Low-frequency electric field fluctuations excited by ring current protons

Energetic protons haying ring type distributions are shown to generate low-frequency electrostatic waves, propagating nearly transverse to the geomagnetic field lines, in the ring current region by exciting Mode 1 arid Mode 2 nonresonant instabilities and a resonant instability. Mode 1 nonresonant instability has frequencies around ~4 Hz with transverse wavelengths of ~(8–80) km, and it is likely to occur in the region L = (7–8). Mode 2 nonresonant instability can generate frequencies ~(850–1450) Hz with transverse wavelengths ~(2–20) km. The typical frequencies and transverse wavelengths associated with the resonant instability are (950–1250) Hz and (30–65) km. Both the Mode 2 nonresonant instability and the resonant instability can occur in the ring current region with L = (4–6). The low-frequency modes driven by energetic protons could attain maximum saturation electric field amplitude varying from 0.8 mV/m to 70 mV/m. It is suggested that the turbulence produced by the low-frequency modes may cause pitch angle scattering of ring current protons in the region outside the plasmapause resulting in the ring current decay.     

Solar radio burst (type III)

This article describes the observations of a type III radio burst observed at 103 MHz simultaneously by the two radio telescopes situated at Rajkot (22.3°N, 70.7°E) and Thaltej (23°N, 72.4°E). This event occurred on September 30, 1993 at about 0430 UT and lasted for only half a minute. The event consisted of several sharp spikes in a group. The rise and fall time of these are comparable, however the peaks of individual spikes varied by a factor of four. The comparison of these observations with the data of solar radio spectrograph HiRAS indicates that this was a metric radio burst giving highest emission at about 103 MHz.     

Generating interface waves using a freely falling, instrumentedsource

In recent years, interface waves such as the Scholte wave have become important tools in the study of the geoacoustic properties of near-bottom seafloor sediments. Traditionally, these waves have been generated by explosive or pneumatic sources deployed at or near the seafloor and monitored by ocean-bottom seismographs or geophone arrays. While these sources generate the requisite interface waves, they also produce higher frequency compressional waves in the water and sediment that tend to contaminate the surface wave and make inversion of the data difficult in the near field. In this paper, a new source consisting of a freely falling projectile instrumented with an accelerometer is described. When the projectile impacts the bottom, the exact time history of the vertical force applied to the sediment is known and therefore may be convolved with the transfer function of a sediment geoacoustic model to produce accurate synthetic seismograms. Moreover, the vertical force applied to the seafloor is very efficient in generating surface wave motion while producing very little compressional wave energy so that the near-field signals are much more easily analyzed. An example of the use of the new source is presented including inversion of the received signals to obtain shear-wave velocity and attenuation as a function of depth in the near bottom sediments at a shallow-water site     

Post-solidification cooling and the age of Io's lava flows

The modeling of thermal emission from active lava flows must account for the cooling of the lava after solidification. Models of lava cooling applied to data collected by the Galileo spacecraft have, until now, not taken this into consideration. This is a flaw as lava flows on Io are thought to be relatively thin with a range in thickness from ∼1 to 13 m. Once a flow is completely solidified (a rapid process on a geological time scale), the surface cools faster than the surface of a partially molten flow. Cooling via the base of the lava flow is also important and accelerates the solidification of the flow compared to the rate for the ‘semi-infinite’ approximation (which is only valid for very deep lava bodies). We introduce a new model which incorporates the solidification and basal cooling features. This model gives a superior reproduction of the cooling of the 1997 Pillan lava flows on Io observed by the Galileo spacecraft. We also use the new model to determine what observations are necessary to constrain lava emplacement style at Loki Patera. Flows exhibit different cooling profiles from that expected from a lava lake. We model cooling with a finite-element code and make quantitative predictions for the behavior of lava flows and other lava bodies that can be tested against observations both on Io and Earth. For example, a 10-m-thick ultramafic flow, like those emplaced at Pillan Patera in 1997, solidifies in ∼450 days (at which point the surface temperature has cooled to ∼280 K) and takes another 390 days to cool to 249 K. Observations over a sufficient period of time reveal divergent cooling trends for different lava bodies [examples: lava flows and lava lakes have different cooling trends after the flow has solidified (flows cool faster)]. Thin flows solidify and cool faster than flows of greater thickness. The model can therefore be used as a diagnostic tool for constraining possible emplacement mechanisms and compositions of bodies of lava in remote-sensing data.     

The evolutionary history of early-type galaxies as derived from the fundamental plane

The fundamental plane (FP) scaling relations and their evolution are a powerful tool for studying the global properties of early-type galaxies and their evolutionary history. The form of the FP, as derived by surveys in the local Universe at wavelengths ranging from the U to the K band, cannot be explained by metallicity variations alone among early-type galaxies; systematic variations in age, dark matter content, or homology breaking are required. A large-scale study of early-type galaxies at 0.1 < z < 0.6demonstrates that the SB intercept of the FP, the rest frame (U-V) colour, and the absorption line strengths all evolve passively, thereby implying a high mean formation redshift for the stellar content. The slope of the FP evolves with redshift, which is broadly consistent with systematic age effects occurring along the early-type galaxy sequence. The implication that the least luminous early-type galaxies formed later than the luminous galaxies is discussed in the context of the evolution of thecolour–magnitude relation, the Butcher–Oemler effect and hierarchical galaxy formation models. This revised version was published online in July 2006 with corrections to the Cover Date.     

Infrared observations of serendipitous hard Chandra X-ray sources

We present observations of a sample of optically faint, hard X-ray sources of the kind likely to be responsible for much of the hard X-ray background. We confirm that such sources are easily detected in the near-infrared, and find that they have a featureless continuum suggesting that the active nucleus is heavily obscured. The infrared colours of the majority of the targets observed are consistent with absorbed elliptical host galaxies at z =1–2. It is likely that we are observing some of the brighter members of the important new class of X-ray type II quasars.     

Three-dimensional coronal structures using clark lake observations

We have undertaken a study of coronal features observed at meter-decameter wavelengths using the Clark Lake radioheliograph. Among the coronal structures we have studied are the radio manifestations of coronal streamers on the solar disk and above the solar limb. We have analyzed the radio data quantitatively, using ray-tracing models for comparison with the maps. Our study provides information about the streamers' three-dimensional shapes, scales, and density profiles, for comparison with related observations using white-light coronagraphs.