Dense collection areas and terrestrial alteration of meteorites in the Atacama Desert

In the last 15 years, more than 2700 meteorites have been recovered and officially classified from the Atacama Desert. Although the number of meteorites collected in the Atacama has risen, the physical and climatic properties of the dense collection areas (DCAs) have not been fully characterized. In this article, we compiled the published data of all classified meteorites found in the Atacama Desert to (i) describe the distribution by meteorite groups, (ii) compare the weathering degree of chondrites among different Atacama DCAs and other hot and cold deserts, and (iii) determine the preservation conditions of chondrites in the main Atacama DCAs in relation with the local climatic conditions. The 35 DCAs so far identified in the Atacama Desert are located in three main morphotectonic units: The Coastal Range (CR), Central Depression (CD), and Pre-Andean Range/Basement. A comparison with reported weathering data from other cold and hot deserts indicates that the mean terrestrial weathering of Atacama chondrites (W1–2), displays less alteration than other hot deserts (W2–3) and resembles the weathering distribution of the Antarctic meteorites (W1–2). The highest abundance of Atacama chondrites with low weathering (≤W2) is localized in the CD (78.8%, N = 1435), which is protected from the coastal fog influence and seasonal rainfalls and displays the oldest surfaces in the Atacama Desert. The morphogenetic classification based on present-day temperatures and precipitations of the main Atacama DCAs reveals similar regional/subregional climatic conditions in the most productive areas and a truly productive surface for meteorite recovery between 5% and 58% of the quadrangles formally defined for each Atacama DCA. Our morphogenetic classification lacks consideration of some meteorological parameters such as the coastal fog, so it cannot fully explain the differences in weathering patterns among CR chondrites. Future studies of chondrite preservation in the Atacama DCAs should consider other meteorological variables such as relative humidity, specific humidity, or dew point, in combination with exposure ages of meteorites and its surfaces.     

Influence of storm-related sediment storage on the sediment delivery from tributary catchments in the upper Waipaoa River,New Zealand

Although much is known about overall sediment delivery ratios for catchments as components of sediment production and sediment yield, little is known about the component of temporary sediment storage. Sediment delivery ratios focused on the influence of storm-related sediment storage are measured at Matakonekone and Oil Springs tributaries of the Waipaoa River basin, east coast of New Zealand. The terrace deposits of both tributaries show abundant evidence of storm-related sedimentation, especially sediment delivered from Cyclone Bola, a 50 year return rainfall event which occurred in 1988. The sediment delivery ratio is calculated by dividing the volume of sediment transported from a tributary to the main stream by the volume of sediment generated at erosion sites in the tributary catchment. Because the sediment delivery volume is unknown, it can be calculated as the difference between sediment generation volume and sediment storage volume in the channel reach of the tributary. The volume of sediment generated from erosion sites in each tributary catchment was calculated from measurements made on aerial photographs dating from 1960 (1:44 000) and 1988 (1:27 000). The volume of sediment stored in the tributary can be calculated from measurements of cross-sections located along the tributary channel, which are accompanied by terrace deposits dated by counting annual growth rings of trees on terrace surfaces. Sediment delivery ratios are 0·93 for both Matakonekone catchment and Oil Springs catchment. Results indicate that Oil Springs catchment has contributed more than twice the volume of sediment to the Waipaoa River than the Matakonekone catchment (2·75 × 10⁶ m³ vs 1·22 × 10⁶ m³). Although large volumes of sediment are initially deposited during floods, subsequent smaller flows scour away much of these deposits. The sediment scouring rate from storage is 1·25 × 10⁴ m³ a⁻¹ for Matakonekone stream and 0·83 × 10⁴ m³ a⁻¹ for Oil Springs stream. Matakonekone and Oil Springs channels respond to extreme storms by instantaneously aggrading, then gradually excavating the temporarily stored sediment. Results from Matakonekone and Oil Springs streams suggest a mechanism by which event recurrence interval can strongly influence the magnitude of a geomorphic change. Matakonekone stream with its higher stream power is expected to excavate sediment deposits more rapidly and allow more rapid re-establishment of storage capacity. Copyright © 1999 John Wiley & Sons, Ltd.     

Volumetric strains in neutral surface folding

Neutral surface folding is a significant contributor to fold development. This mechanism produces contrasting strains in the inner and outer arcs of the folded layer that arise from principal stress orientations that are approximately parallel and perpendicular to the layer. We demonstrate that such stress patterns imply significant gradients of mean stress across the folding layer, being more tensional on the outer arc and more compressive in the inner arc. This could pump fluids towards the outer arc during folding and result in heterogeneous volume changes. We conclude that the neutral surface folding model should be adapted to accommodate volumetric strains, in order to explain dilatational structures (e.g. open fractures, veining) on the extrados and volume-loss structures (e.g. pressure solution seams, stylolitic cleavages) on the intrados. This dilatation has economic implications as it allows prediction of sites of mineralization and zones of secondary permeability in fold-related hydrocarbon traps.     

Hydrogen emissions from Erebus volcano, Antarctica

The continuous measurement of molecular hydrogen (H₂) emissions from passively degassing volcanoes has recently been made possible using a new generation of low-cost electrochemical sensors. We have used such sensors to measure H₂, along with SO₂, H₂O and CO₂, in the gas and aerosol plume emitted from the phonolite lava lake at Erebus volcano, Antarctica. The measurements were made at the crater rim between December 2010 and January 2011. Combined with measurements of the long-term SO₂ emission rate for Erebus, they indicate a characteristic H₂ flux of 0.03?kg s^–1 (2.8?Mg? day^–1). The observed H₂ content in the plume is consistent with previous estimates of redox conditions in the lava lake inferred from mineral compositions and the observed CO₂/CO ratio in the gas plume (～0.9 log units below the quartz–fayalite–magnetite buffer). These measurements suggest that H₂ does not combust at the surface of the lake, and that H₂ is kinetically inert in the gas/aerosol plume, retaining the signature of the high-temperature chemical equilibrium reached in the lava lake. We also observe a cyclical variation in the H₂/SO₂ ratio with a period of ～10?min. These cycles correspond to oscillatory patterns of surface motion of the lava lake that have been interpreted as signs of a pulsatory magma supply at the top of the magmatic conduit.     

Comparison of LiDAR waveform processing methods for very shallow water bathymetry using Raman,near‐infrared and green signals

Airborne light detection and ranging (LiDAR) bathymetry appears to be a useful technology for bed topography mapping of non‐navigable areas, offering high data density and a high acquisition rate. However, few studies have focused on continental waters, in particular, on very shallow waters (<2 m) where it is difficult to extract the surface and bottom positions that are typically mixed in the green LiDAR signal. This paper proposes two new processing methods for depth extraction based on the use of different LiDAR signals [green, near‐infrared (NIR), Raman] of the SHOALS‐1000T sensor. They have been tested on a very shallow coastal area (Golfe du Morbihan, France) as an analogy to very shallow rivers. The first method is based on a combination of mathematical and heuristic methods using the green and the NIR LiDAR signals to cross validate the information delivered by each signal. The second method extracts water depths from the Raman signal using statistical methods such as principal components analysis (PCA) and classification and regression tree (CART) analysis. The obtained results are then compared to the reference depths, and the performances of the different methods, as well as their advantages/disadvantages are evaluated. The green/NIR method supplies 42% more points compared to the operator process, with an equivalent mean error (?4·2 cm verusu ?4·5 cm) and a smaller standard deviation (25·3 cm verusu 33·5 cm). The Raman processing method provides very scattered results (standard deviation of 40·3 cm) with the lowest mean error (?3·1 cm) and 40% more points. The minimum detectable depth is also improved by the two presented methods, being around 1 m for the green/NIR approach and 0·5 m for the statistical approach, compared to 1·5 m for the data processed by the operator. Despite its ability to measure other parameters like water temperature, the Raman method needed a large amount of reference data to provide reliable depth measurements, as opposed to the green/NIR method. Copyright © 2010 John Wiley & Sons, Ltd.     

Dynamique et modélisation des crues dans le bassin du Mono à Nangbéto (Togo/Bénin)

Résumé

Les inondations des dernières années en Afrique de l’Ouest rendent nécessaire la prévision hydrologique pour réduire la vulnérabilité des populations. Nous avons étudié la dynamique des crues dans le bassin du Mono en amont du barrage de Nangbéto (Togo et Bénin) par des méthodes statistiques et déterministes. L’augmentation des précipitations au cours de la décennie 1990 et la mise en eau du barrage de Nangbéto en 1988 ont modifié le régime du Mono, dont les débits d’étiages ont augmenté. Les débits entrants et sortants du barrage sont équivalents, même lors des crues. Les maximums annuels des débits entrants peuvent être modélisés par une distribution des valeurs extrêmes (GEV) de type Fréchet, tandis que ceux des débits sortants, suivent une loi GEV de type Weibull (bornée). Le mécanisme dominant de génération des crues dans le bassin est la montée progressive des eaux associée à l’augmentation de la saturation des sols. L’analyse des débits de crue entre 1988 et 2010 n’a pas montré d’augmentation de la magnitude ou de la fréquence des crues. Le modèle GR4J reproduit bien les débits de crues en période calage, mais ces critères de performance se dégradent lorsque l’on s’en éloigne. Dans ces conditions, l’utilisation de ce modèle pour évaluer les risques futurs de crues serait hasardeuse et il est nécessaire d’envisager d’autres types d’approches.     

Quantifying internal variability in a regional climate model: a case study for Southern Africa

This study aims at presenting various methodologies to separate the reproducible and irreproducible components of seasonal and intraseasonal climate variability simulated by a regional climate model over Southern Africa (south of 15°S), during an austral summer rainy season representative of the climatology. To that end, a 30-member ensemble simulation is performed using WRF laterally forced by the ERA40 reanalyses. Retained metrics include the analysis of weather regimes, signal-to-noise ratio, inter-member standard deviation and coefficient of variation. At the seasonal timescale, simulated rainfall amounts generally show a strong reproducibility, except in the subtropics and over the southern part of the Mozambique Channel. There, the number of rainy days is roughly similar in all members, while their average intensity varies extensively. At the intraseasonal timescale, the chronology of weather regimes, derived from the 500?hPa geopotential height, is highly reproducible. Rainfall variability is much less reproducible, especially in the central parts of the domain and near its outflow boundaries. Analysis of a South African regional index nonetheless indicates that both wet and dry spells tend to be accurately simulated and occur in phase in most members, demonstrating that they are embedded in large-scale variability patterns. Internal variability is lastly related to the lateral forcings along the domain boundaries. An objective classification of inflow/outflow mass fluxes allows identification of the recurrent synoptic configurations that favor strong or weak regional reproducibility. The main uncertainties concern the basic morphological features of rain-bearing systems (i.e., their spatial extension, location and propagation speed). Consequences for tropical-temperate interactions are then discussed.