Mg-Fe partitioning between olivine and ultramafic melts at high pressures

Precise determination of the partitioning of Mg and Fe²⁺ between olivine and ultramafic melt has been made at pressures from 5 to 13 GPa using a MA-8 type multi-anvil high-pressure apparatus (PREM) installed at Earthquake Research Institute, University of Tokyo. A very short rhenium capsule (<100 μm sample thickness) was adopted to minimize temperature variation within the sample container. Synthetic gels with the composition of the upper mantle peridotite were used as starting materials to promote the homogeneity. Analyses of quenched melts and coexisting olivines were made with an electron probe microanalyzer. The obtained partition coefficient, K_D [=(FeO/MgO)^ol/(FeO/MgO)^melt], decreases from 0.35 to 0.25 with increasing pressure from 5 to 13 GPa, suggesting a negative correlation between pressure and K_D above 5 GPa. Our result is consistent with a parabolic relationship between K_D and degree of polymerization (NBO/T) of melts reported by previous studies at lower pressures. The negative correlation between pressure and K_D suggests that olivine crystallizing in a magma ocean becomes more Mg-rich with depth and that primary magmas generated in the upper mantle become more Fe-rich with depth than previously estimated.     

Studying air pollution with kitt peak solar flux atlas — analysis method and results of observation

For the measurement of atmospheric NO2 vertical column density (VCD), Kitt Peak Solar Flux Atlas can be substituted as an extraterrestrial solar radiation. Compared with differential analysis method, the Taylor expansion of integrated transfer equation underestimates the VCD. This underestimation is as large as 35% when the amount of NO2 is 1 × 1017 cm－2 and observation is conducted with an air mass factor of 10. Even when the VCD is 2 × 1016 cm－2 and the air mass factor is 4, the relative error of the retrieved VCD is still no less than 3%. If the observation is restricted under the small air mass factor condition (≤4), with Kitt Peak Solar spectrum as an extraterrestrial solar radiation, only an atmospheric layer of 2 km thick from ground can be studied, which will make the absorption too weak to be detected by normal instruments.The VCD in winter Tokyo area was observed and analyzed by differential method, which shows a good precision even when the absorption is as low as 3%. The largest average VCD was about 1.3 × 1017 cm－2, and the lowest was about 1.3 × 1016 cm－2. The trend of its variation was almost the same as the ground level observation by Saltzman reagent method.     

Studying Air Pollution with Kitt Peak Solar Flux Atlas—Analysis Method and Results of Observation

l.Introducti0nTwoflightsoftheSAGEIIIinstrumentwereplanedbeinglaunchedinJune2O00byRussianMeteor-3Mandin2002byInternationalSpaceStation(ISS).Itisexpectedthattheywouldofferinformationofalmostglobalcoverage.Theseinstrumentswillutilizetheselfcal-ibratingsolaroccultationtechniquetomeasureprofilesofaerosoIextinctionfrom0to4Okm,ozonefrom6to85km,nitrogendioxidefroml0to5Okm,andwatervaporfrom0to5Okm,andutilizelunaroccultationobservati0nstomonitorthekeynighttimesPecies,nitrogentrioxidefrom22to55k…     

Thermoelastic properties of the high-pressure phase of SnO2 determined by in situ X-ray observations up to 30 GPa and 1400 K

 In situ synchrotron X-ray experiments in the system SnO₂ were made at pressures of 4–29 GPa and temperatures of 300–1400 K using sintered diamond anvils in a 6–8 type high-pressure apparatus. Orthorhombic phase (α-PbO₂ structure) underwent a transition to a cubic phase (Pa3ˉ structure) at 18 GPa. This transition was observed at significantly lower pressures in DAC experiments. We obtained the isothermal bulk modulus of cubic phase K ₀= 252(28) GPa and its pressure derivative K ^′=3.5(2.2). The thermal expansion coefficient of cubic phase at 25 GPa up to 1300 K was determined from interpolation of the P-V-T data obtained, and is 1.7(±0.7) × 10⁻⁵ K⁻¹ at 25 GPa. Received: 7 December 1999 / Accepted: 27 April 2000     

Recent increase of DIC in the western North Pacific

The temporal variation of the total dissolved inorganic carbon (DIC) content in the western North Pacific is investigated by comparing the DIC distribution obtained from the data sets of three different periods, the GEOSECS data observed in 1973, the CO₂ dynamics Cruise data observed in 1982, and recent Japanese data sets observed during the early 1990s. The overall feature of the signal of temporal DIC change during 1973 and early 1990s agreed with that of former studies, and did not significantly change with the calculation scheme (the grid-selection method vs. the multiple regression method). The observed increase in DIC among the different time scales showed a good inner consistency, which also indicates the stability of the method used in the DIC change calculation. The apparent rate of increase of the DIC inventory in the upper 1000 m water column, however, differed significantly by the data set used for the calculation: It was 5.6±2.4 g C/m²/year, based on the data comparison between 1982 and the early 1990s, while it became 7.6±2.4 g C/m²/year when based on the data between 1973 and the early 1990s. This result provides us an information about the data-dependency on the former estimation of temporal DIC change.     

Cross-Validation of Open-Path and Closed-Path Eddy-Covariance Techniques for Observing Methane Fluxes

Methane ( ${\mathrm {CH}}_{4}$ ) fluxes observed with the eddy-covariance technique using an open-path ${\mathrm {CH}}_{4}$ analyzer and a closed-path ${\mathrm {CH}}_{4}$ analyzer in a rice paddy field were evaluated with an emphasis on the flux correction methodology. A comparison of the fluxes obtained by the analyzers revealed that both the open-path and closed-path techniques were reliable, provided that appropriate corrections were applied. For the open-path approach, the influence of fluctuations in air density and the line shape variation in laser absorption spectroscopy (hereafter, spectroscopic effect) was significant, and the relative importance of these corrections would increase when observing small ${\mathrm {CH}}_{4}$ fluxes. A new procedure proposed by Li-Cor Inc. enabled us to accurately adjust for these effects. The high-frequency loss of the open-path ${\mathrm {CH}}_{4}$ analyzer was relatively large (11 % of the uncorrected covariance) at an observation height of 2.5 m above the canopy owing to its longer physical path length, and this correction should be carefully applied before correcting for the influence of fluctuations in air density and the spectroscopic effect. Uncorrected ${\mathrm {CH}}_{4}$ fluxes observed with the closed-path analyzer were substantially underestimated (37 %) due to high-frequency loss because an undersized pump was used in the observation. Both the bandpass and transfer function approaches successfully corrected this flux loss. Careful determination of the bandpass frequency range or the transfer function and the cospectral model is required for the accurate calculation of ${\mathrm {CH}}_{4}$ fluxes with the closed-path technique.     

Flux of low salinity water from Aniva Bay (Sakhalin Island) to the southern Okhotsk Sea

In this study, we examined the relationship between the low salinity water in the shelf region of the southern Okhotsk Sea which was seasonally sampled (0–200 m), and fluxes of low salinity water from Aniva Bay. To express the source of freshwater mixing in the surface layer, we applied normalized total alkalinity (NTA) and stable isotopes of seawater as chemical tracers. NTA-S diagrams indicate that NTA of low salinity water in the upper 30 m layer just off the Soya Warm Current is clearly higher than in the far offshore region in summer and autumn. Using NTA-S regression lines, we could deduce that the low salinity and high NTA water in the upper layer originates from Aniva Bay. For convenience, we defined this water as the Aniva Surface Water (ASW) with values S < 32, NTA > 2450 μmol kg⁻¹. Formation and transport processes of ASW are discussed using historical data. The interaction between the maximum core of high NTA water on the bottom slope of eastern Aniva Bay and an anticyclonic eddy at the mouth of Aniva Bay are concluded to control ASW formation. Upwelling of the Cold Water Belt water at the tip of Cape Krillion is considered to cause ASW outflow from Aniva Bay.     

New high-pressure phases in BaCO<Subscript>3</Subscript>

Barium carbonate (BaCO₃) was examined in a diamond anvil cell up to a pressure of 73 GPa using an in situ angle-dispersive X-ray diffraction technique. Three new phases of BaCO₃ were observed at pressures >10 GPa. From 10 to 24 GPa, BaCO₃-IV had a post-aragonite structure with space group Pmmn. There are two molecules in a single unit cell (Z = 2) of the orthorhombic phase, which is same as the high-pressure phases of CaCO₃ and SrCO₃. The isothermal bulk modulus of BaCO₃-IV is K ₀ = 84(4) GPa, with V ₀ = 129.0(7) Å³ when K ₀′ = 4. The c axis of the unit cell parameter is less compressible than the a and b axes. The relative change in volume that accompanies the transformation between BaCO₃-III and BaCO₃-IV is ～6%. BaCO₃-V, which has an orthorhombic symmetry, was synthesized at 50 GPa. As the pressure increases, BaCO₃-V is transformed into tetragonal BaCO₃-VI. This transformation is likely to be second order, because the diffraction pattern of BaCO₃-V is similar to that of BaCO₃-VI, and some single peaks in BaCO₃-VI become doublets in BaCO₃-V. After decompression, the new high-pressure phases transform into BaCO₃-II. Our findings resolve a dispute regarding the stable high-pressure phases of BaCO₃.     

Lessons Learned from the 2011 Great East Japan Tsunami: Performance of Tsunami Countermeasures, Coastal Buildings, and Tsunami Evacuation in Japan

In 2011, Japan was hit by a tsunami that was generated by the greatest earthquake in its history. The first tsunami warning was announced 3 min after the earthquake, as is normal, but failed to estimate the actual tsunami height. Most of the structural countermeasures were not designed for the huge tsunami that was generated by the magnitude M = 9.0 earthquake; as a result, many were destroyed and did not stop the tsunami. These structures included breakwaters, seawalls, water gates, and control forests. In this paper we discuss the performance of these countermeasures, and the mechanisms by which they were damaged; we also discuss damage to residential houses, commercial and public buildings, and evacuation buildings. Some topics regarding tsunami awareness and mitigation are discussed. The failures of structural defenses are a reminder that structural (hard) measures alone were not sufficient to protect people and buildings from a major disaster such as this. These defenses might be able to reduce the impact but should be designed so that they can survive even if the tsunami flows over them. Coastal residents should also understand the function and limit of the hard measures. For this purpose, non-structural (soft) measures, for example experience and awareness, are very important for promoting rapid evacuation in the event of a tsunami. An adequate communication system for tsunami warning messages and more evacuation shelters with evacuation routes in good condition might support a safe evacuation process. The combination of both hard and soft measures is very important for reducing the loss caused by a major tsunami. This tsunami has taught us that natural disasters can occur repeatedly and that their scale is sometimes larger than expected.