Buchbesprechungen

Ohne Zusammenfassung     

Analysis of anomalies in ADS-B and its GPS data

Traditionally, the surveillance component of the air traffic management system has been based on radar, which consists of two separate systems: primary radar and secondary radar, which both enable the measurement of the aircraft range and bearing to the radar station. Primary radar is based on signals emitted by a ground station simply being reflected off an object and detected by a ground-based receiver. Secondary radar also emits signals, but relies upon a transponder onboard the aircraft to emit a signal itself, modulated among others by a four-digit aircraft identity (Mode A), aircraft altitude (Mode C) and/or 24-bit unique address (Mode S). Typical accuracies of secondary radar are of the order of 0.03 NM in range and 0.07° in azimuth. However, no position integrity report is provided. Air traffic density is expected to significantly increase in the future. In order to maintain or enhance air travel efficiency, while maintaining safety, more accurate surveillance systems, with the required integrity, will be required. Automatic dependent surveillance–broadcast (ADS-B) is a new aviation surveillance system, envisioned to overcome the limitations of radar and to enhance surveillance performance and thereby increase airspace capacity. However, its high dependence on external systems such as onboard navigation and communication systems also increases the number of potential points of failure. It is important to understand and mitigate these failure modes before the system can reliably be implemented. The present study emerged as an exploratory research as part of a safety assessment framework development for the ADS-B system. It reviews the ADS-B failure modes, data collection and analysis of ADS-B and its corresponding onboard GPS data. The study identifies a set of failures common to certain aircraft models, with consistent error patterns. A key failure mode was found to be associated with the navigation data from the onboard GPS. We discuss the identified failure modes and investigate the nature and causes of these failures. The findings highlight some of the deficiencies of the current ADS-B system, which will need to be addressed before the ADS-B system can reliably be implemented.     

Further Information of the Associated Li Deposits in the No.6 Coal Seam at Jungar Coalfield,Inner Mongolia,Northern China

Total 138 coal samples and 14 parting samples were taken from the No. 6 Seam of the Jungar Coalfield, Inner Mongolia. These samples were analysed by optical microscopy, sequential chemical extraction procedure (SCEP), inductively coupled plasma mass spectrometry (ICP-MS), X-ray powder diffraction (XRD), and scanning electron microscope in conjunction with an energy-dispersive X-ray spectrometer (SEM-EDX) analysis. The results indicate that the Li contents have reached the industrial grade of the coal associated Li deposit, and the total Li reserves have reached 2406600 tons, that is, 5157000 tons Li2O in the No. 6 seam in the Jungar Coalfield. The sequential chemical extraction procedure results suggest that the Li concentration is mainly related to inorganic matter. The minerals in the coals consist of kaolinite, boehmite, chlorite-group mineral, quartz, calcite, pyrite, siderite and amorphous clay material. Some Li could be absorbed by clay minerals in the Li-bearing coal seam. The chlorite phase?could be?most likely the host for a part of Li. The Yinshan Oldland should be the most possible source of Li of the coal.     

One‐dimensional dynamics of saturated incompressible porous media: analytical solutions and influence of inertia terms

The complexity of formulations for the hydromechanical coupled mechanics of porous media is typically minimised by simplifying assumptions such as neglecting the effect of inertia terms. For example, three formulations commonly employed to model practical problems are classified as fully dynamic, simplified dynamic and quasi‐static. Thus, depending on the porous media conditions, each formulation will have advantages and limitations. This paper presents a comprehensive analysis of these limitations when solving one‐dimensional fully saturated porous media problems in addition to a new solution that considers a more general loading situation. A phase diagram is developed to assist on the selection of which formulation is more appropriate and convenient regarding particular cases of porosity and hydraulic conductivity values. Non‐dimensional formulations are proposed to achieve this goal. Results using the analytical solutions are compared against numerical values obtained with the finite element method, and the effect of porosity is investigated. Copyright © 2016 John Wiley & Sons, Ltd.     

Palaeoecology and Archaeology of the Kärlich–Seeufer Open-Air Site (Middle Pleistocene) in the Central Rhineland, Germany

The Kärlich–Seeufer archaeological site in Germany's central Rhineland was excavated between 1980 and 1992. The site provides evidence for hominid activity during a Middle Pleistocene interglaciation known up to now only from the Kärlich clay pit and therefore defined as the Kärlich Interglaciation, which is considered to be post-Cromer IV and pre-Holstein (sensu stricto) in age. The site is characterized by Acheulean artifacts, a fauna dominated byElephas (Palaeoloxodon) antiquus,and a unique and outstanding preservation of wooden and other palaeobotanical remains. Assuming all finds are associated, the site previously was interpreted as an elephant hunting camp with a wooden structure, together with wood and bone implements preservedin situ.Recent analysis of the same features has shown that the site can also be interpreted as a reworked archaeological sample. Hominid occupation occurred in the vicinity of a small lake with prevailing meso-oligotrophic conditions. Expanding boreal forests and fen vegetation characterized the landscape.     

Hotspot distribution, gravity, mantle tomography: evidence for plumes

Thermal convection is the motor of Earth dynamics and therefore is the link between plate motions, hotspots, seismic velocity variations in the mantle, and anomalies of the gravity field. Small scale mantle anomalies, such as plumes, do, however, generally escape detection by tomographic methods. It is attempted to approach the problem of detection in a somewhat statistical manner. Correlations are sought between spherical harmonic expansions of the fields under study: the hotspot distribution, mantle velocity variations, gravity, heat flow. Using spherical harmonic representations of global fields implies integration and averaging over the whole globe. Thus, although relationships may remain masked in the space domain by a multitude of effects, tendencies may become visible in the spectra or in appropriate averages.The main results are the following: There is a significant long wavelength (n=2,3) negative correlation between the hotspot density and the P-wave velocity variation in the lower mantle. Positive hotspot density of degree 2 to 9 generally correlates with low seismic velocity in all depths of the upper mantle and with positive gravity. This fits well with plume-type convection. These results are also confirmed regionally for a number of individual mid-ocean ridges and hotspots. The hotspot density and the free air anomalies are distinctly positive above regions of low velocity extending to great depth. The effect is not distinct at ridges with shallow velocity anomalies. In a general way, we suggest that the antipodal upwellings (Pacific, Africa) are divided by downwelling currents around the shrinking Pacific. Plate boundaries can easily move away from their past connections with the deeper mantle. Small scale plume currents seem to be depicted in the hotspot expansion. © 1999 Elsevier Science Ltd. All rights reserved.     

Benthic carbonate factories of the Phanerozoic

Marine carbonate precipitation occurs in three basic modes: abiotic (or quasi-abiotic), biotically induced, and biotically controlled. On a geologic scale, these precipitation modes combine to form three carbonate production systems, or "factories" in the benthic environment: (1) tropical shallow-water factory, dominated by biotically controlled (mainly photo-autotrophic) and abiotic precipitates; (2) cool-water factory, dominated by biotically controlled (mainly heterotrophic) precipitates; and (3) mud-mound factory, dominated by biotically induced (mainly microbial) and abiotic precipitates. Sediment accumulations of the factories differ in composition, geometry, and facies patterns, and some of these differences appear prominently in seismic data, thus facilitating subsurface prediction. The characteristic accumulation of the tropical factory is the flat-topped, often reef-rimmed platform. In cool-water systems, reefs in high-energy settings are scarce and hydrodynamic influence dominates, producing seaward-sloping shelves and deep-water sediment drifts often armored by skeletal framework. The typical accumulation of the mud-mound factory is groups of mounds in deeper water. Where the mud-mound factory expands into shallow water, it forms rimmed platforms similar to the tropical factory. The tropical factory is most productive; the mud-mound factory reaches 80–90%, and the cool-water factory 20–30% of the tropical growth rate. The three factories represent end members connected by transitions in space. Transitions in time are linked to biotic evolution.     

The Kabanga Ni sulfide deposit, Tanzania: I. Geology, petrography, silicate rock geochemistry, and sulfur and oxygen isotopes

The Kabanga Ni sulfide deposit represents one of the most significant Ni sulfide discoveries of the last two decades, with current indicated mineral resources of 23.23 Mt at 2.64% Ni and inferred mineral resources of 28.5 Mt at 2.7% Ni (Nov. 2008). The sulfides are hosted by a suite of ∼1.4 Ga ultramafic–mafic, sill-like, and chonolithic intrusions that form part of the approximately 500 km long Kabanga–Musongati–Kapalagulu igneous belt in Tanzania and Burundi. The igneous bodies are up to about 1 km thick and 4 km long. They crystallized from several compositionally distinct magma pulses emplaced into sulfide-bearing pelitic schists. The first magma was a siliceous high-magnesium basalt (approximately 13.3% MgO) that formed a network of fine-grained acicular-textured gabbronoritic and orthopyroxenitic sills (Mg# opx 78–88, An plag 45–88). The magma was highly enriched in incompatible trace elements (LILE, LREE) and had pronounced negative Nb and Ta anomalies and heavy O isotopic signatures (δ¹⁸O +6 to +8). These compositional features are consistent with about 20% contamination of primitive picrite with the sulfidic pelitic schists. Subsequent magma pulses were more magnesian (approximately 14–15% MgO) and less contaminated (e.g., δ¹⁸O +5.1 to +6.6). They injected into the earlier sills, resulting in the formation of medium-grained harzburgites, olivine orthopyroxenites and orthopyroxenites (Fo 83–89, Mg# _opx 86–89), and magmatic breccias consisting of gabbronorite–orthopyroxenite fragments within an olivine-rich matrix. All intrusions in the Kabanga area contain abundant sulfides (pyrrhotite, pentlandite, and minor chalcopyrite and pyrite). In the lower portions and the immediate footwall of two of the intrusions, namely Kabanga North and Kabanga Main, there occur numerous layers, lenses, and veins of massive Ni sulfides reaching a thickness of several meters. The largest amount of high grade, massive sulfide occurs in the smallest intrusion (Kabanga North). The sulfides have heavy S isotopic signatures (δ³⁴S wr = +10 to +24) that broadly overlap with those of the country rock sulfides, consistent with significant assimilation of external sulfur from the Karagwe–Ankolean sedimentary sequence. However, based partly on the relatively homogenous distribution of disseminated sulfides in many of the intrusive rocks, we propose that the Kabanga magmas reached sulfide saturation prior to final emplacement, in staging chambers or feeder conduits, followed by entrainment of the sulfides during continued magma ascent. Oxygen isotope data indicate that the mode of sulfide assimilation changed with time. The heavy δ¹⁸O ratios of the early magmas are consistent with ingestion of the sedimentary country rocks in bulk. The relatively light δ¹⁸O ratios of the later magmas indicate less bulk assimilation of the country rocks, but in addition the magmas selectively assimilated additional S, possibly through devolatization of the country rocks or through cannibalization of magmatic sulfides deposited in the conduits by preceding magma surges. The intrusions were tilted at ca. 1.37 Ga, during the Kibaran orogeny and associated synkinematic granite plutonism. This caused solid-state mobilization of ductile sulfides into shear zones, notably along the base of the intrusions where sulfide-hornfels breccias and lenses and layers of massive sulfides may reach a thickness of >10 m and can extend for several 10 s to >100 m away from the intrusions. These horizons represent an important exploration target for additional nickel sulfide deposits.