Linear and nonlinear computations of the 1992 Nicaragua earthquake tsunami

Numerical computations of tsunamis are made for the 1992 Nicaragua earthquake using different governing equations, bottom frictional values and bathymetry data. The results are compared with each other as well as with the observations, both tide gauge records and runup heights. Comparison of the observed and computed tsunami waveforms indicates that the use of detailed bathymetry data with a small grid size is more effective than to include nonlinear terms in tsunami computation. Linear computation overestimates the amplitude for the later phase than the first arrival, particularly when the amplitude becomes large. The computed amplitudes along the coast from nonlinear computation are much smaller than the observed tsunami runup heights; the average ratio, or the amplification factor, is estimated to be 3 in the present case when the grid size of 1 minute is used. The factor however may depend on the grid size for the computation.     

Introduction to “Tsunami Science Four Years After the 2004 Indian Ocean Tsunami, Part I: Modelling and Hazard Assessment”

In this introduction we briefly summarize the 14 contributions to Part I of this special issue on Tsunami Science Four Years after the 2004 Indian Ocean Tsunami. These papers are representative of the new tsunami science being conducted since the occurrence of that tragic event. Most of these were presented at the session: Tsunami Generation and Hazard, of the International Union of Geodesy and Geophysics XXIV General Assembly held at Perugia, Italy, in July of 2007. That session included over one hundred presentations on a wide range of topics in tsunami research. The papers grouped into Part I, and introduced here, cover topics directly related to tsunami mitigation such as numerical modelling, hazard assessment and databases. Part II of this special issue, Observations and Data Analysis, will be published in a subsequent volume of Pure and Applied Geophysics.     

Geological setting of basaltic rocks in an accretionary complex,Khangai–Khentei Belt,Mongolia

We describe the mode of occurrence and geochemical characteristics of basalts, in the Khangai–Khentei belt in Mongolia, overlain by Middle Paleozoic radiolarian chert in an extensive accretionary complex. These basalts are greatly enriched in K, Ti, Fe, P, Rb, Ba, Th, and Nb in comparison to the composition of the mid‐ocean ridge basalts, indicative of within‐plate alkaline type. Ti/Y vs Nb/Y and MnO/TiO₂/P₂O₅ ratios of the basalts also suggest within‐plate affinities. Considering the geochemical characteristics as well as the conformable relationship with the overlying radiolarian chert, the alkaline basalts were clearly not continental but formed a pelagic oceanic island. The mode of occurrence and geochemistry of the basalts show that the alkaline basaltic volcanic activity had taken place to form an oceanic island in the Paleozoic pelagic region sufficiently far from continents to allow radiolarian ooze accumulation.     

Tsunami Source of the 2010 Mentawai, Indonesia Earthquake Inferred from Tsunami Field Survey and Waveform Modeling

The 2010 Mentawai earthquake (magnitude 7.7) generated a destructive tsunami that caused more than 500 casualties in the Mentawai Islands, west of Sumatra, Indonesia. Seismological analyses indicate that this earthquake was an unusual “tsunami earthquake,” which produces much larger tsunamis than expected from the seismic magnitude. We carried out a field survey to measure tsunami heights and inundation distances, an inversion of tsunami waveforms to estimate the slip distribution on the fault, and inundation modeling to compare the measured and simulated tsunami heights. The measured tsunami heights at eight locations on the west coasts of North and South Pagai Island ranged from 2.5 to 9.3 m, but were mostly in the 4–7 m range. At three villages, the tsunami inundation extended more than 300 m. Interviews of local residents indicated that the earthquake ground shaking was less intense than during previous large earthquakes and did not cause any damage. Inversion of tsunami waveforms recorded at nine coastal tide gauges, a nearby GPS buoy, and a DART station indicated a large slip (maximum 6.1 m) on a shallower part of the fault near the trench axis, a distribution similar to other tsunami earthquakes. The total seismic moment estimated from tsunami waveform inversion was 1.0 × 10²¹ Nm, which corresponded to M_w 7.9. Computed coastal tsunami heights from this tsunami source model using linear equations are similar to the measured tsunami heights. The inundation heights computed by using detailed bathymetry and topography data and nonlinear equations including inundation were smaller than the measured ones. This may have been partly due to the limited resolution and accuracy of publically available bathymetry and topography data. One-dimensional run-up computations using our surveyed topography profiles showed that the computed heights were roughly similar to the measured ones.     

Stratigraphic records of tsunamis along the Japan Sea,southwest Hokkaido,northern Japan

The stratigraphy of tsunami deposits along the Japan Sea, southwest Hokkaido, northern Japan, reveals tsunami recurrences in this particular area. Sandy tsunami deposits are preserved in small valley plains, whereas gravelly deposits of possible tsunami origin are identified in surficial soils covering a Holocene marine terrace and a slope talus. At least five horizons of tsunami events can be defined in the Okushiri Island, the youngest of which immediately overlies the Ko‐d tephra layer (1640 AD) and was likely formed by the historical Oshima‐Ohshima tsunami in 1741 AD. The four older tsunami deposits, dated using accelerator mass spectrometry ¹⁴C, were formed at around the 12th century, 1.5–1.6, 2.4–2.6, and 2.8–3.1 ka, respectively. Tsunami sand beds of the 1741 AD and circa 12th century events are recognized in the Hiyama District of Hokkaido Island, but the older tsunami deposits are missing. The deposits of these two tsunamis are found together at the same sites and distributed in regions where wave heights of the 1993 tsunami (Hokkaido Nansei‐oki earthquake, Mw = 7.7) were less than 3 m. Thus, the 12th century tsunami waves were possibly generated near the south of Okushiri Island, whereas the 1993 tsunami was generated towards the north of the island. The estimated recurrence intervals of paleotsunamis, 200–1100 years with an average of 500 years, likely represents the recurrence interval of large earthquakes which would have occurred along several active faults offshore of southwest Hokkaido.     

The 1957 great Aleutian earthquake

The 9 March 1957 Aleutian earthquake has been estimated as the third largest earthquake this century and has the longest aftershock zone of any earthquake ever recorded—1200 km. However, due to a lack of high-quality seismic data, the actual source parameters for this earthquake have been poorly determined. We have examined all the available waveform data to determine the seismic moment, rupture area, and slip distribution. These data include body, surface and tsunami waves. Using body waves, we have estimated the duration of significant moment release as 4 min. From surface wave analysis, we have determined that significant moment release occurred only in the western half of the aftershock zone and that the best estimate for the seismic moment is 50–100×10²⁰ Nm. Using the tsunami waveforms, we estimated the source area of the 1957 tsunami by backward propagation. The tsunami source area is smaller than the aftershock zone and is about 850 km long. This does not include the Unalaska Island area in the eastern end of the aftershock zone, making this area a possible seismic gap and a possible site of a future large or great earthquake. We also inverted the tsunami waveforms for the slip distribution. Slip on the 1957 rupture zone was highest in the western half near the epicenter. Little slip occurred in the eastern half. The moment is estimated as 88×10²⁰ Nm, orM _w =8.6, making it the seventh largest earthquake during the period 1900 to 1993. We also compare the 1957 earthquake to the 1986 Andreanof Islands earthquake, which occurred within a segment of the 1957 rupture area. The 1986 earthquake represents a rerupturing of the major 1957 asperity.     

Kuroko and Hydrocarbon Deposits from Northern Honshu,Japan: A Possible Common Hydrothermal/Magmatic Origin?

Abstract. Northern Honshu is the most important area for mineral and oil resources in Japan. Many kuroko deposits and oil and gas fields are distributed in two belts along the northeast Japan arc, the kuroko metal‐belt on the Pacific side and the oil‐belt on the Sea of Japan side. The kuroko deposits are located mainly in the Green Tuff strata which formed as a result of submarine vol‐canism during the late Miocene and Pliocene. Most of the source rocks of the oil and gas deposits formed at the same time as the kuroko deposits and some of them are located in reservoirs of hydrothermally‐altered volcanic rocks in the Green Tuff region. There is general agreement that the kuroko deposits formed as a result of submarine hydrothermal and magmatic activity whereas almost all petroleum geologists and geochemists consider that hydrocarbon deposits were generated independently of such activity. Since the discovery of hydrothermally‐generated petroleum in the Guaymas Basin, Gulf of California, however, it is clear that petroleum can be formed almost instantaneously in terrestrial and submarine hydrothermal areas. The paleo‐northeastern Sea of Japan is therefore considered to be a potential area for hydrothermal petroleum generation because thick organic‐rich sediments overlie an active submarine volcanic area. Several lines of geological and geochemical evidence suggest the possibility of hydrothermally‐enhanced maturation of organic matter and the contribution of magmatic activity to the formation of these deposits. Although most of the oil and gas in northern Honshu has been generated conventionally as a consequence of the high geothermal gradients there, it appears that some of the oil and gas fields may have formed as a result of extensive hydrothermal and magmatic activity during the late Miocene to Pliocene. Because of the much steeper angle of the faults in the vicinity of the Hokuroku basin than in the Akita basin, the magmatic contribution to the kuroko mineralization would have been far greater than to the oil and gas deposits of the Niigata and Akita basins. We therefore propose a strong relationship between metal and oil and gas generation in northern Honshu based on the structure and tectonics of the northern Honshu arc‐backarc system.     

The geochemistry of volatile species in melt inclusions and sulfide minerals from Izu-Oshima volcano, Japan

Olivine-hosted melt inclusions in the O95 pyroclastic layer of Izu-Oshima volcano, Japan are basaltic to basaltic-andesitic in composition. The negative correlation between SiO₂ and H₂O in melt inclusions and reverse compositional zoning observed in olivine and other mineral phenocrysts is inferred to arise from mixing between a highly evolved and a less evolved magma. The latter is characterized by the highest S (0.15 wt.%) and H₂O (3.4 wt.%) concentrations among those described in reports of previous studies. The S⁶⁺/S_total ratios in melt inclusions were 0.64?–?0.73, suggesting a relatively high oxidation state (NNO + 0.87 at 1150°C). The presence of pyrrhotites, which are found only in titanomagnetite microlites, suggests that sulfide saturation occurred during microlite growth under at a sulfur fugacity (log fS₂) value of around + 0.5 for T = 1060°C. The groundmass glass compositions are more evolved (andesitic composition) than any melt inclusions containing high amounts of Cl (0.13 wt.%) but negligible H₂O (0.20 wt.%) and S (< 70 ppm), suggesting that Cl was retained in the magma, in contrast to S and H₂O, which degassed strongly during magma effusion.