Using a regional numerical weather prediction model for GNSS positioning over Brazil

The global navigation satellite system (GNSS) can provide centimeter positioning accuracy at low costs. However, in order to obtain the desired high accuracy, it is necessary to use high-quality atmospheric models. We focus on the troposphere, which is an important topic of research in Brazil where the tropospheric characteristics are unique, both spatially and temporally. There are dry regions, which lie mainly in the central part of the country. However, the most interesting area for the investigation of tropospheric models is the wet region which is located in the Amazon forest. This region substantially affects the variability of humidity over other regions of Brazil. It provides a large quantity of water vapor through the humidity convergence zone, especially for the southeast region. The interconnection and large fluxes of water vapor can generate serious deficiencies in tropospheric modeling. The CPTEC/INPE (Center for Weather Forecasting and Climate Studies/Brazilian Institute for Space Research) has been providing since July 2012 a numerical weather prediction (NWP) model for South America, known as Eta. It has yield excellent results in weather prediction but has not been used in GNSS positioning. This NWP model was evaluated in precise point positioning (PPP) and network-based positioning. Concerning PPP, the best positioning results were obtained for the station SAGA, located in Amazon region. Using the NWP model, the 3D RMS are less than 10 cm for all 24 h of data, whereas the values reach approximately 60 cm for the Hopfield model. For network-based positioning, the best results were obtained mainly when the tropospheric characteristics are critical, in which case an improvement of up to 7.2 % was obtained in 3D RMS using NWP models.     

Fish Interactions with a Commercial-Scale Tidal Energy Device in the Natural Environment

Fish are a key part of the marine ecosystem likely to be affected by hydrokinetic tidal turbines, but little is known about their behavior around such obstacles in the natural environment. In September 2010, two DIDSON acoustic cameras were used to observe fish interactions with a commercial-scale turbine in Cobscook Bay, Maine. Twenty-two hours (nearly two tidal cycles) of footage were collected. Behaviors of individual fish and schools were classified (e.g., entering, avoiding, passing, or remaining in the wake of the turbine). We analyzed the effects of turbine motion (rotating or not rotating), diel condition (day or night), and fish size (small, ≤10 cm; large, >10 cm) on individual fish behaviors, and compared behaviors of individual fish to schools of fish. When the turbine was rotating, the probability of fish entering the turbine decreased by over 35 % from when it was not. The probability that fish would enter the turbine was higher at night than during the day, and this difference was greater for small fish than for large fish (probability of small fish entering?=?0.147 day, 0.513 night; large fish?=?0.043 day, 0.333 night). Fish were almost always present in the wake of the turbine. Schools of fish had a 56 % lower probability of entering the turbine than individual fish, and reacted at greater distances from the turbine (median distance of 2.5 m for schools, 1.7 m for individuals). This study indicates that fish behavior in response to tidal turbines appears to be similar to responses to obstacles such as trawls, and highlights the importance of environmental context in determining the effects of a tidal turbine on fish.     

Stable carbon isotopes (δ<Superscript>13</Superscript>C) of total organic carbon and long-chain <Emphasis Type="Italic">n</Emphasis>-alkanes as proxies for climate and environmental change in a sediment core from Lake Petén-Itzá, Guatemala

Sediment core PI-6 from Lake Petén Itzá, Guatemala, possesses an ~85-ka record of climate and environmental change from lowland Central America. Variations in sediment lithology suggest large and abrupt changes in precipitation during the last glacial and deglacial periods, and into the early Holocene. We measured stable carbon isotope ratios of total organic carbon and long-chain n-alkanes from the core, the latter representing a largely allochthonous (terrestrial) source of organic matter, to reveal past shifts in the relative proportion of C₃–C₄ terrestrial biomass. We sought to test whether stable carbon isotope results were consistent with other paleoclimate proxies measured in the PI-6 core, and if extraction and isotope analysis of n-alkanes is warranted. The largest δ¹³C variations are associated with Heinrich Events. Carbon isotope values in sediments deposited during the last glacial maximum indicate moderate precipitation with little fluctuation. The deglacial was a period of pronounced climate variability, e.g. a relatively warm and moist Bølling–Allerød, but a cool and dry Younger Dryas. Arid periods of the deglacial were inferred from samples with high δ¹³C values in total organic carbon, which reflect times of greater proportions of C₄ plants. These inferences are supported by stable isotope measurements on ostracod shells and relative abundance of grass pollen from the same depths in core PI-6. Similar trends in carbon stable isotopes measured on bulk organic carbon and n-alkanes suggest that carbon isotope measures on bulk organic carbon in sediments from this lake are sufficient to infer past climate-driven shifts in local vegetation.     

Data-Driven Predictive Modeling of Mineral Prospectivity Using Random Forests: A Case Study in Catanduanes Island (Philippines)

The Random Forests (RF) algorithm is a machine learning method that has recently been demonstrated as a viable technique for data-driven predictive modeling of mineral prospectivity, and thus, it is instructive to further examine its usefulness in this particular field. A case study was carried out using data from Catanduanes Island (Philippines) to investigate further (a) if RF modeling can be used for data-driven modeling of mineral prospectivity in areas with few (i.e., <20) mineral occurrences and (b) if RF modeling can handle predictor variables with missing values. We found that RF modeling outperforms evidential belief (EB) modeling of prospectivity for hydrothermal Au–Cu deposits in Catanduanes Island, where 17 hydrothermal Au–Cu prospects are known to exist. Moreover, just like EB modeling, RF modeling allows analysis of the spatial relationships between known prospects and individual layers of predictor data. Furthermore, RF modeling can handle missing values in predictor data through an RF-based imputation technique whereas in EB modeling, missing values are simply represented by maximum uncertainty. Therefore, the RF algorithm is a potentially useful method for data-driven predictive modeling of mineral prospectivity in regions with few (i.e., <20) occurrences of mineral deposits of the type sought. However, further testing of the method in other regions with few mineral occurrences is warranted to fully determine its usefulness in data-driven predictive modeling of mineral prospectivity.     

Determination of Ocean Wave Period from Altimeter Data Using Wave-Age Concept

This study makes use of the concept of wave age in estimating ocean wave period from space borne altimeter measurements of backscattering coefficient and significant wave height. Introduction of wave age allowed better accounting of the difference between swells and wind waves. Using two years (1998 and 1999) data of TOPEX/Poseidon altimeter and ocean data buoy observations in the Indian Ocean, coefficients were generated for wave period, which were subsequently tested against data for the years 2000 and 2001. The results showed the wave period accuracy to be of the order of 0.6 sec (against 1.3 sec obtained with the semiempirical approach, reported earlier).     

Evapotranspiration management based on the application of SWAT for balancing water consumption: A case study in Guantao,China

Rapid social and economic development results in increased demand for water resources. This can lead to the unsustainable development and exploitation of water resources which in turn causes significant environmental problems. Conventional water resource management approaches, such as supply and demand management strategies, frequently fail to restore regional water balance. This paper introduces the concept of water consumption balance, the balance between actual evapotranspiration (ET) and target ET, and establishes a framework to realize regional water balance. The framework consists of three stages: (1) determination of target ET and actual ET; (2) quantification of the water-saving requirements for the region; and (3) reduction of actual ET by implementing various water saving management strategies. Using this framework, a case study was conducted for Guantao County, China. The SWAT model was utilized to aid in the selection of the best water saving management strategy by comparing the ET of different irrigation methods and crop pattern adjustments. Simulation results revealed that determination of SWAT model parameters using remote sensing ET is feasible and that the model is a valuable tool for ET management. Irrigation was found to have a greater influence on the ET of winter wheat as compared to that of maize, indicating that reduction in winter wheat cultivation is the most effective way to reduce regional ET. However, the effect of water-saving irrigation methods on the reduction of ET was not obvious. This indicates that it would be difficult to achieve regional ET reduction using water-saving irrigation methods only. Furthermore, selecting the best water saving management strategy by relying solely on the amount of reduced ET was insufficient, because it ignored the impact of water conservation measures on the livelihood of the agricultural community. Incorporating these considerations with our findings, we recommend changing the current irrigation method to sprinkler irrigation and replacing 20% of the winter wheat-maize cultivated area with cotton, as the best strategy to achieve water balance in the study area.     

An application of three-dimensional electrical resistivity imaging for the detection of an underground waste-water system

A 3D electrical resistivity imaging survey is presented in this paper. The objective was to investigate an underground wastewater system at the University of Malaya, Malaysia. Apparent resistivity data were collected along ten parallel lines using a Wenner-Schlumberger configuration; electrode cables were oriented in the x-direction with 3 m spacing. Roll-along measurements using a line spacing of 3 m were carried out covering a grid of 20 × 10 electrodes. All data sets were merged into a single data file in order to perform a 3D inversion. Two different 3D least squares algorithms, based on the robust inversion method and the smoothness-constrained technique, were used for the inversion of the apparent resistivity data. Both the horizontal and vertical extents of the anomalous zones found by inversion are displayed. The results indicate the superiority of the robust inversion method over the smoothness-constrained technique at this site. The results are in sufficient accordance with previously known information about the investigation area. The results show that 3D electrical resistivity imaging surveys, in combination with an appropriate 3D inversion method, can be highly useful for engineering and archaeological investigations as well as for environmental applications.     

The 23 April 1909 Benavente earthquake (Portugal): macroseismic field revision

The 23 April 1909 earthquake, with epicentre near Benavente (Portugal), was the largest crustal earthquake in the Iberian Peninsula during the twentieth century (M _w = 6.0). Due to its importance, several studies were developed soon after its occurrence, in Portugal and in Spain. A perusal of the different studies on the macroseismic field of this earthquake showed some discrepancies, in particular on the abnormal patterns of the isoseismal curves in Spain. Besides, a complete list of intensity data points for the event is unavailable at present. Seismic moment, focal mechanism and other earthquake parameters obtained from the instrumental records have been recently reviewed and recalculated. Revision of the macroseismic field of this earthquake poses a unique opportunity to study macroseismic propagation and local effects in central Iberian Peninsula. For this reasons, a search to collect new macroseismic data for this earthquake has been carried out, and a re-evaluation of the whole set has been performed and it is presented here. Special attention is paid to the observed low attenuation of the macroseismic effects, heterogeneous propagation and the distortion introduced by local amplifications. Results of this study indicate, in general, an overestimation of the intensity degrees previously assigned to this earthquake in Spain; also it illustrates how difficult it is to assign an intensity degree to a large town, where local effects play an important role, and confirms the low attenuation of seismic propagation inside the Iberian Peninsula from west and southwest to east and northeast.     

Travertine deposition and faulting: the fault-related travertine fissure-ridge at Terme S. Giovanni,Rapolano Terme (Italy)

In this paper we describe an example of travertine fissure-ridge development along the trace of a normal fault with metre displacement, located in the eastern margin of the Neogene–Quaternary Siena Basin, in the Terme S. Giovanni area (Rapolano Terme, Italy). This morphotectonic feature, 250 m long, 30 m wide and 10 m high, formed from supersaturated hot waters (39.9°C) flowing from thermal springs aligned along the trace of the normal fault dissecting travertines not older than Late Pleistocene (24 ± 3 ka). A straight, continuous fissure with a maximum width of 20 cm occurs at the top of the ridge, along its crest. Hot fluids flow from cones mainly located at the extremities of the ridge, where travertine is depositing. The travertine fissure-ridge shows an asymmetrical profile since it buries the fault scarp. The difference in height of slopes corresponds to the vertical displacement of the normal fault. Fissuring of the recent travertine deposits along the strike of the crestal fissure, as well as recent hydrothermal circulation, lead us to believe that the Terme S. Giovanni normal fault may be currently active. On the whole, the Terme S. Giovanni fissure ridge can be defined as a travertine fault trace fissure-ridge, adding a helpful example for studying the relationship between faulting and travertine deposition.     

Influence of landscape restoration and degradation on storm surge and waves in southern Louisiana

The purpose of this investigation was to examine storm surge and wave reduction benefits of different environmental restoration features (marsh restoration and barrier island changes), as well as the impact of future wetland degradation on local surge and wave conditions. Storm surge simulations of two representative hurricanes were performed using the ADCIRC storm surge model with the inclusion of radiation stress gradients from the STWAVE nearshore wave model. Coupled model simulations were made for a number of landscape configurations that involved both restored and degraded wetland features. The impact of barrier island condition on hurricane surge and waves was also evaluated. Effects of landscape features were represented by changes in elevation and frictional resistance. Restoration and degradation of marsh resulted in decreases (for restoration cases) and increases (for degradation cases) in both surge and waves. The magnitude of change was correlated with the magnitude of the horizontal extent and elevation changes in the marsh. In general, the wave change patterns are consistent with the water level changes. Deflation of the Chandeleur Islands (barrier island chain) resulted in slightly increased surge. Results suggest that coastal marsh does have surge and wave reduction potential. Results also indicate that the impact of the landscape features is amplified in areas where there are levee “pockets.” Barrier islands and coastal ridges reduce wave heights, even if in a degraded condition and thus can reduce wave energy in wetland areas, protecting them from erosion.