Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

A POORLY GRAPHITISED CARBON CONTAMINANT IN STUDIES OF EXTRATERRESTRIAL MATERIALS

Poorly-graphitised carbon particles are formed during manufacture of sample substrates (holey carbon films) for Analytical Electron Microscopy studies of small particles. The particles form during heat treatment of cellulose acetobutyrate at about 975 °C and 1050 °C. In AEM studies of fine-grained carbonaceous extraterrestrial materials, these particles are easily recognised.     

AN EVALUATION OF SAS/GRAPH SOFTWARE FOR COMPUTER CARTOGRAPHY1

The SAS® computer software system, widely used and respected for its capabilities in statistical analysis and data base management, now includes a new set of graphic and cartographic procedures called SAS GRAPH?. We have used these cartographic procedures in research on mapping ethno-cultural census data from metropolitan areas in Ontario and in undergraduate and graduate courses in computer cartography. On the basis of that experience, we describe and evaluate SAS/GRAPH'S cartographic capabilities and illustrate with maps drawn by various devices.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Microstructures of co-axially folded vein segments and crenulation cleavage： Evidence for dissolution phenomena in the Chamba Thrust Sheet, western Himalayas

The metasediments in the Chamba region experienced three phases of deformation: DF1, DF2 and DF3.Folded quartz veins are co-folded with the F2 crenulation folds. Their geometric and tectonic significance is studied by microstructures and shortening adjacent to the discrete crenulation cleavage, S2. Microstructures of folded vein segments, their geometric changes and truncation to cleavage (S2) are mainly due to pressure-solution phenomena and the estimated volume loss from reconstructed vein segments range from 16 to 25.5%,which is closely related to volume decrease (26%) calculated from the polydeformed slates of North Wales areas.     

Calibration of the kinematic method of studying solar wind disturbances on the basis of a one-dimensional MHD solution and a simulation study of the heliosphere disturbances between 22 november and 6 december 1977

An empirical kinematic method developed by Hakamada and Akasofu (1982) is calibrated on the basis of a one-dimensional MHD solution. The calibrated results are used to simulate the stream-stream interaction and the background corotating structure in a simple situation and also during 22 November–6 December 1977. The solar wind disturbances caused by solar activities during this period are then introduced into the above background stream in simulating the heliospheric disturbance event which was observed by an aligned set of spacecraft at distances between 0.6 and 1.6 a.u. The observations and the simulated results are satisfactory, and a little more refinement in the simulation could reconstruct reasonably well the data by filling the data gaps in the solar wind speed, the density and the IMF magnitude.     

THE BLOOMINGTON (LL6) CHONDRITE AND ITS SHOCK MELT GLASSES

The Bloomington meteorite, a 67.8 gram veined, brecciated chondrite, fell during the summer of 1938 in Bloomington, Illinois. Its olivine, orthopyroxene and metal compositions (fo₆₉, en₇₄ and Fe₅₂ Ni₄₈ respectively) and its texture identify it as a brecciated LL6 chondrite of shock facies d. Shock melt glasses occur in Bloomington as sparse melt pockets and veins in clasts and as isolated masses in the black, clast-rich matrix. The vein glasses chemically resemble bulk LL-group chondrites and thus appear to reflect total melting of the host meteorite. The melt pocket and matrix glasses, like those described previously in L-group chondrites, have more varied compositions and are typically enriched in normative plagioclase. All glasses that we analyzed in Bloomington have FeO/MgO and Na/Al ratios similar to those of LL-group chondrites, indicating that melting of this meteorite involved neither a significant change in the oxidation state of iron nor loss of sodium to a vapor phase. Bloomington is a monomict breccia whose components formed in place as a result of a single episode of shock and attendant melting.     

Stray-light measurements at the Observatorio del Teide

A new procedure to separate the instrumental and atmospheric components of stray light is presented. It is based on the dependence of the aureole's atmospheric component on the air mass and is applied to measurements taken with the Vacuum Newton Telescope (VNT) at the Observatorio del Teide (Tenerife). The resulting instrumental part is independent of the air mass.The variation of both components with wavelength is also studied. The instrumental component shows no dependence on wavelength, in contrast to the atmospheric one which is greater in the blue than in the red.It is concluded that observations with air masses larger than two will probably be strongly affected by stray light.     

TWO COMPONENTS OF COSMIC-RAY MODULATION

The long-term modulation of galactic cosmic rays is investigated from 1957 up to 1992 analysing the dynamic and the quasi-stationary components, separately. It has been found that the dynamic component is characterized by the presence of two peaks at the maximum phase of each solar activity cycle. We infer that the time interval between the two peaks corresponds to a period (well-related to the polar heliomagnetic reversal) in which somewhat decreased activity occurs for intense and long-lasting solar events. In fact, a contemporary dip in the magnetic energy released from the Sun was observed, in agreement with the suggested double maximum displayed by the basic features of the 11-year solar-activity cycle (Gnevyshev, 1977, and references therein). Moreover, the dynamic component of cosmic-ray modulation often shows a multi-structured profile in both peaks of activity, fairly well-connected with the pattern of the green corona brightness. On the other hand, analysing the quasi-stationary long-term trend of cosmic-ray intensity we pick out a good relationship between periods of enhanced cosmic-ray modulation and the area expansion of coronal intensity levels. The relevance of our results for solar-terrestrial forecasting is underlined.