Seismic Ground Motion Expected for the Eastern District of Naples

The seismic ground motion of a test area in the eastern district of Naples is computed with a hybrid technique based on the mode summation and the finite difference methods. This technique allows us the realistic modelling of source and propagation effects, including local soil conditions. In the modelling, we consider the 1980 Irpinia earthquake, a good example of strong shaking for the area of Naples, which is located about 90 km from the epicenter.The detailed geological setting is reconstructed from a large number of drillings. The sub-soil is mainly formed by alluvial (ash, stratified sand and peat) and pyroclastic materials overlying a pyroclastic rock (yellow neapolitan tuff), representing the neapolitan bedrock. The detailed information available on mechanical properties of the sub-soil and its geometry warrants the application of the sophisticated hybrid technique.As expected, the sedimentary cover causes an increase of the signal's amplitudes and duration. If thin peat layers are present, the amplification effects are reduced, and the peak ground accelerations are similar to those observed for the bedrock model. This can be explained by the backscattering of wave energy at such layers, that tend to seismically decouple the upper from the lower part of the structure.For SH-waves, the influence of the variations of the S-wave velocities on the spectral amplification is studied, by considering locally measured velocities and values determined from near-by down-hole measurements. The comparison between the computed spectral amplifications confirms the key role of an accurate determination of the seismic velocities of the different layers.The comparison performed between a realistic 2-D seismic response and a standard 1-D response, based on the vertical propagation of waves in a plane layered structure, shows considerable difference, from which it is evident that serious caution must be taken in the modelling of expected ground motion at a specific site.     

The Nootka Fault Zone — a new plate boundary off western Canada

Summary. Relative motion across a boundary between the main Juan de Fuca plate and its northern extension, the Explorer plate, had earlier been suggested from sea-floor magnetic anomaly analysis and from earthquakes recorded on the western Canada land seismic network. The location of the boundary, called the Nootka fault zone, and the motion across it have been examined through seismic reflection profiles, accurate location of earthquakes with an array of ocean bottom seismometers and through analysis of magnetic, gravity and bathymetric data. The fault zone extends from a ridge-fault—fault triple point at the northern end of the Juan de Fuca ridge to a fault—trench—trench triple junction at the margin off north-central Vancouver Island. The active portion of the fault zone is about 20 km wide, and has produced extensive disturbance in the 0.5 to 1 km of overlying sediments. Magnetic anomaly analysis suggests present left-lateral strike slip motion of about 3 cm/yr, with convergence at the margin being more rapid to the south than to the north of the fault zone. Because of rapidly changing spreading parameters on the Explorer and Juan de Fuca ridges over the past 5 Myr the Nootka fault zone has had a very complex history.     

Survival of organic phases in porous IDPs during atmospheric entry: A pulse‐heating study

Abstract— In this study, we have performed pulse‐heating experiments at different temperatures for three organic molecules (a polycyclic aromatic hydrocarbon [PAH], a ketone, and an amino acid) absorbed into microporous aluminum oxide (Al₂O₃) in order to imitate the heating of the organic molecules in interplanetary dust particles (IDPs) and micrometeorites (MMs) during atmospheric entry and to investigate their survival. We have shown that modest amounts (a few percent) of these organic molecules survive pulse‐heating at temperatures in the 700 to 900 °C range. This suggests that the porosity in IDPs and MMs, combined with a sublimable phase (organic material, water), produces an ablative cooling effect, which permits the survival of organic molecules that would otherwise be lost either by thermal degradation or evaporation during atmospheric entry.     

Residual deformations and seismic hazard of fault zones in underground workings

The results of long-term measurements of residual deformations in the area of the Severomuiskii tunnel during its construction are given. Comparison of spatial and temporal distributions between deformations and earthquakes shows that they are interrelated. The nonlinear behavior of disintegrated and waterlogged rocks within tectonic fault zones should be taken into account even for moderate intensity earthquakes, since they are accompanied by ground subsidence. Underground workings within such sites are subjected to loads that are greater than expected according to current hypotheses, which are the basis for calculations of rock pressure. It is established that the most probable mechanism of ground subsidence and residual deformation in underground workings could be the gravity load of the overlying strata of disintegrated and waterlogged rocks within a fault zone, which leads to instability of the rocks. Approximate stress estimations are made on the basis of the results of measurements of residual deformations of roof supports (linings).     

Fe and O isotope composition of meteorite fusion crusts: Possible natural analogues to chondrule formation?

Meteorite fusion crust formation is a brief event in a high‐temperature (2000–12,000 K) and high‐pressure (2–5 MPa) regime. We studied fusion crusts and bulk samples of 10 ordinary chondrite falls and 10 ordinary chondrite finds. The fusion crusts show a typical layering and most contain vesicles. All fusion crusts are enriched in heavy Fe isotopes, with δ⁵⁶Fe values up to +0.35‰ relative to the solar system mean. On average, the δ⁵⁶Fe of fusion crusts from finds is +0.23‰, which is 0.08‰ higher than the average from falls (+0.15‰). Higher δ⁵⁶Fe in fusion crusts of finds correlate with bulk chondrite enrichments in mobile elements such as Ba and Sr. The δ⁵⁶Fe signature of meteorite fusion crusts was produced by two processes (1) evaporation during atmospheric entry and (2) terrestrial weathering. Fusion crusts have either the same or higher δ¹⁸O (0.9–1.5‰) than their host chondrites, and the same is true for Δ¹⁷O. The differences in bulk chondrite and fusion crust oxygen isotope composition are explained by exchange of oxygen between the molten surface of the meteorites with the atmosphere and weathering. Meteorite fusion crust formation is qualitatively similar to conditions of chondrule formation. Therefore, fusion crusts may, at least to some extent, serve as a natural analogue to chondrule formation processes. Meteorite fusion crust and chondrules exhibit a similar extent of Fe isotope fractionation, supporting the idea that the Fe isotope signature of chondrules was established in a high‐pressure environment that prevented large isotope fractionations. The exchange of O between a chondrule melt and an ¹⁶O‐poor nebula as the cause for the observed nonmass dependent O isotope compositions in chondrules is supported by the same process, although to a much lower extent, in meteorite fusion crusts.     

A spectroscopic study of the microorganism model of interstellar grains

The microorganism model of interstellar grains is investigated by spectroscopy from the infrared (IR), visible to the ultraviolet (UV) wave regions.E. coli, yeast and spores ofBacillus subtilis exhibit absorption bands at =3.1 and 9.7 m; they also exhibit several absorptions at 68 m which are in agreement with the observed IS extinction curves.To obtain the extinction curves in the visible and UV regions, dry films of microorganism are prepared on a MgF₂ plate or synthesized quartz plate and their spectra measured. In the wavelength region 190400 nm, conventional spectrophotometers are adopted for the measurement. The extinction curve of the film ofE. coli is similar to the observed IS curve.For the wave-range 100<<400 nm, a vacuum UV spectrometer is adopted to avoid absorptions due to O₂ in the atmosphere. The extinction spectra by this method are in agreement with the result obtained by the conventional method where comparison is possible. The extinction curves ofE. coli and yeast are such that they incrase towards the short wavelength and exhibit a peak at -190 nm, which is different from the well-known IS peak at =220 nm. It remains to be seen whether interstellar low temperatures (1040 K) can shift the peak position in the extinction curve of biochemical materials.