3-D Radargrammetric Modeling of RADARSAT-2 Ultrafine Mode: Preliminary Results of the Geometric Calibration

The geometry and the accuracy of the 3-D cartographic localization of RADARSAT-2 images are being evaluated as part of the Canadian Space Agency's Science and Operational Applications Research program. In a first step, the Toutin's 3-D physical model, previously developed for RADARSAT-1, was adapted to RADARSAT-2 sensor and applied to two ultrafine mode images (U2 and U25) acquired over an area in Beauport, Quebec. Both the 3-D modeling computed with only 12 ground control points and its geometric localization were evaluated with different check data: 1) independent check points; 2) the two quasi-epipolar images; 3) the two orthoimages; and 4) 1-m accurate orthophotos. All four results and validations are in agreement and confirm that the 3-D geometric localization and restitution accuracy are 1 m in planimetry and 2 m in elevation. The checked data error being included in these evaluations and the relative error computed from the quasi-epipolar comparison provided a high level of confidence that the precision of Toutin's 3-D radargrammetric model is better than 0.25 m.     

Phase center modeling for LEO GPS receiver antennas and its impact on precise orbit determination

Most satellites in a low-Earth orbit (LEO) with demanding requirements on precise orbit determination (POD) are equipped with on-board receivers to collect the observations from Global Navigation Satellite systems (GNSS), such as the Global Positioning System (GPS). Limiting factors for LEO POD are nowadays mainly encountered with the modeling of the carrier phase observations, where a precise knowledge of the phase center location of the GNSS antennas is a prerequisite for high-precision orbit analyses. Since 5 November 2006 (GPS week 1400), absolute instead of relative values for the phase center location of GNSS receiver and transmitter antennas are adopted in the processing standards of the International GNSS Service (IGS). The absolute phase center modeling is based on robot calibrations for a number of terrestrial receiver antennas, whereas compatible antenna models were subsequently derived for the remaining terrestrial receiver antennas by conversion (from relative corrections), and for the GNSS transmitter antennas by estimation. However, consistent receiver antenna models for space missions such as GRACE and TerraSAR-X, which are equipped with non-geodetic receiver antennas, are only available since a short time from robot calibrations. We use GPS data of the aforementioned LEOs of the year 2007 together with the absolute antenna modeling to assess the presently achieved accuracy from state-of-the-art reduced-dynamic LEO POD strategies for absolute and relative navigation. Near-field multipath and cross-talk with active GPS occultation antennas turn out to be important and significant sources for systematic carrier phase measurement errors that are encountered in the actual spacecraft environments. We assess different methodologies for the in-flight determination of empirical phase pattern corrections for LEO receiver antennas and discuss their impact on POD. By means of independent K-band measurements, we show that zero-difference GRACE orbits can be significantly improved from about 10 to 6 mm K-band standard deviation when taking empirical phase corrections into account, and assess the impact of the corrections on precise baseline estimates and further applications such as gravity field recovery from kinematic LEO positions.     

Hyperspectral remote sensing of evaporate minerals and associated sediments in Lake Magadi area, Kenya

Pleistocene to present evaporitic lacustrine sediments in Lake Magadi, East African Rift Valley, Kenya were studied and mapped using spectral remote sensing methods. This approach incorporated surface mineral mapping using space-borne hyperspectral Hyperion imagery together with laboratory analysis, including visible, near-infrared diffuse reflectance spectroscopy (VNIR) measurements and X-ray diffraction for selected rock and soil samples of the study area. The spectral signatures of Magadiite and Kenyaite, which have not been previously reported, were established and the spectral signatures of trona, chert series, volcanic tuff and the High Magadi bed were also analyzed.Image processing techniques, MNF (Minimum Noise Fraction) and MTMF (Mixture Tuned Matched Filtering) using a stratified approach (image analysis with and without the lake area), were used to enhance the mapping of evaporates. High Magadi beds, chert series and volcanic tuff were identified from the Hyperion image with an overall mapping accuracy of 84.3%. Even though, the spatial distribution of evaporites and sediments in Lake Magadi area change in response to climate variations, the mineralogy of this area has not been mapped recently. The results of this study shows the usefulness of the hypersspectral remote sensing to map the surface geology of this kind of environment and to locate promising sites for industrial open-pit trona mining in a qualitative and quantitative manner.     

A note on frame transformations with applications to geodetic datums

Rigorous equations in compact symbolic matrix notation are introduced to transform coordinates and velocities between ITRF frames and modern GPS-based geocentric geodetic datums. The theory is general but, after neglecting higher than second-order terms, it is shown that the equations revert to the formulation currently applied in most major continental datums. We discuss several examples: the North American Datum of 1983 (NAD83), the European Terrestrial Reference System of 1989 (ETRS89), the Geodetic Datum of Australia of 1994 (GDA94), and the South American Geocentric Reference System (SIRGAS). Electronic Publication     

Generation of Vegetation Fraction and Surface Albedo Products Over India from Ocean Colour Monitor (OCM) Data Onboard Oceansat-2

The use of Local Area Coverage (LAC) data from Ocean Color Monitor (OCM) sensor of Oceansat-2 with its high radiometric resolution (12 bits/pixel) and 2-day repeat cycle for rapid monitoring of vegetation growth and estimating surface albedo for the Indian region is demonstrated in this study. For the vegetation monitoring, normalized difference vegetation index (NDVI) and vegetation fraction (VF) products were estimated by maximum value composite approach fortnightly and were resampled to 1 km. The surface albedo products were realized by converting narrow-band eight-band spectral reflectance OCM data to a) visible (300–700 nm) and b) broad band (300–3,000 nm) data. For validation, the derived products were compared with respective MODIS global products and found to be in good agreement.     

Monitoring of salt affected soils — A case study using aerial photographs,salyut‐7 space photographs,and landsat TM data

Soils of part of Ukai‐kakarapar Command area, Gujarat (India) have been mapped at 1:25, 000 scale using aerial photographs of December 1977. It was observed that about 36.3% of the area was affected by soil salinity/alkalinity. The test area has been remapped using Salyut‐7 space photographs taken during Indo‐Soviet joint flight in April, 1984. The area affected by soil salinity/alkalinity was found to be substantially higher (80.3%). The earlier mapping using aerial photographs was done when the soil surface was compartively moist (December 1977) as compared to date of Salyut‐7 photography (April 1984), when the soil surface was likely to be devoid of moisture and the salts moved to the surface. To have easy comparision with the map prepared by using aerial photographs, Landsat TM data of December, 1985 was used in which 45.7% of the total area was mapped as salt affected. The extent of area delineated using Landsat TM was higher than that of 1977 but much lesser than the area delineated using Salyut‐7 (MKF‐6M) photographs. This indicated that the increase in the extent of salt affected area in the map prepared using the MKF‐6M photographs might be partly due to actual increase in the salinity/alkalinity and partly due to the seasonal affects. Among the various bands of MKF‐6M, band ‐4 was found to be the best for delineating the salt affected soils. The boundaries were sharper in the FCC and band No.4 of MKF‐6M than in the aerial photographs.