湘中奥陶纪锰矿带成矿特征及资源前景

湘中奥陶纪沉积锰矿带位于湖南省安化县、桃江县、宁乡县境内,呈近EW向展布,矿带内锰矿以质量好而著称。该成矿带的成锰沉积盆地受控于加里东期张性断裂系统,为一断陷盆地。盆地内发育一组NW向同沉积断裂,形成了一系列断陷槽,控制了沉积岩相的分布。锰矿主要产于盆地中心亚相的黑色页岩夹碳酸锰矿微相内。据矿带中锰矿的地质和地球化学特征以及微量元素和碳、氧、锶同位素组成,笔者认为,该锰矿属于热水沉积成因。综合对比表明,该成矿带具有良好的成矿条件和值得注意的资源潜力,有可能发展为大型锰成矿带。     

云南官房铜矿床矿石矿物特征及银的赋存状态

通过显微镜鉴定、电子探针(EPMA)及扫描电镜能谱分析(SEM/EDS)等方法,首次对官房铜矿的矿物组合和银的赋存状态进行了研究。初步查明,矿石矿物为中-低温热液成因,并受火山机构及断裂构造的控制;银矿物主要为碲银矿和辉银矿。矿石中银与铜呈明显正相关关系,而方铅矿中不含银。银主要以类质同象的形式赋存于含铜矿物或黄铁矿中;银的独立矿物含量低,且多呈包裹体的形式存在于黄铜矿、斑铜矿及黄铁矿中,或以微细粒状赋存于矿物颗粒间和斑铜矿的表面。     

赣南淘锡坑钨多金属矿床花岗岩和云英岩岩石特征及云英岩中白云母40Ar/39Ar定年

赣南崇义县淘锡坑钨矿位于南岭东西向构造带东段,属于以黑钨矿石英脉型为主的钨多金属矿床。矿床形成与燕山期中酸性岩浆作用有密切关系,石英矿脉受一组北西向断裂控制,穿切新元古界。本文在淘锡坑钨矿区3个揭露到花岗岩体顶部的中段（206、106、56中段）采集到岩体顶部云英岩样品,利用40Ar/39Ar同位素定年测得云英岩中的白云母的坪年龄分别为152.7 ± 1.5 Ma（206中段）,153.4 ± 1.3 Ma（106中段）,155.0 ± 1.4 Ma（56中段）。与前人用其他方法测定的花岗岩成岩和成矿年龄几乎一致。花岗岩和云英岩全岩稀土元素均具有M型四分组效应和强烈的Eu亏损特征,反映出花岗质岩浆经历了高度分异演化及其岩体结晶晚期流体/熔体相互作用。综合前人在南岭地区同类矿床的研究资料,可知南岭地区160～150Ma成岩成矿作用主要分布于南岭中-东段,可能为大陆边缘弧后岩石圈伸展的构造动力学背景的产物。     

澜沧江云南德钦古水一带第四纪堰塞湖的沉积特征及其环境意义

在云南省西北部德钦县古水一带深切的澜沧江河谷中,发现了一套第四纪湖相沉积物,以纹层状粘土、粉砂质粘土和粉砂的互层组合为特征,构成了第三和第四级阶地的基座.笔者对该湖相剖面进行了U系、孢粉和若干地球化学指标的分析测试,并以这些结果讨论了古湖的形成时代和成因,以及古湖堆积时期的古植被和古气候.剖面顶部、中部和中下部粘土的U系法年龄测定结果分别为52.3±3.4 ka、64.2±5.6 ka和81.9±6.5 ka,说明古水古湖形成于晚更新世早中期的末次间冰期晚期和末次冰期的早冰阶与间冰阶早期,很可能是大型冰川(如下游的明永冰川等)或巨量的冰水沉积物堰塞了澜沧江河谷而造成的结果.     

Occurrence and evolution of the Xiaotangshan hot spring in Beijing, China

Thermal groundwater occurs in bedrock aquifers consisting of the dolomite of the Wumishan Group of the Jixianin System and the Cambrian carbonate in the Xiaotangshan geothermal field near the northern margin of the North China Plain, China. The hot water in the geothermal field of basin-type discharges partly in the form of the Xiaotangshan hot spring under natural conditions. The hot water has TDS of less than 600 mg/L and is of Na·Ca-HCO₃ type. The geothermal water receives recharge from precipitation in the mountain area with elevation of about 500 m above sea level to the north of the spring. Thermal groundwater flows slowly south and southeast through a deep circulation with a residence time of 224 years estimated with the Ra–Rn method. The Xiaotangshan hot spring dried up in the middle of the 1980s owing to the increasing withdrawal of the hot water in the geothermal field in the past decades. The water level of the geothermal system still falls continually at an annual average rate of about 2 m, although water temperature changes very little, indicating that the recharge of such a geothermal system of basin-type is limited. Over-exploitation has a dramatic impact on the geothermal system, and reduction in exploitation and reinjection are required for the sustainable usage of the hot water.     

Recharge source and hydrogeochemical evolution of shallow groundwater in a complex alluvial fan system,southwest of North China Plain

Many cities around the world are developed at alluvial fans. With economic and industrial development and increase in population, quality and quantity of groundwater are often damaged by over-exploitation in these areas. In order to realistically assess these groundwater resources and their sustainability, it is vital to understand the recharge sources and hydrogeochemical evolution of groundwater in alluvial fans. In March 2006, groundwater and surface water were sampled for major element analysis and stable isotope (oxygen-18 and deuterium) compositions in Xinxiang, which is located at a complex alluvial fan system composed of a mountainous area, Taihang Mt. alluvial fan and Yellow River alluvial fan. In the Taihang mountainous area, the groundwater was recharged by precipitation and was characterized by Ca–HCO₃ type water with depleted δ¹⁸O and δD (mean value of −8.8‰ δ¹⁸O). Along the flow path from the mountainous area to Taihang Mt. alluvial fan, the groundwater became geochemically complex (Ca–Na–Mg–HCO₃–Cl–SO₄ type), and heavier δ¹⁸O and δD were observed (around −8‰ δ¹⁸O). Before the surface water with mean δ¹⁸O of −8.7‰ recharged to groundwater, it underwent isotopic enrichment in Taihang Mt. alluvial fan. Chemical mixture and ion exchange are expected to be responsible for the chemical evolution of groundwater in Yellow River alluvial fan. Transferred water from the Yellow River is the main source of the groundwater in the Yellow River alluvial fan in the south of the study area, and stable isotopic compositions of the groundwater (mean value of −8.8‰ δ¹⁸O) were similar to those of transferred water (−8.9‰), increasing from the southern boundary of the study area to the distal end of the fan. The groundwater underwent chemical evolution from Ca–HCO₃, Na–HCO₃, to Na–SO₄. A conceptual model, integrating stiff diagrams, is used to describe the spatial variation of recharge sources, chemical evolution, and groundwater flow paths in the complex alluvial fan aquifer system.     

Assessment of frozen-ground conditions for engineering geology along the Qinghai–Tibet highway and railway, China

The Qinghai–Tibet Highway and Railway (the Corridor) across the Qinghai–Tibet Plateau traverses 670 km of permafrost and seasonally frozen-ground in the interior of the Plateau, which is sensitive to climatic and anthropogenic environmental changes. The frozen-ground conditions for engineering geology along the Corridor is complicated by the variability in the near-surface lithology, and the mosaic presence of warm permafrost and talik in a periglacial environment. Differential settlement is the major frost-effect problem encountered over permafrost areas. The traditional classification of frozen ground based on the areal distribution of permafrost is too generalized for engineering purposes and a more refined classification is necessary for engineering design and construction. A proposed classification of 51 zones, sub-zones, and sections of frozen ground has been widely adopted for the design and construction of foundations in the portion of the Corridor studied. The mean annual ground temperature (MAGT), near-surface soil types and moisture content, and active faults and topography are most commonly the primary controlling factors in this classification. However, other factors, such as local microreliefs, drainage conditions, and snow and vegetation covers also exert important influences on the features of frozen ground. About 60% of the total length of the Corridor studied possesses reasonably good frozen-ground conditions, which do not need special mitigative measures for frost hazards. However, other sections, such as warm and ice-rich or -saturated permafrost, particularly in the sections in wetlands, ground improvement measures such as elevated land bridges and passive or proactive cooling techniques need to be applied to ensure the long-term stability of thermally unstable, thick permafrost subsoils, and/or refill with non-frost-susceptible soils. Due to the long-history of the construction and management of the Corridor by various government departments, adverse impacts of construction and operation on the permafrost environment have been resulted. It is recommended that an integrated, executable plan for the routing of major construction projects within this transportation corridor be established and long-term monitoring networks installed for evaluating and mitigating the impact from anthropogenic and climatic changes in frozen-ground conditions.     

Diamond formation in sulfide pyrrhotite-carbon melts: Experiments at 6.0–7.1 GPa and application to natural conditions

Experiments at 6.0–7.1 GPa and 1500–1700°C were carried out to explore the boundary conditions of diamond nucleation and growth in pyrrhotite-carbon melt-solutions. Pyrrhotite is one of the main sulfide minerals of the pyrrhotite-pentlandite-chalcopyrite assemblage of mantle rocks and primary inclusions in diamond. Solutions of carbon in sulfide melts oversaturated with respect to diamond at the expense of the dissolution of starting graphite (thermodynamically unstable phase) are formed owing to the difference between the solubilities of graphite and diamond, which increases under the influence of temperature gradients in experimental samples. We determined the fields of carbon solutions in pyrrhotite melt showing labile and metastable oversaturation with respect to diamond, which correspond to the spontaneous nucleation of the diamond phase and diamond growth on seeds, respectively. The linear growth rate of diamond in sulfide-carbon melts is rather high (on average, 10 μ/min during the first 1–2 min from the onset of spontaneous crystallization). The nucleation density is estimated as 180 grains per cubic centimeter. Diamonds crystallized from sulfide melts show octahedral and spinel twin shapes. Diamond polycrystals were synthesized for the first time from a sulfide medium as intergrowths of skeletal (edge) or “cryptocrystalline” microdiamonds, from 1 to 100 μm in size, their spinel twins and, occasionally, polysynthetic (star-shaped) twins. During diamond growth from sulfidecarbon melts on smooth faces of cuboctahedral diamond seeds synthesized in metal systems, smooth-faced layer-by-layer step-like growth was observed on their octahedral (111) faces, whereas growth on the (100) cubic faces produced rough-surfaced layers of intergrown micropyramids, whose axes were oriented normal to the (100) face. The obtained experimental results were applied to the problem of diamond genesis under the conditions of the Earth’s mantle in the framework of the model of carbonate-silicate parental melts with blebs of immiscible sulfide melts.     

Experimental study of fluorine and chlorine contents in mica (biotite) and their partitioning between mica,phonolite melt,and fluid

This paper reports the results of a study of the composition of mica (biotite) crystallizing in the system of phonolite melt-Cl- and F-bearing aqueous fluid at T ～ 850°C, P = 200 MPa, and \(f_{O_2 } \) = Ni-NiO, as well as data on F and Cl partitioning between coexisting phases. It was established that Cl content in mica is significantly lower than in phonolite melt and, especially, in fluid. Fluorine shows a different behavior in this system: its content in mica is always higher than in phonolite melt but lower than in fluid. The mica-melt partition coefficients of Cl and F also behave differently. The Cl partition coefficient gradually increases from 0.17 to 0.33 with increasing Cl content in the system, whereas the partition coefficient of F sharply decreases from 3.0 to 1.0 with increasing total F content. The apparent partition coefficients of F between biotite and groundmass (melt) in various magmatic rocks are usually significantly higher than the experimental values. It was supposed that the higher ^Bt/glassD_F values in natural samples could be related to the influence of later oxidation reactions, reequilibration of biotite at continuously decreasing \(f_{H_2 O} \)/f _HF ratio, and an increase in this coefficients with decreasing total F content in the system.