Atmospheric gravity waves identified by ground-based observations of the intensity and rotational temperature of OH airglow

Spectroscopic observations of OH airglow undertaken on May 2, 2006 at Uji, Japan reveal variations in intensity and rotational temperature related to the passage of an atmospheric gravity wave. The variations exhibit a period of approximately 1 h and magnitudes of 2–6% in intensity and 0.5–2% in rotational temperature. The vertical wavelength and intrinsic frequency of the atmospheric gravity wave were determined from the horizontal wavelength derived by an OH airglow imager, the background horizontal wind velocity obtained by the middle and upper atmosphere (MU) radar, and the dispersion relationship. The observed variations are consistent with the values calculated using the model of Liu, A.Z., Swenson, G.R. [2003. A modeling study of O₂ and OH airglow perturbations induced by atmospheric gravity waves. J. Geophys. Res. 108 (No. D4), 4151. doi:10.1029/2002JD002474].     

SAR- and gravity change-based characterization of the distribution pattern of pyroclastic flow deposits at Mt. Merapi during the past 10 years

Mt. Merapi, Indonesia, is one of the most active and dangerous volcanoes in the Torrid Zone. This volcano has erupted frequently and has produced pyroclastic flows following the collapse of the summit lava dome. We used Synthetic Aperture Radar (SAR) data acquired by JERS-1 and RADARSAT-1 satellites from April 1996 to July 2006 to clarify the distribution patterns of the pyroclastic flow deposits. The extent of the deposits, termed P-zones, was accurately extracted by ratio operation and low-level feature extraction from SAR intensity images. These images highlighted temporal changes of the distribution area, perimeter, flow distance, included angle, and collapse direction. To validate the image-processing results, reflectance spectra of the rock samples collected after the eruption in June 2006 were measured in a laboratory. The reflectance spectra of all samples showed similar characteristics to the reference spectra, which were derived from atmospheric correction of Hyperion sensor image data covering the lava dome at the summit. Therefore, P-zones were confirmed to be the pyroclastic flow deposits originating from destruction of the lava dome at the summit. The image-processing results clarified that the extent of the distribution areas, perimeter, flow distances, and included angle of the P-zones were variable among the eruptions, while the collapse direction had a constant pattern. The collapse pattern followed a clockwise change from the south toward the west. By comparing the ratio maps of Bouguer gravity anomaly data in two periods, the change was interpreted to originate from the inclination of the conduit and the formation of shallow and deep magma reservoirs.     

Assessment of urban groundwater heat contaminant in Jakarta, Indonesia

Urbanization has become one of the domain processes for city development in Indonesia. The results of the extremely high densities of fast growing population have led to negative subsurface environmental impact. Jakarta, as one of the rapidly developed and urbanized cities in Southeast Asia, has become one of the interesting urbanization city to analyze its effects. In Jakarta, the use of groundwater has greatly accelerated conforming to the rise in its population and the development of the industrial sector, which consume a relatively large amount of water. The increase of groundwater exploitation in Jakarta city has already caused a negative impact on these resources. Therefore, an assessment of groundwater trends in the urban area, including their hazard and risk management, is a necessary action. This paper describes the assessment of urban groundwater loading caused by human concentration in Jakarta city. Subsurface heat contamination under the condition of surface warming shows significant effects of urban groundwater loading during the past century in Jakarta city.     

EM Monitoring of Crustal Processes Including the Use of the Network-MT Observations

There are several kinds of coupling mechanisms which can convert mechanical, chemical or thermal energies due to seismic or volcanic activities into electromagnetic energies. As a result of concentrated efforts in laboratory and theoretical research, the basic relationship between the intensity of electromagnetic sources and changes in mechanical, chemical and thermal state is becoming established. Also with the progress of the electromagnetic simulation techniques, it has been possible to evaluate in situ sensitivity. Based on this progress and also due to extensive improvement in measuring techniques, many field experiments have been performed to elucidate subsurface geophysical processes underlying the preparation stage, onset, and subsequent healing stage of earthquakes and volcanic eruptions. In volcanic studies, many studies have reported the measurement of electromagnetic signals which were successfully interpreted in terms of various driving mechanisms. Although there have been numerous reports about the existence of precursory electromagnetic signals in seismic studies, only a few of them could be successfully explained by the proposed mechanisms, whereas coseismic phenomena are often consistent with those mechanisms including the absence of detectable signals. In many cases, one or two orders of higher sensitivity were required, especially for precursory signals. Generally, electromagnetic methods are more sensitive to near-surface phenomena. It will be necessary to discriminate electromagnetic signals due to these near-surface sources, which often possess no relationship with the crustal activities. Further efforts to enhance in situ sensitivity through improvements in observation techniques and in data processing techniques are recommended. At the same time, multi-disciplinary confirmation against the validity of electromagnetic phenomena will inevitably be necessary. A Network-MT observation technique has been developed to determine large-scale deep electrical conductivity structure. In the method, a telephone line network or purpose-built long baseline cables are utilized to measure voltage differences with long electrode separations. Because of the averaging effect of the electric fields, static shift problems due to small-scale, near-surface lateral heterogeneities can be alleviated. Several field experiments revealed regional scale deep electrical conductivity structures related to slab subduction or its stagnation, which enable us to elucidate underlying physical processes caused by the slab motion. The technique can also be applied to monitor the electric potential field related to crustal activities. The annual variation of the potential field and electrical conductivity in the French Alps were interpreted to be caused by the annual variation of lake water level. The method was also used to monitor the regional scale spatio-temporal variation of the SP field and electrical conductivity before and at the onset of earthquakes and volcanic eruptions.     

Penetration into low-density media: In situ observation of penetration process of various projectiles

In order to understand the penetration process of projectiles into lower-density targets, we carry out hypervelocity impact experiments using low-density (60 mg cm^?3) aerogel targets and various types of projectiles, and observe the track formation process in the targets using a high-speed camera. A carrot shaped track, a bulbous, and a “hybrid” one consisting of bulbous and thin parts, are formed. The results of the high-speed camera observations reveal the similarity and differences on the temporal evolution of the penetration depth and maximum diameter of these tracks. At very early stages of an impact, independent of projectile type, the temporal penetration depth is described by hydrodynamic models for the original projectiles. Afterward, when the breakup of projectiles does not occur, intact projectiles continue to penetrate the aerogels. In the case of the breakup of projectiles, the track expands with a velocity of about a sound velocity of the aerogel at final stages. If there are large fragments, they penetrate deeper and the tracks become a hybrid type. The penetration of the large fragments is described by hydrodynamic models. Based on these results, we discuss the excavation near the impact point by shock waves.     

Zircon U–Pb ages of granitic and mafic dikes associated with granitoids and metamorphic rocks of the Ryoke Belt in the eastern Kii Peninsula,southwest Japan

Zircon U–Pb dates for felsic and intermediate to mafic dikes intruding into the Ryoke granitoids and metamorphic rocks at selected outcrops in the Takamiyama area of the eastern Kii Peninsula, southwest Japan, were determined along with their geology and petrography to reveal the history of Cretaceous magmatism. At each outcrop, the felsic and intermediate to mafic dikes exhibit specific structures that are indicative of magma intermingling and have coeval intrusion ages of ca. 81–77 Ma. Our zircon U–Pb data complement previously published data, suggesting that the mafic magmatism continued intermittently from 83 to 76 Ma in the Takamiyama area and that magmatism migrated eastward within the Ryoke Belt. A comparison of intrusion ages between a dike and a host Ryoke granitoid at one outcrop indicates that the host rock experienced ductile deformation at ~88 to ~83 Ma. Judging from the small number of zircons and the concordant date distributions, we didn't recognize the evidence suggesting the partial melting of the host rocks, as Nakajima et al. (Journal of the Geological Society of Japan, 2021, 127, 69–78) reported.     

A recent history of science cases for optical interferometry

Optical long-baseline interferometry is a unique and powerful technique for astronomical research. Since the 1980’s (with I2T, GI2T, Mark I to III, SUSI, ...), optical interferometers have produced an increasing number of scientific papers covering various fields of astrophysics. As current interferometric facilities are reaching their maturity, we take the opportunity in this paper to summarize the conclusions of a few key meetings, workshops, and conferences dedicated to interferometry. We present the most persistent recommendations related to science cases and discuss some key technological developments required to address them. In the era of extremely large telescopes, optical long-baseline interferometers will remain crucial to probe the smallest spatial scales and make breakthrough discoveries.     

Finite‐element analysis of laminated rubber bearing of building frame under seismic excitation

Finite element analysis is carried out for a building frame supported by laminated rubber bearings to simultaneously investigate global displacement and local stress responses under seismic excitation. The frame members and the rubber bearings are discretized into hexahedral solid elements with more than 3 million degrees of freedom. The material property of rubber is represented by the Ogden model, and the frame is assumed to remain in elastic range. It is shown that the time histories of non‐uniform stress distribution and rocking behavior of the rubber bearings under a frame subjected to seismic excitation can be successfully evaluated, and detailed responses of base and frame can be evaluated through large‐scale finite element analysis. Copyright © 2015 John Wiley & Sons, Ltd.     

Temporal variations in channel patterns and facies architecture in a gravelly fluvial system: The Paleogene Iwaki Formation on the Joban Coalfield,a forearc basin in Northeast Japan

This paper examined sequence‐stratigraphic features of a gravelly fluvial system of the Iwaki Formation, which developed in a forearc‐basin setting in Northeast Japan during the Eocene through Oligocene. On the basis of three‐dimensional architectural element analysis, we discriminated three major cycles of channel complexes, which contain ten component channel deposits in total in the fluvial succession. Component channel deposits in the uppermost part of each cycle are sandier and associated with overbank muddy deposits and coal beds as compared with those in the lower part of the cycle. Mean clast‐size also decreases upsection in the entire gravelly fluvial deposits. The fluvial succession is interpreted to have been deposited in response to an overall rise in relative sea level that was superimposed by three short‐term relative sea‐level rises on the basis of vertical stacking patterns and component lithofacies features of channel deposits, and of correlation of the fluvial succession with an age‐equivalent marine succession in an area about 50 km offshore. However, geometry and stacking patterns of the channel complexes do not exhibit any distinct temporal variation and amalgamated channel and bar deposits are dominant throughout the transgressive fluvial succession. On the other hand, an overall fining‐upward pattern of the entire Iwaki Formation fluvial deposits in association with three component fining‐upward patterns is distinct, and is interpreted to be consistent with the tenet of the standard fluvial sequence‐stratigraphic models. This indicates that the present example represents one type of variation in the standard fluvial sequence‐stratigraphic models, possibly reflecting the forearc‐basin setting, which is generally represented by higher valley slope, higher shedding of coarse‐grained sediments, and shorter longitudinal profiles to the coastal area as compared with a passive‐continental‐margin setting.