地震前兆台网观测数据质量分析——中国地震背景场探测项目实施

地震前兆台网的运行直接影响产出的观测数据质量。观测数据平均连续率和平均数据完整率可以反映地震前兆台网的运行质量。对中国地震背景场探测项目试行期间(2014年)及正式启动后2015年度的观测数据质量,从以上2个指标进行分析,并对比原有仪器运行质量,可知背景场项目试运行期间,各学科台网投入仪器运行稳定,观测数据符合相关要求,总体质量良好,观测仪器可以投入正式运行。     

Trend analysis of reference evapotranspiration in Northwest China: The roles of changing wind speed and surface air temperature

Reference evapotranspiration (ET₀) is an important element in the water cycle that integrates atmospheric demands and surface conditions, and analysis of changes in ET₀ is of great significance for understanding climate change and its impacts on hydrology. As ET₀ is an integrated effect of climate variables, increases in air temperature should lead to increases in ET₀. However, this effect could be offset by decreases in vapor pressure deficit, wind speed, and solar radiation which lead to the decrease in ET₀. In this study, trends in the Penman–Monteith ET₀ at 80 meteorological stations during 1960–2010 in the driest region of China (Northwest China) were examined. The results show that there was a change point for ET₀ series around the year 1993 based on the Pettitt's test. For the region average, ET₀ decreased from 1960 to 1993 by ?2.34 mm yr^?2, while ET₀ began to increase since 1994 by 4.80 mm yr^?2. A differential equation method based on the Food and Agriculture Organization Penman–Monteith formula was used to attribute the change in ET₀. The attribution results show that the significant decrease in wind speed dominated the change in ET₀, which offset the effect of increasing air temperature and led to the decrease in ET₀ from 1960 to 1993. However, wind speed began to increase, and the amplitude of increase in air temperature also rose significantly since the mid‐1990s. Increases in air temperature and wind speed together reversed the trend in ET₀ and led to the increase in ET₀ since 1994. Copyright © 2012 John Wiley & Sons, Ltd.     

低频检波器频谱补偿算法建模及仿真

采用数值仿真的方法建立了动圈式检波器的仿真模型,推导检波器传递函数,通过对实际动圈式检波器频率特性的测试,验证了动圈式检波器数值仿真模型的正确性,分析动圈检波器频率响应特性,分别对动圈式检波器的自然频率、灵敏度、阻尼比进行仿真,对不同自然频率、灵敏度、阻尼比对检波器输出频率特性的影响进行了分析,使用二阶二次型反馈补偿方法,设计检波器低频补偿结构,结果表明：数值仿真模型与实际检波器的频率响应一致,补偿结构使检波器自然频率由2 Hz降低至0.2 Hz.

     

The variation of temperature with time and hydrocarbon maturation in sedimentary basins formed by extension

When a sedimentary basin is formed by extension both the subsidence history and the temperature gradient can be calculated. Hence the time-temperature history of any stratum can be obtained. Three types of behaviour occur. The temperature of material which never reaches depths greater than about 4 km increases at all times. The time-temperature history of material which finally sinks to greater depths reaches a maximum during the subsidence history. The time at which this maximum occurs decreases as the depth increases. At greater depths the maximum temperature occurs at the time the basin is formed. The time-temperature history is then used to calculate Lopatin's maturation index for each stratum as a function of time, and the index plotted as a function of depth and time for different amounts of extension. The maximum temperature at a given depth, and hence Lopatin's index, is almost independent of the amount of extension when the age of the basin is greater than about 150 Ma. Similar calculations taking account of sediment compaction show the same behaviour, though the maturity of the material at a given depth is increased. Because both Lopatin's index and its calibration are empirical it is important to develop new maturation indices based on individual molecular reactions whose activation energies can be determined in the laboratory.     

The orientation of the stress axes within sinking slabs

In principle it should be possible to obtain information about the orientation of the stress axes within a sinking slab from the first motions observed at a single suitably placed seismic station. This idea is tested on the Tonga-Fiji-Kermadec Arc, using the short-period vertical seismograms from Port Moresby, and the orientations so obtained agree with those derived from fault plane solutions.     

On the automatic interpretation of direct current resistivity soundings

A method for the automatic inversion of resistivity soundings is presented. The procedure consists of two main stages. First, application of linear filters which transforms the apparent resistivity curve into the kernel function, and vice versa. In the second stage the first and second derivatives of the kernel function are calculated and used in a second-order modified Newton-Raphson iterative fitting procedure. The model obtained is optimal in the least squares sense. The method has been tried on some field examples and produced resistivity models which show a good agreement with the geological well logs.     

Reverse time migration of CMP-gathers an effective tool for the determination of interval velocities

One of the most important steps in the conventional processing of reflection seismic data is common midpoint (CMP) stacking. However, this step has considerable deficiencies. For instance the reflection or diffraction time curves used for normal moveout corrections must be hyperbolae. Furthermore, undesirable frequency changes by stretching are produced on account of the dependence of the normal moveout corrections on reflection times. Still other drawbacks of conventional CMP stacking could be listed.One possibility to avoid these disadvantages is to replace conventional CMP stacking by a process of migration to be discussed in this paper. For this purpose the Sherwood-Loewenthal model of the exploding reflector has to be extended to an exploding point model with symmetry to the lineP _EX M whereP _EX is the exploding point, alias common reflection point, andM the common midpoint of receiver and source pairs.Kirchhoff summation is that kind of migration which is practically identical with conventional CMP stacking with the exception that Kirchhoff summation provides more than one resulting trace.In this paper reverse time migration (RTM) was adopted as a tool to replace conventional CMP stacking. This method has the merit that it uses the full wave equation and that a direct depth migration is obtained, the velocityv can be any function of the local coordinatesx, y, z. Since the quality of the reverse time migration is highly dependent on the correct choice of interval velocities such interval velocities can be determined stepwise from layer to layer, and there is no need to compute interval velocities from normal moveout velocities by sophisticated mathematics or time consuming modelling. It will be shown that curve velocity interfaces do not impair the correct determination of interval velocities and that more precise velocity values are obtained by avoiding or restricting muting due to non-hyperbolic normal moveout curves.Finally it is discussed how in the case of complicated structures the reverse time migration of CMP gathers can be modified in such a manner that the combination of all reverse time migrated CMP gathers yields a correct depth migrated section. This presupposes, however, a preliminary data processing and interpretation.     

Vertical concentration profile of nonuniform sediment

A new formula for the concentration profile of nonuniform sediment is derived using the diffusion differential equation with equilibrium bed concentration.The interaction coefficient for nonuniform sediment particles as a function of both relative diameter and geometric standard deviation of nonuniform sediment is taken into account in the settling velocity.The diffusion coefficient is obtained from the logarithmic velocity profile.This new formula possesses several advantages as follows:(1)avoids theoretical defect of the Rouse formula,which states that the sediment concentration is infinite at the bottom and zero at the water surface.(2)suitable for an arbitrary fraction of nonuniform sediment,and(3)easy to apply with a simple form.The formula yields less difference among concentration profiles for various particles than that for uniform sediment and reveals the lawfor fractional concentration distribution of nonuniform sediment.The calculated concentration agrees well with the measured data from the Yangtze River.     

京西盆岭构造区积累库仑破裂应力变化对强震的影响

Since 231 B. C.,a total of 15 M6.0 - 7.5 earthquakes have been recorded in the west Beijing basin-range tectonic region( 38.3°- 41.5° E,112°- 116.2° N),a region mainly under the action of tensional normal faulting. In this paper,we calculate the Coulomb stress change of each earthquake and the cumulative Coulomb stress change,and on this basis we analyze the stress triggering of strong earthquakes. The research shows that there are 10 of 14 earthquakes that occurred in the trigger zones,in which the Coulomb stress change is positive,and the trigger rate is 71%. The positive areas of cumulative Coulomb stress change caused by these 15 earthquakes are: middle of northern Liulengshan fault,Northern Huaizhuo basin fault,Xinbaoan-Shacheng fault,Sangganhe fault and Southern Yuxian basin fault. This necessarily increases the seismic risk of these faults and can be used as a reference for future seismic risk analysis in this area.     

Climate changes in the Lhasa River basin,Tibetan Plateau: irrigation-induced cooling along with a warming trend

Characterizing the response of temperature variables to agricultural irrigation is expected to be an important challenge for understanding the full impact of water management on regional climate change. In this paper, the trend analysis and abrupt change test were applied to detect the global warming effect. Then, the quantitative irrigation-induced cooling effects on temperature variables between April and August from 1970 to 2010 in the Lhasa River basin were estimated using historical time series of gridded meteorological records and a map of the area equipped for irrigation. Trends in the maximum temperature (Tmax) were statistically positive, and a significant increasing trend for the minimum temperature (Tmin) was detected at the 0.01 and 0.05 confidence levels. No abrupt changing point of warming was detected in the time series for Tmax. The abrupt changes in Tmin in the irrigation concentration period took place in 1995, 5 years later than the corresponding change in April. Affected by global warming, the increase in temperature was the largest in July and August, when the irrigation-induced cooling effect was also the most significant. The irrigation-induced cooling effect for Tmax and Tmin in April–August (except for June) ranged from − 0.017 to − 0.009 °C/decade and from − 0.011 to − 0.001 °C/decade, respectively, and the cooling effect for diurnal temperature range (DTR) ranged from − 0.011 to 0 °C/decade. The cooling effect on temperature reached above 0.01 °C in July and August, but for the growing seasons, the effect was weak, only 0.001 °C. The Tmax and Tmin trends during the whole growing seasons decreased by both 0.002 °C/decade, respectively, with a 10% increase in irrigation land proportion. Even in July and August, the trends were expected to decrease by about 0.005 °C/decade with a 10% increase in irrigation land proportion. The irrigation-induced cooling effect could partially slow global warming.