An investigation of soil erosion and redistribution in a Mediterranean lowland agricultural catchment using caesium-137

This study sought to contribute to an improved understanding of soil erosion and redistribution on Mediterranean agricultural land, where traditional soil conservation practices have been applied over millennia to provide effective protection of cultivated land. The study was undertaken in the Na Borges catchment, a groundwater-dominated lowland limestone basin (319 km2), located in the northeastern part of Mallorca, Spain. The average sediment yield from the basin, based on river sediment load data, is 1 t/km2·yr. The 137Cs technique was used to quantify soil redistribution rates over the past 40 years and to identify the key factors involved in soil erosion and redistribution processes. To estimate erosion and deposition rates and to elucidate the main factors affecting soil redistribution, samples were collected from six slope transects representative of the local land use and slope gradients and the presence or absence of soil conservation practices. A mass balance and a profile distribution conversion model were used for cultivated areas and areas of natural vegetation, respectively, to derive point estimates of the soil redistribution rates from the 137Cs inventories measured for individual soil bulk cores. In areas without soil conservation practices, the estimated mean soil erosion rates ranged from 12.7 to 26.4 t/ha·yr, which correspond to the slight and moderate erosion classes. The erosivity of Mediterranean climatic conditions combined with the influence of agricultural practices and slope gradient on soil erosion, represent the main factors responsible for the variation of soil losses documented for the cultivated land located in downslope areas, in the absence of soil conservation practices. Deposition dominated for those transects affected by soil conservation practices, with rates ranging between 18.8 and 96.6 t/ha·yr. However, this situation does not mean that soil conservation measures retain all the sediment, but rather that agriculture and urbanization (i.e. new rural paths and stone boundaries) modified the micro-topography and diverted sediment from other upslope zones towards the slopes where sampling transects were located.     

Tuning the second-generation SDI: theoretical aspects and real use cases

Spatial data infrastructure (SDI) actors have great expectations for the second-generation SDI currently under development. However, SDIs have many implementation problems at different levels that are delaying the development of the SDI framework. The aims of this article are to identify these difficulties, in the literature and based on our own experience, in order to determine how mature and useful the current SDI phenomena are. We can then determine whether a general reconceptualization is necessary or rather a set of technical improvements and good practices needs to be developed before the second-generation SDI is completed. This study is based on the following aspects: metadata about data and services, data models, data download, data and processing services, data portrayal and symbolization, and mass market aspects. This work aims to find an equilibrium between user-focused geoportals and web service interconnection (the user side vs. the server side). These deep reflections are motivated by a use case in the healthcare area in which we employed the Catalan regional SDI. The use case shows that even one of the best regional SDI implementations can fail to provide the required information and processes even when the required data exist. Several previous studies recognize the value of applying Web 2.0 and user participation approaches but few of these studies provide a real implementation. Another objective of this work is to show that it is easy to complement the classical, international standard-based SDI with a participative Web 2.0 approach. To do so, we present a mash-up portal built on top of the Catalan SDI catalogues.     

Heterogeneous characteristics of streambed saturated hydraulic conductivity of the Touchet River,south eastern Washington,USA

Traditionally a streambed is treated as a layer of uniform thickness and low saturated hydraulic conductivity (K) in surface‐ and ground‐water studies. Recent findings have shown a high level of spatial heterogeneity within a streambed and such heterogeneity directly affects surface‐ and ground‐water exchange and can have ecological implications for biogeochemical transformations, nutrient cycling, organic matter decomposition, and reproduction of gravel spawning fish. In this study a detailed field investigation of K was conducted in two selected sites in Touchet River, a typical salmon spawning stream in arid south eastern Washington, USA. In‐stream slug tests were conducted to determine K following the Bouwer and Rice method. For the upper and lower sites, each 50 m long and 9 m wide and roughly 20 m apart, a sampling grid of 5 m longitudinally and 3 m transversely was used. The slug tests were performed for each horizontal coordinate at 0·3–0·45, 0·6–0·75, 0·9–1·05 and 1·2–1·35 m depth intervals unless a shallower impenetrable obstruction was encountered. Additionally, water levels were measured to obtain vertical hydraulic gradient (VHG) between each two adjacent depth intervals. Results indicated that K ranged over three orders of magnitude at both the upper and lower sites and differed between the two sites. At the upper site, K did not differ significantly among different depth intervals based on nonparametric statistical tests for mean, median, and empirical cumulative distribution, but the spatial pattern of K varied among different depth intervals. At the lower site, K for the 0·3–0·45 m depth interval differed statistically from those at other depth intervals, and no similar spatial pattern was found among different depth intervals. Zones of upward and downward water flow based on VHG also varied among different depth intervals, reflecting the complexities of the water flow regime. Detailed characterization of the streambed as attempted in this study should be helpful in providing information on spatial variations of streambed hydraulic properties as well as surface‐ and ground‐water interaction. Copyright © 2009 John Wiley & Sons, Ltd.     

Assessment of the hydraulic slope flow approach using a mesoscale model

The simplified hydraulic two-layer model for a katabatic flow is analysed using the outputs from a high-resolution mesoscale simulation. A stably stratified night is simulated for the Duero basin, a complex terrain area located in the northern Spanish plateau, with large vertical and horizontal spatial resolution. Well-defined katabatic flows on the basin slopes are generated by the simulation, that are relatively stationary and quasi-bidimensional for some areas in the central part of the night. The bulk quantities used in the two-layer approach as well as the different terms in the equations are computed from the three-dimensional information provided by the mesoscale simulation. This method allows to inspect how well the simplified approach represents the katabatic flow generated by the mesoscale model. The study shows that the hydraulic model allows for a comprehensive analysis of the basic mechanisms of the slope flows but is not able to close the budget equations, since the residuals are large.     

Formation of U-depleted rhyolite from a basanite at El Hierro, Canary Islands

Phonolite and trachyte are the felsic magmas of the alkaline magma suites, which characterize the Canary Islands. The October 2011 submarine eruption off El Hierro, the westernmost island, nevertheless, produced a small volume of rhyolitic magma. The rhyolite occurred as highly vesicular, white coloured pumices enveloped in and mingled with darker coloured basanitic pumice. The basanitic pumice is relatively crystal poor with a few euhedral olivines (mostly Fo_77–79), clinopyroxenes and Fe-rich spinels, whereas very rare olivine of same composition is found together with equally rare Fe-sulphide and FeTi-rich oxides in the rhyolite. The Fe–Mg exchange equilibrium in the oxides permits to calculate an equilibrium temperature of 970–890 °C for the rhyolite, in agreement with quartz-melt equilibrium at ca. 930 °C. A striking mineralogical feature of the rhyolite is the presence of rounded to contorted grains of milky quartz, which are xenocrysts incorporated and partly dissolved into the magma. Analyses of residual volatile concentrations in the glasses show that the rhyolite melt was highly degassed, whereas the basanitic glass still has important halogen concentrations. Trace element patterns of the mafic glasses and their elevated incompatible element concentrations are typical of the western Canary Island basanites. In contrast, the trace element composition of the rhyolite shows surprisingly low concentrations for all elements except the most incompatible ones (e.g. Rb, Ba, K and Th). All other measured LILE, HFSE and REE have significantly lower concentration than the basanitic counterpart that can be explained by fractionation of accessory phases (1 % apatite, 1 % sphene and 0.1 % zircon). Surprisingly, low U concentration is presumably related to elevated oxygen fugacity in the rhyolite, causing U to be in a hexavalent state, and fluxing of F-rich gas leading to volatilization of UF₆, known to emanate at low temperature. The results suggest that a gas-rich basanitic melt remobilized a small volume of stagnant rhyolitic melt formed by incorporation of approximately 10 % quartz-rich sediment into a late differentiate of trachytic composition. Sediments at the interface of an old oceanic crust adjacent to a continental shield and younger volcanic island are likely to act as magma traps were sediment assimilation may alter the mantle-derived magma composition. Quartz assimilation thus explains the production of rhyolite magma in a volcanic island characterized by an alkaline magma series from primitive basanites to trachytes.     

An Intercomparison of Large-Eddy Simulations of the Stable Boundary Layer

Results are presented from the first intercomparison of large-eddy simulation (LES) models for the stable boundary layer (SBL), as part of the Global Energy and Water Cycle Experiment Atmospheric Boundary Layer Study initiative. A moderately stable case is used, based on Arctic observations. All models produce successful simulations, in as much as they generate resolved turbulence and reflect many of the results from local scaling theory and observations. Simulations performed at 1-m and 2-m resolution show only small changes in the mean profiles compared to coarser resolutions. Also, sensitivity to subgrid models for individual models highlights their importance in SBL simulation at moderate resolution (6.25 m). Stability functions are derived from the LES using typical mixing lengths used in numerical weather prediction (NWP) and climate models. The functions have smaller values than those used in NWP. There is also support for the use of K-profile similarity in parametrizations. Thus, the results provide improved understanding and motivate future developments of the parametrization of the SBL.     

Satellite monitoring of sea surface temperatures off China

Satellite measurements of global sea surface temperatures (SST) have been made since 1982 using the multi-channel radiometers (AVHRR) on NOAA polar orbiting satellites. A four year data set was accumulated at daily intervals and a spatial resolution of about 100 kilometers on an interactive computer system. The time lapse evaluation of the data revealed variations of the SST which were related to coastal and equatorial upwelling events as well as to the pronounced equatorial warming associated with the 1982–1983 El Niño. In the present study, satellite time series are used to describe the annual variability of the SST at selected locations along the coast of China, the Yellow Sea, the Sea of Japan and the Equatorial Indian and Pacific Oceans. Further study of the SST off China using higher resolution satellite data are also described.

     

Geology,fluid inclusion and sulphur isotope characteristics of the El Cobre VHMS deposit,Southern Cuba

The El Cobre deposit is located in eastern Cuba within the volcanosedimentary sequence of the Sierra Maestra Paleogene arc. The deposit is hosted by tholeiitic basalts, andesites and tuffs and comprises thick stratiform barite and anhydrite bodies, three stratabound disseminated up to massive sulphide bodies produced by silicification and sulphidation of limestones or sulphates, an anhydrite stockwork and a siliceous stockwork, grading downwards to quartz veins. Sulphides are mainly pyrite, chalcopyrite and sphalerite; gold occurs in the stratabound ores. Fluid inclusions measured in sphalerite, quartz, anhydrite and calcite show salinities between 2.3 and 5.7 wt% NaCl eq. and homogenisation temperatures between 177 and 300°C. Sulphides from the stratabound mineralisation display δ ³⁴S values of 0‰ to +6.0‰, whilst those from the feeder zone lie between −1.4‰ and +7.3‰. Sulphides show an intra-grain sulphur isotope zonation of about 2‰; usually, δ ³⁴S values increase towards the rims. Sulphate sulphur has δ ³⁴S in the range of +17‰ to +21‰, except two samples with values of +5.9‰ and +7.7‰. Sulphur isotope data indicate that the thermochemical reduction of sulphate from a hydrothermal fluid of seawater origin was the main source of sulphide sulphur and that most of the sulphates precipitated by heating of seawater. The structure of the deposit, mineralogy, fluid inclusion and isotope data suggest that the deposit formed from seawater-derived fluids with probably minor supply of magmatic fluids.