Controlled experiment in the ionosphere with a rocket-borne plasma gun

A controlled active experiment was performed by a plasma gun on-board a rocket to study the plasma stream across the magnetic field in space. A mother and daughter system was employed. An 8 kV 0.8 μF (25 J) capacitor bank on the daughter rocket was discharged every 12 s and about 10¹⁶ ion and electron pairs were ejected. A plasma signal was detected on the electron temperature probe. The propagation speed of the plasma stream is estimated to be 10⁶ cm/s, considerably lower than that obtained in the prelaunch test. The amplitude of the plasma signal decays as the inverse square of the mutual distance between the mother and daughter rockets and this decay is much slower than the free streaming. The importance of the geomagnetic field on the plasma propagation in space is discussed.     

Bedrock structure in Adapazari, Turkey—a possible cause of severe damage by the 1999 Kociaeli earthquake

The 1999 Kocaeli earthquake brought serious damage to downtown of Adapazari. To study why strong motions were generated at the town, a bedrock structure was investigated on the basis of Bouguer gravity anomaly, and SPAC and H/V analyses of microseisms. It was revealed that, the basin consists of three narrow depressions of bedrock with very steep edges, extending in E–W or NE–SW directions along the North Anatolia faults, and the depth to bedrock reaches 1000 m or more. Downtown of Adapazari is located 1–2 km apart from the basin-edge. It is considered that, the specific configuration of bedrock amplifies ground motions at the downtown area by focusing of seismic waves and/or interference between incident S-waves and surface-waves secondarily generated at the basin-edge. Studying 3D bedrock structure is an urgent issue for microzoning an urban area in a sedimentary basin.     

Deep structure of the northeastern Japan arc and its implications for crustal deformation and shallow seismic activity

Seismic tomography studies in the northeastern Japan arc have revealed the existence of an inclined sheet-like seismic low-velocity and high-attenuation zone in the mantle wedge at depths shallower than about 150 km. This sheet-like low-velocity, high-attenuation zone is oriented sub-parallel to the subducted slab, and is considered to correspond to the upwelling flow portion of the subduction-induced convection. The low-velocity, high-attenuation zone reaches the Moho immediately beneath the volcanic front (or the Ou Backbone Range) running through the middle of the arc nearly parallel to the trench axis, which suggests that the volcanic front is formed by this hot upwelling flow. Aqueous fluids supplied by the subducted slab are probably transported upward through this upwelling flow to reach shallow levels beneath the Backbone Range where they are expelled from solidified magma and migrate further upward. The existence of aqueous fluids may weaken the surrounding crustal rocks, resulting in local contractive deformation and uplift along the Backbone Range under the compressional stress field of the volcanic arc. A strain-rate distribution map generated from GPS data reveals a notable concentration of east–west contraction along the Backbone Range, consistent with this interpretation. Shallow inland earthquakes are also concentrated in the upper crust of this locally large contraction deformation zone. Based on these observations, a simple model is proposed to explain the deformation pattern of the crust and the characteristic shallow seismic activity beneath the northeastern Japan arc.     

U-Pb and Pb-Pb ages of zircons from basaltic eucrites: Implications for early basaltic volcanism on the eucrite parent body

We have undertaken petrologic and SHRIMP U-Th-Pb isotopic studies on zircons from basaltic eucrites (Yamato [Y]-75011, Y-792510, Asuka [A]-881388, A-881467 and Padvarninkai) with different thermal and shock histories. Eucritic zircons are associated with ilmenite in most cases and have subhedral shapes in unmetamorphosed and metamorphosed eucrites. Some zircons in highly metamorphosed eucrites with granulitic texture occur alone in pyroxene, and typically have rounded to subrounded shapes due to recrystallization. Superchondritic Zr/Hf ratios of eucritic zircons indicate that they crystallized from incompatible element-rich melts after crystallization of ilmenite. Concentrations of uranium and thorium in zircons in the unmetamorphosed eucrite Y-75011 are higher than those in metamorphosed eucrites.The U-Pb systems of eucritic zircons are almost concordant but some zircon grains show reverse discordance. Radiogenic lead-loss up to 48% from zircons is observed in the shock-melted eucrite Padvarninkai. The ²⁰⁷Pb-²⁰⁶Pb ages of zircon in Y-75011 (4550 ± 9 Ma, n = 5) are nearly identical, within analytical uncertainty, to the ages of zircons from the metamorphosed eucrite Y-792510 (4545 ± 15 Ma, n = 13), the highly metamorphosed eucrites A-881388 (4555 ± 54 Ma, n = 5) and A-881467 (4558 ± 13 Ma, n = 8), and the shock-melted eucrite Padvarninkai (4555 ± 13 Ma, n = 18). The averaged ²⁰⁷Pb-²⁰⁶Pb age of zircon from five eucrites analyzed in this study is 4554 ± 7 Ma (95% confidence limits, n = 49), indistinguishable from the averaged U-Pb age (4552 ± 9 Ma) of the same samples. Because of the high closure temperature of lead in zircon (T_closure = ∼1050°C with a cooling rate of 0.2°C/yr), the ²⁰⁷Pb-²⁰⁶Pb ages of eucritic zircon do not represent metamorphic ages but crystallization ages of extrusive lavas.This fact strongly suggests that volcanism of the eucrite parent body occurred at a very early stage of the Solar System history, 7-20 Ma after CAI formation (4567.2 ± 0.6 Ma), thus basaltic eucrites crystallized from parental magmas within a short interval following the differentiation of their parent body. The U-Pb ages of eucritic zircons are older than the U-Pb, Sm-Nd and Rb-Sr ages of some basaltic eucrites, which is consistent with differences in closure temperatures of each isotopic system, and suggests that thermal and shock metamorphism affected the isotopic systems of pyroxene, plagioclase and phosphates.     

Fluid Inclusion Study and Opaque Mineral Assemblage at the Deep and Shallow Part of the Batu Hijau Porphyry Copper-gold Deposit, Sumbawa, Indonesia

The Batu Hijau deposit is the only porphyry type deposit in production in the Sunda‐Banda arc, Indonesia. This study discusses the reason for the localization of copper grade at the deep part of the deposit based on the observation of opaque mineral assemblage. In addition, the formation condition of quartz veins and opaque minerals is discussed on the basis of the fluid inclusion microthermometry. Samples were selected from drill holes SBD100, SBD168, SBD194, SBD254, and SBD257 to cover the wide vertical range. At the Batu Hijau deposit, quartz veins have been classified mainly into four types called A, B, C and D veins, and the A veins contain mainly bornite, often associated with digenite and chalcocite. In addition, magnetite occurs in A veins. However, at the deep part of the deposit, there are quartz veins associated with magnetite, but few copper sulfides such as bornite and chalcopyrite in quartz veins, as observed in SBD257. Quartz veins at depth in SBD257 have abundant magnetite and pyrite. Pyrite in quartz veins at depth in SBD257 mainly occur at the rim of magnetite grains or interstices between them. In quartz veins in SBD254, there are abundant copper sulfides such as bornite and chalcopyrite in spite of the depth. Bornite and chalcopyrite occur as inclusions in magnetite grains in quartz veins in SBD254. Pyrite which often occurs in low grade zone in quartz veins in SBD254 is also recognized at the rims of copper sulfides. This indicates that pyrite in SBD257 and SBD254 formed later than magnetite. On the other hand, blebs of bornite and chalcopyrite inclusions in magnetite grains, which are recognized in quartz veins in SBD168 at shallow high grade part, suggest that the hydrothermal fluid, from which magnetite was deposited also brought the copper sulfides such as bornite and chalcopyrite to the deep part of the Batu Hijau deposit. Therefore, it is concluded that initially the high grade ore zone extended to depth without localization. However due to the later overprinting hydrothermal activity, copper sulfides and magnetite were replaced or dissolved and pyrite was formed, resulting the low grade zone at the deep part of the deposit. Dissolution temperatures (Td) of halite obtained by from fluid inclusion microthermometry show significant differences between SBD168 and other drill holes. The high Td obtained in SBD168 may indicate larger volume of NaCl crystals in hydrothermal fluid at the time of entrapment of the fluid inclusions and formation of other opaque minerals such as magnetite and copper‐iron sulfides. It suggests that the ratio of vapor to brine is also higher at the shallow part of the deposit. The higher vapor to brine ratio may suggest a higher degree of boiling. Removal of vapor phase separated from brine during boiling increases the concentration of substances dissolved in the brine, and this will result in saturation, as evidenced by the salinity and NaCl saturation. The higher degree of boiling suggested by the higher vapor to brine ratio at shallow part may have increased the copper concentration in the brine that may have lead the saturation, resulted in the deposition of copper‐bearing minerals.     

地质聚合物技术的发展近况

概要介绍了一种无机聚合物———地质聚合物。首先对地质聚合物材料的制备过程作了介绍。根据原料的不同,地质聚合物材料的制备可以有两种途径:一种是以偏高岭石为基础原料,一种是以粉煤灰为主要原料。通常以硅酸钠水溶液作为单体硅源,氢氧化钠溶液作为碱激发剂以提高原料的溶出性。对某些在常温和低于100 ℃下制备的独石材料作了介绍。对煅烧高岭石,叶蜡石,粉煤灰和钢渣的溶出特性作了阐述。应用SEM EDX,对以粉煤灰为原料的地质聚合物材料的化学组成作了分析。最后对地质聚合物材料的经济性以及在环境保护等领域的应用前景,特别是在减少二氧化碳排放与废弃物处理方面的意义作了介绍。     

Metallogenesis of Porphyry Cu Deposits of the Western Luzon Arc, Philippines: K-Ar ages, SO3 Contents of Microphenocrystic Apatite and Significance of Intrusive Rocks

Abstract: K–Ar ages of the following porphyry Cu deposits in the western Luzon arc are determined: Lobo-Boneng (10.50.4 Ma), Santo Niño (9.50.3 Ma), Black Mountain (2.10.1 Ma), Dizon (2.50.2 Ma) and Taysan (7.30.2 Ma). Microphenocrys-tic apatite in the late Cenozoic intermediate to silicic intrusions associated with porphyry Cu deposits in the western Luzon arc contains sulfur as SO₃ detectable by electron probe microanalyzer. Sulfur is supposed to have been accommodated dominantly as oxidized species in oxidizing hydrous magmas that generated porphyry Cu deposits. Likewise, such high SO₃ contents in microphenocrystic apatite are common characteristics of the intermediate to silicic magmatism of the western Luzon arc, from tonalitic rocks of the Luzon Central Cordillera of about 15 Ma to an active magmatism at Mount Pinatubo. Thus, the western Luzon arc has been generating porphyry Cu mineralization associated with oxidizing hydrous intermediate to silicic magmatism related to eastward subduction, since Miocene to the present day. Intermediate to silicic rocks since 15 Ma to present-day western Luzon arc generally show high whole-rock Sr/Y ratio ranging from 20 to 184. However, porphyry Cu deposit is not necessarily related to the rocks that show higher Sr/Y ratios compared to the other barren rocks in the western Luzon arc. The characteristics of the intermediate to silicic magma associated with porphyry Cu deposit are not attributed to the composition of the source material of the magma, but to the properties defined by the high activity of oxidized species of sulfur in the fluid phase that is encountered during the generation of intermediate to silicic magmas.     

Sulfur Isotopic Study of the Toyoha Deposit, Hokkaido, Japan Comparison between the Earlier-Stage and the Later-Stage Veins

Abstract: The sulfur isotopic ratios (δ³⁴S) of ore minerals from the Toyoha deposit, Hokkaido, one of the largest Pb–Zn–Ag polymetallic vein-type deposits in Japan, were studied. More than 90% of the δ³⁴S values of the studied sulfide minerals collected from the Toyoha deposit range from +5 to +9%, with an average of approximately +7% irrespective of the mineral species, veins, elevations, depth, mineralization stages and mineral assemblages. Relatively uniform δ³⁴S values obtained in this study suggest that the reduced aqueous sulfur species predominated over the oxidized sulfur in the ore solution throughout the mineralization stages. Thus, the source of sulfur for the ore sulfides is postulated to be magmatic.
The temperature obtained from the fluid inclusion study and the temperature of the sulfur isotopic geothermometer are not consistent. This suggests that each mineral precipitated under disequilibrated conditions with respect to the sulfur isotope.
The change in redox conditions presumably encountered between the mineralization stages did not account for the isotopic fluctuations since the isotopic exchanges between the oxidized and reduced aqueous sulfurs are much slower than the rate of oxidation of the ore solution.