Geographical and Ecological Characteristics of the Caspian Sea and Modern Tendencies in the Evolution of Its Ecosystem

The Caspian Sea is characterized in the geographic and ecological aspects, and the state of its ecosystem is estimated. The natural and anthropogenic processes that control the formation of the environmental conditions in the Caspian Sea and the distribution of principal commercial hydrobionts and their food items are analyzed. Data on modern tendencies in changes in the abiotic and biotic parameters of the ecosystem, their causes and mechanisms are summarized. Prospects of further changes related to the development of shelf fields of petroleum hydrocarbons are assessed.     

Fast and direct nonparametric procedures in the L-moment homogeneity test

Regional frequency analysis is an important tool to properly estimate hydrological characteristics at ungauged or partially gauged sites in order to prevent hydrological disasters. The delineation of homogeneous groups of sites is an important first step in order to transfer information and obtain accurate quantile estimates at the target site. The Hosking–Wallis homogeneity test is usually used to test the homogeneity of the selected sites. Despite its usefulness and good power, it presents some drawbacks including the subjective choice of a parametric distribution for the data and a poorly justified rejection threshold. The present paper addresses these drawbacks by integrating nonparametric procedures in the L-moment homogeneity test. To assess the rejection threshold, three resampling methods (permutation, bootstrap and Pólya resampling) are considered. Results indicate that permutation and bootstrap methods perform better than the parametric Hosking–Wallis test in terms of power as well as in time and procedure simplicity. A real-world case study shows that the nonparametric tests agree with the HW test concerning the homogeneity of the volume and the bivariate case while they disagree for the peak case, but that the assumptions of the HW test are not well respected.     

Estimating the influence of seismic and meteorological factors on the accuracy of measurements by relative gravimeters

Continuous high-precision long-term gravity measurements are carried out at the geophysical observatory located in the experimental base of Vladimir State University. The long time series of gravity acceleration and its standard deviation are obtained. The factors responsible for the increases in the studied deviations are analyzed. The recommendations for improving the accuracy of relative gravity measurements are formulated.     

Condensed hyperelements method of non-vertical consistent boundaries for wave propagation analysis in irregular media

The study of wave propagation in finite/infinite media has many applications in geotechnical and structural earthquake engineering and has been a focus of research for the past few decades. This paper presents an analysis of 2D anti- plane problems （Love waves） and 2D in-plane problems （Rayleigh waves） in the frequency domain in media consisting of a near-field irregular and a far-field regular part. The near field part may contain structures and its boundaries with the far-field can be of any shape. In this study, the irregular boundaries of the near-field are treated as consistent boundaries, extending the concept of Lysmer＇s vertical consistent boundaries. The presented technique is called the Condensed Hyperelements Method （CHM）. In this method, the irregular boundary is limited to a vertical boundary at each end that is a consistent boundary at the far-field side. Between the two ends, the medium is discretized with hyperelements. Using static condensation, the stiffness matrix of the far-field is derived for the nodes on the irregular boundary. Examples of the application of the CHM illustrate its excellent accuracy and efficiency.     

Estimate of fine sediment deposit dynamics over a gravel bar using photography analysis

Three different methods to analyse fine sediment deposits on a gravel bar using pictures are presented in this paper. A manual digitization and deposits zone delineation are performed as well as two different automated procedures. The three methods are applied on aerial pictures taken in 2006 by a drone from a height around 150 m above the study site. Two other sets of pictures taken in 2010 are also studied: the first set was obtained from the left side bank of the river at approximately 15m above the gravel bar whereas the second one was taken from a helicopter flying 600～m above the ground. These methods were used to estimate the surface of fine sediment deposits before and after flushing events. They yield similar results even if the first automated procedure is able to capture smaller patches of fine sediments. The total surface of fine sediment deposits seems to be similar before and after a flushing event, but the distribution appears quite different. Before a flushing event, a significant amount of fine sediment deposits are mixed with coarser sediments. After the flushing event, one can observe more large fine sediment deposits located on the downstream part of the secondary channel and at the channel margin. Most of the small fine sediment deposit patches were washed out. A short discussion is provided on the possible dynamics of fine sediment deposits over the gravel bar.     

The Aterno valley strong-motion array: seismic characterization and determination of subsoil model

The paper focuses on the strong motion array deployed in the upper Aterno River Valley, in the immediate outskirts north-west of the town of L’Aquila, which is part of the Italian Strong Motion Network operated by the Department of Civil Protection. The array is composed of six accelerometric stations located along a cross section of the valley. The importance of this array relies on the fact that a large amount of high-quality records were obtained during the 2009 L’Aquila seismic sequence, from both the mainshock and several aftershocks. These data are especially important to investigate site effects in sediment-filled valleys during moderate earthquakes in epicentral area because well-documented observational studies are very limited in the literature. However, the main drawback for the study of site effects in the Aterno valley is the lack of a detailed knowledge of the geometry of the valley, soil layering and dynamic properties of materials. The main motivation for this study stems from the need to provide a reliable subsoil model of the valley coupled with high-quality strong motion data. Based on the above, in the framework of S4 project, a major effort was undertaken to get a trustworthy cross section of the valley by an ad hoc investigation, comprising geological and geotechnical surveys as well as an extensive geophysical campaign, characterized by both active and passive measurements. These results were complemented by additional geological and geotechnical data available in the literature. By merging all the information acquired, a 2D subsoil model of the transversal section of the upper Aterno valley has been produced. The valley is characterised by an asymmetric shape with a shallower rock basement at the western edge of the valley that deepens at the valley centre. Moreover, based on the results of geophysical tests, representative V_s values were assigned to the different lithologic units forming the alluvial deposits filling the valley. Shear wave velocity is a fundamental parameter for ground response studies and it is also effective in classifying the accelerometric station from a seismic point of view. The 2D model may be therefore, considered a benchmark model for future studies of site effects. It will offer the possibility to examine site effects with a complex underlying geology and to validate the results of numerical simulations of site response analyses with the numerous observations from earthquake recordings, both for weak and strong ground motion conditions.     

Determining the location of buried plastic water pipes from measurements of ground surface vibration

‘Mapping the Underworld’ is a UK-based project, which aims to create a multi-sensor device that combines complementary technologies for remote buried utility service detection and location. One of the technologies to be incorporated in the device is low-frequency vibro-acoustics, and techniques for detecting buried infrastructure, in particular plastic water pipes, are being investigated. One of the proposed techniques involves excitation of the pipe at some known location with concurrent vibrational mapping of the ground surface in order to infer the location of the remainder of the pipe. In this paper, measurements made on a dedicated pipe rig are reported. Frequency response measurements relating vibrational velocity on the ground to the input excitation were acquired. Contour plots of the unwrapped phase revealed the location of the pipe to within 0.1-0.2 m. Magnitude contour plots revealed the excitation point and also the location of the pipe end. By examining the unwrapped phase gradients along a line above the pipe, it was possible to identify the wave-type within the pipe responsible for the ground surface vibration. Furthermore, changes in the ground surface phase speed computed using this method enabled the location of the end of the pipe to be confirmed.     

Prominence Characteristics in 16th Activity Cycle

Digitization of the daily prominence sketches based on data from the global observational network of visual solar spectroscopes was performed for 1922–1934. More than 55000 prominences were distinguished. The results of analysis of distributions by area, height, and prominence location are presented. In addition, the prominence characteristics were compared to those obtained from more recent observations at the Kislovodsk Mountain Astronomical Station of Pulkovo Observatory. The distributions of prominence areas and heights are close to lognormal. The maximal height distribution corresponds to ~25–40 arcsecs. A second maximum also exists for prominence heights of ~70–90 arcsecs.