Impact of lightning on organic matter-rich soils: influence of soil grain size and organic matter content on underground fires

A detailed study was carried out on a piece of land that had been struck by lightning during the violent rainstorm that raged over the Island of S?o Miguel (Azores Archipelago) in late October 2006. Temperature and gas measurements (CO₂, CO, H₂S and CH₄) were performed in four study trenches, dug in an area of ∼3 m², where an underground fire had been initiated by the impact with a lightning stroke, followed by the emission of a column of gases and smoke. The soil under study was originally a well-pedogenized about 80 cm thick bed, made of volcanic clayey to silty tephra fallouts and contained 5.5–9.7% of organic matter. The underground fire was monitored for one week and revealed a peak release of 404 ppm CO and 3.4% CO₂ originating from a horizon located about 45 cm under the soil surface. Measurements of temperature, performed one week after the impact, indicated a maximum value of 326°C inside the soil, while 516.5°C were measured on the surface of a lava block interred about 20 cm under the surface. Subsequently, a stratigraphic and sedimentologic study proved the role of the grain-size of the soil and of the organic matter content of the different horizons of the impact area, in determining the ratio between anoxic/oxidised combustion conditions and in the progress of the process itself. It was also noticed that combustion was not total all over in the soil bed and that the process had slightly migrated toward SW during the observation period. The combustion process went on for about ten days, in spite of several other violent rainstorms, until it was artificially extinguished through the excavations made to obtain study trenches. This particular circumstance evidenced the potential natural hazard represented by this kind of atmospheric event, especially in a land where the volcanic nature of the soil may easily mislead inexperienced observers and, consequently, delay proper action.     

Numerical estimation of REV and permeability tensor for fractured rock masses by composite element method

The Monte Carlo method is used to generate parent stochastic discrete fracture network, from which a series of fractured rock samples of different sizes and orientations are extracted. The fracture network combined with a regular grid forms composite element mesh of the fractured rock sample, in which each composite element is composed of sub‐elements incised by fracture segments. The composite element method (CEM) for the seepage is implemented to obtain the nodal hydraulic potential as well as the seepage flow rates through the fractured rock samples. The application of CEM enables a large quantity of stochastic tests for the fractured rock samples because the pre‐process is facilitated greatly. By changing the sizes and orientations of the samples, the analysis of the seepage characteristics is realized to evaluate the variation of the permeability components, the existence of the permeability tensor and the representative element volume. The feasibility and effectiveness are illustrated in a numerical example. Copyright © 2008 John Wiley & Sons, Ltd.     

西宁地区大气中黑碳气溶胶浓度的观测研究

对2005年9月至2007年7月在西宁获得的黑碳气溶胶(BC)浓度观测资料及气象观测资料进行了分析. 结果表明, 受当地冬季取暖和冬季逆温出现频率高的影响, BC浓度的月际变化规律明显, 且变化幅度大, BC浓度高值出现在每年10月至次年1月;低值出现在5-8月;日平均浓度为4 240.1 ng·m-3, 其变化范围为957.5～11 045.5 ng·m-3. 受局地人为活动和大气垂直对流扩散等影响, BC浓度日变化表现出明显的双峰值特征, BC高浓度出现在7:00～12:00和18:00～24:00, 而低浓度一般出现在14:00～17:00和02:00～05:00时段. 与相距90 km的瓦里关全球本底站相比, 西宁BC日平均浓度偏高约13倍, 且月际变化差异大, 但与国内部分城市相比还是较低(除西藏拉萨外).     

青藏高原西部赛利普中新世火山岩源区:地球化学及Sr-Nd同位素制约

青藏高原拉萨地块西部赛利普地区新生代火山岩依据主量元素可划分为超钾质、钾质和钙碱性系列,主要的岩石类型为粗面安山岩、粗面岩,一个超钾质岩石的40Ar-39Ar年龄为17.58Ma,指示出火山活动为中新世.超钾质、钾质和钙碱性火山岩都显示出富集LREE及LILE(Th、U)、亏损HFSE(Nb、Ta、Ti)的特征.超钾质火山岩具有较高的K2O(6.31%～8.55%)、MgO(6.75%～8.96%)、Cr(270.7×10-6～460.4×10-6)、Ni(142.3×10-6～233.9×10-6)含量,较高的(87Sr/86Sr)i(0.71883～0.72732)和较低的εNd(-14.78～-15.37),指示可能起源于一个前期亏损并经后期俯冲作用改造的富钾的方辉橄榄岩富集地幔源区.钾质火山岩具有比超钾质火山岩低的K2O、MgO、Cr、Ni含量以及高的Ba、Sr含量,初始87Sr/86Sr为0.71553～0.71628,初始143Nd/144Nd为0.51197～0.51198,在空间上与超钾质火山岩共生,可能是前者母岩浆的演化产物.钙碱性火山岩具有较高的Sr(881.7×10-6～1309.2×10-6)、Sr/Y比值(50～108)和较低的Y(12.05×10-6～18.02×10-6),明显亏损重稀土Yb(0.93×10-6～1.30×10-6),类似于典型的埃达克质岩成分特征但相对高钾,并具有相对低的(87Sr/86Sr);(0.70928～0.71374)以及高的εNd(-7.90～-10.91),指示起源于富钾增厚下地壳物质的部分熔融.区域上拉萨地块超钾质岩、钾质岩与N-S向地堑系在空间上共存、时间上相吻合,由此本文认为拉萨地块中新世钾质.超钾质岩和南北向地堑系的形成可能与中新世早期北向俯冲的印度大陆岩石圈断离有关.     

青藏高原东南木里地区二叠纪苦橄岩的Os-Sr-Nd同位素地球化学研究

本文报道了在青藏高原东南木里地区发现的二叠纪苦橄岩和与其共生玄武岩的主微量元素地球化学特征以及Os-Sr-Nd同位素组成。苦橄岩和与其共生玄武岩受地壳混染作用影响较小。根据苦橄岩的Ti/Y比值和初始的Os同位素组成,将木里苦橄岩分为两类:高Ti/Y型苦橄岩和低Ti/Y型苦橄岩,其中高Ti/Y型苦橄岩具有高的γ_(Os)= 5.3～ 10.7和ε_(Nd)= 5.9～ 6.4,与全球典型洋岛玄武岩的Os和Nd同位素组成接近,代表了地幔柱源区的同位素特征;而低Ti/Y型苦橄岩具有低的γ_(Os)=-4.1～ 1.2和ε_(Nd)= 3.2～ 5.0,可能表明受到了SCLM(大陆岩石圈地幔)源区物质的混染。与其共生的玄武岩具有低的γ_(Os)=-3.5～-1.6和ε_(Nd)=-0.6～ 0.7,表明其来自于不同于低Ti/Y型苦橄岩也有异于高Ti/Y型苦橄岩的地幔源区,但是也可能受到了SCLM物质的混染。基于Nd-Os同位素的地幔柱与SCLM的二端元混合模型显示:低Ti/Y型苦橄岩可能是SCLM物质组分与地幔柱起源的苦橄质原始岩浆混合形成的;与苦橄岩共生的玄武岩可能是由地幔柱来源的玄武质岩浆与SCLM小比例熔融的熔体混合形成的。     

柴达木盆地北缘侏罗系两类不同有机质丰度泥岩的 生物标志物特征对比研究

在柴达木盆地北缘地区,分别选取有机碳含量很低和较高的侏罗系泥岩样品,对比分析了它们在生物标志物组成上的差异。结果发现,高有机质丰度泥岩的生标组成与我国西北地区侏罗纪煤系有机质的特征差异不大,相比而言,低有机质丰度泥岩的正烷烃以前主峰为特征,Pr/Ph比值在1.0左右,三环萜烷和伽马蜡烷丰度较高,并在部分样品中检出了25 降藿烷系列。结合泥岩的有机岩石学特征,认为这些差异可能反映了泥岩沉积环境和生烃母质的不同:高有机质丰度泥岩的有机显微组分以相对弱还原条件下的形态有机质为主,包括藻类体、孢子体和角质体等,而低有机质丰度泥岩的有机显微组分以相对强还原条件下的矿物沥青基质为主,其母质可能来源于低等显微菌藻类。进一步通过对比不同有机质丰度泥岩,以及区内原油生标组成之间的相互关系,讨论了研究区的油源问题。     

三峡库区生基包滑坡监测及成果分析

生基包滑坡监测属于三峡库区奉节县三期地质灾害监测预警项目之一,该滑坡位于长江左岸,临近人口稠密的安坪乡集镇,地理位置重要。三峡水库175 m蓄水后,其变形破坏特征有何表现？对航道安全运营有无潜在威胁？是否会对滑坡体上的重要建筑及村民生产生活构成危害？针对这些问题,首先分析了滑坡的工程地质特征及主要的影响因素;其次,确立以4种监测手段为主、人工巡查为辅的监测方案;通过对大地变形GPS、深部位移、滑坡推力等几种监测方法的运用及对其成果进行分析研究,以实例说明其在滑坡监测中的应用;再次,结合宏观人工巡查进行对照分析,以充分说明大地变形、深部位移和滑坡推力监测在实际运用中的可行性;最后,根据监测结论提出对生基包滑坡防治的建议。     

旋流除砂机理研究及自动旋流除砂器的开发

旋流除砂技术是利用离心力从泥浆中分离固相成分的技术,可广泛应用在地质钻探、有色、冶金工业及石油天然气工业领域。研制开发的自动旋流除砂器弥补了传统除砂器固相成分分离效果不佳、排砂口易堵的缺陷,显著提高泥浆或矿浆的净化质量与除砂效率,且能自动排堵,降低了除砂工作的时间消耗和成本。     

存储式钻孔测量仪的研制与应用

CE-1型存储式磁敏钻孔测斜仪及QXY-5型存储式钻孔倾斜仪采用智能传感器、数据采集系统、大容量存储芯片,具有小巧轻便、功能强大、测试数据准确性高、稳定性好的特点,实现了数据的自动采集、记录和存储。介绍了CE-1型存储式磁敏钻孔测斜仪及QXY-5型存储式钻孔倾斜仪的研制和实际应用情况。     

广州地区深基坑支护形式研究

介绍了广州地区基坑支护近年来的主要类型及其适用范围,并在分析选型各影响因素的基础上,总结出设计选型的要点。