Bottom currents in Nankai Trough and Sagami Trough

Mean flows and velocity fluctuations are described from direct measurements of bottom currents made at three stations across Nankai Trough and two stations in Sagami Trough from May 1982 to May 1984. Aanderaa current meters were moored 7 m above the bottom. The observed mean flows indicate a counter-clockwise circulation in Nankai Trough with current speeds of 0.9–2.1 cm sec^–1. The mean flows were larger on the slopes than on the flat bottom of the trough. The mean flows observed in Sagami Trough show an inflow into Sagami Bay which is considered to be a part of the Oyashio undercurrent from the north that flows along the eastern coast of Honshu. Velocity fluctuations with periods greater than 100 hr were less energetic in the troughs than those at a station west of Hachijo-jima Island. A highly energetic fluctuation with a period of 66.7 hr was observed on the northern slope of Sagami Trough in the velocity component parallel to the trough axis. A maximum current speed of 49 cm sec^–1 was observed in Sagami Trough.This study was sponsored by the Ministry of Education, Science and Culture, Japan.     

A Study Of The Atmospheric Boundary Layer Using Radon And Air Pollutants As Tracers

Concentrations of radon ²²²Rn andair pollutants, meteorological parametersnear the surface and vertical profiles of meteorological elements were measured atUchio (Okayama City, Okayama Prefecture, Japan) 12 km north from the coast ofthe Inland Sea of Japan. In the nighttime, the ²²²Rn concentration increased in the case of weak winds, but did not increase as much in the case of moderate or strong winds, as had been expected. In the daytime, the ²²²Rn concentrationheld at a slightly higher than average level for the period from sunrise to about 1100 JST. It is considered that this phenomenon is due to a period of morning calm, that is, a transition period from land breeze to sea breeze.NO, which is sensitive to traffic volume,brought information concerning advection.Oxidant concentrations,which reflect the availability of sunlight,acted in the reverse manner to ²²²Rnconcentrations. Thus, a set of ²²²Rn and air pollutants could provide useful information regarding the local conditions of the atmospheric boundary layer.     

High-Reflectivity Coatings for a Vacuum Ultraviolet Spectropolarimeter

Precise polarization measurements in the vacuum ultraviolet (VUV) region are expected to be a new tool for inferring the magnetic fields in the upper atmosphere of the Sun. High-reflectivity coatings are key elements to achieving high-throughput optics for precise polarization measurements. We fabricated three types of high-reflectivity coatings for a solar spectropolarimeter in the hydrogen Lyman-\(\upalpha \) (Ly\(\upalpha \); 121.567 nm) region and evaluated their performance. The first high-reflectivity mirror coating offers a reflectivity of more than 80 % in Ly\(\upalpha \) optics. The second is a reflective narrow-band filter coating that has a peak reflectivity of 57 % in Ly\(\upalpha \), whereas its reflectivity in the visible light range is lower than 1/10 of the peak reflectivity (\(\sim 5~\%\) on average). This coating can be used to easily realize a visible light rejection system, which is indispensable for a solar telescope, while maintaining high throughput in the Ly\(\upalpha \) line. The third is a high-efficiency reflective polarizing coating that almost exclusively reflects an s-polarized beam at its Brewster angle of 68° with a reflectivity of 55 %. This coating achieves both high polarizing power and high throughput. These coatings contributed to the high-throughput solar VUV spectropolarimeter called the Chromospheric Lyman-Alpha SpectroPolarimeter (CLASP), which was launched on 3 September, 2015.     

Mobilization and mechanisms of retardation in the Oklo natural reactor zone 2 (Gabon)—inferences from U, REE, Zr, Mo and Se isotopes

Mineralogical and isotopic studies were carried out on the natural nuclear reaction zone 2 from the Oklo deposit to evaluate the mobility of several nuclear reaction products in response to the alteration of the reaction zone and to identify the mechanisms which could retard the transport of released radionuclides. To address these issues, in situ isotopic analyses by SHRIMP and a selective extraction procedure were performed to constrain the structural location of nuclear reaction products (exchangeable and non exchangeable) and their association with mineral phases. The distribution patterns of U, REE, Zr and Mo isotopes reveal that substantial amounts were released from the core and migrated through the hydrothermal alteration halo over metric distances, owing to uraninite dissolution and advective transport by hydrothermal solutions during and soon after criticality. The results emphasize the mobility of Zr at Oklo, this element being often considered as “immobile” during water–rock interactions. The main output is the demonstration of the net effects of sorption and coprecipitation processes. Chlorite and to a lesser extent illite were found to have adsorbed significant amounts of U, REE, Zr (and probably Th) and less sorbing elements such as Mo. Coprecipitation of secondary UO₂ and P-rich coffinite within the alteration halo is also an important means of retardation. The concentration of radionuclides released from the reactor were probably high and they display solubility limited transport behaviour. No retention effect was found for Se in the immediate vicinity of the reactor and this element may have moved farther from its source of production. These results have interesting implications for the evaluation of long-term containment of radionuclides. They provide a simple illustration of the performance of a clay barrier in the uptake of radionuclides by sorption onto clays and reincorporation in secondary U-minerals. This study also demonstrates the robustness of these retention processes over extremely long periods of time.     

The Japan Trench and its juncture with the Kuril Trench: cruise results of the Kaiko project, Leg 3

This paper presents the results of a detailed survey combining Seabeam mapping, gravity and geomagnetic measurements as well as single-channel seismic reflection observations in the Japan Trench and the juncture with the Kuril Trench during the French-Japanese Kaiko project (northern sector of the Leg 3) on the R/V “Jean Charcot”. The main data acquired during the cruise, such as the Seabeam maps, magnetic anomalies pattern, and preliminary interpretations are discussed. These new data cover an area of 18,000 km² and provide for the first time a detailed three-dimensional image of the Japan Trench. Combined with the previous results, the data indicate new structural interpretations. A comparative study of Seabeam morphology, single-channel and reprocessed multichannel records lead to the conclusion that along the northern Japan Trench there is little evidence of accretion but, instead, a tectonic erosion of the overriding plate. The tectonic pattern on the oceanic side of the trench is controlled by the creation of new normal faults parallel to the Japan Trench axis, which is a direct consequence of the downward flexure of the Pacific plate. In addition to these new faults, ancient normal faults trending parallel to the N65° oceanic magnetic anomalies and oblique to the Japan trench axis are reactivated, so that two directions of normal faulting are observed seaward of the Japan Trench. Only one direction of faulting is observed seaward of the Kuril Trench because of the parallelism between the trench axis and the magnetic anomalies. The convergent front of the Kuril Trench is offset left-laterally by 20 km relative to those of the Japan Trench. This transform fault and the lower slope of the southernmost Kuril Trench are represented by very steep scarps more than 2 km high. Slightly south of the juncture, the Erimo Seamount riding on the Pacific plate, is now entering the subduction zone. It has been preceded by at least another seamount as revealed by magnetic anomalies across the landward slope of the trench. Deeper future studies will be necessary to discriminate between the two following hypothesis about the origin of the curvature between both trenches: Is it due to the collision of an already subducted chain of seamounts? or does it correspond to one of the failure lines of the America/Eurasia plate boundary?     

Stick-slip behavior of Indian gabbro as studied using a NIED large-scale biaxial friction apparatus

This paper reports stick-slip behaviors of Indian gabbro as studied using a new large-scale biaxial friction apparatus, built in the National Research Institute for Earth Science and Disaster Prevention (NIED), Tsukuba, Japan. The apparatus consists of the existing shaking table as the shear-loading device up to 3, 600 kN, the main frame for holding two large rectangular prismatic specimens with a sliding area of 0.75 m² and for applying normal stresses σ_n up to 1.33 MPa, and a reaction force unit holding the stationary specimen to the ground. The shaking table can produce loading rates v up to 1.0 m/s, accelerations up to 9.4 m/s², and displacements d up to 0.44 m, using four servocontrolled actuators. We report results from eight preliminary experiments conducted with room humidity on the same gabbro specimens at v = 0.1-100 mm/s and σ_n = 0.66-1.33 MPa, and with d of about 0.39 m. The peak and steady-state friction coefficients were about 0.8 and 0.6, respectively, consistent with the Byerlee friction. The axial force drop or shear stress drop during an abrupt slip is linearly proportional to the amount of displacement, and the slope of this relationship determines the stiffness of the apparatus as 1.15×10⁸ N/m or 153 MPa/m for the specimens we used. This low stiffness makes fault motion very unstable and the overshooting of shear stress to a negative value was recognized in some violent stick-slip events. An abrupt slip occurred in a constant rise time of 16-18 ms despite wide variation of the stress drop, and an average velocity during an abrupt slip is linearly proportional to the stress drop. The use of a large-scale shaking table has a great potential in increasing the slip rate and total displacement in biaxial friction experiments with large specimens.     

Internal structure of Longmenshan fault zone at Hongkou outcrop,Sichuan, China,that caused the 2008 Wenchuan earthquake

This paper reports the internal structures of the Beichuan fault zone of Longmenshan fault system that caused the 2008 Wenchuan earthquake, at an outcrop in Hongkou, Sichuan province, China. Present work is a part of comprehensive project of Institute of Geology, China Earthquake Administration, trying to understand deformation processes in Longmenshan fault zones and eventually to reproduce Wenchuan earthquake by modeling based on measured mechanical and transport properties. Outcrop studies could be integrated with those performed on samples recovered from fault zone drilling, during the Wenchuan Earthquake Fault Scientific Drilling (WFSD) Project, to understand along-fault and depth variation of fault zone properties. The hanging wall side of the fault zone consists of weakly-foliated, clayey fault gouge of about 1 m in width and of several fault breccia zones of 30–40 m in total width. We could not find any pseudotachylite at this outcrop. Displacement during the Wenchuan earthquake is highly localized within the fault gouge layer along narrower slipping-zones of about 10 to 20 mm in width. This is an important constraint for analyzing thermal pressurization, an important dynamic weakening mechanism of faults. Overlapping patterns of striations on slickenside surface suggest that seismic slip at a given time occurred in even narrower zone of a few to several millimeters, so that localization of deformation must have occurred within a slipping zone during coseismic fault motion. Fault breccia zones are bounded by thin black gouge layers containing amorphous carbon. Fault gouge contains illite and chlorite minerals, but not smectite. Clayey fault gouge next to coseismic slipping zone also contains amorphous carbon and small amounts of graphite. The structural observations and mineralogical data obtained from outcrop exposures of the fault zone of the Wenchuan earthquake can be compared with those obtained from the WFSD-1 and WFSD-2 boreholes, which have been drilled very close to the Hongkou outcrop. The presence of carbon and graphite, observed next to the slipping-zone, may affect the mechanical properties of the fault and also provide useful information about coseismic chemical changes.     

Contamination status and spatial distribution of organochlorine compounds in fishes from Nansei Islands, Japan

Two species of fishes (n=52; tilapia and mullet) from industrialized and urbanized areas of Okinawa Island (Manko-Noha river, Hija river and Shikaza river) and from a remote area of Ishigaki Island (Anparu mudflat), Japan were collected between August 2005 and July 2006, and analyzed for five organochlorine compounds (OCs), viz., DDTs, PCBs, CHLs, HCHs and HCB. Concentrations and the contamination patterns of OCs in fishes varied between locations. Considerable residue levels of OCs, especially CHLs and DDTs were found in both fishes from the main Okinawa Island. These levels were relatively higher than the reported values for seafood from Japanese coasts, indicating that even now pollution sources of these contaminants still exist in this region. On the other hand, lower concentrations of OCs were detected in fishes from Ishigaki Island waters than those of other Japanese coastal waters, suggesting that this region is less contaminated by OC contaminants.     

Normal faulting of the Daiichi-Kashima Seamount in the Japan Trench revealed by the Kaiko I cruise, Leg 3

A detailed topographic and geophysical survey of the Daiichi-Kashima Seamount area in the southern Japan Trench, northwestern Pacific margin, clearly defines a high-angle normal fault which splits the seamount into two halves. A fan-shaped zone was investigated along 2–4 km spaced, 100 km long subparallel tracks using narrow multi-beam (Seabeam) echo-sounder with simultaneous measurements of gravity, magnetic total field and single-channel seismic reflection records. Vertical displacement of the inboard half was clearly mapped and its normal fault origin was supported. The northern and southern extensions of the normal fault beyond the flank of the seamount were delineated. Materials on the landward trench slope are displaced upward and to sideways away from the colliding seamount. Canyons observed in the upper landward slope terminate at the mid-slope terrace which has been uplifted since start of subduction of the seamount. Most of the landward slope except for the landward walls aside the seamount comprises only a landslide topography in a manner similar to the northern Japan Trench wall. This survey was conducted on R/V “Jean Charcot” as a part of the Kaiko I cruise, Leg 3, in July–August 1984 under the auspices of the French-Japanese scientific cooperative program.