3D shear-wave velocity structure of the Eifel plume, Germany

The Quaternary Eifel volcanic fields, situated on the Rhenish Massif in Germany, are the focus of a major interdisciplinary project. The aim is a detailed study of the crustal and mantle structure of the intraplate volcanic fields and their deep origin. Recent results from a teleseismic P-wave tomography study reveal a deep low-velocity structure which we infer to be a plume in the upper mantle underneath the volcanic area [J.R.R. Ritter et al., Earth Planet. Sci. Lett. 186 (2001) 7-14]. Here we present a travel-time investigation of 5038 teleseismic shear-wave arrivals in the same region. First, the transverse (T) and radial (R) component travel-time residuals are treated separately to identify possible effects of seismic anisotropy. A comparison of 2044 T- and 2994 R-component residuals demonstrates that anisotropy does not cause any first-order travel-time effects. The data sets reveal a deep-seated low-velocity anomaly beneath the volcanic region, causing a delay for teleseismic shear waves of about 3 s. Using 3773 combined R- and T-component residuals, an isotropic non-linear inversion is calculated. The tomographic images reveal a prominent S-wave velocity reduction in the upper mantle underneath the Eifel region. The anomaly extends down to at least 400 km depth. The velocity contrast to the surrounding mantle is depth-dependent (from −5% at 31-100 km depth to at least −1% at 400 km depth). At about 170-240 km depth the anomaly is nearly absent. The resolution of the data is sufficient to recover the described features, however the anomaly in the lower asthenosphere is underestimated due to smearing and damping. The main anomaly is similar to the P-wave model except the latter lacks the ‘hole’ near 200 km depth, and both are consistent with an upper mantle plume structure. For plausible anhydrous plume material in the uppermost 100 km of the mantle, an excess temperature as great as 200-300 K is estimated from the seismic anomaly. However, 1% partial melt reduces the required temperature anomaly to about 100 K. The temperature anomaly associated with the deeper part of the plume (250 to about 450 km depth) is at least 70 K. However, this estimate is quite uncertain, because the amplitude of the shear-wave anomaly may be larger than the modelled one. Another possibility is water in the upwelling material. The gap at 170-240 km depth could arise from an increase of the shear modulus caused by dehydration processes which would not affect P-wave velocities as much. An interaction of temperature and compositional variations, including melt and possibly water, makes it difficult to differentiate quantitatively between the causes of the deep-seated low-velocity anomaly.     

The BEAM-project: prediction and assessment of mixture toxicities in the aquatic environment

Freshwater and marine ecosystems are exposed to various multi-component mixtures of pollutants. Nevertheless, most ecotoxicological research and chemicals regulation focus on hazard and exposure assessment of individual substances only, the problem of chemical mixtures in the environment is ignored to a large extent. In contrast, the assessment of combination effects has a long tradition in pharmacology, where mixtures of chemicals are specifically designed to develop new products, e.g. human and veterinary drugs or agricultural and non-agricultural pesticides. In this area, two concepts are frequently used and are thought to describe fundamental relationships between single substance and mixture effects: Independent Action (Response Addition) and Concentration Addition. The question, to what extent these concepts may also be applied in an ecotoxicological and regulatory context may be considered a research topic of major importance, as the concepts would allow to make use of already existing single substance toxicity data for the predictive assessment of mixture toxicities. Two critical knowledge gaps are identified: (a) There is a lack of environmental realism, as a huge part of our current knowledge about the applicability of the concepts is restricted to artificial situations with respect to mixture composition or biological effect assessment. (b) The knowledge on what exactly is needed for using the concepts as tools for the predictive mixture toxicity assessment is insufficient. Both gaps seriously hamper the necessary, scientifically sound consideration of mixture toxicities in a regulatory context.In this paper, the two concepts will be briefly introduced, the necessity of considering the toxicities of chemical mixtures in the environment will be demonstrated and the applicability of Independent Action and Concentration Addition as tools for the prediction and assessment of mixture toxicities will be discussed. An overview of the specific aims and approaches of the BEAM project to fill in the identified knowledge gaps is given and first results are outlined.     

Microbial Degradation of Tar Oil Compounds under Different Redox Conditions

The microbial transformation of typical tar oil compounds such as acridine, benzo(b)thiophene, dibenzofuran, indane, and indene under different redox conditions was investigated in microcosm studies. Under aerobic conditions the inherent contamination in polluted soil as well as the added N‐, S‐, O‐ heterocyclic and homocyclic compounds were transformed predominantly apart from thiophene. 1‐Indanone was detected by RP‐HPLC‐DAD and GC‐MS as an intermediate metabolite from indane and indene. Under nitrate and sulfate reducing conditions indane, benzo(b)thiophene, and dibenzofuran were transformed in assays with the polluted soil samples from well B 65 and B 66 within 426 days, whereas they were persistent in assays with the highly polluted soil B 67. All heterocyclic and homocyclic compounds added to the non‐contaminated soil from well B 85 were not degraded under nitrate and sulfate reducing conditions, too. The results indicate that for the decision, wether natural attenuation can be implemented in the remediation of contaminated site, in addition to BTEX and PAHs especially the fate of further tar oil compounds in anoxic aquifers has to be considered.     

A Machine Learning Approach for Improving the Detection Capabilities at 3C Seismic Stations

We apply and evaluate a recent machine learning method for the automatic classification of seismic waveforms. The method relies on Dynamic Bayesian Networks (DBN) and supervised learning to improve the detection capabilities at 3C seismic stations. A time-frequency decomposition provides the basis for the required signal characteristics we need in order to derive the features defining typical “signal” and “noise” patterns. Each pattern class is modeled by a DBN, specifying the interrelationships of the derived features in the time-frequency plane. Subsequently, the models are trained using previously labeled segments of seismic data. The DBN models can now be compared against in order to determine the likelihood of new incoming seismic waveform segments to be either signal or noise. As the noise characteristics of seismic stations varies smoothly in time (seasonal variation as well as anthropogenic influence), we accommodate in our approach for a continuous adaptation of the DBN model that is associated with the noise class. Given the difficulty for obtaining a golden standard for real data (ground truth) the proof of concept and evaluation is shown by conducting experiments based on 3C seismic data from the International Monitoring Stations, BOSA and LPAZ.     

Tracing variability of run‐off generation in mountainous permafrost of semi‐arid north‐eastern Mongolia

The headwaters of mountainous, discontinuous permafrost regions in north‐eastern Mongolia are important water resources for the semi‐arid country, but little is known about hydrological processes there. Run‐off generation on south‐facing slopes, which are devoid of permafrost, has so far been neglected and is totally unknown for areas that have been affected by recent forest fires. To fill this knowledge gap, the present study applied artificial tracers on a steppe‐vegetated south‐facing and on two north‐facing slopes, burned and unburned. Combined sprinkling and dye tracer experiments were used to visualize processes of infiltration and water fluxes in the unsaturated zone. On the unburned north‐facing slope, rapid and widespread infiltration through a wet organic layer was observed down to the permafrost. On the burned profile, rapid infiltration occurred through a combusted organic and underlying mineral layer. Stained water seeped out at the bottom of both profiles suggesting a general tendency to subsurface stormflow (SSF). Ongoing SSF could directly be studied 24 h after a high‐intensity rainfall event on a 55‐m hillslope section in the burned forest. Measurements of water temperature proved the role of the permafrost layer as a base horizon for SSF. Repeated tracer injections allowed direct insights into SSF dynamics: A first injection suggested rather slow dispersive subsurface flow paths; whereas 18 h later, a second injection traced a more preferential flow system with 20 times quicker flow velocities. We speculate that these pronounced SSF dynamics are limited to burned slopes where a thermally insulating organic layer is absent. On three south‐facing soil profiles, the applied tracer remained in the uppermost 5 cm of a silt‐rich mineral soil horizon. No signs of preferential infiltration could be found, which suggested reduced biological activity under a harsh, dry and cold climate. Instead, direct observations, distributed tracers and charcoal samples provided evidence for the occurrence of overland flow. Copyright © 2014 John Wiley & Sons, Ltd.     

Prograded foredunes of Western Australia's macro‐tidal coast – implications for Holocene sea‐level change and high‐energy wave impacts

The Holocene evolution of the Canning Coast of Western Australia has largely been overlooked so far mainly due to its remoteness and low population density. We report on new data from a sequence of foredunes inside the macro‐tidal Admiral Bay, 110 km southwest of Broome. Based on sediment cores, differential global positioning system (dGPS)‐based elevation transects, and stratigraphical analyses on outcrops of the relict foredunes, we aim at reconstructing Holocene coastal changes and relative sea levels (RSLs), as well as identifying and dating imprints of extreme‐wave events. Sedimentary analyses comprise the documentation of bedding structures, foraminiferal content and macrofaunal remains, grain size distribution, and organic matter. The chronological framework is based on 26 carbon‐14 accelerator mass spectrometry (¹⁴C‐AMS) datings. Marine flooding of the pre‐Holocene surface landward of the 2.5 km‐wide foredune barriers occurred 7400–7200 cal bp , when mangroves colonized the area. After only 200–400 years, a high‐energy inter‐tidal environment established and prevailed until c. 4000 cal bp , before turning into the present supralittoral mudflat. During that time, coastal regression led to beach progradation and the formation of aligned foredunes. Drivers of progradation were a stable RSL or gradual RSL fall after the mid‐Holocene and a positive sand budget. The foredunes overlie upper beach deposits located up to >2 m above the present upper beach level and provide evidence for a higher mid‐Holocene RSL. Discontinuous layers of coarse shells and sand are intercalated in the foredunes, indicating massive coastal flooding events. One such layer was traced over three dune ridges and dated to c. 1700–1550 cal bp . However, it seems that most tropical cyclones induce net erosion rather than deposition at aligned foredunes and thus, they are only suitable for reconstructing temporal variability if erosional features or sedimentation reliably tied to these events can be identified and dated accurately. Copyright © 2014 John Wiley & Sons, Ltd.     

Investigating suspended particulate matter in coastal waters using the fractal theory

Ocean Dynamics - Suspended particulate matters (SPM) in coastal waters were investigated with an approach combining suspended particulate matter concentrations (SPMCs) measured by an optical...     

Correlation of seismic activity and fumarole temperature at the Mt. Merapi volcano (Indonesia) in 2000

In this paper we present densely sampled fumarole temperature data, recorded continuously at a high-temperature fumarole of Mt. Merapi volcano (Indonesia). These temperature time series are correlated with continuous records of rainfall and seismic waveform data collected at the Indonesian–German multi-parameter monitoring network. The correlation analysis of fumarole temperature and precipitation data shows a clear influence of tropical rain events on fumarole temperature. In addition, there is some evidence that rainfall may influence seismicity rates, indicating interaction of meteoric water with the volcanic system. Knowledge about such interactions is important, as lava dome instabilities caused by heavy-precipitation events may result in pyroclastic flows. Apart from the strong external influences on fumarole temperature and seismicity rate, which may conceal smaller signals caused by volcanic degassing processes, the analysis of fumarole temperature and seismic data indicates a statistically significant correlation between a certain type of seismic activity and an increase in fumarole temperature. This certain type of seismic activity consists of a seismic cluster of several high-frequency transients and an ultra-long-period signal (<0.002 Hz), which are best observed using a broadband seismometer deployed at a distance of 600 m from the active lava dome. The corresponding change in fumarole temperature starts a few minutes after the ultra-long-period signal and simultaneously with the high-frequency seismic cluster. The change in fumarole temperature, an increase of 5 °C on average, resembles a smoothed step. Fifty-four occurrences of simultaneous high-frequency seismic cluster, ultra-long period signal and increase of fumarole temperature have been identified in the data set from August 2000 to January 2001. The observed signals appear to correspond to degassing processes in the summit region of Mt. Merapi.     

Snow accumulation distribution inferred from time‐lapse photography and simple modelling

The spatial and temporal distribution of snow accumulation is complex and significantly influences the hydrological characteristics of mountain catchments. Many snow redistribution processes, such as avalanching, slushflow or wind drift, are controlled by topography, but their modelling remains challenging. In situ measurements of snow accumulation are laborious and generally have a coarse spatial or temporal resolution. In this respect, time‐lapse photography shows itself as a powerful tool for collecting information at relatively low cost and without the need for direct field access. In this paper, the snow accumulation distribution of an Alpine catchment is inferred by adjusting a simple snow accumulation model combined with a temperature index melt model to match the modelled melt‐out pattern evolution to the pattern monitored during an ablation season through terrestrial oblique photography. The comparison of the resulting end‐of‐winter snow water equivalent distribution with direct measurements shows that the achieved accuracy is comparable with that obtained with an inverse distance interpolation of the point measurements. On average over the ablation season, the observed melt‐out pattern can be reproduced correctly in 93% of the area visible from the fixed camera. The relations between inferred snow accumulation distribution and topographic variables indicate large scatter. However, a significant correlation with local slope is found and terrain curvature is detected as a factor limiting the maximal snow accumulation. Copyright © 2010 John Wiley & Sons, Ltd.