A catalogue and finding list of galactic novae

A catalogue of galactic novae and an atlas of finding charts are under preparation and will be published in 1984. The status of the project is described.Paper presented at the Lembang-Bamberg IAU Colloquium No. 80 on Double Stars: Physical Properties and Generic Relations, held at Bandung, Indonesia, 3–7 June, 1983.     

The origin of polygonal troughs on the Northern Plains of Mars

Viking photographs have revealed extraordinary systems of crudely polygonal troughs in three different areas of the northern plains of Mars. Trough widths average 200–800 m and average trough spacing is 5–10 km. The widest troughs have flat floors and steep sides which suggest that they are either grabens or tension cracks which have been partially filled. The following three arguments support the garben interpretation: (1) Two clear examples of vertical offsets along trough walls indicate that the troughs formed by downdropping of the floors. (2) Troughs similar in scale and morphology to those of the Martian northern plains form concentric and radial patterns in the Caloris Basin on Mercury. Most likely, they are extensional fractures or grabens resulting from uplift of the basin floor (Strom et al., 1975). The Caloris analogy suggests that the troughs on Mars are similar tectonic features related either to uplift or expansion of the planet. Fourteen rose diagrams of trough azimuths in southeastern Acidalia Planita show that locally they exhibit preferred orientations roughly parallel to the topographic contours, but overall there is no strong regional pattern. (3) The scale of tension crack systems is limited by the depth of fracturing because the extent of stress relief perpendicular to a crack is proportional to the crack depth. Observations of terrestrial tension cracks suggest a lower limit on crack depths of about one-tenth of the average spacing. Thus, if the Martian troughs are tension cracks, they would be expected to have depths of at least 500–1000 m. Mechanical considerations indicate that it is difficult to generate such deep cracks by surficial tension due to thermal cooling and contraction in permafrost, desiccation, or cooling of lava flows. Deep-seated tension of tectonic origin generally results in normal faults and not tension cracks.     

Heat flow near obstacles in the solar convection zone

Disturbances in the heat flow in the solar convection zone are calculated with a turbulent thermal diffusion coefficient based on a mixing length approximation. As a consequence of the radiative boundary condition at the surface and the strong increase of the diffusion coefficient with depth, the convection zone resembles a thermally superconducting shell enclosed between a thin surface layer and an interior core of low thermal conductivity. Thermal disturbances originating in the convection zone do not penetrate into the interior, and penetrate only weakly through the solar surface. A thermally isolating obstacle buried entirely in the convection zone casts a shadow of reduced temperature at the solar surface; the brightening surrounding this shadow is undetectable. The shadow is weak unless the object is located close to the surface (less than 2000 km). Assuming a sunspot to be an area of reduced thermal conductivity which extends a finite depth into the convection zone, the heat flow around this obstacle is calculated. The heat flux blocked below the spot (missing flux) spreads over a very extended area surrounding the spot. The brightening corresponding to this missing flux is undetectable if the reduction of the thermal conductivity extends to a depth greater than 1000 km. It is concluded that no effect other than a decrease of the convective efficiency is needed to explain the temperature change observed at the solar surface in and around a sunspot. The energy balance is calculated between magnetic flux tubes, oriented vertically in the solar surface, (magnetic elements in active regions and the quiet network) and their surroundings. Near the visible surface radiation enters the tube laterally from the surrounding convection zone. The heating effect of this influx is important for small tubes (less than a few arcseconds). Due to this influx tubes less than about 1 in diameter can appear as bright structures irrespective of the amount of heat conveyed along the tube itself. Through the lateral influx, small tubes such as are found in the quiet network act as little leaks in the solar surface through which an excess heat flux escapes from the convection zone.     

Shear-induced instability and arch filament eruption: A magnetohydrodynamic (MHD) numerical simulation

We investigate, via a two-dimensional (nonplanar) MHD simulation, a situation wherein a bipolar magnetic field embedded in a stratified solar atmosphere (i.e., arch-filament-like structure) undergoes symmetrical shear motion at the footpoints. It was found that the vertical plasma flow velocities grow exponentially leading to a new type of global MHD-instability that could be characterized as a Dynamic Shearing Instability, with a growth rate of about 8{ovV} _A a, where {ovV} _A is the average Alfvén speed and a ^–1 is the characteristic length scale. The growth rate grows almost linearly until it reaches the same order of magnitude as the Alfvén speed. Then a nonlinear MHD instability occurs beyond this point. This simulation indicates the following physical consequences: the central loops are pinched by opposing Lorentz forces, and the outer closed loops stretch upward with the vertically-rising mass flow. This instability may apply to arch filament eruptions (AFE) and coronal mass ejections (CMEs).To illustrate the nonlinear dynamical shearing instability, a numerical example is given for three different values of the plasma beta that span several orders of magnitude. The numerical results were analyzed using a linearized asymptotic approach in which an analytical approximate solution for velocity growth is presented. Finally, this theoretical model is applied to describe the arch filament eruption as well as CMEs.