激光拉曼光谱法分析多种显微组分荧光变化及其应用

利用激发488 nm激光的氩离子激光器作为RENISHAW inVia型激光拉曼光谱仪的光源,建立了多种显微组分荧光变化(FAMM)分析方法,并对镜质体反射率明显抑制的东营凹陷有效烃源岩进行了测定。结果表明,东营凹陷有效烃源岩的有机质类型越好,镜质体反射率抑制程度越高,有效烃源岩的真实成熟度应主要处于0.64%~1.30%,而不是实测镜质体反射率所反映的0.37%~1.10%。     

内蒙古正蓝旗羊蹄子山-磨石山钛矿区硅质岩地球化学特征及沉积环境意义

文章通过详细的野外地质调查和系统的岩石化学、稀土元素、微量元素及硅、氧同位素等研究,探讨了羊蹄子山-磨石山钛矿区无矿白色硅质岩和富钛硅质岩的成因及形成地质构造环境。研究结果表明,呈厚层状产出的无矿白色硅质岩具较高的SiO2、Al2O3含量及Al/(Al Fe Mn)、Al2O3/(Al2O3 Fe2O3)比值,稀土元素总量很低,其北美页岩标准化配分模式为向右倾的曲线,无明显铈异常和铕异常,表明其形成于受陆源影响的大陆边缘构造环境;赋矿岩系中薄层状富钛硅质岩的TiO2、Fe2O3、Cu、V含量较高,但Al/(Al Fe Mn)、Al2O3/(Al2O3 Fe2O3)比值较低,稀土元素总量较高,北美页岩标准化曲线为明显左倾型-平坦型,具弱的负铈异常,表明其形成于洋脊及附近环境。两种硅质岩的δ30Si值为变化较小的负值,与热水沉积和某些生物成因硅质岩的硅同位素组成相似,两者的δ18O值范围和平均值均相似。两类硅质岩的成因及形成构造环境不同,富钛硅质岩的地球化学特征表明,该矿床的形成与本区元古宙海底火山热液喷流作用有关。     

西藏驱龙斑岩铜钼矿床中UST石英的发现:初始岩浆流体的直接记录

单向固结结构(UST)是浅成侵位的岩浆出溶过程中形成的一种特殊结构,一般由梳状石英与细晶(斑岩)岩交互生长而成,少数产于斑岩与围岩接触部位,其内的原生包裹体被认为是初始流体出溶的可靠记录.作者在西藏驱龙铜矿床中首次发现了具有单向固结结构的石英.研究表明,驱龙UST石英存在于后期侵位的二长花岗斑岩与花岗闪长岩的接触部位,部分为高温β石英;UST石英中原生包裹体的成分主要为高盐度液相,除石盐子矿物外,还含有硬石膏等其他子矿物.阴极发光及显微测温结果表明,初始流体的出溶发生在高温(t≥573℃)、高压(P≥150～200 MPa)条件下,出溶的流体为高温、高盐度[w(NaCkeq)为44.5%～58%]流体,同时还具有较高的氧逸度.因形成压力较高,判断UST石英不可能由较浅侵位的二长花岗斑岩岩枝冷凝出溶而形成,从而推测驱龙铜矿床深部存在着孕育成矿斑岩的大型岩基.     

高、低煤阶煤层气藏地质特征及控气作用差异性研究

高、低煤阶煤层气地质特征及控气作用差异性是研究煤层气富集成藏的重要组成部分,是煤层气勘探开发理论研究过程中重要的基础性研究领域之一。本文以中国沁水、阜新盆地和美国粉河盆地等典型的含气盆地为例,探讨了高、低煤阶煤层气的储层物性差异,分析了构造控气和水文地质控气作用的差异性。研究表明,高煤阶气藏含气量高,CH4百分含量高,δ13C1值大于-38.75‰,储层渗透率变化小,储层改造难,构造热事件对煤层气的生成、富集贡献大,持续的水动力使气藏遭到破坏,且破坏幅度大,现今地下水格局对气藏的形成具有一定的影响;低煤阶气藏含气量低,CH4百分含量低,δ13C1值大于-49.11‰,储层渗透率变化大,储层易改造,煤热演化史及煤阶影响着煤层气的生成、富集,在煤层气生成过程中活跃的水动力是甲烷生成的主要的水文地质条件之一,但持续的水动力使气藏遭到破坏,且破坏幅度小,而合适的地层水矿化度则是低煤阶煤层气生成的重要条件,地下水格局对气藏的调整和改造起到决定性的影响。     

Assessment of frozen-ground conditions for engineering geology along the Qinghai–Tibet highway and railway, China

The Qinghai–Tibet Highway and Railway (the Corridor) across the Qinghai–Tibet Plateau traverses 670 km of permafrost and seasonally frozen-ground in the interior of the Plateau, which is sensitive to climatic and anthropogenic environmental changes. The frozen-ground conditions for engineering geology along the Corridor is complicated by the variability in the near-surface lithology, and the mosaic presence of warm permafrost and talik in a periglacial environment. Differential settlement is the major frost-effect problem encountered over permafrost areas. The traditional classification of frozen ground based on the areal distribution of permafrost is too generalized for engineering purposes and a more refined classification is necessary for engineering design and construction. A proposed classification of 51 zones, sub-zones, and sections of frozen ground has been widely adopted for the design and construction of foundations in the portion of the Corridor studied. The mean annual ground temperature (MAGT), near-surface soil types and moisture content, and active faults and topography are most commonly the primary controlling factors in this classification. However, other factors, such as local microreliefs, drainage conditions, and snow and vegetation covers also exert important influences on the features of frozen ground. About 60% of the total length of the Corridor studied possesses reasonably good frozen-ground conditions, which do not need special mitigative measures for frost hazards. However, other sections, such as warm and ice-rich or -saturated permafrost, particularly in the sections in wetlands, ground improvement measures such as elevated land bridges and passive or proactive cooling techniques need to be applied to ensure the long-term stability of thermally unstable, thick permafrost subsoils, and/or refill with non-frost-susceptible soils. Due to the long-history of the construction and management of the Corridor by various government departments, adverse impacts of construction and operation on the permafrost environment have been resulted. It is recommended that an integrated, executable plan for the routing of major construction projects within this transportation corridor be established and long-term monitoring networks installed for evaluating and mitigating the impact from anthropogenic and climatic changes in frozen-ground conditions.     

储量计算与勘探线剖面计算机辅助成图一体化

引入关系教据库和GIS自动编图技术,改进传统的垂直断面法储量计算过程,可实现矿山储量计算和勘探线剖面计算机辅助成图的同步和一体化.在共用的矿山地矿信息点源数据库平台基础上.通过设置本地数据库,形成GIS操作时的外挂属性库,用来保存储量计算和机助成图过程中的动态数据.储量计算中的每一步骤中,用户以GIS为操作界面来同步实现对空间图元和外挂属性的操作,这其中对工程样段组合、矿体边界圈连和剖面制图综合等开发了大量自动化辅助功能.储量计算的各步完成后,勘探线剖面图和储量报表即同步生成.这种改进的工作方式实现了垂直断面法全过程的计算机辅助化,将提高这一传统方法的应用效率.     

跨孔电阻率法有限元数值模拟及反演

油气资源和矿产资源勘探中,常需要较大的勘探深度和较高的深部分辨能力.充分利用现有钻孔的井地或跨孔电阻率成像技术适应这种要求,但引起的视电阻率响应复杂,从而给资料的正确处理与解释带来一定的困难,为此有必要通过正演数值模拟和反演相结合的手段,对理论模型井地或跨孔装置的响应异常规律进行研究.文章通过设计一个典型地质模型,利用Ansys有限元软件对模型进行2D跨孔电阻率法有限元正演计算,并将模拟的响应视电阻率作为反演的输入,结合平滑约束最小二乘反演,分析了异常特征和分布规律.     

利用MC-ICPMS对水样中硼同位素比值的测定

采用Amberlite IRA-743硼特效树脂进行水溶液中硼的分离,对洗脱液温度、体积以及树脂动态交换容量等进行了实验.它的动态交换容量为4.2 mg/g,在室温条件下,用5 mL 2%HNO3可定量从树脂柱上洗脱被吸附的硼.采用Neptune型MC-ICPMS进行硼同位素组成的测定,1 μg/g浓度的硼标准溶液获得放大的信号强度约为0.7V,硼的化学分离过程有效避免了质量歧视效应.实验结果表明,MC-ICPMS对硼存在严重的记忆效应,通过采用5%HNO3-(1%HNO3 0.1%HF)-H2O-20%NH3H2O-H2O的交替清洗方法,可在约1 h内消除硼的记忆效应.在最佳仪器条件下,对含有250 ng硼的水样,可以快速测定硼的同位素组成,占δ11B测定的绝对偏差为0.4‰-0.5‰(SD).