Stratigraphy and eruptive dynamics of a pulsating Plinian eruption of Somma-Vesuvius: the Pomici di Mercato (8900 years B.P.)

New volcanological studies allow reconstruction of the eruption dynamics of the Pomici di Mercato eruption (ca 8,900 cal. yr B.P.) of Somma-Vesuvius. Three main Eruptive Phases are distinguished based on two distinct erosion surfaces that interrupt stratigraphic continuity of the deposits, indicating that time breaks occurred during the eruption. Absence of reworked volcaniclastic deposits on top of the erosion surfaces suggests that quiescent periods between eruptive phases were short perhaps lasting only days to weeks. Each of the Eruptive Phases was characterised by deposition of alternating fall and pyroclastic density current (PDC) deposits. The fallout deposits blanketed a wide area toward the east, while the more restricted PDC deposits inundated the volcano slopes. Eruptive dynamics were driven by brittle magmatic fragmentation of a phonolitic magma, which, because of its mechanical fragility, produced a significant amount of fine ash. External water did not significantly contribute either to fragmentation dynamics or to mechanical energy release during the eruption. Column heights were between 18 and 22 km, corresponding to mass discharge rates between 1.4 and 6 × 10⁷ kg s⁻¹. The estimated on land volume of fall deposits ranges from a minimum of 2.3 km³ to a maximum of 7.4 km³. Calculation of physical parameters of the dilute pyroclastic density currents indicates speeds of a few tens of m s⁻¹ and densities of a few kg m⁻³ (average of the lowermost 10 m of the currents), resulting in dynamic pressures lower than 3 kPa. These data suggest that the potential impact of pyroclastic density currents of the Pomici di Mercato eruption was smaller than those of other Plinian and sub-Plinian eruptions of Somma-Vesuvius, especially those of 1631 AD and 472 AD (4–14 kPa), which represent reference values for the Vesuvian emergency plan. The pulsating and long-lasting behaviour of the Pomici di Mercato eruption is unique in the history of large explosive eruptions of Somma-Vesuvius. We suggest an eruptive scheme in which discrete magma batches rose from the magma chamber through a network of fractures. The injection and rise of the different magma batches was controlled by the interplay between magma chamber overpressure and local stress. The intermittent discharge of magma during a large explosive eruption is unusual for Somma-Vesuvius, as well as for other volcanoes worldwide, and yields new insights for improving our knowledge of the dynamics of explosive eruptions.     

Large amplification of ground motion at rock sites within a fault zone in Nocera Umbra (central Italy)

During the two mainshocks of September 26, 1997 inthe Umbria-Marche border a strong-motion accelerographrecorded peak ground accelerations as large as 0.6 g,approximately, in the town of Nocera Umbra, atdistances of 10 to 15 km from the epicentres. Thisvalue is significantly larger than expected on thebasis of the usual regressions with magnitude anddistance. A broad-band amplification up to a factor of10 was consistently estimated in previous papers,using both weak and strong motion data recorded at theaccelerograph site during local moderate earthquakes.To study the cause of this amplification we deployedsix seismologic stations across the tectonic contactbetween the Ceno-Mesozoic limestone and the Mesozoicmarly sandstone where the accelerograph is installed.Seismograms of 21 shallow aftershocks in the magnituderange from 2.2 to 4.0 and a subcrustal M_w = 5.3event are analysed. Regardless of epicentre location,waveforms show a large complexity in an approximately200 m wide band adjacent to the tectonic contact. Thisis interpreted as the effect of trapped waves in thehighly fractured, lower velocity materials within thefault zone.     

Chronicle of the 1865, NE flank eruption of Mt. Etna and geomorphologic survey of the Mts. Sartorius area

The row of pyroclastic cones named Mts. Sartorius, outcropping on the NE flank of Etna, formed in 1865 during a lateral eruption that lasted about 6 months. The event was eye witnessed and described by numerous scientists and reporters. In this work, we use their observations to reconstruct the eruption chronology and scenario, and carry out a detailed geomorphologic survey to identify the eruptive features and pyroclastic deposits. The 1865 eruption began on 29 January along a segment of the main system of fractures oriented ENE–WSW, radial to the central conduit. After 30 January, a secondary system of fractures trending NNW–SSE was simultaneously active. The six larger Mts. Sartorius cones developed since 3 February along the lower extension of the radial system. They are markedly asymmetric due to the persistent winds blowing at the time and to the pre-existing topography formed on underlying deposits, previously unreported, that we have recognized. Now, about 150 years after the eruption, most of the eruptive vents and fractures are no longer observable in the field, being mostly hidden by products of subsequent phases of the eruption and by younger epiclastic deposits.     

The Pomici di Avellino eruption of Somma–Vesuvius (3.9 ka BP). Part II: sedimentology and physical volcanology of pyroclastic density current deposits

Pyroclastic density currents (PDCs) generated during the Plinian eruption of the Pomici di Avellino (PdA) of Somma–Vesuvius were investigated through field and laboratory studies, which allowed the detailed reconstruction of their eruptive and transportation dynamics and the calculation of key physical parameters of the currents. PDCs were generated during all the three phases that characterised the eruption, with eruptive dynamics driven by both magmatic and phreatomagmatic fragmentation. Flows generated during phases 1 and 2 (EU1 and EU3pf, magmatic fragmentation) have small dispersal areas and affected only part of the volcano slopes. Lithofacies analysis demonstrates that the flow-boundary zones were dominated by granular-flow regimes, which sometimes show transitions to traction regimes. PDCs generated during eruptive phase 3 (EU5, phreatomagmatic fragmentation) were the most voluminous and widespread in the whole of Somma–Vesuvius’ eruptive history, and affected a wide area around the volcano with deposit thicknesses of a few centimetres up to more than 25 km from source. Lithofacies analysis shows that the flow-boundary zones of EU5 PDCs were dominated by granular flows and traction regimes. Deposits of EU5 PDC show strong lithofacies variation northwards, from proximally thick, massive to stratified beds towards dominantly alternating beds of coarse and fine ash in distal reaches. The EU5 lithofacies also show strong lateral variability in proximal areas, passing from the western and northern to the eastern and southern volcano slopes, where the deposits are stacked beds of massive, accretionary lapilli-bearing fine ash. The sedimentological model developed for the PDCs of the PdA eruption explains these strong lithofacies variations in the light of the volcano’s morphology at the time of the eruption. In particular, the EU5 PDCs survived to pass over the break in slope between the volcano sides and the surrounding volcaniclastic apron–alluvial plain, with development of new flows from the previously suspended load. Pulses were developed within individual currents, leading to stepwise deposition on both the volcano slopes and the surrounding volcaniclastic apron and alluvial plain. Physical parameters including velocity, density and concentration profile with height were calculated for a flow of the phreatomagmatic phase of the eruption by applying a sedimentological method, and the values of the dynamic pressure were derived. Some hazard considerations are summarised on the assumption that, although not very probable, similar PDCs could develop during future eruptions of Somma–Vesuvius.     

Spatio-temporal distribution of seismic activity during the Umbria-Marche crisis, 1997

We present the spatio-temporal distribution of more than 2000 earthquakesthat occurred during the Umbria-Marche seismic crisis, between September 26and November 3, 1997. This distribution was obtained from recordings of atemporary network that was installed after the occurrence of the first two largest shocks (Mw =, 5.7, Mw = 6.0) of September 26. This network wascomposed of 27 digital 3-components stations densely distributed in theepicentral area. The aftershock distribution covers a region of about 40 km long and about2 km wide along the NW-SE central Apennines chain. The activity is shallow,mostly located at less than 9 km depth. We distinguished three main zonesof different seismic activity from NW to SE. The central zone, that containsthe hypocenter of four earthquakes of magnitude larger than 5, was the moreactive and the more complex one. Sections at depth identify 40–50^°dipping structures that agree well with the moment tensor focalmechanisms results. The clustering and the migration of seismicity from NW to SE and the generalfeatures are imaged by aftershock distribution both horizontally and at depth.     

Numerical inversion and analysis of tephra fallout deposits from the 472 AD sub-Plinian eruption at Vesuvius (Italy) through a new best-fit procedure

A simple semi-analytical model for ash-fall deposit was applied to reconstruct the tephra deposits of the sub-Plinian 472 AD eruption of Vesuvius, Italy, which is of the scale of the reference eruptive scenario for the emergency planning, at Vesuvius. Applying a novel least-squares method, the bulk grain-size distribution, the total mass, and the eruption column height were obtained by fitting the computed ground load and granulometries with the observed ones. The analysis of the effect of three different weighting factors in the minimization procedure was also performed. Results showed that the statistical weighting factor produced the minimum bias. The best correlation between calculated and measured deposit was found, even though the quantity of the input data was not very high, as it commonly occurs for several ancient eruptions. Model results were also in agreement with estimations provided by other independent methods.     

Base isolation for retrofitting historic buildings: Evaluation of seismic performance through experimental investigation

An experimental test program on a full‐scale model representing a sub‐assemblage of the cloister facade of the Sao Vicente de Fora monastery, retrofitted through base isolation, has been recently carried out at the European Laboratory for Structural Assessment of the Joint Research Centre of the European Commission. In this paper an overview of the laboratory model and the experimental results is provided. In particular, firstly the test model is described, including the geometry and mechanical properties of the masonry specimen and the design of the isolation devices; then the testing method and the sub‐structuring of the isolation system are described and the seismic inputs adopted for the pseudo‐dynamic tests are defined. Finally, the experimental results are discussed and compared to the analogous results obtained on the ‘as is’, fixed‐base sub‐assemblage model. The implications of the test outcomes are emphasized and developments of this research line are presented. Copyright © 2001 John Wiley & Sons, Ltd.     

Volcanic ash hazard in the Central Mediterranean assessed from geological data

Volcanic ash produced during explosive eruptions can have very severe impacts on modern technological societies. Here, we use reconstructed patterns of fine ash dispersal recorded in terrestrial and marine geological archives to assess volcanic ash hazards. The ash-dispersal maps from nine Holocene explosive eruptions of Italian volcanoes have been used to construct frequency maps of distal ash deposition over a wide area, which encompasses central and southern Italy, the Adriatic and Tyrrhenian seas and the Balkans. The maps are presented as two cumulative-thickness isopach maps, one for nine eruptions from different volcanoes and one for six eruptions from Somma-Vesuvius. These maps represent the first use of distal ash layers to construct volcanic hazard maps, and the proposed methodology is easily applicable to other volcanic areas worldwide.