Relationship between the seismicity and geologic structure of the Blanco Transform Fault Zone

Morphologic studies of an oceanic transform, the Blanco Transform Fault Zone (BTFZ), have shown it to consist of a series of extensional basins that offset the major strike-slip faults. The largest of the extensional basins, the Cascadia Depression, effectively divides the transform into a northwest segment, composed of several relatively short strike-slip faults, and a southeast segment dominated by fewer, longer faults. The regional seismicity distribution (m _b 4.0) and frequency-magnitude relationships (b-values) of the BTFZ show that the largest magnitude events are located on the southeast segment. Furthermore, estimates of the cumulative seismic moment release and seismic moment release rate along the southeast segment are significantly greater than that of the northwest segment. These observations suggest that slip along the southeast segment is accommodated by a greater number of large magnitude earthquakes. Comparison of the seismic moment rate, derived from empirical estimates, with the seismic moment rate determined from plate motion constraints suggests a difference in the seismic coupling strength between the segments. This difference in coupling may partially explain the disparity in earthquake size distribution. However, the results appear to confirm the relation between earthquake size and fault length, observed along continental strike-slip faults, for this oceanic transform.     

Butyltins in marine waters of The Netherlands in 1988 and 1989; Concentrations and effects

Specific effects of tributyltin (TBT) on Crassostrea gigas—valve thickening, and Nucella lapillus—imposex, were measured on local populations, relatively clean unaffected species from England were transferred to the Netherlands and exposed during six weeks to ambient TBT concentrations. Near marinas 50% of the exposed species were sterile after six weeks. In general, no dissolved butyltins were detected in the Rhine and Scheldt estuaries. In 1988 TBT concentrations in marinas ranged from 120 to 4000 ng litre⁻¹. In sediments (fraction <60 μm) and suspended particulate matter TBT concentrations reached up to 1200 ng g⁻¹. TBT concentrations in mussel tissue ranged from <1 to 2300 ng g⁻¹ based on a dry weight. In 1989 concentrations of dissolved TBT ranged from <0·1 to 7200 ng litre⁻¹. In 1989 a seasonal study in the marina of Colijnsplaat showed that dissolved butyltins increased from April to the end of May due to the launching of freshly painted boats, and decreased afterwards.     

Iodine chemistry in deep anoxic basins and overlying waters of the Mediterranean Sea

Iodate (IO₃⁻) is the predominant dissolved species of iodine in the oxygenated waters of the Mediterranean Sea. Iodide (I⁻) is present in significant quantities (up to 65 nM) in oxygenated waters in the photic zone and near the interface above the anoxic and saline Bannock Basin. Lesser quantities of I⁻ (< 10 nM) are found throughout the rest of the oxic water column. An additional unidentified dissolved iodine species is present immediately above the anoxic interface.Total dissolved iodine (ΣI) increases dramatically across the seawater/brine interface. Part of this increase is undoubtedly the result of the dissolution of iodine-rich evaporites during formation of the brine bodies at the Tyro and Bannock Basins. The vertical distribution of ΣI and other dissolved chemical species (particularly PO₄³⁻) in the Bannock Basin brine, however, suggests an additional, present-day, diagenetic source of dissolved iodine to the brine. Based on the increase in the concentration of the most soluble major ions across the seawater/brine interface, 5–7 μM of the 11.5-μM increase in ΣI concentration must be attributed to diagenesis.     

Heave compensation and formation strength evaluation from downhole acceleration measurements while coring

In order to evaluate the efficiency of heave compensation in the Ocean Drilling Program, we developed a device measuring the acceleration of the core barrels. First results show that heave compensation limits bit motion to 10% of the surface heave. We also use the acceleration data to characterize the formation. On rotary corers, acceleration amplitudes decrease with increasing hardness of the formation. Comparison with geophysical logs shows that this relationship can resolve cm-scale features. On piston corers, the maximum acceleration is characteristic of the sediment shear strength. Easy and fast to deploy, this tool allows to characterize formations before any sample analysis.     

Detection of buried targets using a synthetic aperture sonar

This paper presents observations of buried target detections made using a 20-kHz synthetic aperture sonar. At grazing angles below the critical angle, surprisingly high signal-to-noise detections were made of cylindrical targets buried at depths of 15 and 50 cm. During a separate set of measurements, buried spheres were clearly seen at steep grazing angles, but were generally not seen below the critical angle. Since scattering from wave-generated sand ripples may contribute to detections at grazing angles below critical angle, the information available on the ripple fields is discussed and used in acoustic backscatter simulations for the buried spheres. Lack of information on the ripple height precludes a definitive explanation for the absence of buried sphere detections at subcritical grazing angles.     

The autonomous underwater glider "Spray"

A small (50-kg, 2-m long) underwater vehicle with operating speeds of 20-30 cm/s and ranges up to 6000 km has been developed and field tested. The vehicle is essentially an autonomous profiling float that uses a buoyancy engine to cycle vertically and wings to glide horizontally while moving up and down. Operational control and data relay is provided by GPS navigation and two-way communication through ORBCOMM low-Earth-orbit satellites. Missions are envisioned with profile measurements repeated at a station or spaced along a transect. The initial instrument complement of temperature, conductivity, and pressure sensors was used to observe internal waves and tides in the Monterey underwater canyon     

Tectonics at the intersection of the East Pacific Rise with Tamayo Transform fault

During the Fall of 1979, a manned submersible program, utilizing DSRV ALVIN, was carried out at the intersection of the East Pacific Rise (EPR) with the Tamayo Transform boundary. A total of seven dives were completed in the vicinity of the EPR/Tamayo intersection depression and documented the geologic relationships that characterize the juxtaposition of these types of plate boundaries. The young volcanic terrain of the EPR axis can be traced into and across the Tamayo Transform valley but becomes buried by sedimentary talus that is being shed from sediment scarps along the unstable sediment slope that defines the north side of the intersection depression. Within 4 km of the transform boundary, the dominant trend (000°) of the fissures and faults that disrupt the rise-generated volcanics is markedly oblique to the regional direction of sea floor spreading (120°). Since no evidence was found to suggest that these structures accommodate significant amounts of strike-slip displacement, they are taken to reflect a distortion of the EPR extensional tectonic regime by a transform generated shear couple. The floor of the Tamayo Transform valley in this area is inundated by mass-wasted sediment, and the principal transform displacement zone is characterized at the surface by a narrow (<1.5 km) interval of fault scarps in sediment that trends parallel with the transform valley. Extrapolated to the west, this zone links with zones of transform deformation investigated during earlier submersible studies (CYAMEX and Pastouret, 1981). Evidence of low-level hydrothermal discharge was seen at one locality on the EPR axis and at another 8 km west of the axis at the edge of the zone of transform deformation.     

A hydrodynamic model of a submerged lenticular wave energy device

The wavemaking capability and energy absorbing characteristics of a single submerged body, constrained to move horizontally in a surge mode, are examined. The body possesses both a vertical axis of symmetry and a horizontal plane of symmetry and is ‘thin’ in the sense that the body draft is small compared to the length. The behaviour of a single body subject to a constraint being placed upon the amplitude of its displacement and the properties of an array of interacting identical devices are also discussed.