We investigated the relationships between mineral content and the physical and mechanical properties of landscape rock using a non-destructive remote sensing method applied in the laboratory. Using this technique, the spectral properties of the landscape rock could be collected at different wavelengths without harming the samples. Differences in spectral reflectance were compared with the physical and mechanical properties of the stone. Significant correlations were observed between reflectance values and the rocks’ mechanical and physical properties, with correlation coefficients of 95 to 99 %. However, establishing a correlation between two variables is not a sufficient condition to establish a causal relationship. Mineral densities and mineral content are characteristics used for the classification of landscape rock. We have concluded that although spectral signatures from landscape rock can be used for predicting which stones might have similar features when comparing two batches of stone, the high correlations we discovered cannot confirm a cause and effect relationship that would allow for the prediction of a rock’s physical and mechanical properties. Although this conclusion is disappointing, the mineral content and the significant correlations discovered by hyperspectral reflectance scanning can be used as supplementary information when comparing two samples of landscape rock. 相似文献
In this study, the geometric accuracy comparison of aerial photos and WorldView-2 satellite stereo image data is evaluated with the different number and the distribution of the ground control points (GCPs) on the basis of large scale map production. Also, the current situation of rivalry between airborne and satelliteborne imagery was mentioned. The geometric accuracy of Microsoft UltraCam X 45 cm ground sampling distance (GSD) aerial imagery and WorldView-2 data both with and without GCPs are also separately analyzed. The aerial photos without any GCP by only using global navigation satellite system (GNSS) and inertial measurement unit (IMU) data with tie points give an accuracy of ±1.17 m in planimetry and ±0.71 m in vertical that means nearly two times better accuracy than the rational polynomial coefficient (RPC) of stereo WorldView-2. Using one GCP affects the accuracies of aerial photos and WorldView-2 in different ways. While this situation distorts the aerial photo block, it corrects the shift effect of RPC in WorldView-2 and increases the accuracy. By using four or more GCPs, ½?pixel (~0.23 m) accuracy in aerial photos and 1 pixel (~0.50 m) accuracy in WorldView-2 can be achieved in horizontal. In vertical, aerial photos have 1 pixel (~0.55 m) and WorldView-2 has 1.5 pixels (~0.85 m) accuracy. These results show that Worldview-2 imagery can be used in the production of class I 1:5000 scale maps according to the ASPRS Accuracy Standards for Digital Geospatial Data in terms of geometric accuracy. It is concluded that the rivalry between aerial and satellite imagery will continue for some time in the future. 相似文献
Afyonkarahisar is a very important geothermal province of western Anatolia and has low and medium enthalpy geothermal areas. This study has been carried out for the preparation of distribution maps of soil gases (radon and carbon dioxide) and shallow soil temperature and the exploration of permeable tectonic regions associated with geothermal systems and reveal the origins of radon and carbon dioxide gases. The western district of the study area is characterized by the high radon concentration (168.30 kBq/m3), carbon dioxide ratio (0.30%), and soil temperature (21.0 °C) values. Fethibey and Demirçevre faults, which allow the circulation of geothermal fluids, have been detected in the distribution maps of radon, carbon dioxide, and shallow depth temperature and the directions of the curves in these maps correspond to the strikes of Demirçevre faults. The effect of the fault plays an important role in the change of carbon dioxide concentration along the W-E directional geological section prepared to determine the change of soil gas and shallow depth temperature values depending on lithological differences, fault existence, and geothermal reservoir depth. On the other hand, it was determined that Rn222 concentration and soil temperature changed as a function of geothermal reservoir depth or lithological difference. Tuffs in Köprülü volcano-sedimentary units are the main source of radon due to their higher uranium contents. Besides, the carbon dioxide in Ömer–Gecek soils has geothermal origin because of the highest carbon dioxide content (99.3%) in non-condense gas. The similarities in patterns of soil temperature, radon, and carbon dioxide indicate that the variation in soil temperatures is related to radon and carbon dioxide emissions. It is concluded that soil gas and temperature measurements can be used to determine the active faults in the initial stage of geothermal exploration successfully. 相似文献
In this study, soil radon levels have been measured for the first time across the Ganos fault (GF), which is known as the western part of the North Anatolian Fault Zone. LR 115 Type 2 Solid State Nuclear Track Detectors (time integrated) have been applied to determine soil gas radon levels, and the survey was performed in 16 stations along the fault line. The results showed that soil gas radon concentrations and variation of concentration levels are comparable high along the fault line. It is also observed that in the middle of the Ganos Fault, fairly elevated radon levels were detected. These can be related to the activity of the fault lines. It is confirmed that the study area has a very active tectonic structure and is great location for analyzing radon variations. 相似文献
This study was performed at an area of 50?×?48 m2 being defined as a new settlement in the northeast of Sivas. In the study, the discontinuities that are not deep and their geophysical characteristics were examined by the GPR and MASW methods. For interpretation, GPR cross sections were prepared as 2D–3D, and MASW cross sections were prepared as 2D. As for geophysical cross sections, about 10 m depth was examined. It was understood that the reflections observed in the form of hyperbolas in GPR cross sections correspond to areas having low S wave velocity (Vs) in MASW cross sections. It was understood that the S wave velocities are lower than 653 m/s, that the seismic velocities in between 653 and 275 m/s indicate partially deteriorated areas and that the S wave velocities of unweathered gypsums are higher than 1275 m/s at these low-velocity zones. Thus, it was thought that the fill material that may arise in the fracture, crack and deterioration areas arises from intercalation and clastic gypsum units, and that it plays a role in having low value S wave velocities. In all the geophysical cross sections, it was understood that the structures with gypsum are intense at the initial 5 m. And a fracture at the south of the study area, that it was estimated might be longer than 40 m, was determined as the largest gypsum structure. It was understood that this fracture starts from a depth of about 5 m in the west and that it slopes down to 7 m depth in the east. According to these results, it was understood that the damage amount arising in time in the gypsum structures from the effect of water may increase, the study area was defined as risky, and the required importance should be attached to these structures especially in foundation engineering. 相似文献
We present a study on human perception of map complexity, with the objective of better understanding design decisions that may lead to undesirable levels of complexity in web maps. We compare three complexity metrics to human ratings of complexity obtained through a user survey. Specifically, we use two algorithmic approaches published by others, which measure feature congestion (FC) and subband entropy (SE), as well as our own approach of counting object types rather than individual objects. We compare these metrics with each other as well as with human complexity ratings for three maps of the same area from map providers Google Maps, Bing Maps, and OpenStreetMap. Each map design is assessed at three different scales (levels of detail). We find that (1) the FC and SE metrics appear to be adequate predictors of what humans consider complex; (2) object-type counts are slightly less successful at predicting human-rated complexity, implying that clutter is more important in perceived complexity than diversity of symbology; and (3) generalization choices do impact human complexity ratings. These findings contribute to our understanding of what makes a map complex, with implications for designing maps that are easy to use. 相似文献
Natural Hazards - The seismically induced ground failure is defined as any earthquake-generated process that leads to deformations within a soil medium, which in turn results in permanent... 相似文献
A 6.8-magnitude earthquake that occurred on January 24, 2020, has been effective in Turkey’s eastern regions. The earthquake, with recorded peak ground acceleration (PGA) value of 0.292 g, caused the destruction or heavy damage of buildings, especially in the city center of Elaz?? province. The purpose of this paper was to share the results of detailed investigation in the earthquake-stricken area. Additionally, the causes of damages and failures observed in the buildings were compared to those that had occurred in previous earthquakes in Turkey. In this study, the damages observed in especially RC buildings as well as in masonry and rural buildings were summarized, the lessons learned were evaluated, and the results were interpreted with reference to Turkish earthquake codes. In the study, it was particularly emphasized why the building stock underwent such damage even though the buildings were exposed to earthquake acceleration well below the design acceleration values.
Astronomy Letters - We present LTE analysis of high resolution optical spectra for the B-type abundance standard candidate HD 35039 (HR 1765, 22 Ori) with an ambigous binary nature. The spectra... 相似文献
We present preliminary statistics on the precipitable water vapor (PWV) content over the Karakaya Hills in Erzurum city, where the largest optical and near-infrared astronomical telescope in Turkey will be operated. Since the observatory will observe in the near-infrared (NIR), it is intended to perform PWV measurements of the atmosphere above the site by using signal delays in Global Positioning System (GPS) communication. The analysis of the GPS data recorded on the summit for almost one year shows that the atmosphere over the site of the observatory, which has an altitude of 3170 m, has favorable conditions for NIR observations. From GPS measurements, we report that the site had an average PWV of 3.2 mm and a median PWV of 2.7 mm between October 6, 2016, and June 15, 2017. We also present the time dependency of the PWV content and the correlations between the amount of PWV and the other meteorological records gathered from radiosonde flights and ground-based measurements. 相似文献