Deep-ocean vertical noise directionality

The structure of beam noise measured at the output of a vertical array in a range dependent ocean basin was investigated using the modified wide-angle parabolic equation (PE). Noise sources were distributed throughout the basin, and the field due to each noise source at an array located in the midbasin was calculated. The response of the array to the superposition of the noise sources was found by beamforming. An efficient and direct approach that superimposes the noise sources on the PE field as the field is marched toward the array was developed. Downslope calculations of the midbasin vertical directionality were made between 50 and 400 Hz with this technique. Use of a geoacoustic model shows that the bottom behaves as a low-pass filter     

Inverted echo sounder measurement of dynamic height through an ENSOcycle in the central equatorial Pacific

A four-year record from an inverted echo sounder deployed near Palmyra Island at 6°N in the central Pacific Ocean is compared with a simultaneous record of subsurface pressure from this island lagoon. A factor m, converting round-trip acoustic travel time to surface dynamic height relative to a deep pressure level, was estimated from the ratio of the spectra of the two records in the energetic synoptic oscillation band. Year-to-year variation in m was not statistically significant. For the overall record, m was found to be -70±8 dynamic m/s, where the error bounds represent a 90% confidence interval. This is consistent with first-baroclinic-mode excitation     

Magma homogenization during anatexis,ascent and/or emplacement? Constraints from the Variscan Weinsberg Granites

Recent studies have shown that melts and residues may not equilibrate during anatexis, and uncertainty exists about the scale on which magmas can be homogenized. This study of elemental and isotopic homogeneity of the South Bohemian Weinsberg granites (˜ 5000 km²) identifies three voluminous, relatively homogeneous magma batches. Each batch has different ⁸⁷Sr/⁸⁶Sr_init (0.7080, 0.7093 and 0.7106), but all equilibrated at ˜ 327–329 Ma, very similar to the time of monazite crystallization. The data cannot entirely prove melt/residue equilibration during anatexis. However, elemental and isotopic compositions imply magma generation by partial melting of heterogeneous South Bohemian crust and chemical differentiation subsequent to Sr-isotope equilibration. Assuming relatively rapid ascent and solidification rates, magma homogenization must have occurred mostly just after partial melting, during melt segregation and accumulation in the deeper crust with slow prograde heating. Models of rapid crustal heating and instantaneous melt extraction are incompatible with the data.     

Wooden Panel Deterioration by Tropical Marine Wood Borers

Wood destruction in test panels ofShorea leprosulawas related to the percentage of fouling, types of wood borers and the number of wood borers. The natural durability ofShorea leprosulapanels was estimated to be 4–5 months in Malaysian marine waters. A higher fouling cover resulted in lower rates of wooden panel deterioration. Larger numbers of wood borers brought about greater panel deterioration. Primary wood destruction was caused by bivalve wood borers, mainlyMartesia striata, Lyrodus pedicellatus, Bankia campanellata, Teredo furciferaandTeredo bartschi. Martesia striatawas the important wood destroying agent in the intertidal zone and, together with the shipworms, was also responsible for panel destruction in the subtidal zone.     

Effect of element size on the static finite element analysis of steep slopes

The accuracy of the computed stress distribution near the free surface of vertical slopes was evaluated in this study as a function of the element size, including aspect ratio. To accomplish this objective, a parametric study was carried out comparing stresses computed using the finite element method (FEM) to those obtained from a physical model composed of photoelastic material. The results of the study indicate a reasonable agreement between a gelatin model and the FEM model for shear stresses, and an overall good agreement between the two models for the principal stresses. For stresses along the top of the slope, the height of the element tends to be more important than width or aspect ratio, at least for aspect ratios up to 4. In all cases, the greatest difference between the two models occurs in the vicinity of the slope. Specifically, if H is defined as the slope height, an element height of H/10 appears to be adequate for the study of stresses deep within the slope, such as for typical embankment analyses. However, for cases where tensile stresses in the vicinity of the slope face which are critical, such as for the stability analysis of steep slopes, element heights as small as H/32, or higher‐order elements, are necessary. Copyright © 2001 John Wiley & Sons, Ltd.     

A time series analysis of sound propagation in a strongly multipathshallow water environment with an adiabatic normal mode approach

Measured time series were generated by small omnidirectional explosive sources in a shallow water area. A bottom-mounted hydrophone recorded sound signals that propagated over a sloping bottom. The time series in the 250-500 Hz band were analyzed with a broad-band adiabatic normal mode approach. The measured waveforms contain numerous bottom interacting multipaths that are complicated by the subbottom structure that contains high-velocity layers near the water-sediment interface. Several of the details of the geoacoustic structure and the depth of the water column at the receiver are inferred from comparisons of the measured data to simulated time series. The sensitivity of broad-band matched-field ambiguity surfaces in the range-depth plane for a single receiver to selected waveguide parameters is examined. A consistent analysis is made where the simulated time series are compared to the measured time series along with the single-receiver matched-field localization solutions for ranges out to 5 km. In this range interval, it was found that the peak cross-correlation between the measured and simulated time series varied between 0.84 and 0.69. The difference between the GPS range and the range obtained from the matched-field solution varied from 0 to 63 m. The geoacoustic structure obtained in the analysis consists of an 8-m low-velocity sediment layer over an 8-m high-velocity layer followed by a higher velocity, infinite half-space     

Low-cost volcano surveillance from space: case studies from Etna, Krafla, Cerro Negro, Fogo, Lascar and Erebus

 Satellite data offer a means of supplementing ground-based monitoring during volcanic eruptions, especially at times or locations where ground-based monitoring is difficult. Being directly and freely available several times a day, data from the advanced very high resolution radiometer (AVHRR) offers great potential for near real-time monitoring of all volcanoes across large (3000×3000 km) areas. Herein we describe techniques to detect and locate activity; estimate lava area, thermal flux, effusion rates and cumulative volume; and distinguish types of activity. Application is demonstrated using data for active lavas at Krafla, Etna, Fogo, Cerro Negro and Erebus; a pyroclastic flow at Lascar; and open vent systems at Etna and Stromboli. Automated near real-time analysis of AVHRR data could be achieved at existing, or cheap to install, receiving stations, offering a supplement to conventional monitoring methods. Received: 21 January 1997 / Accepted: 3 April 1997     

Depositional and post‐depositional history of warm stage deposits at Knocknacran,Co. Monaghan,Ireland: implications for preservation of Irish last interglacial deposits

Organic‐rich deposits, uncovered during overburden removal from mantled gypsum karst at Knocknacran opencast gypsum mine, Co. Monaghan, are the best candidate to date for a last interglacial record in Ireland. The two till and organic‐rich deposits (preserved at different quarry elevations) were emplaced on to a Tertiary dolerite surface during high‐energy flood events and subsequently folded and faulted by movement towards sinkholes in underlying gypsum. Uranium–thorium disequilibrium dating suggests that the organic‐rich deposits in the upper section were hydrologically isolated at ca. 41 ka and those in the lower section at ca. 86 ka. Interpretation of the pollen content, although tentative because of the depositional and post‐depositional history of the material, suggests that the organic material originated in a warm stage possibly warmer than the post‐Eemian interstadials. The unusual setting of preservation may indicate that in situ, last interglacial deposits have generally been removed by erosion in Ireland. Copyright © 2004 John Wiley & Sons, Ltd.     

A comparative study of the zooplankton in two adjacent embayments,Port Phillip and Westernport Bays,Australia

We report on a year's study of spatial and seasonal patterns of zooplankton abundance in Port Phillip and Westernport Bays, July 1982 to August 1983. These two bays, closely adjacent on the southern coast of Victoria, Australia, differ in several respects: Port Phillip is a nearly landlocked bay with a broad basin, while Westernport is an open tidal embayment with extensive mud and seagrass banks. Both bays have a resident zooplankton fauna distinct from that of Bass Strait. Although these resident communities have many species in common, patterns of abundance and dominance are quite different. We found that the holoplankton of Port Phillip was about half copepods, mostly Paracalanus indicus, with 23% Caldocera and 21% larvaceans. Westernport Bay zooplankton was dominated by Acartia tranteri, with no resident cladoceran fauna. Bass Strait species were more often found in Westernport than in Port Phillip Bay, but the resident community of Port Phillip Bay was more similar to that of Bass Strait than to that of Westernport.Although this study was undertaken in an exceptionally dry year, the available historical data show that the overall patterns found in 1982–1983 are typical for these bays. The differences in community composition probably relate to differences in depth profile, predator abundance, and suspended matter between the bays.     

An analytical model for the HF backscattered Doppler spectrum for the ocean surface

An analysis previously developed for rough surface scattering with narrow-beam reception is extended to wide-beam or omnidirectional reception. The source is considered to be a pulsed electric dipole. The analysis includes multipathing effects on the received signal. The results are used to develop a model for the backscattered radar cross section of the ocean surface, up to a second-order approximation.