LightSquared effects on estimated C/N 0, pseudoranges and positions

We present experimental results showing the impact of the proposed LightSquared (LS) Long-term Evolution (LTE) signals on both GPS and Galileo civil modulations in the L1/E1 band. The experiments were conducted in radiated mode in a large anechoic chamber. Three Galileo enabled receivers were chosen for the tests, and a state of the art GNSS signal generator was used to simulate both GPS and Galileo signals. The LTE signals were generated by an Agilent Programmable Signal Generator with a license to generate the signals according to the 3GPP LTE FDD standard. The interference impact was measured in terms of a Carrier-to-Noise power spectral density ratio (C/N ₀) degradation, in accordance with the methodology which the LS/GPS Technical Working Group (TWG) established by mandate of the FCC. A model for determining the impact of the LS signal on the considered GNSS signals is provided and is validated against experimental data. It is shown that the Galileo E1 Open Service (OS) signal is marginally more susceptible to this form of interference than the GPS L1 C/A signal due to its greater proximity to the lower edge of the L1 band. The impact of LS interference was further analyzed in terms of pseudorange and position errors. Despite its relevance for most GNSS users, this aspect was not considered by the TWG. Measurement and position domain analysis along with the study of the LS impact on the Galileo OS signals are the major contributions. The analysis confirms the results obtained by the TWG and shows that the receiver front-end plays a major role in protecting GNSS signals against RF interference. While it appears that, for now, the LS network will not be deployed, the approach taken and the results obtained herein can be readily adapted for any future terrestrial mobile network that may take the place of LS.     

The Mineral Adsorption and The Application of a Metamorphic Felsic Rock as Aggregate in Asphalt Pavements

Geotechnical and Geological Engineering - The aggregates consist approximately 85% of the total volume in asphalts pavements, and their properties influence directly their behavior. Therefore, it...     

Anisotropic viscous-fluid cosmological model

We present exact solutions of a Bianchi type VI₀ viscous fluid cosmological model. It is a generalization of the model proposed by Banerjee and Santos (1983) for Bianchi type I.     

Geological and SHRIMP II U-Pb constraints on the age and origin of the Breves Cu-Au-(W-Bi-Sn) deposit,Carajás,Brazil

The Breves deposit in the Carajás Copper-Gold Belt, Brazil, a member of the Cu-Au-(W-Bi-Sn) group of deposits, contains about 50 Mt of 1.22% Cu, 0.75 g/t Au, 2.4 g/t Ag, 1,200 g/t W, 70 g/t Sn, 175 g/t Mo and 75 g/t Bi. It is hosted by sandstones and siltstones of the Águas Claras Formation (minimum age of 2,681±5 Ma) in the roof zone of a complex, highly altered granite intrusion. The mineralisation is disseminated in a greisenized zone, resulting from alteration of probable monzogranites and syenogranites. The ore-bearing greisen contains abundant xenomorphic quartz in association with Fe-chlorite and muscovite. The gangue assemblage also includes fluorite, tourmaline, and minor amounts of monazite, xenotime, chlorapatite, thorite, zircon, calcite, siderite and bastnäesite. Copper mineralisation is dominated by chalcopyrite associated with pyrite, arsenopyrite, pyrrhotite and molybdenite. Gold particles, in equilibrium with native bismuth, are common as inclusions in chalcopyrite. The greisen contains sub-economic concentrations of tungsten and niobium that are related to the presence of ferberite, qitianlingite and Nb-rutile. SHRIMP II zircon dating of the host granites gives ²⁰⁷Pb/²⁰⁶Pb ages of 1,878±8 and 1,880±9 Ma for two phases, and a combined age of 1,879±6 Ma. SHRIMP II dating of monazite and xenotime grains in late- to post-mineralisation veins gives a combined ²⁰⁷Pb/²⁰⁶Pb age of 1,872±7 Ma, indistinguishable from the ages of the granites. This provides a genetic connection between the Breves deposit and the ca. 1.88 Ga A-type granite magmatism that typifies the Carajás Belt as part of a much larger, intracratonic magmatic province that extends over much of the Amazonian Craton. The recognition of this association has exploration implications, not only for the geophysical signature of the granite roof zones, but also for likely geochemical dispersion around the deposits of this type.Editorial handling: G. Beaudoin     

Numerical simulation of the diurnal cycle of rainfall in SW Amazon basin during the 1999 rainy season: the role of convective trigger function

In continental areas, the maximum rainfall simulated with the Brazilian developments on the Regional Atmospheric Modeling System (BRAMS) occurs around 4?h earlier than the one observed with rain gauges. This work presents the successful implementation of a new convective trigger function (CTF) in the convective parameterization scheme used in BRAMS that corrects this misfit between model and observations. The importance of the CTF formulation on the diurnal cycle of rainfall over the Amazon Basin is reflected by the following numbers: Over Rondonia (SW Amazonia), the original version of BRAMS simulates the maximum rainfall at 1400 UTC (1000 LST), with the new CTF maximum shifting to 1800?UTC (1400?LST), while the S-band radar rainfall maximum is at 1900?UTC (1500?LST). This is attributed to two factors: (1) the new CTF is now coupled to the sensible and latent heat fluxes at surface; (2) during the early morning, the convective available potential energy is reduced.     

Downward longwave radiation estimates for clear and all-sky conditions in the Sertãozinho region of São Paulo, Brazil

The accurate estimate of the surface longwave fluxes contribution is important for the calculation of the surface radiation budget, which in turn controls all the components of the surface energy budget, such as evaporation and the sensible heat fluxes. This study evaluates the performance of the various downward longwave radiation parameterizations for clear and all-sky days applied to the Sertãozinho region in São Paulo, Brazil. Equations have been adjusted to the observations of longwave radiation. The adjusted equations were evaluated for every hour throughout the day and the results showed good fits for most of the day, except near dawn and sunset, followed by nighttime. The seasonal variation was studied by comparing the dry period against the rainy period in the dataset. The least square linear regressions resulted in coefficients equal to the coefficients found for the complete period, both in the dry period and in the rainy period. It is expected that the best fit equation to the observed data for this site be used to produce estimates in other regions of the State of São Paulo, where such information is not available.     

A numerical study of the orbits of second species of the planar circular RTBP

We present a numerical study of the set of orbits of the planar circular restricted three body problem which undergo consecutive close encounters with the small primary, or orbits of second species. The value of the Jacobi constant is fixed, and we restrict the study to consecutive close encounters which occur within a maximal time interval. With these restrictions, the full set of orbits of second species is found numerically from the intersections of the stable and unstable manifolds of the collision singularity on the surface of section that corresponds to passage through the pericentre. A ‘skeleton’ of this set of curves can be computed from the solutions of the two-body problem. The set of intersection points found in this limit corresponds to the S-arcs and T-arcs of Hénon’s classification which verify the energy and time constraints, and can be used to construct an alphabet to describe the orbits of second species. We give numerical evidence for the existence of a shift on this alphabet that describes all the orbits with infinitely many close encounters with the small primary, and sketch a proof of the symbolic dynamics. In particular, we find periodic orbits that combine S-type and T-type quasi-homoclinic arcs.     

Urban forest loss using a GIS-based approach and instruments for integrated urban planning:A case study of Jo(a)o Pessoa,Brazil

Urban forests play an important role in the thermal comfort and overall life of local populations in large-and medium-sized cities.This study analyzes urban forest loss and maps land use and land cover (LULC) changes between 1991 and 2018 by evaluating the use of urban planning instruments for the mitigation of urban forest loss in Jo～o Pessoa,Brazil.For this purpose,satellite-derived LULC images from 1991,2006,2010 and 2018 and data on urban forest loss areas obtained using the Google Earth Engine were used.In addi-tion,this paper also discusses the instruments used for integrated urban planning,which are(a) the legal sector,responsibility and nature;(b) the urban expansion process;and (c) the elements of urban infrastructure.The results show a clear shift in land use in the study area.The major changes in LULC classes occurred in urban areas and herbaceous vegetation,while the greatest loss was in arboreal/shrub vegetation.Thus,an increase in the pressure to occupy zones intended for environmental preservation could be estimated.Our results showed similar accuracies with other studies and more spatial details.The characteristics of the patterns,traces,and hotspots of urban expansion and forest cover loss were explored.We highlighted the potential use of this proposed framework to be applied and validated in other parts of the world to help better understand and quantify various aspects of ur-ban-related problems such as urban forest loss mapping using instruments for integrated urban planning and low-cost approaches.     

Multiple Random Walk Simulation: A Fast Method to Map Grade Uncertainty with Large Datasets

Multiple Random Walk Simulation consists of a methodology adapted to run fast simulations if close-spaced data are abundant (e.g., short-term mining models). Combining kriging with the simulation of random walks attempts to approximate traditional simulation algorithm results but at a computationally faster way when there is a large amount of conditioning samples. This paper presents this new algorithm illustrating the situations where the method can be used properly. A synthetic study case is presented in order to illustrate the Multiple Random Walk Simulation and to analyze the speed and goodness of its results against the ones from using Turning Bands Simulation and Sequential Gaussian Simulation.     

Influence of earthquake ground‐motion duration on damage estimation: application to steel moment resisting frames

This paper presents an analytical study evaluating the influence of ground motion duration on structural damage of 3‐story, 9‐story, and 20‐story SAC steel moment resisting frame buildings designed for downtown Seattle, WA, USA, using pre‐Northridge codes. Two‐dimensional nonlinear finite element models of the buildings are used to estimate the damage induced by the ground motions. A set of 44 ground motions is used to study the combined effect of spectral acceleration and ground motion significant duration on drift and damage measures. In addition, 10 spectrally equivalent short‐duration shallow crustal ground motions and long‐duration subduction zone records are selected to isolate duration effect and assess its effect on the response. For each ground motion pair, incremental dynamic analyses are performed at at least 20 intensity levels and response measures such as peak interstory drift ratio and energy dissipated are tracked. These response measures are combined into two damage metrics that account for the ductility and energy dissipation. Results indicate that the duration of the ground motion influences, above all, the combined damage measures, although some effect on drift‐based response measures is also observed for larger levels of drift. These results indicate that because the current assessment methodologies do not capture the effects of ground motion duration, both performance‐based and code‐based assessment methodologies should be revised to consider damage measures that are sensitive to duration. Copyright © 2016 John Wiley & Sons, Ltd