Acoustic oceanography by remote sensing

Ocean dynamical processes exist over a wide range of temporal and spatial scales. Remotely stationed acoustic devices are being used to "sense" the interior of the oceans at previously unattainable scales. The method is similar to computer-aided tomography (CAT) scans of the brain, but the measurement difficulties are far more severe. The results of a demonstration experiment are reviewed and some directions for acoustic oceanography are discussed.     

Infrared spectrophotometry of Comet IRAS-Araki-Alcock (1983d): a bare nucleus revealed?

Spectra of the central core and surrounding coma of Comet IRAS-Araki-Alcock (1983d) were obtained at 8–13 μm on 11 May and 2–4 μm on 12 May 1983. Spatially resolved measurements at 10 μm with a 4-arcsec beam showed that the central core was more than 100 times brighter than the inner coma only 8 arcsec away; for radially outflowing dust, the brightness ratio would be a factor of 8. The observations of the central core are consistent with direct detection of a nucleus having a radius of approximately 5 km. The temperature of the sunlit hemisphere was > 300 K. Spectra of the core are featureless, while spectra of the coma suggest weak silicate emission. The spectra show no evidence for icy grains. The dust producton rate on 11.4 May was ～ 10⁵ g/sec, assuming that the gas flux from the dust-producing areas on the nucleus was ～ 10^?5 g/cm²/sec.     

Numerical simulation of comet nuclei I. Water-ice comets

A one-dimensional simulation of pure water-ice cometary nuclei is presented, and the effect of the nucleus as a heat reservoir is considered. The phase transition from amorphous to crystalline ice is studied for two cases: (1) where the released latent heat goes entirely into heating adjacent layers and (2) where the released latent heat goes entirely into sublimation. For a Halley-like orbit it was found that for case 1 the phase boundary penetrates about 15 m on the first orbit and does not advance until sublimation brings the surface to some 10 m from the phase boundary. For case 2 the phase boundary penetrates about 1 m below the surface and remains at this depth as the surface sublimates. For an orbit like that of Schwassmann-Wachmann 1 the phase boundary penetrates about 50 m initially for case 1 and about 1 m for case 2. There is no further transformation until the entire comet is heated slowly to near the transition temperature, after which the entire nucleus is converted to crystalline ice. For an Encke-type orbit case 1 gives a nearly continuous transition of the entire nucleus to crystalline ice, while for case 2 the initial penetration is about 8 m and remains at this depth relative to the surface as sublimation decreases the cometary radius. Thus the entire comet is converted to crystalline ice just before it is completely dissipated.     

Coma Morphology of Three Non-periodic Comets

The coma morphology and short-term evolution was investigated of three non-periodic comets in retrograde orbits, C/2001 Q4 (NEAT), C/2002 T7 (LINEAR), and C/2003 K4 (LINEAR). All three comets display distinct coma features, which were very different from one comet to the next and remained rather constant in shape during the observational period. A single, broad feature perpendicular to the sun-tail direction dominated the coma of C/2003 K4 in all used filters (B,V,R,I), whereas the coma of Comet C/2002 T7 exhibited different features in blue and red filters. C/2001 Q4 showed rather complex coma morphology with clear short-term variability in coma brightness. Therefore, these non-periodic comets neither show a featureless coma nor any similarities of the features detected. The overall distribution of coma material was investigated from the shape of radial coma profiles averaged around the comet nucleus. For C/2001 Q4 and C/2002 T7, the slopes fitted to the linear part of these profiles are flatter in the blue than in the red, which can be explained by the presence of coma gas. For C/2003 K4 no such difference is indicated in the May observations (r = 2.3 AU), while in July (r = 1.7 AU) the profiles in the B-filter are flatter than in V, R, and I, hence gas contamination was relevant at least in the B filter. The R and I filter images were used to determine approximate Afρ values of each comet as a function of time.     

X-ray synchrotron emission from the oblique shock in the jet of the powerful radio galaxy 3C 346

We report the first detection, with Chandra , of X-ray emission from the jet of the powerful narrow-line radio galaxy 3C 346. X-rays are detected from the bright radio and optical knot at which the jet apparently bends by approximately 70°. The Chandra observation also reveals a bright galaxy-scale atmosphere within the previously known cluster and provides a good X-ray spectrum for the bright core of 3C 346. The X-ray emission from the knot is synchrotron radiation, as seen in lower-power sources. In common with these sources, there is evidence of morphological differences between the radio/optical and X-ray structures, and the spectrum is inconsistent with a one-component continuous-injection model. We suggest that the X-ray-bright knot is associated with a strong oblique shock in a moderately relativistic, light jet, at ∼ 20° to the line of sight, and that this shock is caused by the jet interacting with the wake in the cluster medium behind the companion galaxy of 3C 346. The general jet curvature can result from pressure gradients in the cluster atmosphere.     

Deep-ocean piezometer probe technology for geotechnical investigations

Two single-sensor piezometer probes, 8 mm in diameter, were developed for deep-ocean geotechnical investigations. These probes were tested in a hyperbaric chamber pressurized to 55 MPa (8000 psi). Testing was performed for a period of five weeks under high hydrostatic pressure with the probes inserted in reconstituted illitic marine sediment. Small differential pore-water pressures were generated in response to both mechanically and thermally generated forcing functions. During deep-ocean simulated pressure tests, the sensors exhibited excellent sensitivity and stability. These developments in piezometer-probe technology provide a quantitative means of assessing important geotechnical parameters of fine-grained seabed deposits.     

Einsteins' gravity with massive gravitons

Graviton may, in principle, have a small non-zero mass. In this paper the relevant theory of the massive graviton with six polarisations is developed. The drastic impact of a non-zero mass of the graviton on cosmology is also illustrated.     

Generalized strain probing of constitutive models

Advanced material constitutive models are used to describe complex soil behaviour. These models are often used in the solution of boundary value problems under general loading conditions. Users and developers of constitutive models need to methodically investigate the represented soil response under a wide range of loading conditions. This paper presents a systematic procedure for probing constitutive models. A general incremental strain probe, 6D hyperspherical strain probe (HSP), is introduced to examine rate‐independent model response under all possible strain loading conditions. Two special cases of HSP, the true triaxial strain probe (TTSP) and the plane‐strain strain probe (PSSP), are used to generate 3‐D objects that represent model stress response to probing. The TTSP, PSSP and general HSP procedures are demonstrated using elasto‐plastic models. The objects resulting from the probing procedure readily highlight important model characteristics including anisotropy, yielding, hardening, softening and failure. The PSSP procedure is applied to a Neural Network (NN) based constitutive model. It shows that this probing is especially useful in understanding NN constitutive models, which do not contain explicit functions for yield surface, hardening, or anisotropy. Copyright © 2004 John Wiley & Sons, Ltd.     

Porous interstellar grains

Recent observations of stellar composition suggest that elements in the Sun are significantly more abundant than in other stars. The reduction in the available element budget implies a drastic revision in current models of interstellar dust. Theoretical models are therefore exploring fluffy, porous physical structure for the grain material. Since a detailed exact treatment of extinction cross-sections is mandatory for a correct understanding of the nature of interstellar dust, we present a technique based on the multipole expansions of the electromagnetic field, which has proven to be general, flexible and powerful in treating scattering of light by porous, composite, arbitrarily shaped particles. The results of this study speak in favour of core–mantle structures characterized by the presence of porosities.     

Theoretical accuracy of synthetic aperture sonar micronavigation using a displaced phase-center antenna

The Cramer-Rao lower bounds on the cross-track translation and rotation of a displaced phase-center antenna (DPCA) in the slant range plane between two successive pings (known as DPCA sway and yaw in what follows) are computed, assuming statistically homogeneous backscatter. These bounds are validated using experimental data from a 118-182-kHz sonar, showing an accuracy of the order of 20 microns on the ping-to-ping cross-track displacements. Next, the accuracy required on the DPCA sway and yaw in order to achieve a given synthetic aperture sonar (SAS) beampattern specification, specified by the expected SAS array gain, is computed as a function of the number P of pings in the SAS. Higher accuracy is required when P increases to counter the accumulation of errors during the integration of the elementary ping-to-ping estimates: the standard deviation must decrease as P/sup -1/2/ for the DPCA sway and P/sup -3/2/ for the yaw. Finally, by combining the above results, the lower bounds on DPCA micronavigation accuracy are established. These bounds set an upper limit to the SAS length achievable in practice. The maximum gain Q in cross-range resolution achievable by a DPCA micronavigated SAS is computed as a function of the key SAS parameters. These theoretical predictions are compared with simulations and experimental results.