Semisubmersible response to transient ice forces

The paper presents an analytical and experimental study on the transient response of semisubmersibles to bergybit impact and the strength of bergybit ice to high strain-rate loadings. Two approaches have been proposed for the solution of the semisubmersible-bergybit interaction problem, one using the energy approach and the other using the conventional structural dynamics approach with initial velocity conditions. In addition the local behaviour of the impacted regions have been analysed for deformation and failure. Numerical results have been given for local behaviour of an impacted column and global behaviour of semisubmersible-bergybit system. Experimental study has been reported on the impact strength of iceberg ice at strain rates of 10⁻³, 10⁻² and 10⁻¹; the indentation impact strength of ice is found to be 3–4 times the unaixial compressive strength, at the same strain rate.     

Production of the Crab Elamenopsis kempiHymenosomatidae in the Garmat-Ali Region, Basrah, Iraq

Abstract. The production of the hymenosomatid crab Elamenopsis kempi was calculated for a period of 18 months from a subtidal area of the Garmat-Ali river, southern Iraq. The highest average individual somatic energy was attained in spring. Maximum population biomass and production were attained by the summer cohort and the minimum values were exhibited by the overwintering cohort. The fluctuations of the average population biomass were followed throughout the sampling period. Average total annual population production was 13.2 g DW · m^-2· a^-1 and the P/B ratio was 5.9. These values were compared with those of the most common crustaceans in the region.     

Dissolved aluminium and the silicon cycle in the Arctic Ocean

Concentrations of dissolved (0.2 µm filtered) aluminium (Al) have been determined for the first time in the Eurasian part of the Arctic Ocean over the entire water column during expedition ARK XXII/2 aboard R.V. Polarstern (2007). An unprecedented number of 666 samples was analysed for 44 stations along 5 ocean transects. Dissolved Al in surface layer water (SLW) was very low, close to 1 nM, with lowest SLW concentrations towards the Canadian part of the Arctic Ocean and higher values adjacent to and in the shelf seas. The low SLW concentrations indicate no or little influence from aeolian dust input. Dissolved Al showed a nutrient-type increase with depth up to 28 nM, but large differences existed between the different deep Arctic basins. The differences in concentrations of Al between water masses and basins could largely be related to the different origins of the water masses. In the SLW and intermediate water layers, Atlantic and Pacific inflows were of importance. Deep shelf convection appeared to influence the Al distribution in the deep Eurasian Basin. The Al distribution of the deep Makarov Basin provides evidence for Eurasian Basin water inflow into the deep Makarov Basin. A strong correlation between Al and Silicon (Si) was observed in all basins. This correlation and the nutrient-like profile indicate a strong biological influence on the cycling and distribution of Al. The biological influence can be direct by the incorporation of Al in biogenic silica, indirect by preferential scavenging of Al onto biogenic siliceous particles, or by a combination of both processes. From the slope of the overall Al–Si relationship in the intermediate water layer (AIDW; ~ 200–2000 m depth), an Al/Si ratio of 2.2 atoms Al per 1000 atoms Si was derived. This ratio is consistent with the range of previously reported Al/Si uptake ratio in biogenic opal frustules of diatoms. In the deepest waters (>2000 m depth) a steeper slope of the Al–Si relationship of 7.4 to 13 atoms Al per 1000 atoms Si likely results from entrainment of cold shelf water into the deep basins, carrying the signal of dissolution of terrigenous particles with a much higher Al:Si ratio of crustal abundance. Only a small enrichment with such crustal Al and Si component may readily account for the higher Al:Si slope in the deepest waters.     

Petroleum composition in the Cuu Long Basin (Mekong Basin) offshore southern Vietnam

The Cuu Long Basin (Mekong Basin) is a rift basin off southern Vietnam, and the most important petroleum producing basin in the country. However, information on petroleum type and characteristics has hitherto been largely unavailable to the public. This paper presents petroleum geochemical data on nine oil samples from four different producing fields in the Cuu Long Basin: the Dragon (Rong), Black Lion (Sutu-Den), Sunrise (Rang ?ong) and White Tiger (Bach Ho) Fields. The oils are highly paraffinic with bimodal normal alkane distributions and show moderate pristane to phytane ratios and a conspicuous hyperbolic decrease in abundance with increasing carbon number of hopane homologues from C₃₀ to C₃₅. The TPP-index of Holba et al. (Holba, A.G., Dzou, L.I., Wood, G.D., Ellis, L., Adam, P., Schaeffer, P., Albrecht, P., Greene, T., Hughes, W.B., 2003. Application of tetracyclic polyprenoids as indicators of input from fresh–brackish water environments. Organic Geochemistry 34, 441–469) is equal to 1 in all samples which in combination with tricyclic triperpane T26/T25 ratios >1 and the n-alkane and hopane distributions mentioned above provide a strong indication of an origin from lacustrine source rocks. This is supported by the absence of marine C₃₀ desmethyl steranes (i.e. 24-n-propylcholestanes) and marine diatom-derived norcholestanes. Based on the overall biological marker distributions, the lakes probably belonged to the overfilled or balanced-fill types defined by Bohacs et al. (Bohacs, K.M., Carroll, A.R., Neal, J.E., Mankiewicz, P.J., 2000. Lake-basin type, source potential, and hydrocarbon character. An integrated sequence-stratigraphic–geochemical framework. AAPG Studies in Geology 46, 3–34). The oils were generated from source rocks at early- to mid-oil-window maturity, presumably Oligocene lacustrine shales that are present in the syn-rift succession. Oils from individual fields may, however, be distinguished by a combination of biological marker parameters, such as the oleanane index, the gammacerane index, the relative abundance of tricyclic terpanes, the proportions of diasteranes and 28-norspergulane, complemented by other parameters. The oils of the Cuu Long Basin show an overall similarity to the B-10 oil from the Song Hong Basin off northern Vietnam, but are markedly different from the seepage oils known from Dam Thi Nai on the coast of central Vietnam.     

Modeling an atypical petroleum system: A case study of hydrocarbon generation,migration and accumulation related to igneous intrusions in the Neuquen Basin,Argentina

In the Altiplanicie del Payún area (Neuquen Basin, Argentina), immature source rock sections intruded by up to 600 m thick Tertiary laccoliths show full spectrum maturity aureoles over hundreds of meters from the contacts. Commercial oil accumulations (20–33°API) and oil shows are located along the entire column, both in sandstone/carbonate and fractured igneous reservoirs. A challenging numerical model that included the emplacement of the intrusive bodies, with extreme temperature ranges and unusually short calculation time steps, has been done with the aim to better understand hydrocarbon generation and migration processes related to these thermal anomalies.     

Fundamental study for morphodynamic modelling: Sand mounds in oscillatory flows

Experiments on sand mounds in oscillatory flow, undertaken in controlled, large-scale laboratory conditions, have produced well-defined data sets for model comparison. Three bathymetries with different levels of submergence, including a surface-piercing case, were tested. The maximum slope was about 1:5.5. Sediment transport is due to bed load with ripple formation. The principal time-dependent bulk parameters are the vertical distance of the centre of gravity above the base and the volume of the mound. A semi-implicit finite-volume depth-averaged hydrodynamic model is used to drive morphodynamics, using van Rijn's sediment flux model generalized to take account of bed slope, and some justification is given for depth-averaged modeling in these conditions. Starting the model runs with the conditions at the end of the first cycle avoided initial atypical physical behaviour. In general good predictions were obtained with an angle of repose reduced from the standard value of about 30° for stationary beds to 15°. For these situations, morphodynamics was largely unaffected by a hydrodynamic roughness height in the range 2.5D₅₀ to 51D₅₀, with larger values accounting for ripple roughness. The reduced angle of repose may be physically expected with mobile beds but this specific value is only expected to be suited to this form of bed motion. In one case an exaggerated ripple formed near the top of the mound reducing agreement with experiment. For the submerged case with normal ripple structure excellent predictions were obtained. For the initially surface-piercing mound, the time of submergence was better predicted with a 30° angle of repose, presumably due to the prominent influence of the near stationary bed near the wet/dry interface, although long term predictions were better predicted with 15°. The occurrence of vortex shedding in the first cycle modeled was in agreement with experimental observation.     

The effect of a topographic high on the morphological stability of a two-inlet bay system

The cross-sectional stability of two tidal inlets connecting the same back-barrier lagoon to the ocean is investigated. The condition for equilibrium is the cross-sectional area tidal prism relationship. In an earlier study [Van de Kreeke, J., 1990. Can multiple inlets be stable? Estuarine, Coastal and Shelf Science 30: 261–273.], using the same equilibrium condition, it was concluded that where two inlets connect the same basin to the ocean ultimately one inlet will close. One of the major assumptions in that study was that the water level in the basin fluctuated uniformly. In hindsight this assumption might be too restrictive. For example, in the Wadden Sea the back barrier lagoon consists of a series of basins, rather than one single basin, separated by topographic highs. These topographic highs limit but do not exclude the exchange of water between the sub-basins. For this reason in the present study, a topographic high in the form of a weir was added, separating the back-barrier lagoon in two sub-basins. The water level in the sub-basins, rather than in the back-barrier as a whole, is assumed to fluctuate uniformly. For this schematization the hydrodynamic equations are solved using a finite difference method. The results, together with the equilibrium condition, yield the equilibrium flow curve for each of the inlets. The intersections of the two equilibrium flow curves represent combinations of cross-sectional areas for which both inlets are in equilibrium. The stability of the equilibriums was investigated using a non-linear stability analysis resulting in a flow diagram. Calculations were carried out for different inlet and weir characteristics. Sinussoidal tides were the same for both inlets. The results show that for relatively large wetted cross-sectional areas over the topographic high, approaching the situation of a single basin, there are no combinations of inlet cross-sectional areas for which both inlets are in a stable equilibrium. This supports the conclusion in the earlier study. For relatively small wetted cross-sectional areas over the topographic high there is one set of stable equilibriums. In that case the two-inlet bay system approaches that of two single-inlet bay systems.     

A two-dimensional finite volume hydrodynamic model for coastal areas: Model development and validation

A two dimensional implicit finite volume scheme for solving the shallow-water equations is developed. The effects of the Coriolis force, surface wind stress, and waves are included. A non-uniform rectilinear forward staggered grid is used with Cartesian coordinates. The time integration is performed using the Euler implicit technique. The convective flux is treated using the deferred correction method. The viscous terms are discretized using a second order central difference approximation. The SIMPLE (Semi-Implicit Method for Pressure-Linked Equations) algorithm is used for coupling the velocity components and the water elevation gradient for the water level correction. The system of equations is solved sequentially using the Strongly Implicit Procedure (SIP). To simulate wave driven current, a phase averaged wave model is used first to simulate wave transformation and calculate radiation stresses. The performance of the developed model is validated for different sources of external forces and different combinations of boundary conditions. The validation cases include tidal circulation in a harbor and wave induced currents behind a breakwater parallel to the coastline. The model is finally applied to simulate the flow pattern in a closed artificial lagoon and along the coastline near Damietta Port located along the Northern coast of Egypt. Results of the developed model agree well with the published results for the considered cases.