Structural evolution of a 2M 1 phengite mica up to 11 GPa: an in situ single-crystal X-ray diffraction study

The structural evolution at high pressure of a natural 2M ₁-phengite [(K_0.98Na_0.02)_Σ=1.00(Al_1.55Mg_0.24Fe_0.21Ti_0.02)_Σ=2.01(Si_3.38Al_0.62)O₁₀(OH)₂; a = 5.228(2), b = 9.057(3), c = 19.971(6)Å, β = 95.76(2)°; space group: C2/c] from the metamorphic complex of Cima Pal (Sesia Zone, Western Alps, Italy) was studied by single-crystal X-ray diffraction with a diamond anvil cell under hydrostatic conditions up to ~11 GPa. A series of 12 structure refinements were performed at selected pressures within the P range investigated. The compressional behaviour of the same phengite sample was previously studied up to ~25 GPa by synchrotron X-ray powder diffraction, showing an irreversible transformation with a drastic decrease of the crystallinity at P > 15–17 GPa. The elastic behaviour between 0.0001 and 17 GPa was modelled by a third-order Birch–Murnaghan Equation of State (BM-EoS), yielding to K _T0 = 57.3(10) GPa and K′ = ?K _T0/?P = 6.97(24). The single-crystal structure refinements showed that the significant elastic anisotropy of the 2M ₁-phengite (with β(a):β(b):β(c) = 1:1.17:4.60) is mainly controlled by the anisotropic compression of the K-polyhedra. The evolution of the volume of the inter-layer K-polyhedron as a function of P shows a negative slope, Fitting the P–V(K-polyhedron) data with a truncated second-order BM-EoS we obtain a bulk modulus value of K _T0(K-polyhedron) = 26(1) GPa. Tetrahedra and octahedra are significantly stiffer than the K-polyhedron. Tetrahedra behave as quasi-rigid units within the P range investigated. In contrast, a monotonic decrease is observed for the octahedron volume, with K _T0 = 120(10) GPa derived by a BM-EoS. The anisotropic response to pressure of the K-polyhedron affects the P-induced deformation mechanism on the tetrahedral sheet, consisting in a cooperative rotation of the tetrahedra and producing a significant ditrigonalization of the six-membered rings. The volume of the K-polyhedron and the value of the ditrigonal rotation parameter (α) show a high negative correlation (about 93%), though a slight discontinuity is observed at P >8 GPa. α increases linearly with P up to 7–8 GPa (with ?α/?P ≈ 0.7°/GPa), whereas at higher Ps a “saturation plateau” is visible. A comparison between the main deformation mechanisms as a function of pressure observed in 2M ₁- and 3T-phengite is discussed.     

Beryllium-10 in Australasian tektites: Constraints on the location of the source crater

By using accelerator mass spectrometry we have measured the ¹⁰Be concentrations of 86 Australasian tektites. Corrected to the time of tektite production ∼0.8 My ago, the ¹⁰Be concentrations (10⁶ atom/g) range from 59 for a layered tektite from Huai Sai, Thailand, to 280 for an australite from New South Wales, Australia. The average value is 143 ± 50. When tektites are sorted by country, their average measured ¹⁰Be concentrations increase slowly with increasing distance from Southeast Asia, the probable location of the tektite producing event, from 59 ± 9 for 6 layered tektites from Laos to 136 ± 20 for 20 splash-form tektites from Australia. The lowest ¹⁰Be concentrations for tektites fall on or within a contour centered off the shore of Vietnam, south of the Gulf of Tonkin (107°E; 17°N), but also encompassing two other locations in the area of northeastern Thailand previously proposed for the site of a single tektite-producing impact. The ¹⁰Be concentrations of layered tektites show only a weak anticorrelation (R ∼ −0.3) with the numbers of relict crystalline inclusions.Loosely consolidated, fine-grained terrestrial sediments or recently consolidated sedimentary rocks are the most likely precursor materials. Dilution of sediments with other kinds of rock raises problems in mixing and is not supported by petrographic data. Sedimentary columns that have the right range of ¹⁰Be concentrations occur off the coasts of places where sedimentation rates are high relative to those in the deep sea. A single impact into such a region, 15 to 300 m thick, could have propelled near-surface, high-¹⁰Be material farthest—to Australia—while keeping the deeper-lying, low-¹⁰Be layers closer to home. We do not rule out, however, other proposed mechanisms for tektite formation.     

Recruitment patterns of Serpula vermicularis L. (Polychaeta, Serpulidae) in Loch Creran, Scotland

This study aimed to contribute to conservation management of reefs of Serpula vermicularis by increasing understanding of the factors influencing larval settlement. The study was carried out in Loch Creran, which supports the most extensive known development of S. vermicularis reefs in the world. Settlement plates were deployed to examine the influence of season, depth, reef density, substrate type and orientation. Monthly deployment of plates revealed settlement of S. vermicularis to occur predominantly from mid-June to mid-October, peaking in late August to early September. Settlement of Pomatoceros spp. peaked much earlier, in late May to early June. Deployment of plates at different depths revealed a marked reduction in S. vermicularis settlement intensity between 6 and 12 m. As this corresponds with the deeper limit of the peripheral fringe of serpulid reefs in the loch, it is suggested that this limit is imposed by a depth-correlated settlement response, rather than reduction in available substrata. Comparisons of various substrata showed a preference by S. vermicularis larvae for a slate over a scallop substrate and no evidence of enhanced recruitment to occupied or unoccupied tubes of S. vermicularis, suggesting that gregarious attraction is unlikely to be a factor causing reef formation. Settlement onto the upper side of a horizontal scallop substrate was found to be insignificant in comparison with the underside or a vertically orientated scallop. Evidence for the role of light in controlling the depth and substrate-orientation preferences of S. vermicularis larvae is discussed. Based on the results of this study, recommendations are made regarding remediation of areas suffering reef damage.     

Mechanisms linking active rock glaciers and impounded surface water formation in high‐mountain areas

Rock glaciers are slowly flowing mixtures of debris and ice occurring in mountains. They can represent a reservoir of water, and melting ice inside them can affect surface water hydrochemistry. Investigating the interactions between rock glaciers and water bodies is therefore necessary to better understand these mechanisms. With this goal, we elucidate the hydrology and structural setting of a rock glacier–marginal pond system, providing new insights into the mechanisms linking active rock glaciers and impounded surface waters. This was achieved through the integration of waterborne geophysical techniques (ground penetrating radar, electrical resistivity tomography and self‐potentials) and heat tracing. Results of these surveys showed that rock glacier advance has progressively filled the valley depression where the pond is located, creating a dam that could have modified the level of impounded water. A sub‐surface hydrological window connecting the rock glacier to the pond was also detected, where an inflow of cold and mineralised underground waters from the rock glacier was observed. Here, greater water contribution from the rock glacier occurred following intense precipitation events during the ice‐free season, with concomitant increasing electrical conductivity values. The outflowing dynamic of the pond is dominated by a sub‐surface seepage where a minor fault zone in bedrock was found, characterised by altered and highly‐fractured rocks. The applied approach is evaluated here as a suitable technique for investigating logistically‐complex hydrological settings which could be possibly transferred to wider scales of investigation. Copyright © 2017 John Wiley & Sons, Ltd.     

Chlorinated compounds and polybrominated diphenyl ethers (PBDEs) in mussels (Mytilus galloprovincialis) collected from Apulia Region coasts

This project was carried out to assess the levels and spatial distribution of organochlorine compounds in the coastal marine environment, using mussels as bioindicators to evaluate the coastal water quality. Levels of polychlorobiphenils (PCB), chlorinated pesticides (DDT isomers, HCH isomers, Aldrin, Dieldrin, alfa-Endosulfan, Hexachlorobenzene, Pentachlorobenzene) and polybrominated diphenyl ethers (PBDEs) were determined in tissues from mussels (Mytilus galloprovincialis) collected along the Apulia Region coasts (Mediterranean Sea). Results indicate that contamination by organochlorine compounds is higher in mussels sampled in the Ionian Sea than in those from the Adriatic Sea, with PCB levels up to seven times higher in mussels from Ionian than from the Adriatic Sea. Although PCB levels were above the maximum values indicated by both European Community (EC) and National regulation in several sample sites, the PCB concentrations were particularly high in some stations, suggesting that these locations require a much specific attention. Conversely, results on the mussel contamination by PBDEs highlight their ubiquitous environmental distribution, and underline the need to establish the maximum level for these compounds in foodstuff, according to European Regulations.     

Water‐bottom multiple attenuation by Kirchhoff extrapolation

Despite being less general than 3D surface‐related multiple elimination (3D‐SRME), multiple prediction based on wavefield extrapolation can still be of interest, because it is less CPU and I/O demanding than 3D‐SRME and moreover it does not require any prior data regularization. Here we propose a fast implementation of water‐bottom multiple prediction that uses the Kirchhoff formulation of wavefield extrapolation. With wavefield extrapolation multiple prediction is usually obtained through the cascade of two extrapolation steps. Actually by applying the Fermat’s principle (i.e., minimum reflection traveltime) we show that the cascade of two operators can be replaced by a single approximated extrapolation step. The approximation holds as long as the water bottom is not too complex. Indeed the proposed approach has proved to work well on synthetic and field data when the water bottom is such that wavefront triplications are negligible, as happens in many practical situations.     

Long-Term RST Analysis of Anomalous TIR Sequences in Relation with Earthquakes Occurred in Greece in the Period 2004–2013

Real-time integration of multi-parametric observations is expected to accelerate the process toward improved, and operationally more effective, systems for time-Dependent Assessment of Seismic Hazard (t-DASH) and earthquake short-term (from days to weeks) forecast. However, a very preliminary step in this direction is the identification of those parameters (chemical, physical, biological, etc.) whose anomalous variations can be, to some extent, associated with the complex process of preparation for major earthquakes. In this paper one of these parameters (the Earth’s emitted radiation in the Thermal InfraRed spectral region) is considered for its possible correlation with M ≥ 4 earthquakes occurred in Greece in between 2004 and 2013. The Robust Satellite Technique (RST) data analysis approach and Robust Estimator of TIR Anomalies (RETIRA) index were used to preliminarily define, and then to identify, significant sequences of TIR anomalies (SSTAs) in 10 years (2004–2013) of daily TIR images acquired by the Spinning Enhanced Visible and Infrared Imager on board the Meteosat Second Generation satellite. Taking into account the physical models proposed for justifying the existence of a correlation among TIR anomalies and earthquake occurrences, specific validation rules (in line with the ones used by the Collaboratory for the Study of Earthquake Predictability—CSEP—Project) have been defined to drive a retrospective correlation analysis process. The analysis shows that more than 93 % of all identified SSTAs occur in the prefixed space–time window around (M ≥ 4) earthquake's time and location of occurrence with a false positive rate smaller than 7 %. Molchan error diagram analysis shows that such a correlation is far to be achievable by chance notwithstanding the huge amount of missed events due to frequent space/time data gaps produced by the presence of clouds over the scene. Achieved results, and particularly the very low rate of false positives registered on a so long testing period, seems already sufficient (at least) to qualify TIR anomalies (identified by RST approach and RETIRA index) among the parameters to be considered in the framework of a multi-parametric approach to t-DASH.     

Heavy metals in marine sediments of Taranto Gulf (Ionian Sea, Southern Italy)

Al, Cr, Cu, Fe, Hg, Mn, Ni, Pb, Ti and Zn concentrations have been determined in surface sediment samples collected in the Taranto Gulf (Ionian Sea, Southern Italy) in order to evaluate their levels and spatial distribution in this important area of the Mediterranean Sea. For various metals, the geoaccumulation index has been calculated as a criterion to assess if their concentrations represent contamination levels or can be considered as background levels. The results show that metals concentrations in sediments can be considered near the background levels found in the Mediterranean Sea.Analytical results have been elaborated by using a Geographical Information System (GIS) software to show metals accumulation areas. Using multivariate statistical analysis, we evaluate the possibility to distinguish the sampling stations, in relation to their geographical position. Results have showed metals distribution in the Taranto Gulf is principally influenced by industrial and urban wastes, located mostly in the northern coastal area of the Ionian Sea. Rivers in the Basilicata region and prevailing anticlockwise marine currents are further factors influencing metal accumulation in sediments.     

Search For Correlations Between Batse Gamma-Ray Bursts and Supernovae

We report on our statistical research of space–time correlated supernovae and CGRO-BATSE gamma-ray bursts (GRBs). There exists a significantly higher abundance of core-collapse supernovae among the correlated supernovae, but the subset of all correlated objects does not seem to be physically different from the whole set.     

An algorithm to resolve γ-rays from charged cosmic rays with DAMPE

The DArk Matter Particle Explorer(DAMPE),also known as Wukong in China,which was launched on 2015 December 17,is a new high energy cosmic ray and γ-ray satellite-borne observatory.One of the main scientific goals of DAMPE is to observe Ge V-Te V high energy γ-rays with accurate energy,angular and time resolution,to indirectly search for dark matter particles and for the study of high energy astrophysics. Due to the comparatively higher fluxes of charged cosmic rays with respect to γ-rays,it is challenging to identify γ-rays with sufficiently high efficiency,minimizing the amount of charged cosmic ray contamination. In this work we present a method to identify γ-rays in DAMPE data based on Monte Carlo simulations,using the powerful electromagnetic/hadronic shower discrimination provided by the calorimeter and the veto detection of charged particles provided by the plastic scintillation detector. Monte Carlo simulations show that after this selection the number of electrons and protons that contaminate the selected γ-ray events at～10 Ge V amounts to less than 1% of the selected sample.Finally,we use flight data to verify the effectiveness of the method by highlighting known γ-ray sources in the sky and by reconstructing preliminary light curves of the Geminga pulsar.