On the Correlation between Convective Plume Updrafts and Downdrafts,Lidar Reflectivity and Depolarization Ratio

We question the correlation between vertical velocity (w) on the one hand and the occurrence of convective plumes in lidar reflectivity (i.e. range corrected backscatter signal Pz ²) and depolarization ratio (Δ) on the other hand in the convective boundary layer (CBL). Thermal vertical motion is directly investigated using vertical velocities measured by a ground-based Doppler lidar operating at 2 μm. This lidar provides also simultaneous measurements of lidar reflectivity. In addition, a second lidar 200 m away provides reflectivities at 0.53 and 1 μm and depolarization ratio at 0.53 μm. The time series from the two lidars are analyzed in terms of linear correlation coefficient (ρ). The main result is that the plume-like structures provided by lidar reflectivity within the CBL as well as the CBL height are not a clear signature of updrafts. It is shown that the lidar reflectivity within the CBL is frequently anti-correlated (ρ (w, Pz ² )) with the vertical velocity. On the contrary, the correlation coefficient between the depolarization ratio and the vertical velocity ρ (w, Δ ) is always positive, showing that the depolarization ratio is a fair tracer of updrafts. The importance of relative humidity on the correlation coefficient is discussed. An erratum to this article can be found at     

Oxygen and organic carbon fluxes in sediments of the Bay of Biscay

The relationship between particulate organic carbon (POC) concentrations measured in modern sediment and fluxes of exported POC to the sediment surface needs to be understood in order to use POC content as a proxy of paleo-environmental conditions. The objective of our study was to compare POC concentrations, POC mineralization rates calculated from O₂ consumption and POC burial rates. Benthic O₂ distributions were determined in 58 fine-grained sediment cores collected at different periods at 14 stations in the southeastern part of the Bay of Biscay with depths ranging from 140 to 2800 m. Depth-dependent volume-specific oxygen consumption rates were used to assess rates of aerobic oxidation of organic matter (OM), assuming that O₂ consumption solely was related to heterotrophic activity at the sediment–water interface. Heterogeneity of benthic O₂ fluxes denoted changes in time and space of fresh organic material sedimentation. The most labile fraction of exported POC engendered a steep decrease in concentration in the upper 5 mm of vertical O₂ profiles. The rupture in the gradient of O₂ microprofile may be related to the bioturbation-induced mixing depth of fast-decaying carbon. Average diffusive O₂ fluxes showed that this fast-decaying OM flux was much higher than buried POC, although diffusive O₂ fluxes underestimated the total sediment oxygen demand, and thus the fast-decaying OM flux to the sediment surface. Sedimentary POC burial was calculated from sediment mass accumulation rate and the organic carbon content measured at the top of the sediment. The proportion of buried POC relative to total exported POC ranged at the most between 50% and 10%, depending on station location. Therefore, for a narrow geographic area like the Bay of Biscay, burial efficiency of POC was variable. A fraction of buried POC consisted of slow-decaying OM that was mineralized within the upper decimetres of sediment through oxic and anoxic processes. This fraction was deduced from the decrease with depth in POC concentration. At sites located below 500 m water depth, where the fast-decaying carbon did not reach the anoxic sediment, the slow-decaying pool may control the O₂ penetration depth. Only refractory organic material was fossilized in sedimentary records at locations where labile OM did not reach the anoxic portion of the sediment.     

Evidence for a warmer period during the 12th and 13th centuries AD from chironomid assemblages in Southampton Island, Nunavut, Canada

This study presents the Late-Holocene evolution of a northern Southampton Island (Nunavut, Canada) lake, using fossil chironomids supported by sedimentological evidences (XRF, grain size and CNS). All proxies revealed a relatively stable environment during the last millennium with short-lived events driving changes in the entire lake ecosystem. The chironomid-based paleotemperatures revealed variations of significant amplitude coincident with changes in the sediment density and chemical composition of the core. Higher temperature intervals were generally correlated to lower sediment density with higher chironomid concentration and diversity. Higher temperatures were recorded from cal yr AD 1160 to AD 1360, which may correspond to the Medieval Warm Period. Between cal yr AD 1360 and AD 1700, lower temperatures were probably related to a Little Ice Age event. This study presents new information on the timing of known climatic events which will refine our knowledge of the paleoclimate and climatic models of the Foxe Basin region. It also provides a new framework for the evolution of such freshwater ecosystems under the “Anthropocene” and underlines the importance of including sedimentological proxies when interpreting chironomid remains as this combined approach provides an extended overview of the past hydrological and geochemical changes and their impacts on lake biota.     

An enhanced constitutive model for crushable granular materials

Studies in the past have tried to reproduce the mechanical behaviour of granular materials by proposing constitutive relations based on a common assumption that model parameters and parameters describing the properties, including gradation of individual grains are inevitably linked. However successful these models have proved to be, they cannot account for the changes in granular assembly behaviour if the grains start to break during mechanical loading. This paper proposes to analyse the relation between grading change and the mechanical behaviour of granular assembly. A way to model the influence of grain breakage is to use a critical state‐based model. The influence of the amount of grain breakage during loading, depending on the individual grain strength and size distribution, can be introduced into constitutive relations by means of a new parameter that controls the evolution of critical state with changes in grain size distribution. Experimental data from a calcareous sand, a quartz sand, and a rockfill material were compared with numerical results and good‐quality simulations were obtained. The main consequences of grain breakage are increased compressibility and a gradual dilatancy disappearance in the granular material. The critical state concept is also enriched by considering its overall relation to the evolution of the granular material. Copyright © 2009 John Wiley & Sons, Ltd.     

Long-Period Variations of the Eccentricity Vector Valid also for Near Circular Orbits around a Non-Spherical Body

This paper studies the long period variations of the eccentricity vector of the orbit of an artificial satellite, under the influence of the gravity field of a central body. We use modified orbital elements which are non-singular at zero eccentricity. We expand the long periodic part of the corresponding Lagrange equations as power series of the eccentricity. The coefficients characterizing the differential system depend on the zonal coefficients of the geopotential, and on initial semi-major axis, inclination, and eccentricity. The differential equations for the components of the eccentricity vector are then integrated analytically, with a definition of the period of the perigee based on the notion of “free eccentricity”, and which is also valid for circular orbits. The analytical solution is compared to a numerical integration. This study is a generalization of (Cook, Planet. Space Sci., 14, 1966): first, the coefficients involved in the differential equations depend on all zonal coefficients (and not only on the very first ones); second, our method applies to nearly circular orbits as well as to not too eccentric orbits. Except for the critical inclination, our solution is valid for all kinds of long period motions of the perigee, i.e., circulations or librations around an equilibrium point.     

Bioaccumulation et elimination du 65Zn par Gammarus aequicauda martimov

Uptake of ⁶⁵Zn by Gammarus aequicauda results in a concentration factor of approximately 50 and it is characterised by a maximal accumulation level attained as early as the third day of the experiment. After ingestion by the gammarids of twenty contaminated meals which are distributed over a 45-day period, a transfer of ⁶⁵Zn between the food and the consumer can be observed but there is no sign of the biomagnification phenomenon. The retention rate of the radionuclide is only about 1·5% and the ⁶⁵Zn concentration in the gammarids remains markedly inferior to that of the ingested food.The elimination of the ⁶⁵Zn fixed directly from water takes place according to an exponential model which corresponds to the existence of three biological half-lives of the radionuclide, $\text{Tb}{}_1\text{? 0·5 day, Tb}{}_2\text{? 3·5 days and Tb}{}_3\text{? days}$. The excretion of ⁶⁵Zn accumulated from food is a simple exponential phenomenon which corresponds to only one biological half-life of approximately 17 days.     

Jacques Bertin’s legacy in information visualization and the reorderable matrix

ABSTRACT

Jacques Bertin’s legacy extends beyond the domain of cartography, and in particular to the field of information visualization where he continues to inspire researchers and practitioners. Although in the late twentieth century his books were out of print, their reedition around 2010 has steered a renewed interest and inspired new generations of researchers to reinterpret the principles of Semiology of Graphics and La Graphique in a time of interactive computers. In particular, the work of Jacques Bertin on the reorderable matrix has been very challenging in his time, and the quest to its automation has not been satisfactory to him. This article summarizes Bertin’s approach to the reorderable matrix, underlines the limitations of fully automated reordering methods, and introduces Bertifier, a hybrid system to reorder matrices using a combination of machine assistance and human control.