Low-pressure,water-assisted anatexis of basic dykes in a contact metamorphic aureole,Fuerteventura (Canary Islands): oxygen isotope evidence for a meteoric fluid origin

Migmatites produced by low-pressure anatexis of basic dykes are found in a contact metamorphic aureole around a pyroxenite–gabbro intrusion (PX2), on Fuerteventura. Dykes outside and inside the aureole record interaction with meteoric water, with low or negative δ¹⁸O whole-rock values (+0.2 to −3.4‰), decreasing towards the contact. Recrystallised plagioclase, diopside, biotite and oxides, from within the aureole, show a similar evolution with lowest δ¹⁸O values (−2.8, −4.2, −4.4 and −7.6‰, respectively) in the migmatite zone, close to the intrusion. Relict clinopyroxene phenocrysts preserved in all dykes, retain typically magmatic δ¹⁸O values up to the anatectic zone, where the values are lower and more heterogeneous. Low δ¹⁸O values, decreasing towards the intrusion, can be ascribed to the advection of meteoric water during magma emplacement, with increasing fluid/rock ratios (higher dyke intensities towards the intrusion acting as fluid-pathways) and higher temperatures promoting increasing exchange during recrystallisation. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Silicon isotope fractionation in bamboo and its significance to the biogeochemical cycle of silicon

A systematic investigation on silica contents and silicon isotope compositions of bamboos was undertaken. Seven bamboo plants and related soils were collected from seven locations in China. The roots, stem, branch and leaves for each plant were sampled and their silica contents and silicon isotope compositions were determined. The silica contents and silicon isotope compositions of bulk and water-soluble fraction of soils were also measured. The silica contents of studied bamboo organs vary from 0.30% to 9.95%. Within bamboo plant the silica contents show an increasing trend from stem, through branch, to leaves. In bamboo roots the silica is exclusively in the endodermis cells, but in stem, branch and leaves, the silica is accumulated mainly in epidermal cells. The silicon isotope compositions of bamboos exhibit significant variation, from −2.3‰ to 1.8‰, and large and systematic silicon isotope fractionation was observed within each bamboo. The δ³⁰Si values decrease from roots to stem, but then increase from stem, through branch, to leaves. The ranges of δ³⁰Si values within each bamboo vary from 1.0‰ to 3.3‰. Considering the total range of silicon isotope composition in terrestrial samples is only 7‰, the observed silicon isotope variation in single bamboo is significant and remarkable. This kind of silicon isotope variation might be caused by isotope fractionation in a Rayleigh process when SiO₂ precipitated in stem, branches and leaves gradually from plant fluid. In this process the Si isotope fractionation factor between dissolved Si and precipitated Si in bamboo (α_pre-sol) is estimated to be 0.9981. However, other factors should be considered to explain the decrease of δ³⁰Si value from roots to stem, including larger ratio of dissolved H₄SiO₄ to precipitated SiO₂ in roots than in stem. There is a positive correlation between the δ³⁰Si values of water-soluble fractions in soils and those of bulk bamboos, indicating that the dissolved silicon in pore water and phytoliths in soil is the direct sources of silicon taken up by bamboo roots. A biochemical silicon isotope fractionation exists in process of silicon uptake by bamboo roots. Its silicon isotope fractionation factor (α_bam-wa) is estimated to be 0.9988. Considering the distribution patterns of SiO₂ contents and δ³⁰Si values among different bamboo organs, evapotranspiration may be the driving force for an upward flow of a silicon-bearing fluid and silica precipitation. Passive silicon uptake and transportation may be important for bamboo, although the role of active uptake of silicic acid by roots may not be neglected. The samples with relatively high δ³⁰Si values all grew in soils showing high content of organic materials. In contrast, the samples with relatively low δ³⁰Si values all grew in soil showing low content of organic materials. The silicon isotope composition of bamboo may reflect the local soil type and growth conditions. Our study suggests that bamboos may play an important role in global silicon cycle.     

Atomistic simulation of the mechanisms of noble gas incorporation in minerals

Atomistic simulations have been carried out to investigate the mechanisms of noble gas incorporation in minerals using both the traditional two-region approach and the “supercell” method. The traditional two-region approach has been used to calculate defect energies for Ne, Ar, Kr and Xe incorporation in MgO, CaO, diopside and forsterite in the static limit and at one atmosphere pressure. The possibilities of noble gas incorporation via both substitution and interstitial mechanisms are studied. The favored mechanism varies from mineral to mineral and from noble gas to noble gas. In all minerals studied, the variation of the solution energies of noble gas substitution with atomic radius appears approximately parabolic, analogous to those for 1⁺, 2⁺, 3⁺ and 4⁺ trace element incorporation on crystal lattice sites. Noble gas solution energies thus also fall on a curve, similar to those previously observed for cations with different charges, but with much lower curvature.The “supercell” method has been used to investigate the pressure dependence of noble gas incorporation in the same systems. Results indicate a large variation of the solubility of the larger noble gases, Kr and Xe with pressure. In addition, explicit simulation of incorporation at the (0 0 1) surface of MgO shows that the solubility of the heavier noble gases may be considerably enhanced by the presence of interfaces.     

Surface evolution of dissolving minerals investigated with a kinetic Ising model

In natural weathering systems, both the chemistry and the topography of mineral surfaces change as rocks and minerals equilibrate to surface conditions. Most geochemical research has focused on changes in solution chemistry over time; however, temporal changes in surface topography may also yield information about rates and mechanisms of dissolution. We use stochastic dissolution simulations of a regular 2-D lattice with reaction mechanisms defined in terms of nearest neighbor interactions to elucidate how the surface area and reactivity of a crystal evolve during dissolution. Despite the simplicity of the model, it reproduces key features observed or inferred for mineral dissolution. Our model results indicate that: (i) dissolving surfaces reach a steady-state conformation after sufficient dissolution time, (ii) linear defects cause surface area and dissolution rate to vary in concert with one another, (iii) sigmoidal and non-sigmoidal rate vs. free-energy of reaction (ΔG_rxn) behavior can be rationalized in terms of the multiple steps occurring during dissolution, and (iv) surface roughness as a function of ΔG_rxn is highly sensitive to the reaction mechanism. When simulated times to reach steady-state are compared to published time series rate data using suitable scaling, good agreement is found for silicate minerals while the model significantly over-predicts the duration of the transient for Fe and Al oxides. The implication of our simple model is that many aspects of mineral dissolution behavior, including approach to steady-state, sigmoidal vs. non-sigmoidal rate vs. ΔG_rxn behavior, and development of rougher surfaces in conditions further from equilibrium can be explained by nearest neighbor interactions and simple Kossel-type models where reactivity of a surface is defined in terms of perfect surface, step, and kink sites.     

Lateral structural variability in zone of eocene island-arc-continent collision,Kamchatka

The lateral variability of structural elements in the collision zone of the Cretaceous-Paleocene Achaivayam-Valagin island arc with the northeastern Asian margin is considered. The similarity and difference of Eocene collision structural elements in the north and the south of Kamchatka are shown. In northern Kamchatka, the continent-arc boundary is traced along the Lesnaya-Vatyn Thrust Fault, which completed its evolution about 45 Ma ago. The thin, near-horizontal allochthon of this thrust, composed of island-arc rocks, overlies the deformed but unmetamorphosed terrigeneous sequences of the Asian margin. The general structure of this suture in the Kamchatka Isthmus and southern Koryakia is comparable with the uppermost subduction zone, where a thin lithospheric wedge overlaps intensely deformed sediments detached from the plunging plate. In southern Kamchatka (Malka Uplift of the Sredinny Range), the arc-continent collision started 55–53 Ma ago with thrusting of island-arc complexes over terrigenous rocks of continental margin. However, the thickness of the allochthon was much greater than in the north. Immediately after this event, both the autochthon and lower part of allochthon were deformed and subsided to a significant depth. This subsidence gave rise to metamorphism of both the autochthon (Kolpakov and Kamchatka groups, Kheivan Formation) and lower allochthon (Andrianovka and Khimka formations). The anomalously fast heating of the crust was most likely related to the ascent of asthenospheric masses due to slab breakoff, when the Eurasian Plate was plunging beneath the Achaivayam-Valagin arc.     

Late Precambrian rifting in the geological history of the western slope of the South Urals

The rift-related geodynamic setting of the Late Precambrian geological evolution on the western slope of the South Urals is reconstructed on the basis of localization of lithotectonic complexes of this age, their formation conditions, and the geochemistry of rocks. The Early Riphean stage comprises accumulation of coarse-clastic rocks intercalating with alkaline volcanic rocks of the Navysh Complex, which is a constituent of the Ai Formation, and emplacement of doleritic and picritic intrusions of the Shuida Complex and melanocratic dolerite and gabbrodolerite of the Yusha Complex. The Middle Riphean stage is characterized by wide-spread coarse-clastic terrigenous rocks of the Mashak Formation that intercalate with volcanic rocks of the bimodal basalt-rhyolite association, the Berdyaush pluton of rapakivi granite, the Kusa-Kopan layered intrusive complex, the Lapyshta Complex of dolerites and picrites, and numerous occurrences of gabbrodolerites. The terrigenous rocks of the Vendian stage include conglomerate, gravelstone, and sandstone of the Asha Group, while igneous rocks comprise alkaline volcanics of the Arsha Complex, alkali gabbroids of the Miseli Complex, and melanocratic syenite of the Avashla Complex. The geological evolution of the region is distinguished by local (failed or aborted) rifting. The occurrence of lithotectonic complexes is controlled by dynamic conditions of rifting. A certain inheritance in the evolution may be traced for the Early and Middle Riphean and partly for the Late Riphean and Vendian.     

Large and giant hydrocarbon accumulations in the transitional continent-ocean zone

The petroleum resource potential is considered for the Atlantic, West Pacific, and East Pacific types of deepwater continental margins. The most considerable energy resources are concentrated at the Atlantic-type passive margins in the zone transitional to the ocean. The less studied continental slope of backarc seas of the generally active margins of the West Pacific type is currently not so rich in discoveries as the Atlantic-type margin, but is not devoid of certain expectations. In some of their parameters, the margins bounded by continental slopes may be regarded as analogs of classical passive margins. At the margins of the East Pacific type, the petroleum potential is solely confined to transform segments. In the shelf-continental-slope basins of the rift and pull-apart nature, petroleum fields occur largely in the upper fan complex, and to a lesser extent in the lower graben (rift) complex. In light of world experience, the shelf-continental-slope basins of the Arctic and Pacific margins of Russia are evaluated as highly promising.     

Lateral protrusions in the structure of the Earth’s lithosphere

The factual material and modeling results concerning the geology of specific structural elements defined as lateral protrusions, or flowing layers, are considered. The formation of such structural elements is a fundamental phenomenon that controls many features of the structural evolution and geodynamics of platform basement and foldbelts. A lateral protrusion, or flowing layer, is a spatially constrained, nearly horizontal geological body with attributes of 3D tectonic flow (rheid deformation) and lateral transport of rock masses. Flowing layers are large lateral protrusions that play important role in the structure of the continental and oceanic lithosphere. They embody the internal mobility of huge rock bodies and confirm the possibility of their lateral redistribution at different depths of the continental lithosphere. The lateral displacement of rocks within such assemblies may occur in the regime of cold deformation, heating, metamorphism, and ductile flow of rocks under subsolidus conditions or in the process of their partial melting.     

Comparison of arsenic concentrations in simultaneously-collected groundwater and aquifer particles from Bangladesh,India, Vietnam,and Nepal

One of the reasons the processes resulting in As release to groundwater in southern Asia remain poorly understood is the high degree of spatial variability of physical and chemical properties in shallow aquifers. In an attempt to overcome this difficulty, a simple device that collects groundwater and sediment as a slurry from precisely the same interval was developed in Bangladesh. Recently published results from Bangladesh and India relying on the needle-sampler are augmented here with new data from 37 intervals of grey aquifer material of likely Holocene age in Vietnam and Nepal. A total of 145 samples of filtered groundwater ranging in depth from 3 to 36 m that were analyzed for As (1–1000 μg/L), Fe (0.01–40 mg/L), Mn (0.2–4 mg/L) and S (0.04–14 mg/L) are compared. The P-extractable (0.01–36 mg/kg) and HCl-extractable As (0.04–36 mg/kg) content of the particulate phase was determined in the same suite of samples, in addition to Fe(II)/Fe ratios (0.2–1.0) in the acid-leachable fraction of the particulate phase. Needle-sampler data from Bangladesh indicated a relationship between dissolved As in groundwater and P-extractable As in the particulate phase that was interpreted as an indication of adsorptive equilibrium, under sufficiently reducing conditions, across 3 orders of magnitude in concentrations according to a distribution coefficient of 4 mL/g. The more recent observations from India, Vietnam and Nepal show groundwater As concentrations that are often an order of magnitude lower at a given level of P-extractable As compared to Bangladesh, even if only the subset of particularly reducing intervals characterized by leachable Fe(II)/Fe >0.5 and dissolved Fe >0.2 mg/L are considered. Without attempting to explain why As appears to be particularly mobile in reducing aquifers of Bangladesh compared to the other regions, the consequences of increasing the distribution coefficient for As between the particulate and dissolved phase to 40 mL/g for the flushing of shallow aquifers of their initial As content are explored.     

Biofacies analysis of Upper Cretaceous deposits in the Ust-Yenisei region: Implications of palynomorphs

The results of palynomorph biofacies analysis in the Upper Cretaceous deposits of the Ust-Yenisei region are presented. The established facies confinement and indicative features of separate palynomorph groups are used, along with identified dinocyst morphotypes and taxa, in paleogeographic reconstructions. Seven palynomorph associations characterizing continental, coastal-marine, shallow-and deep-water facies are distinguished based on quantitative proportions between morphological groupings and individual taxa. As boundaries between distinguishable biostratigraphic and facies subdivisions do not coincide, dinocysts were likely insignificantly dependent in distribution on facies in the West Siberian epicontinental basin at least. On the other hand, distribution trends of particular dinocyst morphotypes and other microphytofossils are correlative with transgressive-regressive cycles and can be used for reconstruction of paleoenvironments.