Mössbauer studies of iron silicate spinel at high pressure

We have measured in situ Mössbauer transmission spectra of iron silicate spinel (γ-Fe₂SiO₄) in a diamond anvil cell at room temperature and pressures up to 16 GPa. The observed spectra show a doublet characteristic of the paramagnetic state. The isomer shift and quadrupole splitting at atmospheric pressure are 1.10 and 2.63 mm/s, respectively, which are smaller than those of fayalite (α-Fe₂SiO₄). Both the isomer shift and quadrupole splitting decrease linearly with pressure with slope of ?0.003(1) and ?0.020(1) mm/sec · GPa, respectively. This simple linear trend suggests that no electronic or polymorphic transitions occur under 16 GPa except for those due to the small and continuous changes of volume and local symmetry under pressure. On the basis of a crystalline field calculation, the negative pressure derivative of the quadrupole splitting is associated with a trend towards an ideal cubic symmetry of the oxygen sublattice.     

Cation ordering of orthopyroxenes from the Skaergaard Intrusion: implications for the subsolidus cooling rates and permeabilities

 We have determined the quenched cation ordering states of five orthopyroxene crystals collected from the marginal border group and the lower zone a and b of the Skaergaard intrusion, and modeled these data to retrieve their closure temperatures (T _c) of Fe–Mg ordering and cooling rates. According to existing thermal models for the Skaergaard pluton, conductive cooling dominated the high and low temperature regimes, which were separated by an intermediate temperature regime in which the cooling was controlled primarily by convective fluid circulation. The cooling rates retrieved from the quenched cation ordering states of the orthopyroxene crystals strictly apply to temperatures around the closure temperatures of the ordering states, ∼340–400^° C, which fall at the transition from convective to the lower temperature conductive cooling. The cooling rates obtained from the cation ordering states of orthopyroxene vary from ∼1 to 270 K/ka. These results agree well with a thermal model calculated using an assumed average permeability of 10^-12 cm² for the pluton, but not completely with a model calculated on the basis of an average permeability of 10^-13 cm², although both values produced shifts of δ¹⁸O that are comparable to those observed in the pluton. Received: 27 February 1995/Accepted: 20 July 1995     

Contribution à la surveillance de l'activité de l'Etna à partir de l'étude des zones fumerolliennes

Resume La convection de la vapeur d'eau formée en profondeur dans une zone fumerollienne crée en surface une anomalie hydrique, thermique et électrique, cette dernière pouvant être la plus sensible à une variation de l'activité thermique profonde. L'amplitude des anomalies dépend de la position du site par rapport à la configuration de l'activité magmatique, mais aussi des conditions hydrogéologiques locales. La surveillance spatiale et temporelle des éruptions à partir du phénomène convectif hydrique doit tenir compte de ces conditions.

---

The water steam convection existing below a fumarolic area creates hydraulic, thermal and electric anomalies, the electric anomaly being probably the most correlated to a change of the deep thermal activity. The anomaly range depends on the position of the site connected with the configuration of the magmatic activity, but also on the local hydrogeologic conditions. The spatial and temporal surveillance of the eruptions based on these convective data should take into consideration these conditions.

     

A rapid-response 2-D drag anemometer for atmospheric turbulence measurements

A rapid response drag anemometer for measuring streamwise and lateral components of horizontal windspeed is described. Theory of operation, design and calibration are discussed with emphasis on the electronic preconditioning of signals and problems associated with using a mechanically resonant system as a sensor. Field comparisons showed half-hourly means and standard deviations of the streamwise component to be within 8% and 5% of respective values obtained from a 3-dimensional sonic anemometer. The lateral component from the drag anemometer was significantly more noisy than that from the 3-D sonic due to induced oscillations arising from vortex shedding. After mechanical and electronic filtering, half-hourly standard deviation comparisons agreed to within 6% for this component. Friction velocities obtained from the drag anemometer in combination with a 1-D sonic, agreed with measurements from the 3-D sonic anemometer to within 4% over a measured range of 0.05 to 1.2 m s^-1