg enrichments derived from circulating seawater, we estimate the following minimum water/rock ratios: 9, 3, 6, and 9 for the argillic, propylitic, silicic, and sericitic zones, respectively. Hydrothermal fluid pH for the propylitic and silicic zones was neutral to slightly basic and relatively acidic for the sericitic zone as a result of condensation of carbonic and perhaps other acids.     

Abbassamento elettroosmotico della superficie piezometrica in un suolo saturo d'acqua

Riassunto Si studia il fenomeno di elettroprosciugamento di un terreno, in un caso particolare di disposizione elettrodica (piano-parallela, e parallela alla superficie del suolo), con particolare riguardo all'abbassarsi nel tempo del limite fra terreno saturo d'acqua e terreno asciutto. Si scrivono formule che forniscono i tempi di prosciugamento, e l'espressione dell'energia elettrica assorbita dal processo.

---

Summary In present paper the A. deals with the electro-drainage phenomenon, on account of a particular distribution of the electrodes (plane-parallel, and parallel to soil surface), in regard chiefly to the lowering, relative to time, of the boundary between the zone of water-saturated soil and the zone of dry soil. Formulae are given in order to evaluate the duration of electro-drainage and the amount of electric energy taken over by the process.

     

Geotechnical characterization of the upper Pleistocene–Holocene alluvial deposits of Roma (Italy) by means of multivariate geostatistics: Cross-validation results

We are presenting an attempt to evaluate the spatial variability of geotechnical parameters in the upper Pleistocene–Holocene alluvial deposits of Roma (Italy) by means of multivariate geostatistics.The upper Pleistocene–Holocene alluvial deposits of Roma are sensitive to high levels of geohazard. They occupy a sizable and significant part of the city, being the foundation for many monuments, historical neighborhoods, and archaeological areas, and the main host of the present and future subway lines. We have stored information from more than 2000 geotechnical boreholes crossing the alluvial deposits into a relational database. For the present study, only the boreholes with lithologic/textural interpretation and geotechnical information were selected. The set includes 283 boreholes and 719 samples, which have a set of geotechnical information comprising physical properties and mechanical parameters.Techniques of multivariate statistics and geostatistics were combined and compared to evaluate the estimation methods of the mechanical parameters, with special reference to the drained friction angle from direct shear test (φ′). Principal Component Analysis was applied to the dataset to highlight the relationships between the geotechnical parameters. Through cross-validation analysis, multiple linear regression, kriging, and cokriging were tested as estimators of φ′. Cross-validation demonstrates that the cokriging with granulometries as auxiliary variables is the most suitable method to estimate φ′. In addition to proving that cokriging is a good estimator of φ′, cross-validation demonstrates that input data are coherent and this allows us to use them for estimation of geotechnical parameters, although they come from different laboratories and different vintages.Nevertheless, to get the same good results of cross-validation in estimation, it is necessary for granulometries to be available at grid points. Since this information being not available at all grid points, it is expected that, in the future, textural information can be derived in an indirect way, i.e., from lithologic/textural spatial reconstructions.     

Survival of crucian carp,Carassius carassius,exposed to a high low-molecular weight inorganic aluminium challenge

Crucian carp were exposed to three combinations of pH and inorganic aluminium concentrations for 25 days. Mortality, plasma chloride and haematocrit, and gill aluminium content were investigated. No mortality was observed in any of the three exposures. Crucian carp survived acidic Al-rich water (pH 5.17) with a high concentration of low-molecular weight inorganic Al species (242 µgl^–1) for 25 days. These fish had lowered plasma chloride levels and high amounts of aluminium on their gills compared to fish exposed to acidic Al-poor water (pH 5.16 and 12 µgl^–1 Al_i) and control water (pH 6.29 and 4 µgl^–1 Al_i). Haematocrit was the same in all three exposures. Because aluminium was not acutely toxic to the anoxia tolerant crucian carp, the present results give support to the hypothesis that Al polymerization with subsequent hypoxia is of high importance for the mechanism of acute Al toxicity to fish.     

Periodic Orbits Around Geostationary Positions

We generate families of planar periodic orbits emanating from the geostationary points, both stable and unstable. We show that, even for the unstable points, it is possible to have stable periodic orbits.This revised version was published online in October 2005 with corrections to the Cover Date.     

Flooding scenarios due to land subsidence and sea‐level rise: a case study for Lipari Island (Italy)

Archaeological and instrumental data indicate that the southern sector of the volcanic island of Lipari has been subsiding for the last 2100 years due to isostatic and tectonic factors, at variable rates of up to ~11 mm a^?1. Based on this data, a detailed marine flooding scenario for 2100 AD is provided for the bay of Marina Lunga in the eastern part of the island from (1) an ultra‐high‐resolution Digital Terrain and Marine Model (DTMM) generated from multibeam bathymetry (MB) and Unmanned Aerial Vehicles (UAV), (2) the rate of land subsidence from Global Positioning System (GPS) data and (3) the regional sea‐level projections of the International Panel on Climate Change (IPCC). When land subsidence is considered, the upper bound of sea‐level rise is estimated at 1.36 m and 1.60 m for RCP4.5 and RCP8.5 climate change scenarios, respectively. Here, we show the expected impact of marine flooding at Lipari for the next 85 years and discuss the hazard implications for the population living along the shore.