Identification of yield drift deformations and evaluation of the degree of damage through the direct sensing of drift displacements

Inter‐story drift displacement data can provide useful information for story damage assessment. The authors' research group has developed photonic‐based sensors for the direct measurement of inter‐story drift displacements. This paper proposes a scheme for evaluating the degree of damage in a building structure based on drift displacement sensing. The scheme requires only measured inter‐story drift displacements without any additional finite element analysis. A method for estimating yield drift deformation is proposed, and then, the degree of beam end damage is evaluated based on the plastic deformation ratios derived with the yield drift deformation values estimated by the proposed method. The validity and effectiveness of the presented scheme are demonstrated via experimental data from a large‐scale shaking table test of a one‐third‐scale model of an 18‐story steel building structure conducted at E‐Defense. Copyright © 2016 John Wiley & Sons, Ltd.     

Uptake and biological effects of synthetic glucocorticoids in common carp (Cyprinus carpio)

Uptake and biological effects of synthetic glucocorticoids (GCs) were analyzed using common carp (Cyprinus carpio). Fish were exposed to clobetasol propionate (CP) or clobetasone butyrate (CB) individually or in mixture at 1 μg L⁻¹ for 21 days. Bioconcentration factor (BCF) of CB was calculated as 100, and BCF of CP was less than 16. No effects were found in fish erythrocyte and leukocyte numbers and serum glucose levels after exposure to the selected GCs. On the other hand, serum concentrations of free amino acids significantly increased in GC-exposed groups. Thus, exposures to synthetic GCs at relatively low concentrations seemed to cause enhancement of protein degradation and subsequent increase of serum free amino acids without a corresponding increase in serum glucose levels, an effect which might be related to partial induction of gluconeogenesis by GC.     

Anomalous sea-ice reduction in the Eurasian Basin of the Arctic Ocean during summer 2010

During the summer of 2010 ice concentration in the Eurasian Basin, Arctic Ocean was unusually low. This study examines the sea-ice reduction in the Eurasian Basin using ice-based autonomous buoy systems that collect temperature and salinity of seawater under the ice along the course of buoy drift. An array of GPS drifters was deployed with 10 miles radius around an ice-based profiler, enabling the quantitative discussion for mechanical ice divergence/convergence and its contribution to the sea-ice reduction. Oceanic heat fluxes to the ice estimated using buoy motion and mixed-layer (ML) temperature suggest significant spatial difference between fluxes under first-year and multi-year ice. In the former, the ML temperature reached 0.6 K above freezing temperature, providing >60–70 W m^?2 of heat flux to the overlying ice, equivalent to about 1.5 m of ice melt over three months. In contrast, the multiyear ice region indicates nearly 40 W m^?2 at most and cumulatively produced 0.8 m ice melt. The ice concentration was found to be reduced in association with an extensive low pressure system that persisted over the central Eurasian Basin. SSM/I indicates that ice concentration was reduced by 30–40% while the low pressure persisted. The low ice concentration persisted for 30 days even after the low dissipated. It appears that the wind-forced ice divergence led to enhanced absorption of incident solar energy in the expanded areas of open water and thus to increased ice melt.     

Scientific role of ACA for low-mass star-formation study

We discuss the scientific role of the Atacama Compact Array (ACA), the Japanese contribution to the ALMA project, for low-mass star-formation study. Our recent observations of several low-mass protostellar envelopes in the submillimeter CS (J=7–6) and HCN (J=4–3) lines with the SMA and ASTE have revealed that these submillimeter emissions are more extended than ∼2000 AU and show different velocity structures from those traced by millimeter lines. These results suggest the importance of taking short-spacing informations the ACA can offer. Our comprehensive imaging simulations of these protostellar envelopes, as well as prestellar cores and debris disks, unprecedentedly demonstrate the scientific importance of ACA.     

Strontium, oxygen, and hydrogen isotope geochemistry of hydrothermally altered and weathered rocks in DSDP Hole 504B, Costa Rica Rift

DSDP Hole 504B was drilled into 6 Ma crust, about 200 km south of the Costa Rica Rift, Galapagos Spreading Center, penetrating 1.35 km into a section that can be divided into four zones—Zone I: oxic submarine weathering; Zone II: anoxic alteration; Zones III and IV: hydrothermal alteration to greenschist facies. In Zone III there is intense veining of pillow basalts. Zone IV consists of altered sheeted dikes. Isotopic geochemical signatures in relation to the alteration zones are recorded in Hole 504B, as follows:

Zone	Depth(m)	Average87Sr/86Sr	Average δ18O (%o)	Average δD (%o)
I	275–550	0.7032	7.3	−63
II	550–890	0.7029	6.5	−45
III	890–1050	0.7035	5.6	−31
IV	1050–1350	0.7032	5.5	−36

Full-size table

Alteration temperatures are as low as 10°C in Zones I and II based on oxygen isotope fractionation. Strontium isotopic data indicate that a circulation of seawater is much more restricted in Zone II than in Zone I. Fluid inclusion measurements of vein quartz indicate the alteration temperature was mainly 300 ± 20°C in Zones III and IV, which is consistent with secondary mineral assemblages.The strontium, oxygen, and hydrogen isotopic compositions of hydrothermal fluids which were responsible for the greenschist facies alteration in Zones III and IV are estimated to be 0.7037, 2‰, and 3‰, respectively. Strontium and oxygen isotope data indicate that completely altered portions of greenstones and vein minerals were in equilibrium with modified seawater under low water/rock ratios (in weight) of about 1.6. This value is close to that of the end-member hydrothermal fluids issuing at 21°N EPR.Basement rocks are not completely hydrothermally altered. About 32% of the greenstones in Zones III and IV have escaped alteration. Thus 1 g of fresh basalt including the 32% unaltered portion are required in order to make 1 g of end-member solution from fresh seawater in water-rock reactions.     

Step-like temperature fluctuations associated with inverted ramps in a stable surface layer

Ensemble averages of temperature before and after step-like temperature fluctuations reveal the presence of inverted ramps in a stable surface layer. Normalized frequency of upward steps increases with increasing stability, whereas normalized magnitude of the temperature step decreases with stability and becomes constant at about R _i = 1. These results suggest that the significance of temperature steps increases as stability increases. In moderate stability, the temperature pattern shows a gradual decrease after an upward step, which can be called a time-inverted ramp. Descending air and large downward heat flux are observed in a time-inverted ramp, suggesting a contribution from an ordered motion in wind. On the other hand, the temperature steps are related to gravity waves in strong stability.     

Iterative deconvolution of complex body waves from great earthquakes—the Tokachi-Oki earthquake of 1968

A method of body-wave inversion is developed in an attempt to extract the information about asperities or barriers in a fault zone. A sequence of point sources, each being characterized with the seismic moment, the onset time and the location, are iteratively derived from observed records at multi-stations, where the two-dimensional extent of the source location is taken into account. A modification is made of the iterative method of Kikuchi and Kanamori on the formulation of inversion procedure to facilitate the computation.Using this method, we analyse long period P waves of the Tokachi-Oki earthquake of 1968 (M_w = 8.2) and obtain several significant subevents with time durations of ～ 10 s. Their spatio-temporal distribution shows that the rupture process consists of three characteristic stages: (A) a stage of introductory rupture, (B) a stage of main rupture and (C) a stage of aftershocks. The main rupture takes place in the form of clustering around a few sites of the fault plane. The largest subevent occurs in the northwestern corner. The stress drop associated with this event is estimated to be ～ 200 bars, one order of magnitude higher than the stress drop averaged over the entire fault plane. The sum of the seismic moments of the individual subevents amounts to 2.3 × 10²⁸ dyn. cm which approximately coincides with the one estimated from the analysis of long-period surface waves. This implies that the source of the Tokachi-Oki earthquake consists of several major subevents with time durations of ～ 10 s in addition to other minor subevents.     

Evidences linking ENSO and coral growth in the Southwestern-South Atlantic

Physical and biological changes in the marine environment, induced by oceanic-atmospheric processes, can be imprinted in massive coral skeletons. Herein, we present an evidence of potential El Niño impacts at the Southwestern South Atlantic Ocean (SWSA) inferred from the sclerochronology of the reef coral Favia leptophylla. The application of spectral analysis (wavelet decomposition and the iterative regression) to coral growth length and to meteorological-oceanographic parameters (air temperature, sea surface temperature and precipitation) as well as to Southern Oscillation Index (SOI) and solar irradiation indicated a major significant inverse relationship between SOI and coral growth length at the 4–8 years frequency band. We propose here that coral growth length from the SWSA could be affected by El Niño Southern Oscillation (ENSO) events through an “atmospheric bridge”, in contrast to its direct effect at the Pacific Ocean, related to the increase in sea surface temperature.     

A mechanical model for elastomeric seismic isolation bearings including the influence of axial load

For the purpose of predicting the large‐displacement response of seismically isolated buildings, an analytical model for elastomeric isolation bearings is proposed. The model comprises shear and axial springs and a series of axial springs at the top and bottom boundaries. The properties of elastomeric bearings vary with the imposed vertical load. At large shear deformations, elastomeric bearings exhibit stiffening behavior under low axial stress and buckling under high axial stress. These properties depend on the interaction between the shear and axial forces. The proposed model includes interaction between shear and axial forces, nonlinear hysteresis, and dependence on axial stress. To confirm the validity of the model, analyses are performed for actual static loading tests of lead–rubber isolation bearings. The results of analyses using the new model show very good agreement with the experimental results. Seismic response analyses with the new model are also conducted to demonstrate the behavior of isolated buildings under severe earthquake excitations. The results obtained from the analyses with the new model differ in some cases from those given by existing models. Copyright © 2008 John Wiley & Sons, Ltd.     

Population Development of the DinoflagellatesCeratium furca andCeratium fusus during Spring and Early Summer in Iwa Harbor, Sagami Bay, Japan

To examine the population development of the dinoflagellates, Ceratium furca and Ceratium fusus, daily field monitoring was conducted between April and July 2003 in the temperate coastal water of Sagami Bay, Japan. During the study period, the concentrations of C. furca were always lower than those of C. fusus. A sharp increase in the densities of both species was recorded on 5 May showing the maximum cell concentrations (C. furca = 14,800 cells L^-1, C. fusus = 49,600 cells L^-1). In the 7 days prior to the May bloom of the Ceratium species (29 April to 1 May), the highest density of the heterotrophic dinoflagellate Noctiluca scintillans was observed. Additionally, a second bloom of C. fusus occurred on 22 July. Here, two causes of the significant increases in the Ceratium populations during the two blooming periods (first time; 1 to 8 May, second time; 15 to 22 July) are presented. First, an increase in the nutrients of the surface layer regenerated by the breakdown of blooms by N.scintillans could be considered as a major cause of the population increase of the two Ceratium species. Second, a decrease in salinity (to 27 psu) was correlated with the later bloom ofC. fusus. These results suggest that the population development of the two Ceratium species requires nutrients regenerated after the reduction of the diatom population byN. scintillans and, forC. fusus, continuous low salinity conditions, compared to other environmental factors during the rainy season. Key words: Ceratium furca; Ceratium fusus; Noctiluca scintillans; Bloom process; Environmental factor