Submarine canyon development in the Izu-Bonin forearc: A SeaMARC II and seismic survey of Aoga Shima Canyon

SeaMARC II sidescan (imagery and bathymetry) and seismic data reveal the morphology, sedimentary processes, and structural controls on submarine canyon development in the central Izu-Bonin forearc, south of Japan. Canyons extend up to 150 km across the forearc from the trench-slope break to the active volcanic arc. The canyons are most deeply incised (1200–1700 m) into the gentle gradients (1–2°) upslope on the outer arc high (OAH) and lose bathymetric expression on the steep (6–18°) inner trench-slope. The drainage patterns indicate that canyons are formed by both headward erosion and downcutting. Headward erosion proceeds on two scales. Initially, pervasive small-scale mass wasting creates curvilinear channels and pinnate drainage patterns. Large-scale slumping, evidenced by abundant crescent-shaped scarps along the walls and tributaries of Aoga Shima Canyon, occurs only after a channel is present, and provides a mechanism for canyon branching. The largest slump has removed >16 km³ of sediment from an 85 km² area of seafloor bounded by scarps more than 200 m high and may be in the initial stages of forming a new canyon branch. The northern branch of Aoga Shima Canyon has eroded upslope to the flanks of the arc volcanoes allowing direct tapping of this volcaniclastic sediment source. Headward erosion of the southern branch is not as advanced but the canyon may capture sediments supplied by unconfined (non-channelized) mass flows.Oligocene forearc sedimentary processes were dominated by unconfined mass flows that created sub-parallel and continuous sedimentary sequences. Pervasive channel cut-and-fill is limited to the Neogene forearc sedimentary sequences which are characterized by migrating and unconformable seismic sequences. Extensive canyon formation permitting sediment bypassing of the forearc by canyon-confined mass flows began in the early Miocene after the basin was filled to the spill points of the OAH. Structural lows in the OAH determined the initial locus of canyon formation, and outcropping basement rocks have prevented canyon incision on the lower slope. A major jog in the canyon axis, linear tributaries, and a prominent sidescan lineament all trend NW-NNW, reflecting OAH basement influence on canyon morphology. This erosional fabric may reflect joint/fracture patterns in the sedimentary strata that follow the basement trends. Once the canyons have eroded down to more erosion-resistant levels, channel downcutting slows relative to lateral erosion of the canyon walls. This accounts for the change from a narrow canyon axis in the thickly sedimented forearc basin to a wider, more rugged canyon morphology near the OAH. About 9500 km³ of sediment has been eroded from the central, 200 km long, segment of the Izu-Bonin forearc by the formation of Aoga Shima, Myojin Sho and Sumisu Jima canyons. The volume of sediment presently residing in the adjacent trench, accretionary wedge, and lower slope terrace basin accounts for <25% of that eroded from the canyons alone. This implies that a large volume (>3500 km³ per 100 km of trench, ignoring sediments input via forearc bypassing) has been subducted beneath the toe of the trench slope and the small accretionary prism. Unless this sediment has been underplated beneath the forearc, it has recycled arc material into the mantle, possibly influencing the composition of arc volcanism.     

The Regional Ocean Modeling System (ROMS) 4-dimensional variational data assimilation systems: Part II - Performance and application to the California Current System

The Regional Ocean Modeling System (ROMS) 4-dimensional variational (4D-Var) data assimilation systems have been systematically applied to the mesoscale circulation environment of the California Current to demonstrate the performance and practical utility of the various components of ROMS 4D-Var. In particular, we present a comparison of three approaches to 4D-Var, namely: the primal formulation of the incremental strong constraint approach; the dual formulation “physical-space statistical analysis system”; and the dual formulation indirect representer approach. In agreement with theoretical considerations all three approaches converge to the same ocean circulation estimate when using the same observations and prior information. However, the rate of convergence of the dual formulation was found to be inferior to that of the primal formulation. Other aspects of the 4D-Var performance that relate to the use of multiple outer-loops, preconditioning, and the weak constraint are also explored. A systematic evaluation of the impact of the various components of the 4D-Var control vector (i.e. the initial conditions, surface forcing and open boundary conditions) is also presented. It is shown that correcting for uncertainties in the model initial conditions exerts the largest influence on the ability of the model to fit the available observations. Various important diagnostics of 4D-Var are also examined, including estimates of the posterior error, the information content of the observation array, and innovation-based consistency checks on the prior error assumptions. Using these diagnostic tools, we find that more than 90% of the observations assimilated into the model provide redundant information. This is a symptom of the large percentage of satellite data that are used and to some extent the nature of the data processing employed. This is the second in a series of three papers describing the ROMS 4D-Var systems.     

Encounter norms, social carrying capacity indicators, and standards of quality at a marine protected area

This article examines visitors’ normative acceptance of encounters with boats at a marine protected area and the extent that the number of boats, size of boats, and size of boat on which individuals were traveling influences these encounter norms. Data were obtained from a survey of 439 people visiting Molokini Shoal Marine Life Conservation District in Hawai’i, and photographs depicting four levels of boat use and three proportions of boat size measured encounter norms. Number of boats most strongly influenced encounter norms, boat size was less influential, and the size of boats on which respondents were traveling had little influence. Visitors wanted fewer boats at this site and a majority would not accept encountering more than 15 or 16 boats at one time. When the impact of boat size was considered, they would not accept encountering more than 12 large boats to 17 small boats. Implications for future research and managing standards of quality and social carrying capacity indicators at this marine protected area are discussed.     

Thermal history of the unsaturated zone at Yucca Mountain,Nevada, USA

Secondary calcite, silica and minor amounts of fluorite deposited in fractures and cavities record the chemistry, temperatures, and timing of past fluid movement in the unsaturated zone at Yucca Mountain, Nevada, the proposed site of a high-level radioactive waste repository. The distribution and geochemistry of these deposits are consistent with low-temperature precipitation from meteoric waters that infiltrated at the surface and percolated down through the unsaturated zone. However, the discovery of fluid inclusions in calcite with homogenization temperatures (T_h) up to ∼80 °C was construed by some scientists as strong evidence for hydrothermal deposition. This paper reports the results of investigations to test the hypothesis of hydrothermal deposition and to determine the temperature and timing of secondary mineral deposition. Mineral precipitation temperatures in the unsaturated zone are estimated from calcite- and fluorite-hosted fluid inclusions and calcite δ¹⁸O values, and depositional timing is constrained by the ²⁰⁷Pb/²³⁵U ages of chalcedony or opal in the deposits. Fluid inclusion T_h from 50 samples of calcite and four samples of fluorite range from ∼35 to ∼90 °C. Calcite δ¹⁸O values range from ∼0 to ∼22‰ (SMOW) but most fall between 12 and 20‰. The highest T_h and the lowest δ¹⁸O values are found in the older calcite. Calcite T_h and δ¹⁸O values indicate that most calcite precipitated from water with δ¹⁸O values between −13 and −7‰, similar to modern meteoric waters.     

Assessment of agricultural drought during crop-growing season in the Sudano–Sahelian region of Cameroon

Natural Hazards - Drought is a recurrent phenomenon in the Sudano–Sahelian region of Cameroon. However, it has received very little attention, especially, on its impacts on the growing season...     

Petrogenesis of late stage magmatism at Hold with Hope, East Greenland

The Myggbukta caldera complex and a swarm of basic dykes constitute the latest Tertiary magmatism in the Hold with Hope region, East Greenland. The Sr and Nd isotope ratios of these rocks show coherent variations which extend to high ⁸⁷Sr/⁸⁶Sr and low ¹⁴³Nd/¹⁴⁴Nd values and require a contribution from continental lithosphere. Broad correlations with major element differentiation indices suggest that the continental component was incorporated during magmatic differentiation thereby favouring a crustal contamination process. Trace element concentrations are strongly correlated with isotopic compositions but display ranges for many incompatible elements which extend beyond likely crustal contaminant compositions. This is readily modelled by AFC processes in which the dominant cause of trace element enrichment is the concentration effect of fractional crystallisation rather than the composition of the contaminant. The simplest such models still require unrealistically high degrees of fractional crystallisation to explain the ten-fold enrichment of some trace elements. This can be overcome if the primary magmas entering the crust already had highly variable trace element compositions. Such variability is readily achieved if melts from different parts of the melting column escape without thorough homogenization. An AFC model which incorporates variability in parental magma composition is then able to simulate the range of compositions observed at Hold with Hope. This carries the implication that the variations observed are more readily attributed to changes in uncontaminated parental magma than to variations in the composition or amount of contaminant. Received: 5 March 1998 / Accepted: 16 June 1998     

Revised age of proximal deposits in the Zagros foreland basin and implications for Cenozoic evolution of the High Zagros

The regionally extensive, coarse-grained Bakhtiyari Formation represents the youngest synorogenic fill in the Zagros foreland basin of Iran. The Bakhtiyari is present throughout the Zagros fold-thrust belt and consists of conglomerate with subordinate sandstone and marl. The formation is up to 3000 m thick and was deposited in foredeep and wedge-top depocenters flanked by fold-thrust structures. Although the Bakhtiyari concordantly overlies Miocene deposits in foreland regions, an angular unconformity above tilted Paleozoic to Miocene rocks is expressed in the hinterland (High Zagros).

The Bakhtiyari Formation has been widely considered to be a regional sheet of Pliocene–Pleistocene conglomerate deposited during and after major late Miocene–Pliocene shortening. It is further believed that rapid fold growth and Bakhtiyari deposition commenced simultaneously across the fold-thrust belt, with limited migration from hinterland (NE) to foreland (SW). Thus, the Bakhtiyari is generally interpreted as an unmistakable time indicator for shortening and surface uplift across the Zagros. However, new structural and stratigraphic data show that the most-proximal Bakhtiyari exposures, in the High Zagros south of Shahr-kord, were deposited during the early Miocene and probably Oligocene. In this locality, a coarse-grained Bakhtiyari succession several hundred meters thick contains gray marl, limestone, and sandstone with diagnostic marine pelecypod, gastropod, coral, and coralline algae fossils. Foraminiferal and palynological species indicate deposition during early Miocene time. However, the lower Miocene marine interval lies in angular unconformity above ~ 150 m of Bakhtiyari conglomerate that, in turn, unconformably caps an Oligocene marine sequence. These relationships attest to syndepositional deformation and suggest that the oldest Bakhtiyari conglomerate could be Oligocene in age.

The new age information constrains the timing of initial foreland-basin development and proximal Bakhtiyari deposition in the Zagros hinterland. These findings reveal that structural evolution of the High Zagros was underway by early Miocene and probably Oligocene time, earlier than commonly envisioned. The age of the Bakhtiyari Formation in the High Zagros contrasts significantly with the Pliocene–Quaternary Bakhtiyari deposits near the modern deformation front, suggesting a long-term (> 20 Myr) advance of deformation toward the foreland.     

Transient soil response in a porous seabed with variable permeability

The soil permeability of many natural marine sediments decreases with depth because of consolidation under overburden pressure. This is accompanied by a decrease in porosity and void ratio that also affect the permeability. Conventional theories for wave-induced soil response have assumed a homogeneous porous seabed. This paper presents a new approach for the wave-induced response in a soil matrix, with variable permeability as a function of burial depth. The soil matrix considered is unsaturated and anisotropic, and is subject to a three-dimensional wave system. The pore pressure and effective stresses induced by such a system are obtained from a set of equations incorporating a variable permeability. Verification is available through reduction to the simple case of uniform permeability. The results indicate that the effect of variable soil permeability on pore pressure and vertical effective stress may be significant, especially in a gravelled seabed and for unsaturated sandy soils.