Post-earthquake investigation on several geosynthetic-reinforced soil retaining walls and slopes during the Ji-Ji earthquake of Taiwan

This paper gives an overview on the application of geosynthetic-reinforced soil structures in Taiwan. Taiwan has an unique topography and geotechnical conditions that rendered a less conservative and more challenging design compared to that of North America, Europe and Japan. The Ji-Ji (Chi-Chi) earthquake of 1999 gave an opportunity to examine the behavior of reinforced soil structures. The performance of several modular-block reinforced soil retaining walls and reinforced slopes at the vicinity of the fault was evaluated. Reinforced structures performed better than unreinforced soil retaining walls. The failure cases were highlighted and the cause of failure was identified. The lack of seismic design consideration could be a major cause of failure. The compound failure mode, the inertia force of the blocks, and the connection stiffness and strength relative to the large dynamic earth pressure, were among major items that would warrant further design consideration.     

Impact of model development,calibration and validation decisions on hydrological simulations in West Lake Erie Basin

Watershed simulation models are used extensively to investigate hydrologic processes, landuse and climate change impacts, pollutant load assessments and best management practices (BMPs). Developing, calibrating and validating these models require a number of critical decisions that will influence the ability of the model to represent real world conditions. Understanding how these decisions influence model performance is crucial, especially when making science‐based policy decisions. This study used the Soil and Water Assessment Tool (SWAT) model in West Lake Erie Basin (WLEB) to examine the influence of several of these decisions on hydrological processes and streamflow simulations. Specifically, this study addressed the following objectives (1) demonstrate the importance of considering intra‐watershed processes during model development, (2) compare and evaluated spatial calibration versus calibration at outlet and (3) evaluate parameter transfers across temporal and spatial scales. A coarser resolution (HUC‐12) model and a finer resolution model (NHDPlus model) were used to support the objectives. Results showed that knowledge of watershed characteristics and intra‐watershed processes are critical to produced accurate and realistic hydrologic simulations. The spatial calibration strategy produced better results compared to outlet calibration strategy and provided more confidence. Transferring parameter values across spatial scales (i.e. from coarser resolution model to finer resolution model) needs additional fine tuning to produce realistic results. Transferring parameters across temporal scales (i.e. from monthly to yearly and daily time‐steps) performed well with a similar spatial resolution model. Furthermore, this study shows that relying solely on quantitative statistics without considering additional information can produce good but unrealistic simulations. Copyright © 2015 John Wiley & Sons, Ltd.     

The mass accommodation coefficient of ammonia on water

The mass accommodation coefficient of ammonia gas on water has been determined by measuring the absorption rate of 50–200 ppm NH₃ in one atm of air or helium into a liquid jet of 97 µm diameter as function of the exposed jet length, and comparing the results with numerical simulations which treat as the only free parameter. The model considers in detail transport of NH₃ by molecular diffusion, penetration of the gas/water interface, hydrolysis in the acidified water, and transport of the solutes from the surface into the jet. A correction is applied for the time evolution of the jet surface speed, using literature data on the fluid mechanics of liquid jets. The result of nine sets of independent measurements is

Land surface coupling in regional climate simulations of the West African monsoon

Coupling of the Community Land Model (CLM3) to the ICTP Regional Climate Model (RegCM3) substantially improves the simulation of mean climate over West Africa relative to an older version of RegCM3 coupled to the Biosphere Atmosphere Transfer Scheme (BATS). Two 10-year simulations (1992–2001) show that the seasonal timing and magnitude of mean monsoon precipitation more closely match observations when the new land surface scheme is implemented. Specifically, RegCM3–CLM3 improves the timing of the monsoon advance and retreat across the Guinean Coast, and reduces a positive precipitation bias in the Sahel and Northern Africa. As a result, simulated temperatures are higher, thereby reducing the negative temperature bias found in the Guinean Coast and Sahel in RegCM3–BATS. In the RegCM3–BATS simulation, warmer temperatures in northern latitudes and wetter soils near the coast create excessively strong temperature and moist static energy gradients, which shifts the African Easterly Jet further north than observed. In the RegCM3–CLM3 simulation, the migration and position of the African Easterly Jet more closely match reanalysis winds. This improvement is triggered by drier soil conditions in the RegCM3–CLM3 simulation and an increase in evapotranspiration per unit precipitation. These results indicate that atmosphere–land surface coupling has the ability to impact regional-scale circulation and precipitation in regions exhibiting strong hydroclimatic gradients.     

Stratigraphy of total metals in PIRLA sediment cores

Sediment cores from 30 low-alkalinity lakes in northern New England (NE), New York (NY), the northern Great Lakes States (NGLS) of Minnesota, Michigan, and Wisconsin, and Florida (FL) have been dated by ²¹⁰Pb and analyzed for water and organic content, eight major elements (Al, Ti, Fe, Mn, Ca, Mg, Na, K) plus four trace metals (Pb, Zn, Cu, and V). Variations in the percentages of major elements through time are dominated by long-term independent variations in the abundance of SiO₂, FeO, and to a lesser extent Ca and Al. Additional variations are caused by varying proportions of inorganic matter. Major variations in chemistry are generally unrelated to documented distrubances in the watersheds; most disturbances are minor fires or selective logging.Accelerated accumulation of Pb from atmospheric sources into sediment first occurs in sediment dated between 1800 and 1850 in NY and NE, slightly later in the NGLS region, and about 1900 in FL. Modern accumulation rates in all areas are comparable (ca. 1 to 4 g cm^–2 yr^–1). Accumulation rates of Pb in some lakes have declined significantly from 1975 to 1985. Atmospheric deposition of anthropogenic Zn and Cu is also indicated by generally increasing accumulation rates in sediment cores, but the record is not as clear nor are chemical profiles in all lakes parallel to the trends in atmospheric emissions inferred on the basis of fossil fuel consumption, smelting, and other industrial activities. Inter-lake variations in profiles of Cu and Zn are large. Vanadium accumulation rates increase by the 1940s in NY and NE, but not until the 1950s in the NGLS region. This timing correlates with regional trends in the combustion of fuel oil, a major source of atmospheric V.Acidification of some of the lakes is suggested by decreases in the concentration and accumulation rates of Mn, Ca, and Zn in recent sediment, relative to other elements of catchment origin. The decreases generally occur slightly before the onset of acidification as indicated by diatoms. Increased sediment accumulation rates for Fe may indicate the acidification of watershed soils. The use of the accumulation rate of TiO₂ as an indicator of rates of erosion and for normalization of trace metal accumulation rates is in question for lakes where the flux of TiO₂ from the atmosphere varies and is a significant fraction of the total flux of TiO₂ to the sediment.This is the thirteenth of a series of papers to be published by this journal which is a contribution of the Paleoecological Investigation of Recent Lake Acidification (PIRLA) project. Drs. D. F. Charles and D. R. Whitehead are guest editors for this series.     

Impact of the moisture transport formulation on the simulated tropical rainfall in a general circulation model

The impact of numerical modeling of moisture transport on the simulation of the seasonal mean pattern of precipitation in the tropics is studied. The NCAR CCM2 with spectral and semi-Lagrangian moisture transport has been used for this purpose. The differences in the numerical modeling of moisture transport are found to have a significant impact on the simulation of the seasonal mean patterns. The major differences while using the spectral method (vis-a-vis the semi-Lagrangian method) are (1) a decrease in rainfall over the Indian monsoon region, (2) a decrease in rainfall over the west Pacific region and (3) an increase in rainfall over the central and east Pacific regions. There are substantial differences in the amount of precipitable water vapor simulated by the two moisture transport techniques. It is shown that the difference in precipitable water vapor between the two simulations is associated with changes in the vertical moist static stability (VMS) of the atmosphere, and differences in the simulated precipitation patterns. Received: 7 August 1998 / Accepted: 15 October 1999     

Numerical experiments on the four-dimensional assimilation of the observation data derived in the Black Sea in June 1984 on the basis of a numerical energy-balanced model

A procedure for the four-dimensional (4D) analysis of the hydrophysical fields in the Black Sea with an assimilation of the temperature and salinity (T, S) data was realized on the basis of a numerical model which involves the primitive equations of motion, and the heat and salt advection equations. Two experiments were carried out which differed by the observation data assimilation procedure. Analysis has shown that the observation data assimilation procedure realized using the energy-balanced model allows the reproduction of some synoptic features of the circulation in the Black Sea. A comparison of two computations demonstrates the efficiency of assimilating the measurement data on the basis of the 4D analysis as compared with the sequential objective analysis.Translated by Mikhail M. Trufanov.     

Neutron background in large-scale xenon detectors for dark matter searches

Simulations of the neutron background for future large-scale particle dark matter detectors are presented. Neutrons were generated in rock and detector elements via spontaneous fission and (α,n) reactions, and by cosmic-ray muons. The simulation techniques and results are discussed in the context of the expected sensitivity of a generic liquid xenon dark matter detector. Methods of neutron background suppression are investigated. A sensitivity of 10⁻⁹–10⁻¹⁰ pb to WIMP-nucleon interactions can be achieved by a tonne-scale detector.     

The August 27, 2008, M w = 6.3 Kultuk earthquake (South Baikal): The stress-strain state of the source area from the aftershock data

We consider the results of reconstructing the stress-strain state of the Earth’s crust in South Baikal from the focal mechanism data for the Kultuk earthquake of August 27, 2008 (M _w = 6.3) and its aftershocks. The source parameters of the main shock were determined by calculating the seismic moment tensor. The focal mechanism solutions of 32 aftershocks (M _w ≥ 2.3) were obtained through the deployment of a local seismic network at South Baikal. It is found that the main shock and first aftershocks (August–September) gave rise to the activation of latitudinal fragments of the segmented near-edge fault, and the sources of the consequent aftershocks were dominated by the NW-striking planes related to the small intrabasin structures. The calculations of seismotectonic deformations based on the data on the focal mechanisms of the earthquakes show that the area of activation is dominated by the transtension regime (with deformation in the form of extension with shear). The epicentral and hypocentral fields of the aftershocks and the mechanisms of their sources reflect the complex tectonic structure of the source zone of the Kultuk earthquake, which exhibits a clear subvertical zonality of the local seismically active volume and a wedge-shaped area of crustal destruction.