一种曲线拟合圆心坐标算法及精度分析

针对在工程应用中,经常需要根据某些圆形物体上的离散点求取其圆心坐标,而采用何种算法简单易行,其精度又与哪些因素有关的相关研究较少的问题,该文提出一种利用曲线拟合求取圆心坐标的简洁算法,并编程实现。然后采用模拟仿真结合统计分析的方法评估了该算法在不同条件下的拟合精度,得出测点误差越大,拟合精度越低;测点个数越多,分布越均匀,拟合精度越高;圆半径对拟合精度影响甚小等结论。在某工程项目中使用该算法得到的结果精度较高,验证了其有效可行,且与采用其他方法得到的坐标值较为接近,说明了该算法的可靠性高。     

基于热储法的鲁西平原地热资源评价

鲁西平原地处山东省的西南部,热储层主要有新近系馆陶组、明化镇组,古近系东营组和奥陶系。通过野外勘察和室内分析结果,选取合理的计算参数,利用热储法等对鲁西平原地热资源进行了评价。结果表明鲁西平原地区地热资源量达1.735 5×1021J,折合标准煤5.923 3×1010t;可利用地热资源量达3.252×1020J,折合标准煤1.110×1010t;热储层百年地热水储存量为4.229×1011 m3,地热水允许开发量为4.229×1011 m3。     

An optimized sequential extraction scheme for molybdenum association in environmental samples

By comparing three sequential extraction procedures, a new optimized extraction scheme for the molybdenum association in environmental samples was proposed. Five operational steps were described as exchangeable (KH₂PO₄ + K₂HPO₄: including water-soluble), associated with organic matter (NaOH), Fe–Mn oxides and/or carbonates (HCl), sulfides (H₂O₂) and residue (HNO₃ + HF + H₂O₂). An optimized extraction scheme was compared with Tessier’s procedure and the Commission of European Communities Bureau of Reference (BCR) was applied to black shales. Results showed Tessier’s procedure gave the lowest concentration values for exchangeable molybdenum and the highest values for the residual molybdenum, which could not present the efficiency of the extraction reagents. BCR’s procedure showed the highest values in oxidizable molybdenum and presented four fractions of molybdenum, which did not demonstrate the fractions of molybdenum in the black shales in detail. The optimized extraction scheme demonstrated a certain improvement on extraction efficiency over Tessier’s procedure for the lowest residual molybdenum, and revealed more featured fraction information of molybdenum in black shales than BCR’s. Therefore, after a comparison with other two extraction procedures, the optimized extraction scheme proved suitable for the molybdenum in black shales and it also showed an accurate determination of the molybdenum in the fractions and source of bioavailable Mo.     

激电测量在苏吉泉东金矿勘查中的应用

对苏吉泉东金矿进行激电测量,获得激电异常数据(电阻率ρ_s和视极化率η_s)。把不同测线上性质相同的电阻率ρ_s和视极化率η_s的反交点按对应关系联接起来,分别作为相应的破碎带和极化体位置,同时结合地质资料多次反馈,逐步逼近真实地质体。圈定了PSD1,PSD2两个破碎带和Jht1,Jht2,Jht3三个极化体,通过ρ_s和η_s的一维反演及二维反演,拟合出破碎带和极化体的形态特征及相对深度,为矿产勘探提供了较为明确的地球物理依据。     

Review on Montane Forest Eco-hydrology in Arid Area

Since the forest eco-hydrology of arid area shows a well sensitivity of the global climate change, the relationship between forest and water and the hydrological function has attracted the attention of academic communites and management departments. This paper expounds the research progress in arid mountain forest eco-hydrology, and analyses the formation and stable mechanism of forest patch pattern, the relationship between forest and water yield and the response of forest eco-hydrology to climate change from three aspects: Forest spatial pattern, hydrological process and its response to climate change. In addition, combined with the current research progress, the research emphases in the future are put forward: Strengthening the research on the coupling of vegetation pattern and hydrological process; solving the scale problem by using remote sensing technique and model; enhancing the understanding towards the hydrological function of forest; determining the suitable forest scale which can balance the relationship of ecology and hydrological effect.     

金川铜镍矿床中新生代抬升冷却过程：来自裂变径迹的证据

本文基于热年代学理论,利用锆石和磷灰石裂变径迹测年数据及对磷灰石热史的模拟,分析探讨金川铜镍矿床在中新生代的抬升冷却过程,认为金川超基性岩体自中生代以来一直处于持续的冷却抬升阶段,且在中侏罗世和晚白垩世早期经历了两期快速的抬升冷却事件,推断此事件与青藏高原后期活动时间相对应,证明金川岩体受到该事件的远程效应波及,致使该矿床遭受了一定的改造。     

西藏雅鲁藏布江缝合带西段普兰纯橄岩中橄榄石的出溶特征及指示意义

西藏雅鲁藏布江缝合带西段普兰纯橄岩中橄榄石存在透辉石和磁铁矿共生出溶现象。这类纯橄岩非常新鲜,主要由橄榄石、尖晶石和透辉石等矿物组成。橄榄石的Fo值是90.1~90.7,铬尖晶石的Cr~#为19.8~20.8,远小于蛇绿岩地幔橄榄岩中常见纯橄岩中铬尖晶石的铬值(Cr~#60)。基于前人研究结果,提出这种现象是由于亏损方辉橄榄岩与含钛、铝、钙熔体发生交代作用,从而形成橄榄石的固溶体存在Ti~(4+)、Al~(3+)、Ca~(2+)、Fe~(3+),而Cr~(3+)进入铬尖晶石结晶。后期由于岩体在抬升过程中降温,橄榄石中出溶形成单斜辉石和磁铁矿,而铬尖晶石结晶被保留。依据铬尖晶石-橄榄石的矿物化学成分,识别出低铬纯橄岩具有最低的部分熔融程度为~8%,Cr~#最高的纯橄岩壳其部分熔融程度达到~50%,表明不同岩相间其形成背景存在明显差异。因此,笔者认为普兰蛇绿岩具有多阶段的过程。首先是在洋中脊环境下经历富Ca、Al和Na等熔体交代和部分熔融作用,后受到俯冲带玻安质熔体改造。     

点苍山-哀牢山杂岩带中北段嘎洒地区变沉积岩的成因矿物学与变质演化特征

点苍山-哀牢山变质杂岩带中北段嘎洒地区出露了多种典型的变沉积岩,其中夕线石榴黑云二长片麻岩和二云母片岩保存多期/多阶段矿物相转变特征,本文通过岩相学和矿物化学的综合分析,并结合传统矿物对温压计的估算结果,限定上述典型变沉积岩峰期角闪-麻粒岩相(M1)阶段、近等温减压-高温剪切变形阶段(M2)和晚期退变质(M3)阶段的矿物组合及变质温压条件。峰期角闪-麻粒岩相(M1)阶段的矿物组合为:石榴石(Grt)+板柱状夕线石(Sil1)+黑云母(Bt1)+钾长石(Kfs)+斜长石(Pl)+石英(Qtz)+钛铁矿(Ilm),变质温度压力条件为t=690~750℃,p=690~810 MPa;近等温减压-高温剪切变形阶段(M2)阶段,稳定矿物组合为:Grt+Sil2+Bt2+Kfs+Pl+Qtz+Ilm,黑云母在强烈走滑剪切作用下发生脱水熔融反应:2 Bt→Sil+6(Mg,Fe)O+K_2O+5 Qtz+2 H_2O,石榴石、黑云母和夕线石等受到剪切变形影响而发生强烈定向,形成的温度压力条件为t=650~720℃,p=450~630 MPa;晚期退变质阶段(M_3)的稳定矿物组合为:Qtz+Bt+Ms+Pl,退变的温度压力条件为t=580~640℃,p=400~500MPa。其变质演化p-T轨迹样式具有近等温减压的顺时针型式,表明点苍山-哀牢山变质杂岩带曾经历了一次明显的俯冲-碰撞造山事件,峰期变质可达到角闪-麻粒岩相;在碰撞后的构造折返过程中,上述变质岩石发生强烈的高温剪切变形作用,并伴随着黑云母等含水矿物的脱水熔融。     

澜沧江杂岩带小黑江-上允地区蓝片岩的成因及变质演化

通过对澜沧江杂岩带小黑江-上允地区蓝片岩的岩相学、地球化学、成因矿物学以及相平衡模拟的综合研究,阐述蓝片岩的原岩以及变质演化过程。地球化学分析结果显示,蓝片岩具有一致的稀土元素配分模式,具弱Eu正或负异常,稀土元素和微量元素特征与OIB相似,其原岩可能为OIB型玄武岩。详细矿物学研究表明,本区蓝片岩记录了俯冲峰期蓝片岩相变质和峰期后绿片岩相变质两个变质阶段,其矿物组合分别为蓝闪石+钠长石+多硅白云母+绿泥石+绿帘石和蓝闪石+钠长石±阳起石+绿泥石+绿帘石。通过Na_2O-Ca O-Fe O-MgO-Al_2O_3-SiO_2-H_2O-O体系相平衡计算,得到两个阶段的压力范围分别约为0.95 GPa和0.40 GPa。