新疆阿尔泰造山带构造作用的锆石裂变径迹分析

在新疆阿尔泰造山带所获得的19个锆石裂变径迹年龄变化于155-243Ma之间，明显地分为2组，分别对应于2个构造活动期，早期为155-189Ma，晚期为189-243Ma。这与磷灰石裂变径迹年龄反映的62-100Ma和100-160Ma两个构造期完全一致。早期和晚期构造活动期持续的时间分别为54-60Ma和34-38Ma，而这两个构造期之间的间隔时间，则从早到晚由83-89Ma变为89-93Ma。同时，锆石裂变径迹年龄与距特斯巴汗断裂和巴寨断裂的距离有关，反映这两条断裂带对区域构造演化的控制作用。     

Did Paleogene North Atlantic rift-related eruptions drive early Eocene climate cooling?

The delivery of volcanogenic sulphur into the upper atmosphere by explosive eruptions is known to cause significant temporary climate cooling. Therefore, phreatomagmatic and phreatoplinian eruptions occurring during the final rifting stages of active flood basalt provinces provide a potent mechanism for triggering climate change.

During the early Eocene, the northeast Atlantic margin was subjected to repeated ashfall for 0.5 m.y. This was the result of extensive phreatomagmatic activity along 3000 km of the opening northeast Atlantic rift. These widespread, predominantly basaltic ashes are now preserved in marine sediments of the Balder Formation and its equivalents, and occur over an area extending from the Faroe Islands to Denmark and southern England. These ash-bearing sediments also contain pollen and spore floras derived from low diversity forests that grew in cooler, drier climates than were experienced either before or after these highly explosive eruptions. In addition, coeval plant macrofossil evidence from the Bighorn Basin, Wyoming, USA, also shows a comparable pattern of vegetation change. The coincidence of the ashes and cooler climate pollen and spore floras in northwest Europe identifies volcanism as the primary cause of climate cooling. Estimates show that whilst relatively few phreatomagmatic eruptive centres along the 3000 km opening rift system could readily generate 0.5–1 °C cooling, on an annual basis, only persistent or repeated volcanic phases would have been able to achieve the long-term cooling effect observed in the floral record. We propose that the cumulative effect of repeated Balder Formation eruptions initiated a biodiversity crisis in the northeast Atlantic margin forests. Only the decline of this persistent volcanic activity, and the subsequent climatic warming at the start of the Eocene Thermal Maximum allowed the growth of subtropical forests to develop across the region.     

Continental rift systems and anorogenic magmatism

Precambrian Laurentia and Mesozoic Gondwana both rifted along geometric patterns that closely approximate truncated-icosahedral tessellations of the lithosphere. These large-scale, quasi-hexagonal rift patterns manifest a least-work configuration. For both Laurentia and Gondwana, continental rifting coincided with drift stagnation, and may have been driven by lithospheric extension above an insulated and thermally expanded mantle. Anorogenic magmatism, including flood basalts, dike swarms, anorthosite massifs and granite-rhyolite provinces, originated along the Laurentian and Gondwanan rift tessellations. Long-lived volcanic regions of the Atlantic and Indian Oceans, sometimes called hotspots, originated near triple junctions of the Gondwanan tessellation as the supercontinent broke apart. We suggest that some anorogenic magmatism results from decompression melting of asthenosphere beneath opening fractures, rather than from random impingement of hypothetical deep-mantle plumes.     

Compositional variations (major and trace elements) of clinopyroxene and Ti-andradite from pyroxenite, ijolite and nepheline syenite, Alnö Island, Sweden

Clinopyroxenes from pyroxenite, ijolite and nepheline syenite from the main intrusion of the Alnö complex define two sub-parallel compositional trends with respect to Na, Ca and Fe_TOT plotted against alkali-pyroxene fractionation index (Na–Mg). Both trends define a smooth fractionation of increasing Na and Fe_TOT and decreasing Ca with increasing Na–Mg, but one set of samples contain clinopyroxenes that constantly plot at higher Na and lower Fe_TOT and Ca (at similar Na–Mg) than the rest of the samples. Clinopyroxenes with higher Ca and Fe_TOT and lower Na (trend 1) co-exist with substantial amounts of Ti-andradite (up to 70 vol.%), while the sample set defining the more Na-rich trend (trend 2) lack co-existing Ti-andradite. Clinopyroxenes from both trends show fractionated REE patterns with a distinct difference in HREE content, reflecting the content of co-existing Ti-andradite. The rocks of the first Ti-andradite-bearing trend crystallized slightly prior to the rocks of the second trend, probably from a primitive, Ca- and Ti-rich nephelinitic magma. Crystallisation of pyroxenite and melteigite occurred under low aSiO₂ and high aCaO and aTiO₂ as evidenced by the presence of perovskite and sometimes substantial amounts of magnetite. Subsequent increase in aSiO₂ is evidenced in the overgrowth of perovskite by titanite, which in turn is overgrown by Ti-andradite. Nepheline syenitic residuals crystallized under higher aSiO₂ and aNa₂O and lower aCaO and aTiO₂, which reduced Ti-andradite into an accessory phase and produced more Si- and Na-rich clinopyroxenes. Some of these residuals probably also mixed with new primitive magma producing a hybrid magma that crystallised the more Na-rich and Ca- and Fe_TOT-poor clinopyroxenes of trend 2. The complete lack of Ti-andradite in these rocks indicates different crystallisation conditions and also a different magma composition.     

Modeling of in-situ crystallization processes in the Permian mafic layered intrusion of Mont Collon (Dent Blanche nappe, western Alps)

The Mont Collon mafic complex is one of the best preserved examples of the Early Permian magmatism in the Central Alps, related to the intra-continental collapse of the Variscan belt. It mostly consists (> 95 vol.%) of ol + hy-normative plagioclase-wehrlites, olivine- and cpx-gabbros with cumulitic structures, crosscut by acid dikes. Pegmatitic gabbros, troctolites and anorthosites outcrop locally. A well-preserved cumulative sequence is exposed in the Dents de Bertol area (center of intrusion). P–T calculations indicate that this layered magma chamber emplaced at mid-crustal levels at about 0.5 GPa and 1100 °C. The Mont Collon cumulitic rocks record little magmatic differentiation, as illustrated by the restricted range of clinopyroxene mg-number (Mg#_cpx = 83–89). Whole-rock incompatible trace-element contents (e.g. Nb, Zr, Ba) vary largely and without correlation with major-element composition. These features are characteristic of an in-situ crystallization process with variable amounts of interstitial liquid L trapped between the cumulus mineral phases. LA-ICPMS measurements show that trace-element distribution in the latter is homogeneous, pointing to subsolidus re-equilibration between crystals and interstitial melts. A quantitative modeling based on Langmuir's in-situ crystallization equation successfully duplicated the REE concentrations in cumulitic minerals of all rock facies of the intrusion. The calculated amounts of interstitial liquid L vary between 0 and 35% for degrees of differentiation F of 0 to 20%, relative to the least evolved facies of the intrusion. L values are well correlated with the modal proportions of interstitial amphibole and whole-rock incompatible trace-element concentrations (e.g. Zr, Nb) of the tested samples. However, the in-situ crystallization model reaches its limitations with rock containing high modal content of REE-bearing minerals (i.e. zircon), such as pegmatitic gabbros. Dikes of anorthositic composition, locally crosscutting the layered lithologies, evidence that the Mont Collon rocks evolved in open system with mixing of intercumulus liquids of different origins and possibly contrasting compositions. The proposed model is not able to resolve these complex open systems, but migrating liquids could be partly responsible for the observed dispersion of points in some correlation diagrams. Absence of significant differentiation with recurrent lithologies in the cumulitic pile of Dents de Bertol points to an efficiently convective magma chamber, with possible periodic replenishment.     

Fractally Invariant Distributions and an Application in Geochemical Exploration

Fractal modelling has been applied extensively as a means of characterizing the spatial distribution of geological phenomena that display self-similarity at differing scales of measurement. A fractal distribution exists where the number of objects exhibiting values larger than a specified magnitude displays a power-law dependence on that magnitude, and where this relationship is scale-invariant. This paper shows that a number of distributions, including power-function, Pareto, log-normal and Zipf, display fractal properties under certain conditions and that this may be used as the mathematical basis for developing fractal models for data exhibiting such distributions. Population limits, derived from fractal modelling using a summation method, are compared with those derived from more conventional probability plot modelling of stream sediment geochemical data from north-eastern New South Wales. Despite some degree of subjectivity in determining the number of populations to use in the models, both the fractal and probability plot modelling have assisted in isolating anomalous observations in the geochemical data related to the occurrence of mineralisation or lithological differences between sub-catchments. Thresholds for the main background populations determined by the fractal model are similar to those established using probability plot modelling, however the summation method displays less capacity to separate out anomalous populations, especially where such populations display extensive overlap. This suggests, in the geochemical data example provided, that subtle differences in the population parameters may not significantly alter the fractal dimension.     

Martian Topography: Scaling, Craters, and High-Order Statistics

The high-order structure functions of Mars topography reveal three specific ranges of scales: (1) scaling range at small scales where the structure functions exhibit scaling behavior; (2) transition range where the structure functions continue to grow but do not reveal scaling; and (3) saturation range at large scales where the structure functions saturate. The scaling and saturation ranges are explored in detail in respect to scaling and intermittency. Analysis of the Mars Orbiter Laser Altimeter (MOLA) data and computer simulations suggest that there are two potential contributors to the small-scale scaling: (i) scale-invariant surface formation; and (ii) effects of discrete morphological forms such as craters. The crater effect also provides an explanation for the large-scale intermittency revealed using the normalized structure functions within the saturation range, which cannot be explained by the ‘scale-invariant’ concept. Overall, the obtained results suggest that the “crater” contribution to the structure function behavior often dominates over the effect of the scale-invariant surface formation.     

“青藏高原南部空白区基础地质调查与研究”计划项目新成果、新进展

通过2 0 0 4年度各相关图幅的大力工作,在基础地质、矿产和资源等方面取得了大量实际材料,综合研究区域构造地层格架、青藏高原地质图和青藏高原南部火山岩及其地球动力学意义等,取得重要进展和新认识,在矿产资源、旅游和人文景观等方面也取得重要阶段性成果。     

地质微生物地球化学作用的意义与展望

概要论述了地质微生物学、地下水微生态学、微生物地球化学作用的基本概念、研究内容、研究现状、科学意义、关键问题、发展前景和在地下水环境保护中的作用。该研究领域不仅拓宽了整个地质科学的研究范畴,而且推动了地质科学的发展,具有一定的创新性。     

三峡库区巴东县城附近主要滑坡边界轨迹分形分维特征与滑坡稳定性关系

为了探索复杂滑坡轨迹结构演化及其稳定性定量分析计算的新途径，本文利用分形分维理论，分析三峡库区巴东县城附近滑坡边界轨迹的几何分形结构，并采用盒维数法分别求得巴东县城附近11个滑坡边界轨迹的分维值，计算结果表明：每个滑坡的轨迹结构具有其特征性的分维值，轨迹结构越复杂，结构层次越清楚，分维值越高；其中，榨房坪滑坡和黄腊石滑坡的分维值最高，分别为1.50和1.483，西壤口和谭家湾滑坡的分维值最低，分别为0.925和0.732；而黄土坡和赵树岭滑坡的分维值介于二者之间，分别为1.111和1.091。结合典型滑坡边界轨迹结构演化与滑坡稳定性关系的定性分析及前期滑坡稳定性定量计算和模拟分析，初步揭示：滑坡边界轨迹结构与稳定性是密切相关的，滑坡边界轨迹宏观扩展增值越明显，轨迹结构越复杂，分维值越高，其稳定性条件也越差，因此，分数维可作为衡量滑坡轨迹结构复杂性和稳定性的重要标志；滑坡边界轨迹宏观扩展变形存在一个极限，超过这个极限滑坡的局部失稳就转化为整体滑动；而滑坡边界轨迹则记录了滑坡变形扩展现象和信息，因此，相对应地滑坡轨迹分形结构的分维值也应存在一个极值，在极值点滑坡体处于临滑状态；滑坡边界轨迹结构的极限分维值大致为1.4～1.5，此时滑坡接近于整体极限失稳状态，而分维值在1.1～1.3之间则表示滑坡处于整体稳定，局部存在潜在失稳状态，分维值小于1则表示滑坡处于相对稳定状态。