A Si/CdTe Compton Camera for gamma-ray lens experiment

Cadmium telluride (CdTe) and cadmium zinc telluride (CdZnTe) have been regarded as promising semiconductor materials for hard X-ray and γ-ray detection. However, a considerable amount of charge loss in these detectors results in a reduced energy resolution. We have achieved a significant improvement in the spectral properties by forming the Schottky junction on the Te side of the CdTe wafer. With the further reduction of leakage current by an adoption of guard ring structure, we have demonstrated a CdTe pixel detector with high energy resolution and full charge collection capabilty. The detector has a pixel size of a few mm and a thickness of 0.5 $-$ 1 mm. We apply this high resolution detector to a new silicon and CdTe Compton Camera which features high angular resolution. We also describe a concept of the stack detector which consists of many thin CdTe layers and provides sufficient efficiency for hard X-rays and gamma-rays up to several hundred keV maintaining good energy resolution. A narrow-FOV Compton telescope can be realized by installing a Si/CdTe Compton Camera inside the deep well of an active shield. This configuration is very suitable as focal plane detector for future focusing gamma-ray missions.     

Borehole water and hydrologic model around the Nojima fault, SW Japan

The active fault drilling at Nojima Hirabayashi after the 1995 Hyogoken-nanbu (Kobe) earthquake (M_JMA = 7.2) provides us with a unique opportunity to investigate subsurface fault structure and the in-situ properties of fault and fluid. The borehole intersected the fault gouge of the Nojima fault at a depth interval of 623 m to 625 m. The lithology is mostly Cretaceous granodiorite with some porphyry dikes.The fault core is highly permeable due to fracturing. The borehole water was sampled in 1996 and 2000 from the depth interval between 630 and 650 m, just below the fault core. The chemical and isotopic compositions were analyzed. Carbon and oxygen isotope ratios of carbonates from the fault core were analyzed to estimate the origin of fluid.The following conclusions were obtained. (1) The ionic and isotopic compositions of borehole water did not change from 1996 to 2000. They are mostly derived from local ground water as mentioned by Sato and Takahashi [Sato, T., Takahashi, M., 2000. Chemical and isotopic compositions of groundwater obtained from the Hirabayashi well. Geological Survey of Japan Interim Report No. EQ/00/1, 187–192.]. (2) Geochemical speciation revealed that the borehole water was derived from a relatively deep reservoir, which may be situated at a depth of 3 to 4 km where the temperature is about 80–90 °C. (3) The shallower part of the Nojima fault (shallower than the reservoir depth) has not been healed from the hydrological viewpoints 5 years after the event, in contrast to the rapid healing detected by S wave splitting [Tadokoro, K., Ando, M., 2002. Evidence for rapid fault healing derived from temporal changes in S wave splitting, Geophys. Res. Lett., 29, 10.1029/2001GL013644.]. (4) Precipitation of calcite from the present borehole water since drilling supports the idea of precipitation of some calcite in coseismic hydraulic fractures in the fault core [Boullier, A-M., Fujimoto, K., Ohtani, T., Roman-Ross, G., Lewin, E., Ito, H., Pezard, P., Ildefonse, B., 2004. Textural evidence for recent co-seismic circulation of fluids in the Nojima fault zone, Awaji Island, Japan., Tectonophysics, 378, 165–181.]. (5) Carbon and oxygen isotope ratios of calcite indicated that the meteoric water flux had been localized at the fault core. (6) A difference in the carbon isotope ratio between the footwall and the hanging wall suggests that the fault has been acted as a hydrologic barrier, although the permeability along the fault is still high.     

Fault configuration produced by initial arc rifting in the Parece Vela Basin as deduced from seismic reflection data

Abstract   The Parece Vela Basin (PVB), which is a currently inactive back-arc basin of the Philippine Sea Plate, was formed by separation between the Izu-Ogasawara Arc (IOA) and the Kyushu-Palau Ridge (KPR). Elucidating the marks of the past back-arc opening and rifting is important for investigation of its crustal structure. To image its fault configurations and crustal deformation, pre-stack depth migration to multichannel seismic reflection was applied and data obtained by the Japan Agency for Marine-Earth Science and Technology and Metal Mining Agency of Japan and Japan National Oil Corporation (Japan Oil, Gas and Metals National Corporation). Salient results for the pre-stack depth-migrated sections are: (i) deep reflectors exist around the eastern margin of KPR and at the western margin of IOA down to 8 km depth; and (ii) normal fault zones distributed at the eastern margin of the KPR (Fault zone A) and the western margin of the IOA (Fault zone B) have a total displacement of greater than 500 m associated with synrift sediments. Additional normal faults (Fault zone C) exist 20 km east of the Fault zone B. They are covered with sediment, which indicates deposition of recent volcanic products in the IOA. According to those results: (i) the fault displacement of more than 500 m with respect to initial rifting was approximately asymmetric at 25 Ma based on PSDM profiles; and (ii) the faults had reactivated after 23 Ma, based on the age of deformed sediments obtained from past ocean drillings. The age of the base sediments corresponds to those of spreading and rotation after rifting in the PVB. Fault zone C is covered with thick and not deformed volcanogenic sediments from the IOA, which suggests that the fault is inactive.     

Tsunami Assessment for Risk Management at Nuclear Power Facilities in Japan

The present study focuses on evaluation of the maximum and minimum water levels caused by tsunamis as risk factors for operation and management at nuclear power facilities along the coastal area of Japan. Tsunamis generated by submarine earthquakes are examined, basing literature reviews and databases of information on historical tsunami events and run-up heights. For simulation of water level along the coast, a numerical calculation system should be designed with computational regions covering a particular site. Also the calculation system should be verified by comparison of historical and calculated tsunami heights. At the beginning of the tsunami assessment, the standard faults, their locations, mechanisms and maximum magnitudes should be carefully estimated by considering historical earthquake-induced tsunamis and seismo-tectonics at each area. Secondly, the range of errors in the model parameters should be considered since earthquakes and tsunamis are natural phenomena that involve natural variability as well as errors in estimating parameters. For these reasons, uncertainty-induced errors should be taken into account in the process of tsunami assessment with parametric study of the tsunami source model. The element tsunamis calculated by the standard fault models with the errors would be given for the design. Then, the design tsunami can be selected among the element tsunamis with the most significant impact, maximum and minimum water levels, on the site, bearing in mind the possible errors in the numerical calculation system. Finally, the design tsunami is verified by comparison with the run-up heights of historical tsunamis, ensuring that the design tsunami is selected as the highest of all historical and possible future tsunamis at the site.     

On the relation between the solar activity cycle and the solar tidal force induced by the planets

The cross-correlation coefficient (t) of the solar tidal force induced by the planets f(x + t) with the sunspot number g(x) during a period of 44 years is about -0.7 when t is about -2 years. This fact will be useful for predicting solar activity. The solar tidal force was calculated from 1928 to 1971 for every degree on the equatorial plane and every time every planet moves one degree. As the solar tidal force, we used the moving annual average by months of the square of the vertical tidal force on the sun, and as the sunspot number we used the Zürich mean annual sunspot number.     

Status of butyltin pollution along the coasts of western Japan in 2001, 11 years after partial restrictions on the usage of tributyltin

Restrictions on the use of tributyltin (TBT) in aquaculture and on boats in coastal regions, except for ocean-going vessels, have been in place in Japan since 1990 due to the strong toxic effects of TBT on marine organisms. However, TBT pollution along the Japanese coasts has been reported after this legislation was enacted. In order to elucidate the present status of contamination by butyltin (BT) compounds, we measured the levels of BTs [monobutyltin (MBT), dibutyltin (DBT) and TBT] in seawater and Caprella spp. samples obtained from the western part of Seto Inland Sea, Uwa Sea and Uranouchi Bay in western Japan during March to September, 2001. Butyltins were detected in more than 90% of the seawater samples (n = 59), with average concentrations of 8.2 ± 9.2 (SD) ng MBT L⁻¹, 3.3 ± 3.0 ng DBT L⁻¹ and 9.0 ± 7.0 ng TBT L⁻¹. Among 41 stations situated on coastal lines, a sufficient number of Caprella organisms for chemical analysis could be collected from only 16 stations. The butyltin concentrations in seawater and Caprella samples from Uwa Sea and Uranouchi Bay, in which the dominant industry in both waters is aquaculture, showed significantly higher than or no significant differences from those samples from the western part of Seto Inland Sea, a major heavy-industry area in Japan. As the TBT concentration in seawater increased, the number of Caprella organisms collected decreased. The mean TBT concentration among the seawater samples was above the estimated lowest observable effect concentration (LOEC) that reduces the survival rate of Caprella danilevskii. Thus, the present study indicates that TBT is still a potential ecological hazard to the survival of marine invertebrates inhabiting coasts along western Japan, even 11 years after the partial ban on TBT usage was implemented.     

DECADAL CLIMATE VARIABILITY OF RAINFALL AROUND THE MIDDLE AND LOWER REACHES OF THE YANGTZE RIVER AND ATMOSPHERIC CIRCULATION

1 INTRODUCTION Summer climate plays an especially important role in the people’s daily life around East Asia, one of the most populated regions in the world, for most of the regions receive more than 70% of the annual precipitation in summer due to the effect of monsoon climate. Global climate change caused by mankind activities have become a hot topic in recent years, though it is still not clear how these activities result in the climate change around East Asia. Successive studies (Qi…     

Studying air pollution with kitt peak solar flux atlas — analysis method and results of observation

For the measurement of atmospheric NO2 vertical column density (VCD), Kitt Peak Solar Flux Atlas can be substituted as an extraterrestrial solar radiation. Compared with differential analysis method, the Taylor expansion of integrated transfer equation underestimates the VCD. This underestimation is as large as 35% when the amount of NO2 is 1 × 1017 cm－2 and observation is conducted with an air mass factor of 10. Even when the VCD is 2 × 1016 cm－2 and the air mass factor is 4, the relative error of the retrieved VCD is still no less than 3%. If the observation is restricted under the small air mass factor condition (≤4), with Kitt Peak Solar spectrum as an extraterrestrial solar radiation, only an atmospheric layer of 2 km thick from ground can be studied, which will make the absorption too weak to be detected by normal instruments.The VCD in winter Tokyo area was observed and analyzed by differential method, which shows a good precision even when the absorption is as low as 3%. The largest average VCD was about 1.3 × 1017 cm－2, and the lowest was about 1.3 × 1016 cm－2. The trend of its variation was almost the same as the ground level observation by Saltzman reagent method.