Semi‐active fuzzy control for seismic response reduction using magnetorheological dampers

A semi‐active fuzzy control strategy for seismic response reduction using a magnetorheological (MR) damper is presented. When a control method based on fuzzy set theory for a structure with a MR damper is used for vibration reduction of a structure, it has an inherent robustness, and easiness to treat the uncertainties of input data from the ground motion and structural vibration sensors, and the ability to handle the non‐linear behavior of the structure because there is no longer the need for an exact mathematical model of the structure. For a clipped‐optimal control algorithm, the command voltage of a MR damper is set at either zero or the maximum level. However, a semi‐active fuzzy control system has benefit to produce the required voltage to be input to the damper so that a desirable damper force can be produced and thus decrease the control force to reduce the structural response. Moreover, the proposed control strategy is fail‐safe in that the bounded‐input, bounded‐output stability of the controlled structure is guaranteed. The results of the numerical simulations show that the proposed semi‐active control system consisting of a fuzzy controller and a MR damper can be beneficial in reducing seismic responses of structures. Copyright © 2004 John Wiley & Sons, Ltd.     

Depositional wedge tops: interaction between low basal friction external orogenic wedges and flexural foreland basins

Growth structures develop mainly across depositional wedge tops where the top of the distal orogenic wedge lies below local base level within the flexural foreland basin. Documented examples indicate that optimum conditions for the development of a depositional wedge top occur when the dip of the upper surface of the outer orogenic wedge (α) is low (0–1°), regardless of the taper angle (α+β), where β is the inclination of the base of the wedge. Low α angles are associated with the presence of low friction décollements, usually salt. Therefore, depositional wedge tops develop most commonly on low basal friction wedges. In natural examples such as the northern Apennines, the South Central Pyrenees and the Zagros, it is shown that whereas α is consistently low, β can vary considerably (1–9°), being principally controlled by flexure of the lower plate. In addition, the distribution of deformation in the wedge is complex. The applicability of the critical wedge model to low basal friction external orogenic zones is examined. Neither taper angles, nor the complex distribution of internal deformation nor the often associated forward slip of the whole wedge, can be satisfactorily explained by the established critical wedge model. As weak detachments such as salt cannot support any significant topography, it follows that low basal friction wedges cannot attain a critical state and, therefore, the critical wedge model cannot be satisfactorily applied to these external orogenic systems. This model, however, explains well the behaviour of external orogenic wedges with high basal friction. In the analysis of orogenic wedges, separate analysis of the angles α and β proves more useful than the critical taper angle α+β.     

Contrôle structural du partage de Rb entre fluide et micas potassiques dans les pegmatites du Brésil

A geochemical study of pegmatitic micas from Minas Gerais State in Brazil was performed with an electron microprobe, in order to examine the variations of Rb, K, Al and F contents. It is observed a linear decreasing relationship between the [Rb/K] ratio of the micas and their contents in Al^VI. The interpretation is based on the hypothesis that the partition coefficient C_Rb/K^mica/fl between fluid and mineral does not vary significantly as a function of temperature and pressure in the narrow conditions of crystallization of pegmatites. It is suggested that the relation: C_Rb/K^mica/fl=0.55×(5?[Al^VI]) is of crystallochemical order. Micas with low contents in Al take higher contents in Rb because the potassic sites where Rb enters are larger. This relation gives another way of calculating the values [Rb/K] of the fluids knowing Rb, K, Al and Si in the micas. This crystallochemistry also allows us to foresee a direct correlation between Rb and F in the pegmatitic micas. To cite this article: J. Quéméneur et al., C. R. Geoscience 336 (2004).     

Sources of osmium to the modern oceans: new evidence from the Pt-Os system

High precision Os isotope analysis of young marine manganese nodules indicate that whereas the composition of modern seawater is radiogenic with respect to ¹⁸⁷Os/¹⁸⁸Os, it has ¹⁸⁶Os/¹⁸⁸Os that is within uncertainty of the chondritic value. Marine Mn nodule compositions thus indicate that the average continental source of Os to modern seawater had long-term high Re/Os compared to Pt/Os. Analyses of loess and freshwater Mn nodules support existing evidence that average upper continental crust (UCC) has resolvably suprachondritic ¹⁸⁶Os/¹⁸⁸Os, as well as radiogenic ¹⁸⁷Os/¹⁸⁸Os. Modeling the composition of seawater as a two-component mixture of oceanic/cosmic Os with chondritic Os compositions and continentally-derived Os demonstrates that, insofar as estimates for the composition of average UCC are accurate, congruently weathered average UCC cannot be the sole continental source of Os to seawater. Our analysis of four Cambrian black shales confirm that organic-rich sediments can have ¹⁸⁷Os/¹⁸⁸Os ratios that are much higher than average UCC, but ¹⁸⁶Os/¹⁸⁸Os compositions that are generally between those of chondrites and average-UCC. Preferential weathering of black shales can result in dissolved Os discharged to the ocean basins that has a much lower ¹⁸⁶Os/¹⁸⁸Os than does average upper crust. Modeling the available data demonstrates that augmentation of estimated average UCC compositions with less than 0.1% additional black shale and 1.4% additional ultramafic rock can produce a continental end-member Os isotopic composition that satisfies the requirements imposed by the marine Mn nodule data. The interplay of these two sources provides a mechanism by which the ¹⁸⁷Os/¹⁸⁸Os of seawater can change as sources and weathering conditions change, yet seawater ¹⁸⁶Os/¹⁸⁸Os varies only minimally.     

Rates of silicate dissolution in deep-sea sediment: In situ measurement using U/U of pore fluids

Bulk dissolution rates for sediment from ODP Site 984A in the North Atlantic are determined using the ²³⁴U/²³⁸U activity ratios of pore water, bulk sediment, and leachates. Site 984A is one of only several sites where closely spaced pore water samples were obtained from the upper 60 meters of the core; the sedimentation rate is high (11-15 cm/ka), hence the sediments in the upper 60 meters are less than 500 ka old. The sediment is clayey silt and composed mostly of detritus derived from Iceland with a significant component of biogenic carbonate (up to 30%).The pore water ²³⁴U/²³⁸U activity ratios are higher than seawater values, in the range of 1.2 to 1.6, while the bulk sediment ²³⁴U/²³⁸U activity ratios are close to 1.0. The ²³⁴U/²³⁸U of the pore water reflects a balance between the mineral dissolution rate and the supply rate of excess ²³⁴U to the pore fluid by α-recoil injection of ²³⁴Th. The fraction of ²³⁸U decays that result in α-recoil injection of ²³⁴U to pore fluid is estimated to be 0.10 to 0.20 based on the ²³⁴U/²³⁸U of insoluble residue fractions. The calculated bulk dissolution rates, in units of g/g/yr are in the range of 4 × 10⁻⁷ to 2 × 10⁻⁶ yr⁻¹. There is significant down-hole variability in pore water ²³⁴U/²³⁸U activity ratios (and hence dissolution rates) on a scale of ca. 10 m. The inferred bulk dissolution rate constants are 100 to 10⁴ times slower than laboratory-determined rates, 100 times faster than rates inferred for older sediments based on Sr isotopes, and similar to weathering rates determined for terrestrial soils of similar age. The results of this study suggest that U isotopes can be used to measure in situ dissolution rates in fine-grained clastic materials.The rate estimates for sediments from ODP Site 984 confirm the strong dependence of reactivity on the age of the solid material: the bulk dissolution rate (R_d) of soils and deep-sea sediments can be approximately described by the expression R_d ≈ 0.1 Age⁻¹ for ages spanning 1000 to 5 × 10⁸ yr. The age of the material, which encompasses the grain size, surface area, and other chemical factors that contribute to the rate of dissolution, appears to be a much stronger determinant of dissolution rate than any single physical or chemical property of the system.     

Paper 2. agricultural impacts of and responses to climate change in the Missouri-Iowa-Nebraska-Kansas (MINK) region

The climate of the 1930s was used as an analog of the climate that might occur in Missouri, Iowa, Nebraska and Kansas (the MINK region) as a consequence of global warming. The analog climate was imposed on the agriculture of the region under technological and economic conditions prevailing in 1984/87 and again under a scenario of conditions that might prevail in 2030. The EPIC model of Williamset al. (1984), modified to allow consideration of the yield enhancing effects of CO₂ enrichment, was used to evaluate the impacts of the analog climate on the productivity and water use of some 50 representative farm enterprises. Before farm level adjustments and adaptations to the changed climate, and absent CO₂ enrichment (from 350 to 450 ppm), production of corn, sorghum and soybeans was depressed by the analog climate in about the same percent under both current and 2030 conditions. Production of dryland wheat was unaffected. Irrigated wheat production actually increased. Farm level adjustments using low-cost currently available technologies, combined with CO₂ enrichment, eliminated about 80% of the negative impact of the analog climate on 1984/87 baseline crop production. The same farm level adjustments, plus new technologies developed in response to the analog climate, when combined with CO₂ enrichment, converted the negative impact on 2030 crop production to a small increase. The analog climate would have little direct effect on animal production in MINK. The effect, if any, would be by way of the impact on production of feed-grains and soybeans. Since this impact would be small after on-farm adjustments and CO₂ enrichment, animal production in MINK would be little affected by the analog climate.     

Results from field testing A curved box girder bridge using simulated earthquake loads

This paper presents the results of a unique field test on a curved highway overpass. In the test, large horizontal loads were applied to the superstructure of the bridge and quickly released, causing the bridge to vibrate. The resulting large-amplitude vibrations were intended to be similar to the vibrations caused by earthquakes (horizontal accelerations of up to 25 per cent of gravity were measured on the bridge deck). Well-defined lateral, longitudinal, vertical and torsional vibration modes were identified from the test data. The vibration modes were used to verify an analytical model of the bridge's dynamic response. For this paper, the model was verified using only the fundamental vibration mode, which was primarily a horizontal vibration mode. Using a system identification procedure, the dynamic response model was adjusted until its frequency and mode shape matched the measured frequency and mode shape. Parameters in the verified model were compared with the same parameters calculated from information in the structural drawings. Because the fundamental mode represents a horizontal mode, the bridge parameters identified in this paper were those parameters which strongly influence the horizontal response of the bridge.     

Semi-structured interviews on disaster and emergency preparedness for people with disabilities in two states in Mexico

Natural Hazards - When a disaster occurs, people with disabilities are at a higher risk to adverse health outcomes due to inadequate access to resources, high levels of exposure to hazards, and an...