Reproductive biology of Diopatra neapolitana (Annelida,Onuphidae), an exploited natural resource in Ria de Aveiro (Northwestern Portugal)

Diopatra neapolitana Delle Chiaje, 1841 (Annelida, Onuphidae) is an important economic natural resource in Ria de Aveiro (northwestern coast of Portugal) and throughout Europe. The species is intensively harvested for use as fresh bait. However, there is only limited knowledge about its life cycle derived from a previous study in Mediterranean Sea. Reproduction and development patterns are known to vary biogeographically, making it important to base management decisions on locally appropriate information. This work examines reproduction patterns for populations from the Eastern Atlantic, which have not previously been assessed, with an eye towards drawing Atlantic–Mediterranean comparisons and informing local management strategies. The study was conducted from May 2007 to April 2009 in Ria de Aveiro. The reproductive biology of D. neapolitana was described from the proportional variation of worms with gametes in the coelom and from the progression of the oocyte diameter. Individuals with gametes inside the coelom were found all year round, but the peak reproductive period occurred between May and August, when almost all individuals had gametes in the coelom and females contained more oocytes than at any other time of the year. The overall male:female ratio was close to 1:1 and the oocyte diameter ranged from 40 to 240 μm. In vitro fertilization was performed and the results compared to other studies. Based on the present results, some protection measures are suggested to implement a sustainable exploitation of the species.     

Classification of washover dynamics in barrier islands

This study systematically classifies washover dynamics with reference to coastal changes along the Ria Formosa barrier islands (Southern Portugal). Identification of washovers using a sequence of 11 sets of aerial photographs dated between 1947 and 2001 allowed a classification to be developed based on: (1) overwash evolution (increasing, decreasing, or constant overwash processes); (2) the mechanisms promoting washover formation (exceptional to infrequent oceanographic conditions, washout processes, structural erosion, inlet dynamics, and human interventions); and (3) the mechanisms promoting washover cessation (berm development, structural erosion, dune development, inlet dynamics, and human interventions). A total of 369 different washovers were observed along the Ria Formosa barriers during the study period, with 209 washovers being formed in various types of dune morphology and 303 being obliterated. The number of washovers was relatively stable from 1947 to 1972, and increased dramatically between 1972 and 1976 probably as a result of the development of immature inlet margins and downdrift starvation. From 1976 to 2001, washover occurrences declined and their spatial dimensions decreased, leading to a decrease in overwash activity over this time. Overall, the dominant formation mechanisms of washovers in the Ria Formosa were inlet dynamics (accounting for 57% of washovers formed) and structural erosion (20%), with human intervention mechanisms accounting for 12%. The cessation of washovers was dominated by dune development (33% of the washovers obliterated) followed by inlet dynamics (24%) and structural erosion (19%), while human intervention mechanisms accounted for 13%. The classification should be of use for the coastal management of barrier systems including the definition of overwash-prone areas and the determination of the relative importance of the mechanisms contributing to washover formation and cessation.     

Utility of an Automated Thermal-Based Approach for Monitoring Evapotranspiration

A very simple remote sensing-based model for water use monitoring is presented. The model acronym DATTUTDUT (Deriving Atmosphere Turbulent Transport Useful To Dummies Using Temperature) is a Dutch word which loosely translates as “it’s unbelievable that it works”. DATTUTDUT is fully automated and only requires a surface temperature map, making it simple to use and providing a rapid estimate of spatially-distributed fluxes. The algorithm is first tested over a range of environmental and land-cover conditions using data from four short-term field experiments and then evaluated over a growing season in an agricultural region. Flux model output is in satisfactory agreement with observations and established remote sensing-based models, except under dry and partial canopy cover conditions. This suggests that DATTUTDUT has utility in identifying relative water use and as an operational tool providing initial estimates of ET anomalies in data-poor regions that would be confirmed using more robust modeling techniques.     

Estuarine shoreline processes in a dynamic low-energy system

Estuarine shorelines are often classified as low-energy coasts and are, therefore, expected to undergo little variation. Port Stephens (SE Australia) is a ria-like drowned river valley microtidal estuary located on a wave-dominated coast. The outer part of the estuary is tide-dominated and has a large shallow flood-tide delta, which is also affected by waves. The northern (predominantly low-energy) shoreline of outer Port Stephens is a continuous stretch of sand comprising areas of high mobility and areas of relative stability terminating in a western extending sand spit. This paper investigates the effects of periodic high-energy conditions during which waves penetrate into the estuary by analysing two types of storms, low to moderate (more frequent type) storms and severe to extreme (low frequency) storms. It is established that low to moderate storms cause generalised erosion over the northern shoreline. On the contrary, severe to extreme storms, while causing erosion on parts of the beach, can transport new sediment across the flood-tide delta and deposit it to build a mobile shore attached sandwave. Long-term (decadal) trends identified in the study area are in agreement with short- and medium-term results. Moving into the estuary are four complementary zones of sediment transport which include: (1) sandwave formation and westward migration; (2) a relatively stable area between the sandwave and an erosion zone; (3) an erosion zone undergoing shoreline retreat and finally (4) a depositional terminus causing westward extension of the sand spit.     

Earthquake dynamics on circular faults: a review 1970–2015

We review the development of earthquake dynamics taken from the point of view of the origin of seismic radiation instead of the detailed study of rupture propagation on complex surfaces. Many features of seismic radiation can be explained by simple models that serve as elementary canonical problems. Some of these properties are very well known like the fact that at low frequencies, the seismic spectrum is proportional to the seismic moment. At high frequencies, on the other hand, radiation is generated by the motion of the rupture front, in particular stopping phases and geometrical obstacles (barriers). A rupture front moving at constant speed does not produce far-field radiation. For many practical applications, for determining source size and stress drop, for example, it is not necessary to determine geometrical details of the rupture. For such cases, a simple circular crack model is quite sufficient. An improvement on this method is to do dynamic inversion on simple, elliptical-shaped sources and letting the rupture start arbitrarily from a point on the fault. This problem can be solved nowadays with finite differences and a variety of inversion techniques.     

Exploring large wood retention and deposition in contrasting river morphologies linking numerical modelling and field observations

Large wood tends to be deposited in specific geomorphic units within rivers. Nevertheless, predicting the spatial distribution of wood deposits once wood enters a river is still difficult because of the inherent complexity of its dynamics. In addition, the lack of long‐term observations or monitored sites has usually resulted in a rather incomplete understanding of the main factors controlling wood deposition under natural conditions. In this study, the deposition of large wood was investigated in the Czarny Dunajec River, Polish Carpathians, by linking numerical modelling and field observations so as to identify the main factors influencing wood retention in rivers. Results show that wood retention capacity is higher in unmanaged multi‐thread channels than in channelized, single‐thread reaches. We also identify preferential sites for wood deposition based on the probability of deposition under different flood scenarios, and observe different deposition patterns depending on the geomorphic configuration of the study reach. In addition, results indicate that wood is not always deposited in the geomorphic units with the highest roughness, except for low‐magnitude floods. We conclude that wood deposition is controlled by flood magnitude and the elevation of flooded surfaces in relation to the low‐flow water surface. In that sense, the elevation at which wood is deposited in rivers will differ between floods of different magnitude. Therefore, together with the morphology, flood magnitude represents the most significant control on wood deposition in mountain rivers wider than the height of riparian trees. Copyright © 2015 John Wiley & Sons, Ltd.