Tectonics of a fast spreading center: A Deep-Tow and sea beam survey on the East Pacific rise at 19°30′ S

Sea Beam and Deep-Tow were used in a tectonic investigation of the fast-spreading (151 mm yr^-1) East Pacific Rise (EPR) at 19°30 S. Detailed surveys were conducted at the EPR axis and at the Brunhes/Matuyama magnetic reversal boundary, while four long traverses (the longest 96 km) surveyed the rise flanks. Faulting accounts for the vast majority of the relief. Both inward and outward facing fault scarps appear in almost equal numbers, and they form the horsts and grabens which compose the abyssal hills. This mechanism for abyssal hill formation differs from that observed at slow and intermediate spreading rates where abyssal hills are formed by back-tilted inward facing normal faults or by volcanic bow-forms. At 19°30 S, systematic back tilting of fault blocks is not observed, and volcanic constructional relief is a short wavelength signal (less than a few hundred meters) superimposed upon the dominant faulted structure (wavelength 2–8 km). Active faulting is confined to within approximately 5–8 km of the rise axis. In terms of frequency, more faulting occurs at fast spreading rates than at slow. The half extension rate due to faulting is 4.1 mm yr^-1 at 19°30 S versus 1.6 mm yr^-1 in the FAMOUS area on the Mid-Atlantic Ridge (MAR). Both spreading and horizontal extension are asymmetric at 19°30 S, and both are greater on the east flank of the rise axis. The fault density observed at 19°30 S is not constant, and zones with very high fault density follow zones with very little faulting. Three mechanisms are proposed which might account for these observations. In the first, faults are buried episodically by massive eruptions which flow more than 5–8 km from the spreading axis, beyond the outer boundary of the active fault zone. This is the least favored mechanism as there is no evidence that lavas which flow that far off axis are sufficiently thick to bury 50–150 m high fault scarps. In the second mechanism, the rate of faulting is reduced during major episodes of volcanism due to changes in the near axis thermal structure associated with swelling of the axial magma chamber. Thus the variation in fault spacing is caused by alternate episodes of faulting and volcanism. In the third mechanism, the rate of faulting may be constant (down to a time scale of decades), but the locus of faulting shifts relative to the axis. A master fault forms near the axis and takes up most of the strain release until the fault or fault set is transported into lithosphere which is sufficiently thick so that the faults become locked. At this point, the locus of faulting shifts to the thinnest, weakest lithosphere near the axis, and the cycle repeats.     

PCDD/F and PCB in harbour seals (Phoca vitulina) from British Columbia: response to exposure to pulp mill effluents

Blubber of harbour seals (Phoca vitulina) sampled from the Strait of Georgia, BC, in 1991 and 1992 contained higher concentrations of polychlorinated dibenzo-p-dioxins and furans (PCDD/F) than did samples from Quatsino Sound on western Vancouver Island. The higher proportions of 1,2,3,6,7,8-hexachlorodibenzodioxin and 2,3,7,8-tetrachlorodibenzofuran in the Strait of Georgia samples probably reflect contamination arising from the discharge of effluents from bleached kraft mills. Higher concentrations of non-ortho- and mono-ortho substituted polychlorinated biphenyls were also found in the Strait of Georgia samples, probably as a result of general industrial activity in the region. Principal components analysis showed that residues were distributed differently between males and females. Within males, concentrations of PCDD, PCDF and PCBs appeared to increase with age. Toxic equivalents (TEQ) to 2,3,7,8-tetrachlorodibenzodioxin in the Quatsino Sd. samples were close to the working guidelines for edible fish used by Health Canada; TEQ calculated for the Strait of Georgia samples exceeded these guidelines by up to a factor of five.     

Oxidative stress in two populations of killifish (Fundulus heteroclitus) with differing contaminant exposure histories

A population of killifish (Fundulus heteroclitus) inhabiting a creosote-polluted inlet of the Elizabeth River demonstrates tolerance to the acute toxic effects exerted by contaminated sediments on reference site killifish. Previous data have suggested that upregulated antioxidant defenses contribute to short-term tolerance in killifish exposed to Elizabeth River sediments. This study investigated population differences in antioxidant defenses from wild caught Elizabeth River and reference population killifish in different seasons, and after being held in the laboratory. Parameters measured in the killifish were total glutathione concentrations (GSH(T)), activities of glutathione reductase (GR), glutathione peroxidase (GPx), and lipid peroxidation (LPO), all in adult hepatic tissues. The Elizabeth River population exhibited greater GSH(T), higher GPx activities, and increased LPO as compared to the reference population. Sex specific population differences were also observed in GSH(T) and GPx. Both populations displayed decreased GSH(T) and increased GR from early to late summer, as well as after being held in the laboratory. This study indicates that there are many factors that may contribute to differences in levels of antioxidant defenses in addition to exposure to contaminants, including reproductive status and environmental conditions.     

Sample treatment with focused ultrasound and bath sonication as a powerful tool for the evaluation of cadmium pollution in estuarine waters

A new sample treatment was developed for the determination of dissolved cadmium in Tagus estuarine waters, based on focused ultrasound in conjunction with small volumes in the extraction steps for Cd pre-concentration. Cadmium was first pre-concentrated using a classical approach (APDC as the complexing agent and MIBK as the organic phase) and then back-extracted into HNO₃ with the aid of focused ultrasound, which reduced the acid concentration by more than one order of magnitude (from 4 to 0.1 mol L^− 3). This sample treatment was accomplished in less than 5 min, using low sample volume (20 mL), and low-volume, low-concentration reagents. The pre-concentration factor used in this work was 25, but different sample/organic volume ratios may be used in order to increase that value. The limit of detection and the limit of quantification in Tagus water samples were 0.03 nmol L^− 1 and 0.1 nmol L^− 3, respectively. Recoveries from spiked Tagus water were higher than 90%. The procedure was validated using the reference estuarine water NRC-SLEW-3. In the solubilization of Cd particulate, bath ultrasonication was used in conjunction with HNO₃ + HCl, followed by H₂O₂, which took about 2 instead of the usual 12 h (cooling included) when high-pressure microwave digestion is used.     

Suspended sediment concentration in a buoyant plume: Fraser River,Canada

A study of suspended sediment concentration in the buoyant plume of the Fraser River, Canada, showed that unstratified flow conditions at the river mouth caused resuspension of sandy bed material and high concentrations of coarse sediment. When flow at the mouth was stratified, sediment was fine-grained and concentrations were low. Application of a multivariate model revealed that suspended sediment concentration along the plume axis was controlled primarily by distance seaward of the river mouth, secondly by tidal height, and least by sediment concentration in the river.     

A technique for conducting seismic refraction experiments on the ocean bed using bottom shots

A technique has been devised for firing arrays of bottom shots on the ocean bed in depths upto 4000 m or more. Ten kilogram explosive charges are dropped from the surface while the shooting ship is navigated acoustically. They are detonated at preset times by an electronic timer which initiates an electrical detonator, detonating cord and cast PETN/TNT explosive. Ranges to ocean bottom seismographs, and the shot instants, can be calculated from the arrival-time differences of the direct and surface-reflected water waves. The accuracy, which is dependent on water-depth and range, was better than 22 m in range and 14 msec in shot instant for our experiments.     

Wave group statistics from numerical simulations of a random sea

Two commonly used methods of simulating random time series, given a target power spectrum, are discussed. Wave group statistics, such as the mean length of runs of high waves, produced by the different simulation schemes are compared. The target spectra used are obtained from ocean measurements, and cover a wide range of ocean conditions. For a sufficiently large number of spectral components, no significant differences are found in the wave group statistics produced by the two simulation techniques.