On the inner-layer scale height of boundary-layer flow over low hills

The scaling properties of the depth of the inner-layer of flow over low hills are studied by means of numerical solution of the equations. Two closure schemes are applied: the mixing-length model and the E- formulation. It is shown that the scale relation for the inner-layer depth lies between two formulations proposed in literature. It is also shown that the scale relation depends on the closure scheme.Presently at the European Centre for Medium-Range Weather Forecasts, Shinficld Park, Reading, Berkshire RG2 9AX, England.     

Atmospheric dispersion in the arctic: Winter-time boundary-layer measurements

The winter-time arctic atmospheric boundary layer was investigated with micrometeorological and SF₆ tracer measurements collected in Prudhoe Bay, Alaska. The flat, snow-covered tundra surface at this site generates a very small (0.03 cm) surface roughness. The relatively warm maritime air mass originating over the nearby, partially frozen Beaufort Sea is cooled at the tundra surface resulting in strong (4 to 30 °C · (100 m)^-1) temperature inversions with light winds and a persistent weak (1 to 2 °C · (100 m)^-1) surface inversion with wind speeds up to 17 m s^-1. The absence of any diurnal atmospheric stability pattern during the study was due to the very limited solar insolation. Vertical profiles were measured with a multi-level mast from 1 to 17 m and with a Doppler acoustic sounder from 60 to 450 m. With high wind speeds, stable layers below 17 m and above 300 m were typically separated by a layer of neutral stability. Turbulence statistics and spectra calculated at a height of 33 m are similar to measurements reported for non-arctic, open terrain sites and indicate that the production of turbulence is primarily due to wind shear. The distribution of wind direction recorded at 1 Hz was frequently non-Gaussian for 1-hr periods but was always Gaussian for 5-min periods. We also observed non-Gaussian hourly averaged crosswind concentration profiles and assume that they can be modeled by calculating sequential short-term concentrations, using the 5-min standard deviation of horizontal wind direction fluctuations () to estimate a horizontal dispersion coefficient ( _y ), and constructing hourly concentrations by averaging the short-term results. Non-Gaussian hourly crosswind distributions are not unique to the arctic and can be observed at most field sites. A weak correlation between horizontal ( _v ) and vertical ( _w ) turbulence observed for both 1-hr and 5-min periods indicates that a single stability classification method is not sufficient to determine both vertical and horizontal dispersion at this site. An estimate of the vertical dispersion coefficient, _z , could be based on or a stability classification parameter which includes vertical thermal and wind shear effects (e.g., Monin-Obukhov length, L).     

Gravel transport,gravel harvesting,and channel-bed degradation in rivers draining the southern olympic mountains,Washington, U.S.A.

The potential for gravel extraction to adversely affect anadromous fish habitat in three gravel-bed rivers of southwestern Washington, U.S.A., prompted the need to determine sustainable rates of gravel removal. This was accomplished by evaluating the components of a long-term sediment mass balance for the three rivers. Average annual gravel transport was determined by three independent methods. The closely agreeing results indicate that annual bedload supply decreases downstream through deposition and storage in response to declining gradient and from attrition during transport, as confirmed by laboratory experiments. A survey of gravel-bar harvesting operations indicates that the annual replenishment rate has been exceeded for up to three decades, often by more than tenfold. Analysis of data from nine stream gauging stations over a 55-yr period indicates degradation of about 0.03 m/yr in these reaches and suggests that bed degradation has produced the difference between the replenishment rates and the volumes of gravel harvested from the river beds and bars.     

Partitioning data pertaining to Fe-Mg ordering around trace cations in olivine and low-Ca pyroxene

We have used trace element partitioning data available in the literature to investigate nonideality of the cations of Yb, Sm, Gd, Ca, Mn, Sc, Ni, and Al in silicate melt, olivine, and low-Ca pyroxene. Results are consistent with ordering of Mg and Fe around trace cations in olivine and pyroxene. On the basis of these data, we suggest there is an increasing tendency for Fe to congregate in the vincinity of the trace cation as the size of the trace cation increases. These results are important both in achieving a better understanding of trace element behavior in crystals and in constraining the temperature and compositional dependence of trace element partitioning.     

Field Evaluation of a Slim-Hole Borehole Induction Tool

The Geonics EM-39 borehole induction tool was field tested to evaluate its performance under controlled conditions. The effects of temperature changes and borehole fluids were found to be negligible under most conditions. The instrument can be calibrated in large bodies of water of known electrical conductivity. When properly calibrated, the ± 5 percent accuracy claimed by the manufacturer is obtainable. A geologic unit must be at least 4m thick for the electrical conductivity of the unit to be accurately measured. Geologic units thinner than 4m thick can be detected if the conductivity contrast to adjacent units is sufficiently large.     

Hydrocarbon distribution in coals and in dispersed organic matter of different maceral compositions and maturities

More than 60 samples from 5 coal seams and adjacent siltstones and sandstones were selected from a well through Westphalian B sediments from Northern Germany in order to study bitumen generation and migration. The cores were drilled between 1200 und 1530 metres depth. In this interval, vitrinite reflectance (Rr) is increasing from 0.70 to 0.92%. Results reveal high hydrocarbon generation potentials for all coal samples, but not for adjacent clastic rocks, although maceral compositions of both are quite similar. Yields and compositions of thermal extracts from the coals depend on maceral compositions and rank. However, the bulk of the already generated bitumen has not been removed during natural coalification and is not easily releasable by thermovaporisation. A mass balance based on elemental composition of dull coals indicates that in the rather narrow rank interval (0.70–0.92% Rr) a total mass loss of 20% may have occurred by migration. This is evidenced by a loss of about 20% of the original hydrogen, the rest being stored in the coals.

---

Zusammenfassung Um die Entstehung und Migration von Bitumen zu untersuchen wurden in Norddeutschland mehr als 60 Proben aus 5 Kohleflözen und benachbarten Silt- und Sandsteinen aus einer Bohrung durch Westphal B-Sedimente bearbeitet. Die Entnahmetiefe der Bohrkerne liegt zwischen 1200 und 1530 Metern. Innerhalb dieses Intervales steigt die Vitrinit-Reflexion (Rr) von 0,70 auf 0,92%. Für alle Proben aus den Flözen ergeben sich hohe Kohlenwasserstoff-Bildungspotentiale, nicht aber für die benachbarten klastischen Gesteine, obwohl die Mazeral-Zusammensetzungen in beiden ähnlich sind. Die Ausbeute und Zusammensetzung thermaler Extrakte aus den Flözen hängen von Mazeral-Zusammensetzung und Reife ab. Allerdings wurden weder während der Inkohlung größere Mengen des Bitumens abtransportiert, noch ist dieses durch Thermovaporisation leicht freisetzbar. Eine Massenbalanzierung auf der Basis der Elementzusammensetzung ergibt für das relativ schmale Interval von C,70-0,92% Rr ein Massenverlust von 20% durch Migration. Diese Angabe basiert auf einer 20%igen Reduzierung der ursprünglichen Wasserstoffmenge, wobei die restlichen 80% in der Kohle gespeichert bleiben.

---

Résumé Dans un forage pratiqué à travers le Westphalien B du nord de l'Allemagne, on a sélectionné plus de 60 échantillons provenant de 5 couches de charbon ainsi que des siltites et grès adjacents, dans le but d'étudier la formation et la migration du bitume. Les carottes proviennent de profondeurs situées entre 1200 et 1530 m. Dans cet intervalle, le pouvoir réflecteur de la vitrinite (Rr) passe de 0,70 à 0,92%. L'étude révèle des potentiels élevés en hydrocarbure pour tous les échantillons de charbon, mais pas pour les roches détritiques voisines, bien que les compositions «macérales» soient analogues dans les deux cas. L'importance et la composition des extrait athermiques des charbons dépendent de la composition «macérale» et du degré d'évolution. Toutefois, la plus grande partie du bitume engendré est restée sur place au cours de la houillification naturelle et elle est difficile à extraire avex la methode de thermovaporisation. Une balance des masses d'éléments indique pour cet intervalle relativement étroit (0,7–0,92% Rr) une perte totale de masse de 20% due à la migration. Ce résultat correspond à une perte d'environ 20% de l'hydrogène originel, les 80% restants étant demeurés dans le charbon.

---

60 5 , , . 1200 1530 . /Rr/ 0,7 0,92. , , . , , . , , . , , 20% 0,7 0,92 %. 20%; , 80%, .

     

Si,Al ordering in leucite by high-resolution 27Al MAS NMR spectroscopy

High-resolution ²⁷Al MAS NMR spectra of natural leucite recorded at H ₀=11.7T contain three resolvable resonances at ²⁷Al δ _i = 69.2, 64.7, and 61.0±0.5 ppm. These three resonances are assigned to the three inequivalent framework positions of leucite: T3, T2, and T1, respectively. Fitting the observed spectra yields a Si,Al distribution for leucite in which approximately one-half of the Al is in T1 and one-quarter in each of T2 and T3. This Si,Al distribution differs substantially from those obtained by previous workers using ²⁹Si NMR spectroscopy and X-ray diffraction. New ²⁹Si NMR spectra and revision of previously reported ²⁹Si NMR peak assignments, however, make the ²⁷Al and ²⁹Si NMR results consistent. The ²⁷Al δ _i correlate linearly with the mean T-O-T′ bond angles of the average structure, which allows the peak assignments to be made. However, this correlation lies distinctly toward higher frequency and larger bond angles than correlations for Si,Al ordered aluminosilicates, suggesting that the mean T(Al)-O-T′(Si) bond angle for each site in leucite is smaller than the mean bond angle of the average structure, which is averaged over T(Al)-O-T′(Si) and T(Si)-OT′(Si,Al) angles.     

Structure and subduction processes along the Oregon-Washington margin

Seismic reflection and refraction data off Washington and Oregon are used to determine the style of sediment deformation and to infer the physical properties of accreted sediments on the lower slope. Onshore-offshore seismic refraction data off Washington are used to determine the location of the trench, or where the plate bending starts.We find that off Washington the subduction zone is characterized by a trench whose physiographic expression is buried under several kilometers of sediments and is tens of kilometers landward of the lower slope, which is accreting seaward as the result of the offscraping of sediments.Seismic reflection data support previous observations that offscraping occurs along seaward and landward dipping thrust faults. Refraction data indicate that a sediment package thrust up along a seaward dipping fault (off Washington) was not measurably changed in velocity with respect to a Cascadia basin section. However a package uplifted by thrusting along a landward dipping fault (off Oregon) did have increased velocity. It is suggested that the increased velocities off Oregon could be the result of erosion and exposure of more deeply buried and compacted sediments, rather than the result of dewatering due to tectonic stress. Off Washington the sensitivity of velocity to porosity and resolution of the seismic method does not preclude dewatering due to tectonic stress, but it does limit the degree of dewatering.In the deeper parts of the lower slope section off Washington and Oregon velocities as high as 3 to 4 km/sec are found. Heat flow data indicate that the temperatures in this high velocity regime are greater than 100°C. It is hypothesized that lithification related to clay diagenesis may be partly responsible for the high velocities, rather than simply compaction. It also appears that the high velocity sediments are subducted while the unlithified low velocity sediments are offscraped.