Potential of Oil Palm Trunk Sap as a Novel Inexpensive Renewable Carbon Feedstock for Polyhydroxyalkanoate Biosynthesis and as a Bacterial Growth Medium

Utilization of cheap renewable carbon feedstock for polyhydroxyalkanoate (PHA) production not only brings down its production cost but also ensures sustainability. The scope of this study was to evaluate the potential of sap extracted from felled oil palm trunk (OPT) as a novel inexpensive renewable carbon source for PHA production. OPT sap was found to be nutritionally rich and contained various fermentable sugars (5.5% w/v) as its major constituent. Termite gut isolate, Bacillus megaterium MC1 grew profoundly in mineral medium with OPT sap as carbon source and a cell density of 10.9 g/L was attained after 16 h of cultivation in shake flask cultures. A maximum poly‐3‐hydroxybutyrate [P(3HB)] content (% cell dry weight; CDW) of 30 wt% and a P(3HB) concentration of 3.28 g/L was recorded. Additionally, OPT sap extracted from younger tree trunks with prolonged storage had higher sugar content (10.8% w/v) and, when used as a growth medium without the addition of any nutrients, supported bacterial growth comparable to commercially available media.     

The assessment of weathering stages in granites using an EC/pH meter

The sidewall effects of a wind tunnel on aeolian sand transport were investigated experimentally. A wind tunnel was used to conduct the experiments with a given channel height of 120 cm and varying widths (B) of 40, 60, 80, 100 and 120 cm. Both vertical profiles of wind velocity and sand mass flux were measured at different locations across the test section. The results show that the wind velocity with saltation first increases and then decreases to a minimum, from the sidewall to the central line of the wind tunnel. The discrepancy among wind velocities at different locations of the transverse section decreases with decreasing tunnel width. The wind friction velocity across the wind tunnel floor, with the exception of the region closest to the sidewalls, does not deviate strongly in wide wind tunnels from that along the central line, whereas it does vary in narrow tunnels. The sand mass fluxes, with the exception of some near-bed regions, are larger along the central line of the wind tunnel than they are at the quarter width location from the sidewall. Unlikely previously reported results, the dimensionless sand transport rate, Qg / (ρu³) (where Q is the total sand transport rate, g is the gravitational acceleration constant, ρ is the air density, and u is the wind friction velocity), first decreases and then increases with the dimensionless friction velocity, u / u_t (where u_t is the threshold friction velocity). The above differences may be attributed to the sidewall effects of the wind tunnel. A dimensionless parameter, F_B = u / (gB)^1/2, is defined to reflect the sidewall effects on aeolian sand transport. The flows with F_B of 0.33 or less may be free from the sidewall effects of the wind tunnel and can ensure accurate saltation tunnel simulation.     

The lived experience of preparing for earthquakes in households: a phenomenological psychological study

Natural Hazards - This phenomenological study aimed to explore the lived experiences of households after the installation of seismic hazard mitigation measures. Unlike studies aimed at identifying...     

Spatial and temporal variations in summer precipitation in Japanese mountain areas

We examined spatial and temporal variations in precipitation measured during summer season between 1976 and 2007 for 28 stations located in mountain areas across Japan using the amount of precipitation (Pr), the mean depth of precipitation events (η), and the inverse of the mean interval times (λ). We obtained positive correlations between the period mean Pr (Pr ) and the period mean η ( ) and between Pr and the period mean λ ( ) for the 28 stations. Pr was more strongly related to than to , indicating the spatial variations in Pr that are primarily related to the variations in . In addition, Pr was more strongly related to η than to λ for most stations on the basis of data for 1976–2007, indicating that the year‐to‐year variations in Pr are primarily related to η. We also examined temporal trends in Pr, η and λ for 1976–2007 and found no systematic trends for 23 of the 28 stations, suggesting long‐term trends that are not common in mountain areas of Japan. The relationships between Pr and and between Pr and η presented in this study enable us to generate a temporal precipitation distribution pattern based on only Pr and Pr data, respectively. Furthermore, probabilistic stochastic hydrological models require precipitation characteristics as input; thus, this study contributes to the determination of hydrological cycles and their possible future changes in Japanese mountain areas and therefore to water resource management. Copyright © 2010 John Wiley & Sons, Ltd.     

Microbially induced formation of ooid-like coated grains in the Late Cretaceous methane-seep deposits of the Nakagawa area, Hokkaido, northern Japan

Abstract   Ooid-like coated grains are found in the Late Cretaceous methane-seep deposits in the Nakagawa area, Hokkaido, Japan. The coated grains were examined using macro- and microscopic observations, electron-probe microanalysis, and biomarker analysis. They are round- to oval-shaped, with nuclei consisting of fractured sediment and micritic envelopes. The fractures probably occurred as a result of increasing hydrostatic pressure when the sediment was still unconsolidated or weakly consolidated. Biomarker analysis revealed that two types of molecules, crocetane and PMI, are predominant in the hydrocarbon fraction with highly negative carbon isotopic composition as low as −122‰ ( vs Vienna Peedee Belemnite). These data suggest that the coated grains were formed under the influence of anaerobic oxidation of methane, near the sediment/seawater interface. The presence of such grains indicates that methane-containing pore water reached the sea floor at that time.     

Does measuring azimuthal variations in sap flux lead to more reliable stand transpiration estimates?

Stand transpiration (E) estimated using the sap‐flux method includes uncertainty induced by variations in sap flux (F) within a tree (i.e. radial and azimuthal variations) and those between trees. Unlike radial variations, azimuthal variations are not particularly systematic (i.e. higher/lower F is not always recorded for a specific direction). Here, we present a theoretical framework to address the question on how to allocate a limited number of sensors to minimize uncertainty in E estimates. Specifically, we compare uncertainty in E estimates for two cases: (1) measuring F for two or more directions to cover azimuthal variations in F and (2) measuring F for one direction to cover between‐tree variations in F. The framework formulates the variation in the probability density function for E (σ_E) based on F recorded in m different azimuthal directions (e.g. north, east, south and west). This formula allows us to determine the m value that minimizes σ_E. This study applied the framework to F data recorded for a 55‐year‐old Cryptomeria japonica stand. σ_E for m = 1 was found to be less than the values for m = 2, 3 and 4. Our results suggest that measuring F for one azimuthal direction provides more reliable E estimates than measuring F for two or more azimuthal directions for this stand, given a limited number of sensors. Application of this framework to other datasets helps us decide how to allocate sensors most effectively. Copyright © 2016 John Wiley & Sons, Ltd.     

Mass motions due to shock propagations along low-lying loops in the solar atmosphere

The formation of fibrils in low-lying loops is investigated by performing one-dimensional nonlinear hydrodynamic calculations. The loops have the height of 3000–5000 km and have an atmosphere extending from the photosphere to the corona. A shock wave is generated from a pressure pulse in the photosphere and it ejects the chromosphere-corona transition region along the loop, expanding the underlying chromosphere into the corona. This expanding chromospheric material in a loop is regarded as a fibril. The shock propagates in the corona and collides with another transition region where a reflected shock and a penetrating shock are generated. The effect of the reflected shock on the motion of the fibril is weak. The fibril shows a nearly ballistic motion as observations suggest, if it does not extend beyond the summit of the loop. The corona in the loop is compressed nearly adiabatically by the fibril, and the enhanced coronal pressure leads the fibril finally to a retracting motion even if the fibril goes beyond the summit of the loop.Contributions from the Kwasan and Hida Observatories, University of Kyoto, No. 261.     

Characterization of the amorphous state in metamict silicates and niobates by EXAFS and XANES analyses

X-ray absorption spectroscopy using synchrotron radiation has been applied to the investigation of the coordination geometries around Y, Zr and Nb atoms in metamict zircon, gadolinite, fergusonite, euxenite and samarskite. EXAFS and XANES spectra of their crystalline counterparts and synthetic compounds including ZrO₂, Y₂O₃, YNbTiO₆, YNbO₄, LiNbO₃, and NiNb₂O₆ were also measured for comparison. Metamict zircon shows a significant decrease in its Zr-O bond distances accompanying an increase in distortion of the Zr-O coordination polyhedra as compared with crystalline zircon. On the contrary, the average Nb-O bond distances and the symmetry of the coordination polyhedra around the Nb atoms in metamict euxenite and samarskite resemble those in the crystalline euxenite. Compared with crystalline fergusonite, a decrease in the distortion of the Nb-O octahedra is observed in metamict fergusonite. The structures of the second nearest neighbors (the metal-metal interactions) are largely disrupted in the metamict specimens except for metamict zircon and samarskite with high trivalent iron concentration. Nb in metamict samarskite is in octahedral coordination by oxygen and is similar to that in euxenite.     

Hydraulic and numerical study on the generation of a subaqueous landslide-induced tsunami along the coast

By carrying out the hydraulic experiments in a one-dimensional open channel and two-dimensional basin, we clarified the process of how a landslide on a uniform slope causes the generation of a tsunami. The effect of the interactive force that occurs between the debris flow layer and the tsunami is significant in the generation of a tsunami. The continuous flow of the debris into the water makes the wave period of the tsunami short. The present experiments apply numerical simulation using the two-layer model with shear stress models on the bottom and interface, and the results are compared. The simulated debris flow shows good agreement with the measured results and ensures the rushing process into the water. We propose that the model use a Manning coefficient of 0.01 for the smooth slope and 0.015 for the rough slope, and a horizontal viscosity of 0.01 m²/s for the landslide; an interactive force of 0.2 for each layer is recommended. The dispersion effect should be included in the numerical model for the propagation from the shore.