Short-term beach–dune sand budgets on the north sea coast of France: Sand supply from shoreface to dunes, and the role of wind and fetch

Three experimental plots, covering the transition from the upper beach to the dune, on the North Sea coast of France were monitored at various intervals over a period of 18–24 months via high resolution terrain surveys in order to determine inter-site sand budget variability, as well as patterns and processes involved in sand exchanges between the upper beach and dune. The wind regime consists of a fairly balanced mix of moderate (80% of winds are below 8 m/s) onshore, offshore and shore-parallel winds. Sustained dune accretion over several years depends on the periodic local onshore welding of shoreface tidal banks that have developed in the storm- and tide-dominated setting of the southern North Sea. The only site where this has occurred in the recent past is Calais, where bank welding has created a wide accreting upper beach sand flat. At this site, significant sand supply from the subtidal sand bank reservoir to the upper beach flat occurred only once over the 18-month survey following a major storm. The bulk of the sand deposited over this large flat is not directly integrated into the adjacent embryo dunes by onshore winds but is progressively reworked in situ into developing dunes or transported alongshore by the balanced wind regime, thus resulting in alongshore stretching of the embryo dune system. The Leffrinckoucke site near Belgium shows moderate beach–dune mobility and accretion, while the Wissant site exhibits significant upper beach bedform mobility controlled by strong longshore currents that result in large beach budget fluctuations with little net budget change, to the detriment of the adjacent dunes. Accretion at these two sites, which are representative of the rest of the North Sea coast of France, is presently constrained by the absence of a shore-attached sand bank supply reservoir, while upper beach–dune sand exchanges are further limited by the narrow wave-affected upper beach, the intertidal morphology of bars and troughs which segments the aeolian fetch, and the moderate wind energy conditions. The balanced wind regime limits net sand mobilisation in favour of either the beach or the dune, and may explain the relatively narrow longshore morphology of the dune ridges bounding this coast.     

Geomorphic effects of rural-to-urban land use conversion on three streams in the Central Redbed Plains of Oklahoma

This research evaluates the impact of rural-to-urban land use conversion on channel morphology and riparian vegetation for three streams in the Central Redbed Plains geomorphic province (central Great Plains ecoregion) of Oklahoma. The Deep Fork Creek watershed is largely urbanized; the Skeleton Creek watershed is largely rural; and the Stillwater Creek watershed is experiencing a rapid transition from rural to urban land cover. Each channel was divided into reaches based on tributary junctions, sinuosity, and slope. Field surveys were conducted at transects in a total of 90 reaches, including measurements of channel units, channel cross-section at bankfull stage, and riparian vegetation. Historical aerial photographs were available for only Stillwater Creek watershed, which were used to document land cover in this watershed, especially changes in the extent of urban areas (impervious cover).The three streams have very low gradients (< 0.001), width-to-depth ratios < 10, and cohesive channel banks, but have incised into red Permian shales and sandstone. The riparian vegetation is dominated by cottonwoods, ash, and elm trees that provide a dense root mat on stream banks where the riparian vegetation is intact. Channels increased in width and depth in the downstream direction as is normally expected, but the substrate materials and channel units remained unchanged. Statistical analyses demonstrated that urbanization did not explain spatial patterns of changes in any variables. These three channels in the central Redbed Plains are responding as flumes during peak flows, funneling runoff and the wash-load sediment downstream in major runoff events without any effect on channel dimensions. Therefore, local geological conditions (similar bedrock, cohesive substrates and similar riparian vegetation) are mitigating the effects of urbanization.     

基于神经网络的单元自动机CA及真实和忧化的城市模拟

提出了一种基于神经网络的单元自动机（ＣＡ）。ＣＡ已被越来越多地应用在城市及其它地理现象的模拟中。ＣＡ模拟所碰到的最大问题是如何确定模型的结构和参数。模拟真实的城市涉及到使用许多空间变量和参数。当模型较复杂时，很难确定模型的参数值。本模型的结构较简单，模型的参数能通过对神经网络的训练来自动获取。分析表明，所提出的方法能获得更高的模拟精度，并能大大缩短寻找参数所需要的时间。通过筛选训练数据，本模型还可以进行优化的城市模拟，为城市规划提供参考依据。     

Drainage, sediment transport, and denudation rates on the Nanga Parbat Himalaya, Pakistan

The Nanga Parbat Himalaya presents some of the greatest relief on Earth, yet sediment production and denudation rates have only been sporadically addressed. We utilized field measurements and computer models to estimate bank full discharge, sediment transport, and denudation rates for the Raikot and Buldar drainage basins (north slope of Nanga Parbat) and the upper reach of the Rupal drainage basin (south slope).The overall tasks of determining stream flow conditions in such a dynamic geomorphic setting is challenging. No gage data exist for these drainage basins, and the overall character of the drainage basins (high relief, steep flow gradients, and turbulent flow conditions) does not lend itself to either ready access or complete profiling.Cross-sectional profiles were surveyed through selected reaches of these drainage basins. These data were then incorporated into software (WinXSPRO) that aids in the characterization (stage, discharge, velocity, and shear stress) of high altitude, steep mountain stream conditions.Complete field measurements of channel depths were rarely possible (except at several bridges where the middle of the channel could actually be straddled and probed) and, when coupled with velocity measurements, provided discrete points of field-measured discharge calculations. These points were then used to calibrate WinXSPRO results for the same reach and provided a confidence level for computer-generated results.Flow calculations suggest that under near bank full conditions, the upper Raikot drainage basin produces discharges of 61 cm and moves about 11,000 tons day⁻¹ (9980 tons day⁻¹) of sediment through its channel. Bank full conditions on the upper portion of the Rupal drainage basin generate discharges of 84 cm and moves only about 3800 tons day⁻¹ (3450 tons day⁻¹) of sediment. Although the upper Rupal drainage basin moves more water, the lower slope of the drainage basin (0.03) generates a much smaller shear stress (461 Pa) than does the higher slope (0.12) of the upper Raikot drainage basin (1925 Pa).Dissolved and suspended sediment loads were measured from water/sediment samples collected throughout the day and night over a period of 10 days at the height of the summer melt season but proved to be a minor variable in transport flux. Channel bed loads were measured using a pebble count method of bank material and then used to generate ratings curves of bed loads relative to discharge volumes. When coupled with discharge data and basin area, mean annual sediment yield and denudation rates for Nanga Parbat are produced. Denudation rates calculated in this fashion range from 0.2 mm year⁻¹ in the slower, more sluggish Rupal drainage basin to almost 6 mm year⁻¹ in the steeper, faster flowing Raikot and Buldar drainage basins.     

A review of the physics and ecological implications of the thermal bar circulation

Following recent applications of numerical modelling and remote sensing to the thermal bar phenomenon, this paper seeks to review the current state of knowledge on the effect of its circulation on lacustrine plankton ecosystems. After summarising the literature on thermal bar hydrodynamics, a thorough review is made of all plankton observations taken in the presence of a thermal bar. Two distinct plankton growth regimes are found, one with production favoured throughout the inshore region and another with a maximum in plankton biomass near the position of the thermal bar. Possible explanations for the observed distributions are then discussed, with reference to numerical modelling studies, and the scope for future study of this interdisciplinary topic is outlined.     

Petrogenesis of the Greenhills Complex,Southland, New Zealand: magmatic differentiation and cumulate formation at the roots of a Permian island-arc volcano

A Permian (~265 Ma) intrusive complex which formed as a magmatic feeder reservoir to an immature island-arc volcano is fortuitously exposed in southern New Zealand. Known as the Greenhills Complex, this intrusion was emplaced at shallow crustal levels and consists of two layered bodies which were later intruded by a variety of dykes. Cumulates, which include dunite, olivine clinopyroxenite, olivine gabbro, and hornblende gabbro-norite, are related products of parent-magma fractionation. Both primary (magmatic) and secondary platinum-group minerals occur within dunite at one locality. Using the composition of cumulus minerals, mafic dykes and melt inclusions, we have determined that the parent magmas of the complex were hydrous, low-K island-arc tholeiites of ankaramitic affinities. Progressive magmatic differentiation of this parent magma generated fractionated melt of high-alumina basalt composition which is now preserved only as dykes which cut the Complex. Field evidence and cumulus mineral profiles reveal that the magma chambers experienced turbulent magmatic conditions during cumulate-rock formation. Recharge of the chambers by primitive magma is likely to have coincided with eruption of residual melt at the surface. Similar processes are inferred to account for volcanic-rock compositions in other parts of this arc terrane and in modern island-arc systems.     

Oxygen isotope composition and geothermometry of granulite to greenschist facies metamorphic rocks: a study from the Neoproterozoic collision-related nappe system, south of São Francisco Craton, SE Brazil

Oxygen isotope studies were carried out across units of a Neoproterozoic nappe system, south of São Francisco Craton. A temperature decrease toward the base of the system is found, consistent with a previously recognized inverted metamorphic pattern. The tectonic contact of the basal unit and the reworked southern São Francisco craton show a steep temperature gradient, suggesting that low temperature thrusting acted as the dominant tectonic process. The contrasts between the δ¹⁸O values of the Três Pontas-Varginha and Carmo da Cachoeira nappes and the differences among the samples and minerals are consistent with the preservation of sedimentary isotopic composition during metamorphism. The small differences in the δ¹⁸O values between the undeformed and the deformed calc-silicate samples (1.6‰) suggest that the δ¹⁸O value of mylonitization fluids was close to that which equilibrated with the metamorphic assemblage. The distinct δ¹⁸O values of metapelitic and calc-silicate samples and the great temperature difference from one type to the other indicate that no large-scale fluid interaction processes occurred during metamorphism. Oxygen isotopic estimations of both Três Pontas-Varginha undeformed rocks and Carmo da Cachoeira unaltered equivalents indicate δ¹⁸O values of up to 18‰. Comparison between these values and those from the ‘basement’ orthogneisses (8.3–8.5‰) indicates the latter are not sources for the metapelites.