The light curved in the CM field

In this paper we introduce the CM field in Sections 2 and 3 based on the paper by Wang and Peng (1985), and calculate the light curved in the CM field in Section 4. The result shows thatP makes _CM larger than _C at , and smaller at . Under a special circumstance which source, CM lens, and observer are in the same line, if we get | ₀₌₀ , and | _=/2 , we can determine theP(M) andQ(M) of the CM lens,M is the mass of the CM lens.     

On the inclination and the axial velocity of spicules

This paper studies two properties of chromospheric spicules: their angular distribution and the plasma velocity along their axes. To investigate the first property, we measured the apparent tilt of spicules at the limb, and then computed their actual distribution in space. This was achieved by solving first kind Fredholm or Volterra integral equations by various methods. The distribution of the axial velocity of the spicule plasma was studied on the basis of two types of observations: (1) the height variation of the spicules as a function of time and (2) the Doppler shift of the spectral lines. The resulting velocity distributions, using the experimental data of these two sets of observations, are quite different. The average velocity based on the Doppler shift measurements ( 40 km s^–1) is greater than that based on height variation of spicules ( 20 km s^–1). This is due to the ionization of the material as it penetrates the corona.     

Spin rate estimation of sounding rockets using GPS wind-up

Carrier phase wind-up is a well-known effect that arises from the relative rotation between a transmitting and receiving antenna. In GPS measurements at L1 frequency, this effect translates into an error of 19.029 cm per full relative rotation of antennas. Since this effect is independent of the satellite elevation for pure rotation about the antenna boresight axis, it is usually absorbed by the clock estimation in navigation algorithms. Therefore, the impact of wind-up is usually neglected for applications that do not require accuracies to the cm level like RTK. However, in receiving platforms with high rotation rate, the accumulated wind-up value can be important and actually be larger than receiver noise or even ionospheric variations. Therefore, in such scenarios, the wind-up contribution can be isolated and used as a source of information to compute the spin rate of such platforms using an appropriate combination of GPS observables. This work shows some results of a coarse, yet simple, approach to monitor the rotation angle and spin-rate of spin stabilized sounding rockets flown by DLR.     

Simulations of 3D DC borehole resistivity measurements with a goal-oriented <Emphasis Type="Italic">hp</Emphasis> finite-element method. Part II: through-casing resistivity instruments

We simulate direct current (DC) borehole resistivity measurements acquired in steel-cased deviated wells for the assessment of rock formation properties. The assumed data acquisition configuration considers one current (emitter) and three voltage (collector) electrodes that are utilized to measure the second difference of the electric potential along the well trajectory. We assume a homogeneous, 1.27-cm-thick steel casing with resistivity equal to 10^− 5 Ω· m. Simulations are performed with two different numerical methodologies. The first one is based on transferring two-dimensional (2D) axisymmetric optimal grids to a three-dimensional (3D) simulation software. The second one automatically produces optimal 3D grids yielded by a 3D self-adaptive goal-oriented algorithm. Both methodologies utilize high-order finite elements (FE) that are specially well-suited for problems with high-contrast coefficients and rapid spatial variations of the electric field, as it occurs in simulations that involve steel-cased wells. The method based on transferring 2D-optimal grids is efficient in terms of CPU time (few seconds per logging position). Unfortunately, it may produce inaccurate 3D simulations in deviated wells, even though the error remains below 1% for the axisymmetric (vertical) well. The method based on optimal 3D grids, although less efficient in terms of CPU time (few hours per logging position), produces more accurate results that are validated by a built-in a posteriori error estimator. This paper provides the first existing simulations of through-casing resistivity measurements in deviated wells. Simulated resistivity measurements indicate that, for a 30° deviated well, measurements in conductive layers 0.01 Ω· m) are similar to those obtained in vertical wells. However, in resistive layers (10,000 Ω· m), we observe 100% larger readings in the 30° deviated well. This difference becomes 3,000% for the case of a 60° deviated well. For this highly-deviated well, readings corresponding to the conductive formation layer are about 30% smaller in magnitude than those in a vertical well. Shoulder effects significantly vary in deviated wells.     

Water balance in the playa-lakes of an arid environment,Monegros, NE Spain

The playa-lakes of the Monegros desert in north-east Spain are saline wetlands in an arid environment, a rare phenomenon in Europe. These extremely valuable habitats are threatened by changes associated with agricultural expansion and incorporation of new irrigated areas. An understanding of the present hydrologic regime will enable changes to be identified, particularly those brought about by flooding and pollution caused by irrigation surplus. This study sets out to show the results of applying a daily water balance in three selected playa-lakes. The balance was in two parts and consisted of: (1) the average balance for all the endorheic basin using the BALAN_11 program, and (2) the water balance in some playa-lakes, applying discharge flows obtained from the previous balance. The resulting volumes of water were converted to water depths and contrasted with reference volumes taken from field and Landsat images. The model was calibrated by applying various hypotheses of function which enabled the results to be adjusted. The proposed balance is an acceptable reproduction of field water measurements during this period, and underlines the consistency of the conceptual model. The methodology used is appropriate for understanding the playa-lakes function and for monitoring them for conservation purposes.     

Hydrogeochemistry and isotope analyses used to determine groundwater recharge and flow in low-gradient catchments of the province of Buenos Aires,Argentina

The region known as Pampa Plain, in Argentina, is a vast area characterized by slopes of less than 0.05%. The surface sediment is silty sand, mainly Aeolian, referred to as Pampean Loess, which is a phreatic aquifer unit of utmost importance for the water supply of the region. On account of the slight gradient, hydrogeological analyses using only hydraulic measurements are difficult to perform, often leading to confusing results. Thus, the study presented relies on hydrochemical modeling and isotopic determinations as well. The study area comprises three catchments in the inter-mountainous area corresponding to El Moro, Tamangueyú and Seco creeks, and covering 2,570 km² in the province of Buenos Aires. Measurements of piezometric levels and samples of groundwater, surface water and rainwater were carried out between January and March 2005. Major ion results were analyzed by means of hydrochemical graphs and hydrogeochemical modelling using NETPATH. The resulting data show that it is possible to identify local changes in recharge, flow direction and stream/groundwater relationship by using hydrochemical and isotopic information, which may become a useful and more precise tool for the study of particularly flat landscapes.     

High-resolution seismic analysis of the coastal Mecklenburg Bay (North German Basin): the pre-Alpine evolution

The pre-Alpine structural and geological evolution in the northern part of the North German Basin have been revealed on the basis of a very dense reflection seismic profile grid. The study area is situated in the coastal Mecklenburg Bay (Germany), part of the southwestern Baltic Sea. From the central part of the North German Basin to the northern basin margin in the Grimmen High area a series of high-resolution maps show the evolution from the base Zechstein to the Lower Jurassic. We present a map of basement faults affecting the pre-Zechstein. The pre-Alpine structural evolution of the region has been determined from digital mapping of post-Permian key horizons traced on the processed seismic time sections. The geological evolution of the North German Basin can be separated into four distinct periods in the Rerik study area. During Late Permian and Early Triassic evaporites and clastics were deposited. Salt movement was initiated after the deposition of the Middle Triassic Muschelkalk. Salt pillows, which were previously unmapped in the study area, are responsible for the creation of smaller subsidence centers and angular unconformities in the Late Triassic Keuper, especially in the vicinity of the fault-bounded Grimmen High. In this area, partly Lower Jurassic sediments overlie the Keuper unconformably. The change from extension to compression in the regional stress field remobilized the salt, leading to a major unconformity marked at the base of the Late Cretaceous.     

Sediment Organic Carbon in Todos Santos Bay, Baja California, Mexico

Sediment grain size and organic carbon (OC) data collected over the past 50 years, together with δ¹³C values of OC in recently collected samples, were analyzed to improve understanding of sediment OC distribution and abundance in Todos Santos Bay. Sediments in the submarine canyon at the mouth of the bay and in quiet-water locations along the shore are fine grained, high in OC, and have generally low δ¹³C values; sediments in high-energy environments are low in OC and have high δ¹³C values. A bivariate isotopic mixing model indicates that none of the sediments contain >50% terrigenous OC (average ~30%), and that the terrigenous OC content of the sediments is a small proportion of the OC content of local soils. Sediment OC composition is apparently controlled by energy-related sorting and deposition, oxidation of much of the original terrigenous OC, and replacement of some terrigenous OC by marine OC.