The wadic project: A comprehensive field evaluation of directional wave instrumentation

The results of a comprehensive field trial of nearly all commercially available directional wave measurement systems at the Edda field in the North Sea during winter 1985-86 are presented. The results summarize the accuracy of the principal engineering wave parameters from each system and the dependence on sea state. Limiting factors on system performance and operational problems are also included in the assessment. Overall experience has been good with systems utilizing widely different measurement principles returning consistent results.     

The impact of wave loads and pore-water pressure generation on initiation of sediment transport

The build-up of pore-water pressure by waves can lead to sediment liquefaction and subsequent transport by traction currents. This process was investigated by measuring pore-water pressures both in a field experiment and laboratory wave tank tests. Liquefaction was observed in the wave tank tests. The results suggest that sand is less susceptible than silts to wave-induced liquefaction because of the tendency to partially dissipate pore-water pressures. However, previous studies have determined that pore-water pressures must approach liquefaction before current velocities necessary to initiate transport are reduced. Once liquefaction has occurred more sediment can be transported.     

Powder- and single crystal Mössbauer spectroscopy on synthetic fayalite

Mössbauer measurements on synthetic iron orthosilicate Fe₂SiO₄ (fayalite) were carried out in the antiferromagnetic spin state below T _N 65 K. The Mössbauer parameters isomer shift , inner magnetic field H(0), angle between H(0) and the z-component of the electric field gradient (efg), quadrupole splitting QS and asymmetry parameter were determined as a function of temperature. These parameters could be attributed to the two crystallographic sites M1 and M2.The smaller isomer shift on M1 with respect to M2 displays the more covalent character of the Fe-O bond on M1, which is supported by previous neutron diffraction experiments. H(0) shows a Brillouin-type behaviour with different fields on the two crystallographic sites (stronger on M1) and a small discontinuity at T = 23 K which corresponds with previous magnetic measurements. The quadrupole splitting is equal on both sites within error bars, in agreement with previous theoretical results and in contradiction to previous Mössbauer refinements published elsewhere.     

A catalogue and finding list of galactic novae

A catalogue of galactic novae and an atlas of finding charts are under preparation and will be published in 1984. The status of the project is described.Paper presented at the Lembang-Bamberg IAU Colloquium No. 80 on Double Stars: Physical Properties and Generic Relations, held at Bandung, Indonesia, 3–7 June, 1983.     

Heat flow near obstacles in the solar convection zone

Disturbances in the heat flow in the solar convection zone are calculated with a turbulent thermal diffusion coefficient based on a mixing length approximation. As a consequence of the radiative boundary condition at the surface and the strong increase of the diffusion coefficient with depth, the convection zone resembles a thermally superconducting shell enclosed between a thin surface layer and an interior core of low thermal conductivity. Thermal disturbances originating in the convection zone do not penetrate into the interior, and penetrate only weakly through the solar surface. A thermally isolating obstacle buried entirely in the convection zone casts a shadow of reduced temperature at the solar surface; the brightening surrounding this shadow is undetectable. The shadow is weak unless the object is located close to the surface (less than 2000 km). Assuming a sunspot to be an area of reduced thermal conductivity which extends a finite depth into the convection zone, the heat flow around this obstacle is calculated. The heat flux blocked below the spot (missing flux) spreads over a very extended area surrounding the spot. The brightening corresponding to this missing flux is undetectable if the reduction of the thermal conductivity extends to a depth greater than 1000 km. It is concluded that no effect other than a decrease of the convective efficiency is needed to explain the temperature change observed at the solar surface in and around a sunspot. The energy balance is calculated between magnetic flux tubes, oriented vertically in the solar surface, (magnetic elements in active regions and the quiet network) and their surroundings. Near the visible surface radiation enters the tube laterally from the surrounding convection zone. The heating effect of this influx is important for small tubes (less than a few arcseconds). Due to this influx tubes less than about 1 in diameter can appear as bright structures irrespective of the amount of heat conveyed along the tube itself. Through the lateral influx, small tubes such as are found in the quiet network act as little leaks in the solar surface through which an excess heat flux escapes from the convection zone.     

Shear-induced instability and arch filament eruption: A magnetohydrodynamic (MHD) numerical simulation

We investigate, via a two-dimensional (nonplanar) MHD simulation, a situation wherein a bipolar magnetic field embedded in a stratified solar atmosphere (i.e., arch-filament-like structure) undergoes symmetrical shear motion at the footpoints. It was found that the vertical plasma flow velocities grow exponentially leading to a new type of global MHD-instability that could be characterized as a Dynamic Shearing Instability, with a growth rate of about 8{ovV} _A a, where {ovV} _A is the average Alfvén speed and a ^–1 is the characteristic length scale. The growth rate grows almost linearly until it reaches the same order of magnitude as the Alfvén speed. Then a nonlinear MHD instability occurs beyond this point. This simulation indicates the following physical consequences: the central loops are pinched by opposing Lorentz forces, and the outer closed loops stretch upward with the vertically-rising mass flow. This instability may apply to arch filament eruptions (AFE) and coronal mass ejections (CMEs).To illustrate the nonlinear dynamical shearing instability, a numerical example is given for three different values of the plasma beta that span several orders of magnitude. The numerical results were analyzed using a linearized asymptotic approach in which an analytical approximate solution for velocity growth is presented. Finally, this theoretical model is applied to describe the arch filament eruption as well as CMEs.