Power spectrum of geomagneticK p-index detected at Misallat magnetic station

TheK _p-indices measured at Misallat station [ø = 29°45 N; = 30°54 E] during the period 1958–1989, have been compared with the data of two geomagnetic stations; one of them has similar longitude as Misallat and the second has almost similar latitude. The spectra of daily and hourly data of the three stations are compared together to define the latitude and longitude-effects on the detected periodicities. Daily periodicities ofK _p-index activities at the values 32.7, 21.2, 12.9, 11.6 and 9.2 days have been obtained to be common in the spectra of the three stations. The existence of 5-days periodicity in these stations has also been detected.     

Local geoid determination combining gravity disturbances and GPS/levelling: a case study in the Lake Nasser area, Aswan, Egypt

 The use of GPS for height control in an area with existing levelling data requires the determination of a local geoid and the bias between the local levelling datum and the one implicitly defined when computing the local geoid. If only scarse gravity data are available, the heights of new data may be collected rapidly by determining the ellipsoidal height by GPS and not using orthometric heights. Hence the geoid determination has to be based on gravity disturbances contingently combined with gravity anomalies. Furthermore, existing GPS/levelling data may also be used in the geoid determination if a suitable general gravity field modelling method (such as least-squares collocation, LSC) is applied. A comparison has been made in the Aswan Dam area between geoids determined using fast Fourier transform (FFT) with gravity disturbances exclusively and LSC using only the gravity disturbances and the disturbances combined with GPS/levelling data. The EGM96 spherical harmonic model was in all cases used in a remove–restore mode. A total of 198 gravity disturbances spaced approximately 3 km apart were used, as well as 35 GPS/levelling points in the vicinity and on the Aswan Dam. No data on the Nasser Lake were available. This gave difficulties when using FFT, which requires the use of gridded data. When using exclusively the gravity disturbances, the agreement between the GPS/levelling data were 0.71 ± 0.17 m for FFT and 0.63 ± 0.15 for LSC. When combining gravity disturbances and GPS/levelling, the LSC error estimate was ±0.10 m. In the latter case two bias parameters had to be introduced to account for a possible levelling datum difference between the levelling on the dam and that on the adjacent roads. Received: 14 August 2000 / Accepted: 28 February 2001     

Contemporary 14C radiocarbon levels of oxygenated polybrominated diphenyl ethers (O-PBDEs) isolated in sponge-cyanobacteria associations

Considerable debate surrounds the sources of oxygenated polybrominated diphenyl ethers (O-PBDEs) in wildlife as to whether they are naturally produced or result from anthropogenic industrial activities. Natural radiocarbon (¹⁴C) abundance has proven to be a powerful tool to address this problem as recently biosynthesized compounds contain contemporary (i.e. modern) amounts of atmospheric radiocarbon; whereas industrial chemicals, mostly produced from fossil fuels, contain no detectable ¹⁴C. However, few compounds isolated from organisms have been analyzed for their radiocarbon content. To provide a baseline, we analyzed the ¹⁴C content of four O-PBDEs. These compounds, 6-OH-BDE47, 2′-OH-BDE68, 2′,6-diOH-BDE159, and a recently identified compound, 2′-MeO-6-OH-BDE120, were isolated from the tropical marine sponges Dysidea granulosa and Lendenfeldia dendyi. The modern radiocarbon content of their chemical structures (i.e. diphenyl ethers, C₁₂H₂₂O) indicates that they are naturally produced. This adds to a growing baseline on, at least, the sources of these unusual compounds.     

Precipitation rate climatology related to different cloud types using satellite imagery over Iran

Cloud types have a substantial influence on precipitation. This paper presents a study of the monthly variations of daytime different cloud types over Iran using data collected from Moderate-resolution Imaging Spectroradiometer (MODIS) aboard Terra during 2001–2015, MODIS aboard Aqua during 2002–2015, International Satellite Cloud Climatology Project (ISCCP) H-series cloud type data during 2001–2009 and precipitation rate associated with different cloud types using Tropical Rainfall Measuring Mission (TRMM) satellite products during 2001–2009. Different cloud types were determined using MODIS cloud optical thickness and cloud top pressure data based on ISCCP algorithm. The results showed that stratocumulus and cumulus clouds have maximum occurrence frequency over marine areas especially southern seas. The maximum frequency of nimbostratus and deep convective occurrence occurred over mountainous regions particularly at the time of Aqua overpass and cirrus and cirrostratus are observed over southeast of Iran during warm months due to monsoon system. Altostratus cloud is extended in each month except January, at the time of Terra overpass while nimbostratus is seen at the time of Aqua overpass during warm months in the study area. Cumulus and altocumulus clouds have shown remarkable frequency in all months especially over marine regions during warm and fall months. The higher value of precipitation rate is related to altostratus with a rate approximately 7 mm/h at the time of Terra overpass during April. Altostratus has the maximum recorded precipitation rate except in Nov., Dec., Sep., and Jan. at the time of Terra overpass, whereas the maximum precipitation rate is linked to nimbostratus cloud activity (up to 5 mm/h) except for March, April, and Sep. at the time of Aqua overpass. Deep convective (up to 1.32 mm/h), cirrostratus (up to 1.11 mm/h), and cirrus (0.02 mm/h) are observed only in warm months. The results were compared with ISCCP cloud types so that precipitation rate classified from low to high and Spearman rank correlation was calculated. The results showed good agreement between these two cloud type data; however, there were few notable difference between them.     

Geological and geophysical investigation of Kamil crater,Egypt

Abstract– We detail the Kamil crater (Egypt) structure and refine the impact scenario, based on the geological and geophysical data collected during our first expedition in February 2010. Kamil Crater is a model for terrestrial small‐scale hypervelocity impact craters. It is an exceptionally well‐preserved, simple crater with a diameter of 45 m, depth of 10 m, and rayed pattern of bright ejecta. It occurs in a simple geological context: flat, rocky desert surface, and target rocks comprising subhorizontally layered sandstones. The high depth‐to‐diameter ratio of the transient crater, its concave, yet asymmetric, bottom, and the fact that Kamil Crater is not part of a crater field confirm that it formed by the impact of a single iron mass (or a tight cluster of fragments) that fragmented upon hypervelocity impact with the ground. The circular crater shape and asymmetries in ejecta and shrapnel distributions coherently indicate a direction of incidence from the NW and an impact angle of approximately 30 to 45°. Newly identified asymmetries, including the off‐center bottom of the transient crater floor downrange, maximum overturning of target rocks along the impact direction, and lower crater rim elevation downrange, may be diagnostic of oblique impacts in well‐preserved craters. Geomagnetic data reveal no buried individual impactor masses >100 kg and suggest that the total mass of the buried shrapnel >100 g is approximately 1050–1700 kg. Based on this mass value plus that of shrapnel >10 g identified earlier on the surface during systematic search, the new estimate of the minimum projectile mass is approximately 5 t.     

The third harmonic of type III solar radio bursts

The harmonic ratios of a large sample of inverted-U bursts are found to be smaller at the turning frequency than at the starting frequency. Ratios <2.0 are explained by postulating that the lowest fundamental frequencies emitted are prevented from escaping from the corona by an evanescent region between the source and the observer. This concept is used to construct a source model for inverted-U bursts where the density is lower inside a magnetic flux tube than it is outside.     

Analysis of fracture induced scattering of microseismic shear-waves

Fractures are pervasive features within the Earth’s crust and have a significant influence on the multi-physical response of the subsurface. The presence of coherent fracture sets often leads to observable seismic scattering enabling seismic techniques to remotely locate and characterise fracture systems. In this study, we confirm the general scale-dependence of seismic scattering and provide new results specific to shear-wave propagation. We do this by generating full waveform synthetics using finite-difference wave simulation within an isotropic background model containing explicit fractures. By considering a suite of fracture models having variable fracture density and fracture size, we examine the widening effect of wavelets due to scattering within a fractured medium by using several different approaches, such as root-mean-square envelope analysis, shear-wave polarisation distortion, differential attenuation analysis and peak frequency shifting. The analysis allows us to assess the scattering behavior of parametrised models in which the propagation direction is either normal or parallel to the fracture surfaces. The quantitative measures show strong observable deviations for fractures size on the order of or greater than the dominant seismic wavelength within the Mie and geometric scattering regime for both propagation normal and parallel to fracture strike. The results suggest that strong scattering is symptomatic of fractures having size on the same order of the probing seismic wave.     

Regional bivariate modeling of droughts using L-comoments and copulas

The regional bivariate modeling of drought characteristics using the copulas provides valuable information for water resources management and drought risk assessment. The regional frequency analysis (RFA) can specify the similar sites within a region using L-comoments approach. One of the important steps in the RFA is estimating regional parameters of the copula function. In the present study, an optimization-based method along with the adjusted charged system search are introduced and applied to estimate the regional parameters of the copula models. The capability of the proposed methodology is illustrated by copula functions on drought events. Three commonly used copulas containing Clayton, Frank and Gumbel are employed to derive the joint distribution of drought severity and duration. The result of the new method are compared to the method of moments and after applying several goodness-of-fit tests, the results indicate that the new method provides higher accuracy than the classic one. Furthermore, the results of the upper tail dependence coefficient indicate that the Gumbel copula is the best-fitted copula among the other ones for modeling drought characteristics.     

Watershed morphometric analysis of Wadi Baish Dam catchment area using integrated GIS-based approach

The integration of Remote Sensing (RS) and Geographic Information Systems (GIS) constitutes a powerful tool for the evaluation of watershed morphometric parameters. The benefits of this integration include saving time and effort as well as improving the accuracy of the analysis. Moreover, this technique is appropriate for describing the watershed and its streams. In this study, a detailed morphometric analysis of the Wadi Baish catchment area has been performed using the Shuttle Radar Topography Mission (SRTM). The performed morphometric analysis includes linear, areal, and relief aspects. The results of the morphometric analysis reveal that the catchment can be described as of eighth stream order and consists of an area of 4741.07 km². Additionally, the basin is characterized by a relatively high mean value of bifurcation (4.012), indicative of the scarcity of permeable rocks with high slope in the area. This value of bifurcation ratio is consistent with the high drainage density value of 2.064 km/km² and confirms the impermeability of the subsurface material and mountainous relief. The hypsometric integral of the catchment is 47.4%, and the erosion integral of the catchment is 52.6%, both were indications of a mature catchment area.     

Integrated Interpretation of Interwell Connectivity Using Injection and Production Fluctuations

A method to characterize reservoirs, based on matching temporal fluctuations in injection and production rates, has recently been developed. The method produces two coefficients for each injector–producer pair; one parameter, λ, quantifies the connectivity and the other, τ, quantifies the fluid storage in the vicinity of the pair. Previous analyses used λ and τ separately to infer the presence of transmissibility barriers and conduits in the reservoir, but several common conditions could not be easily distinguished. This paper describes how λ and τ can be jointly interpreted to enhance inference about preferential transmissibility trends and barriers. Two different combinations are useful: one is a plot of log (λ) versus log (τ) for a producer and nearby injectors, and the second is a Lorenz-style flow capacity (F) versus storativity (C) plot. These techniques were tested against the results of a numerical simulator and applied to data from the North Buck Draw field. Using the simulated data, we find that the F–C plots and the λ–τ plots are capable of identifying whether the connectivity of an injector–producer well pair is through fractures, a high-permeability layer, multiple-layers or through partially completed wells. Analysis of data from the North Buck Draw field shows a reasonable correspondence between τ and the tracer breakthrough times. Of two possible geological models for Buck Draw, the F–C and λ–τ plots support the model that has less connectivity in the field. The wells in fluvial deposits show better communication than those wells in more estuarine-dominated regions.