The motion of a 9.1 m yacht hull buoy moored in open sea

A 9.1 m yacht hull was instrumented to measure its three-dimensional motion when moored in the open sea. The hull was deployed on three occasions for a total period of about 2 months and encountered a wide range of wind-wave conditions including a strong gale. The data have been analysed to give the response for each component of motion in terms of amplitude and relative phases. The hull motion is compared spectrally to the waves observed by a nearby Waverider. The hull was found to behave as a surface-keyed buoy, with a well defined response for a wide range of conditions. The presence of a resonance in pitch and roll is evident in the data with typical rms values being 5° and 10°, respectively, for significant wave height of 5 m. From data on the mooring dynamics it is concluded that the peaks observed in the tension are a result of the viscous drag opposing the change in the catenary of the mooring and the slow drift oscillations of the buoy. This type of hull is a versatile and economical candidate as a platform for meteorological and oceanographic instrumentation.     

Heat flow and mass wasting in the Wilmington Canyon Region: U.S. Continental Margin

The average corrected heat flow in the Wilmington Canyon region, an area of inferred slope instability, is 35 ± 10 mW/m². This average heat flow is marginally consistent with the 46 ± 9 mW/m² measured at other North Atlantic sites over 160 m.y. old. High topographic relief causes most of the variability in surface heat flow and may lower the mean surface heat flow. There is no significant difference between the average corrected heat flow of 35 ± 10 mW/m² in sediment slide areas and the average corrected heat flow of 34 ± 10 mW/m² in undisturbed sediments.     

Behavioural Effects of Chemically Dispersed Oil and Subsequent Recovery in Diploria strigosa (Dana)

Abstract. Survival and behaviour of the hermatypic coral Diploria strigosa was studied during 6–24 h doses with water-accomodated fractions of chemically dispersed crude oil, and for a subsequent recovery period of 1 month. Experiments utilized a flow-through laboratory dosing procedure and incorporated petroleum hydrocarbon measurements in order to simulate a major but short-term oil spill in shallow subtidal benthic reef environments. Chemically dispersed oil treatments consisted of Arabian Light Crude oil with Corexit 9527 or BP1100WD at 1–20 ppm concentrations of oil.
In general, effects observed were sub-lethal, temporary, and associated with the highest concentrations tested. Responses to the presence of dispersed oil at 20ppm for 24 h included mesenterial filament extrusion, extreme tissue contraction, tentacle retraction and localized tissue rupture. The nature and severity of reactions during the dosing phase varied between colonies and treatments, but colonies typically resumed normal behaviour within 2 h to 4 d of the recovery period. It therefore seems unlikely that observed biological effects would impair long-term viability.     

Population structure of Haliotis rubra from South Australia inferred from nuclear and mtDNA analyses

1Introduction ThemajorityofAustralia’sabalonefisheryex ports(5.135kt,worth＄216millionin2002～2003,ABARE2004)consistofblacklipabalone(HaliotisrubraLeach,1814).AssuchH.rubrais consideredasanimportantmarineresourcewithin Australia.Likemanyabalonespecieswor…     

Optimizing interpolation of shoot density data from a Posidonia oceanica seagrass bed

A case study on the optimization of Posidonia oceanica density interpolation, using a data set from a large meadow at Porto Conte Bay (NW Sardinia, Italy), is presented. Ordinary point kriging, cokriging and a weighted average based on inverse square distance were used to interpolate density data measured in 36 sampling stations. The results obtained from different methods were then compared by means of a leave‐one‐out cross‐validation procedure. The scale at which interpolation was carried out was defined on the basis of the Hausdorff dimension of the variogram. Optimizing spatial scale and data points search strategy allowed obtaining more accurate density estimates independently of the interpolation method.     

Measurement of alkaline and earthy ions in fish otolith and sea water using a high performance ion chromatography

Fish growth and the relation between growth and environmental conditions offer a good opportunity for measuring alkaline and earthy ions in fish otoliths.The analytical method must involve high sensitivity when attempting to discriminate between fish growth and environmental conditions.The aim of this paper is to propose a chromatographic method, with low detection limits, as a new approach in determining some important micronutrients present in sea water and fish otoliths.The work samples are: coastal, off-shore and sediment waters and fish otoliths (Engraulis encrasicholus, Mullus barbatus, Umbrina cirrhosa, Sciaena umbra, Pagellus erythrinus) in the Adriatic Sea and the Canal of Sicily.The analytical method includes an IONPAC CS12A chromatographic column and a 18 mM methanesulfonic acid eluent.The detection limit readings obtained with this method, for one E. encrasicholus fish otolith, weighing 2.6 mg are equal or inferior to 0.1 μg/L for lithium (Li), 59 μg/L for sodium (Na), 46 μg/L for ammonium (NH₄), 23 μg/L for potassium (K), 13 μg/L for magnesium (Mg), 88 μg/L for manganese (Mn), 2.567 μg/L for calcium (Ca) and 13 μg/L for strontium (Sr).The HPIC method minimizes overlaps such as Na on Li, and NH₄ in seawater and Ca on Mg and Sr in fish otolith. These elements are an essential constituent present in otoliths when describing the relation between growth and environmental conditions.Good separation among analytes is achieved within 16 min.     

Input of atmospheric lead to marine sediments in a south-east Pacific coastal area (approximately 36 degrees S)

Atmospheric input of Pb to coastal sediments in the south-east Pacific (approximately 36 degrees S) was estimated using: (1) a salt marsh (non-local emission sources) as a natural collector of atmospheric fluxes and (2) Pb concentrations in rain and air samples, both considered to be representative of the atmospheric input in the study area. A radioisotopic geochronology technique ((210)Pb) was used to estimate the total Pb atmospheric supply to the sediments. The results show that atmospheric input to Concepción Bay accounts for 13-68% of Pb in near shore sediments, evaluated through salt marsh and rain, both showing comparable results. Consequently, there are other relevant Pb sources to explain the higher concentrations in this area. Sediments in the shelf are subject to important influence of upwelling waters, estimated by Salamanca [Sources and sinks of (210)Pb in Concepción Bay, Chile (1993) PhD thesis, Marine Science Research Center, State University of New York at Stony Brook, USA] using (210)Pb. The atmospheric input, however, is mainly responsible for the total Pb input, since the salt marsh (natural atmospheric collector) shows similar Pb(xs) inventories than the shelf, corresponding to a regional-scale Pb emissions.