东中国海黑潮海洋锋的季节变化特征及其成因

利用高分辨率海洋和大气再分析资料研究了东中国海黑潮海洋锋的季节变化特征及其成因。研究表明,东海黑潮海洋锋存在明显的季节变化,从冬季到次年春季逐渐增强,并在春季达到最强,初夏以后强度逐渐减弱,9—10月达到全年最弱。通过诊断混合层热流量方程发现,东海黑潮区一年四季均表现为暖的温度平流,有利于海洋锋的形成和维持,该暖平流也存在季节变化并在春季达到最大,对海洋锋在春季达到最强起了重要作用。海气界面净热通量在秋冬季对海洋锋的形成有促进作用,有利于海洋锋增强,而在春夏季则起抑制作用,促进海洋锋消亡。温度垂直输送全年对海洋锋起一定程度的抑制作用。总之,在海温水平平流和海表净热通量的共同作用下导致海洋锋春季达到最强,而夏秋季海表净热通量和温度垂直输送作用的共同作用致使海洋锋减弱并最后消失。因此,海洋的动力和热力共同作用导致了东海黑潮海洋锋的季节变化,其中海温水平平流和海表净热通量对海洋锋的季节变化起主要作用,而温度垂直输送项对海洋锋的发展起抑制作用,但影响相对较小。     

Weak GPS signal tracking using FFT discriminator in open loop receiver

An open loop tracking architecture, which tracks GPS signals under weak and challenging conditions, is analyzed. The in-phase and quadrature-phase integration pair is regarded as a single tone complex signal. An FFT-based method is used as a frequency discriminator to estimate the Doppler frequency residual of the single tone signal. Another FFT-based method applies complex squaring to eliminate the effect of the navigation data bits polarities. The performance of the FFT-based discriminators is assessed in three criteria. Those criteria are the signal strength and dynamic range that can be tracked and the accuracy of the estimated Doppler frequency. In addition, the performance of the discriminators is analyzed to provide the theoretical and simulated peak detection probability. The results indicate that the FFT discriminator can track signals about 5 dB weaker than the signals that can be tracked by the complex squared FFT discriminator. In a quasi-static environment, the Doppler frequency residual can be assumed to be around zero, which can enable the FFT-based discriminators to track signals with approximately 2 dB less power. Moreover, the performance of the FFT-based discriminators is compared with the performance of two other frequency discriminators, namely the fast–slow and power-based. The comparison results indicate that these two frequency discriminators give higher frequency estimation accuracy, but they have a narrower dynamic range.     

Modification of strain wedge method for lateral soil-pile interaction in sandEI北大核心CSCD

A modified strain wedge (SW) method for analyzing the behavior of laterally loaded single piles in sand is proposed. The modified model assumes that the lateral displacements of a pile behind the three-dimensional passive soil wedge are nonlinear, which makes the horizontal soil strain variable with depths instead of a constant value in the original strain wedge model, and also employs two different hyperbolic models, one for describing horizontal stress increment-strain behavior of soil in the wedge, and the other for describing the shear stress-displacement property at the interface between soil and pile shafts. An example is analyzed to demonstrate the effectiveness of the modified method, and a good agreement is obtained. Finally, the effects of modifications on the lateral bearing capacity of pile shafts are discussed. The results show that the problem of overestimating the lateral bearing capacity of piles with strain wedge method can be ameliorated by introducing the assumption of nonlinear lateral displacements of piles. It makes the SW method more convenient and effective in analyzing the behavior of laterally loaded piles by introducing the new relationships of horizontal stress increment-strain and shear stress-displacement.     

Regional debris flow susceptibility analysis based on principal component analysis and self-organizing map: a case study in Southwest China

A method was developed to analyze the susceptibilities of 541 regional basins affected by debris flows at the Wudongde Dam site in southwest China. Determining susceptibility requires information on source material quantity and occurrence frequency. However, the large number of debris flows can hinder the individual field investigation in a each small basin. Factors that may trigger debris flows can be identified using remotely sensed interpretation information. Susceptibility analysis can then be conducted based on these factors. In this study, SPOT5 satellite imagery, digital elevation models (DEM), a lithology distribution map, and rainfall monitoring data were used to identify 12 debris flow trigger factors: basin relief ratio, slope gradient in the initiation zone, drainage density, downslope curvature of the main channel, vegetation coverage, main channel aspect, topographic wetness index, Melton’s ruggedness number, lithology, annual rainfall, form factor, and cross-slope curvature of the transportation zone. Principal component analysis was used to obtain the eight principal components of these factors that contribute to susceptibility results. Then, a self-organizing map method was adopted to analyze the principal components, which resulted in a debris flow susceptibility classification. Field validation of 26 debris flow basins was used to evaluate the errors of the susceptibility classification, as well as assess the causes of such errors. The study found that principle component analysis and self-organizing map methodologies are good predictors of basin susceptibility to debris flows.     

Underwater Navigation Based on Real-Time Simultaneous Sound Speed Profile Correction

Precise sound speed profile (SSP) information is critical when using sonar for underwater terrain navigation. Nevertheless, acquiring SSP information in real-time is difficult, especially in underwater navigation environment. To account for this problem, this paper presents an underwater navigation method that applies real-time SSP correction to the terrain measurements. The method uses a probe to measure the surface sound speed simultaneously. Meanwhile, redundancy of topographic measurement data is exploited to derive the equivalent SSP information. The acquired equivalent SSP is updated continuously with particle filter algorithm. The terrain measurements can be corrected in real-time with the equivalent SSP to improve the performance of underwater terrain navigation. By removing the impact of inaccurate SSP from the terrain measurements, the proposed method can achieve precise and robust underwater navigation result without using an underway-profiling instrument. Simulated results confirm the good performance of the proposed method.     

基于客观分析的多源卫星叶绿素a浓度产品融合方法研究

本文基于Aqua/MODIS、Terra/MODIS和Envisat/MERIS多源卫星叶绿素a浓度产品,研究了客观分析融合方法,制作了西北太平洋海域(0°~50°N,100°~150°E)叶绿素a浓度融合产品,并从有效数据空间覆盖率和产品精度两个方面对融合方法进行了评价。与单传感器以及欧洲太空局发布的GSM模型业务化融合产品相比,客观分析融合产品空间覆盖率明显提高;与收集的2002-2012年间叶绿素a浓度实测数据比较,GSM模型业务化融合产品的匹配数据点为578个,偏差为-0.20 mg/m3,均方根误差为0.37 mg/m3,客观分析法融合产品的匹配数据点为1432个,偏差为-0.21 mg/m3,均方根误差为0.36 mg/m3。结果表明:本文研究的客观分析融合方法在保证融合产品精度的同时可显著提高产品的空间覆盖率,在海洋水色融合应用前景广阔。     

青岛冷水团的消亡机理研究

本文基于多年月平均水温资料,分析了青岛冷水团的长消过程,并利用气候态月平均大气数据和数值模拟结果,探讨了青岛冷水团的消亡机理。结果表明,青岛冷水团3月出现,4月成型,5月最盛,6月减弱,7月消失;南黄海6-7月间偏南风的增强和温跃层以下反气旋涡的减弱是青岛冷水团消亡的动力机制,而海面净热通量的下传和水平热量的输入则是青岛冷水团消亡的热力机制。     

Modern modes of provenance and dispersal of terrigenous sediments in the North Pacific and Bering Sea: implications and perspectives for palaeoenvironmental reconstructions

During expedition 202 aboard the RV Sonne in 2009, 39 seafloor surface sediment sites were sampled over a wide sector of the North Pacific and adjoining Bering Sea. The data served to infer land–ocean linkages of terrigenous sediment supply in terms of major sources and modes of sediment transport within an over-regional context. This is based on an integrated approach dealing with grain-size analysis, bulk mineralogy and clay mineralogy in combination with statistical data evaluation (end-member modelling of grain-size data, fuzzy cluster analysis of mineralogical data). The findings on clay mineralogy served to update those of earlier work extracted from the literature. Today, two processes of terrigenous sediment supply prevail in the study area: far-distance aeolian sediment supply to the pelagic North Pacific, and hemipelagic sediment dispersal from nearby land sources via ocean currents along the continental margins and island arcs. Aeolian particles show the finest grain sizes (clay and fine silt), whereas hemipelagic sediments have high abundances of coarse silt. Exposed sites on seamounts and the continental slope are partly swept by strong currents, leading to residual enrichment of fine sand. Four sediment sources can be distinguished on the basis of distinct index minerals revealed by statistical data analysis: dust plumes from central Asia (quartz, illite), altered materials from the volcanic regions of Kamchatka and the Aleutian Arc (smectite), detritus from the Alaskan Cordillera (chlorite, hornblende), and fluvial detritus from far-eastern Siberia and the Alaska mainland (quartz, feldspar, illite). These findings confirm those of former studies but considerably expand the geographic range of this suite of proxies as far south as 39°N in the open North Pacific. The present integrated methodological approach proved useful in identifying the major modern processes of terrigenous sediment supply to the study region. This aspect deserves attention in the selection of sediment core sites for future palaeoenvironmental reconstructions related to aeolian and glacial dynamics, as well as the recognition of palaeo-ocean circulation patterns in general.